COMPLETE SOLUTIONS WHERE ENERGY LIVES METAL AND CONCRETE TRANSFORMER SUBSTATIONS DISTRIBUTION SWITCHGEAR UP TO KV - UNISEC ELECTRICAL SWITCHBOARDS LOW AND MEDIUM VOLTAGE ELECTRICAL EQUIPMENT UniSec licensed by ABB, produced by Metix www.metix.bg AIR-INSULATED MEDIUM VOLTAGE SWITCHGEAR FOR SECONDARY DISTRIBUTION UP TO kv, 0A, 2 ka
UniSec Introduction AIR-INSULATED MEDIUM VOLTAGE SWITCHGEAR FOR SECONDARY DISTRIBUTION UP TO kv, 0A, 2 ka The UniSec Switchgear panels are under the license of ABB. They are produced in the factory of Metix, located in the town of Petrich, Bulgaria. The switch-disconnectors and breakers are supplied by Metix, produced by ABB. The assembled panels are factory tested in the Metix before packaging and shipment. Each panel is provided with test protocol and design documentation. Installation and operation manuals are available. Metix provides warranty service and support. After the expiration of warranty period, maintenance services can be contracted. UniSec switchgear features - Air insulation of all live parts - SF6 switch-disconnector - Removable vacuum and SF6 circuit breakers - LSC2A-PM classification for panels with switch-disconnector, in accordance with the loss of service continuity definitions and IEC 62271-200 standards - Complete range of functional units and accessories - Wide choice of state-of-the-art protection relays, either integrated on circuit-breakers or mounted separately for protection, control and measurement functions Available versions - Arc fault tested in accordance with standard IEC 62271-200 in the IAC AFL arc proof version on two sides (front and lateral). ka and IAC AFLR arc proof version on three sides (front, lateral, rear). ka, 16 ka and 21 ka; - Seismic withstand version in accordance with standard IEEE 693 - Marine version. Normal service conditions - Storage temperature: - C + 70 C * - Range of ambient temperature: - C + 40 C * - Maximum relative humidity without condensation: 9 % - Minimum relative humidity without condensation: % - Altitude: < 1000 m above the sea level** (*) Contact Metix for - 2 C operating temperatures and - 40 C storage temperatures. (**) For higher altitudes and higher degrees of protection, contact Metix. Switchgear electrical characteristics Rated voltage kv Test voltage (0-60 Hz х 1 min) kv 28 38 0 Impulse withstand voltage kv 7 9 Rated frequency Hz 0-60 0-60 0-60 Rated main busbar current A /0 /0 /0 Rated short time withstand current ka (3s) 16/20 (4)/ 2 (1)(2) 16/20 (4) /2 (2) 16/20 (4) /2 (2) Peak current ka 40/2./63 40/2./63 40/2./63 (2) Internal arc withstand current (IAC AFLR) ka (1s)./16/21/2 (2)./16/21/2 (2)./16/21
MAIN COMPONENTS GSec SF6-insulated switch-disconnector Vacuum Breaker VD4/R-SEC Design of UniSec panel VD4/SEC Instrumental Transformers Current transformers Voltage transformers Current sensors Microprocessor protection devices 1 - Switch-disconnector 2 - Fuses 3 - Circuit-breaker 4 - Busbar compartment - Mechanism compartment 6 - Circuit-breaker operating mechanism REF601 REF610 REF61
Typical Units UniSec SDC Unit with switch-disconnector SDS Unit with switch-disconnectorisolation 37 00 70 mm 37 00 mm./16(1)/20(2)/2(3) (3s)./16(1)/20(2) (3s)./16(1)/20(2) (3s) (1) 16 ka 3s duble spring operating mechanism (2) Contact Metix for 21kA (3) 2 ka (2s)./16(1)/20(2)/2(3) (3s)./16(1)/20(2) (3s)./16(1)/20(2) (3s) (1) 16 ka 3s duble spring operating mechanism (2) Contact Metix for 21kA (3) 2 ka (2s) SDM Isolating unit with measurement with switchdisconnector 70 mm./16/20(1)/2(2) (3s)./16(1)/20(2) (3s)./16(1)/20(2) (3s) SDD Unit with double switch disconnector 70 mm./16 (3s)./16 (3s)./16 (3s)
Typical Units UniSec UMP Universal measurement unit 70 mm./16/20(1)/2(2) (3s)./16/20(1) (3s)./16/20(1) (3s) SFC Switch-disconnector with fuses SBC Circuit breaker with switchdisconnector 37 00 mm 70 mm./16(1)/20(2)/2(3) (3s)./16(1)/20(2) (3s)./16(1)/20(2) (3s) (*) Making capacity EF 230, F ст-ст предпазител F/A./16/20(1)/2(2) (3s)./16/20(1) (3s)./16/20(1) (3s) (*) Making capacity EF 230 /2. kap SFS Switchdisconnector with fuses -isolation SBS Circuit breaker with switchdisconnector isolation 37 00 mm 70 mm (*) Making capacity EF 230./16/20(1)/2(2) (3s)./16/20(1) (3s)./16/20(1) (3s) F/A./16(1)/20(2)/2(3) (3s)./16(1)/20(2) (3s)./16(1)/20(2) (3s) (*) Making capacity EF 230 /2. kap 31./40/0(1)/63 31./40/0(1) 31./40/0(1) 31./40/0(1)/63 31./40/0(1) 31./40/0(1)
Typical Units UniSec SBM Isolating unit with measurements, circuit breaker and double switchdisconnector SFV Switch-disconnector with fuses measurement 70 mm 00 mm./16/20(1)/2(2) (3s)./16/20(1) (3s)./16/20(1) (3s)./16/20(1)/2(2) (3s)./16/20(1) (3s)./16/20(1) (3s) SBR Reversed circuit breaker unit DRC Direct incoming unit with measurement and busbar earthing 70 mm 37 00 mm./16 (1)s./16 (1)s./16 (1)s (*) Making capacity ESBR230-U (**) Making capacity ESBR230-L /0./16/20(1)/2(2) (3s) /0./16/20(1) (3s)./16/20(1) (3s) (*) Earthing switch making capacity /2. kap 31./40 31./40 31./40 IkAp/kAp(**) DRS Riser unit measurement 37 00 mm /0./16/20(2)/2(3) (3s(4)) /0./16/20(2) (3s(4)) /0(1)./16/20(2) (3s(4)) (1) Only for DRS coupled to WBC/WBS (2) Contact Metix for 21kA/2. kap (3) 2 ka (2s) (4) 2 ka, 3s DRS coupled to WBC/WBS F/A 31./40/0(1)/63 31./40/0(1) 31./40/0(1)
9. Dimensional drawings ative dimensions of typical units but do not refer to specific configurations. Dimensional Drawings The drawings merely show indicative dimensions of typical units but do not refer to specific configurations. Front view view Front 600 00 37 WBC WBS SDC SDS BME SFC SFS DRC DRS mm (*) 70 70 00 SDC (*) SDS SFC (*) SFS SFV (*) DRC (*) DRS HBC 600 WBC WBS SBC (*) SBS WBC WBS SBR SBM SDD SDM UMP SDC WBC WBS BME 70 70 SBC (*) SBS SBR SBM SDD SDM UMP SDC Available also for adaptor panel H = 2000 mm Side view view no IAC IACand anda-fl A-FL. completely against the wall) 2 ka 1skA 1s (solution A-FLSide. kano1s (solution completely against the wall) Production 1700/2000(**) 1700/2000(**) (solution completely against the wall) Engineering 1070 (*) (**) For panels with removable circuit-breakers Not available for panels SBR and UMP 1070 98 110 (*) 110 (*)
FACTORY 2, Petrich, Bulgaria, Industrial area 49 Svoboda str. Telephone: +39/ 74/ 60 743 fax: +39/ 74/ 60 742 e-mail: metix@metix.bg SHOWROOM 1404, Sofia, Bulgaria, complex Motopista - II Ricardo Vacarini, ground floor tel.: +39/2/ 869 06 96 fax: +39/2/ 98 93 34 e-mail: sales@metix.bg www.metix.bg