Multiplexing Multiplexing Wiring Page 1 www.arcticsnowplows.com
Multiplexing Control Module Installation Instructions Warning! When drilling mounting holes or using self-tapping screws in the engine compartment, be sure to check the mounting location for any wires, hoses or other obstructions that could be damaged during installation. When installing the Control Module, if possible mount connector side down. Inside the engine compartment (on the driver s side, if possible) locate a flat surface suitable for mounting the Control Module. Choose a surface that is clear of moving parts and extreme heat. The fire wall, fender well and radiator shroud are possible mounting locations. Note: Make sure that chosen location is in a spot that will allow the wire harness (Vehicle Side & Lighting Harness) to reach their destination. Once location is determined, drill mounting holes and mount securely with bolts or use self-tapping screws. I f an acceptable flat surface is not available, cable tie the control module securely to a harness or an existing bracket. To avoid corrosions and extend the life of the Control module, keep connectors well-greased with dielectric grease. (No service parts inside. Opening will break internal seal, damage module and may void warranty). Installation of Vehicle Harness RED/WHITE (ignition) wire Connect the RED/WHITE wire to a keyed 12V+ ignition source. Note: This 12V+ source should only be active when the key is in the ON position. Failure to wire to a keyed source can allow a condition to occur causing the battery to drain. This will also prevent operation of the plow without the vehicles key being on. To find a keyed 12V+ ignition source, consult the fuse panel section of the vehicles owner s manual. Look for a fuse labeled ACC/IGN or ACC (Accessory). Remove the fuse, apply the fuse tap as shown below and reinstall the fuse. The RED/WHITE ignition wire can now be plugged to the ¼ fast-on tab. Note: Check to make sure that the snowplow control ONLY has power when the vehicle ignition switch is ON. If NO accessory fuse is available, a test light may have to be used to determine if power to a certain fuse (or any other power source) is switched / keyed or not. Note: The RED/WHITE ignition wire is equipped with its own 10 amp fuse, so it can be tapped to any size fuse (10 or above). Do not use two taps on the same fuse. Page 2 www.arcticsnowplows.com
Multiplexing Multiplexing Parts Part # Description Light Adapters 1 767054-MPX Bulb # H9005/H9006 / GM (90-07) - 6 Pole "Classic" 2 767042-MPX Bulb # H9004 / Ford(87-91)/Dodge Ram 1500(94-01)/Dodge Ram 2500(94-02) 3 767052-MPX Bulb # H9007 / F150 (92-03)/F250/350/450 (92-04)/Dakota (97-04)/Ram 1500 (02-05)/Ram2500 (03-05) / Hummer H2 (03-10) 4 800034-MPX Bulb # H13 / Ford F150 (04-10)/F250/F350/F450 (05-14), Dakota (05-13), Ram 1500/2500 (06-13), GMC Yukon/Denali (07-13) 5 800042-MPX Bulb # H9005/H11 / Chev Silverado/Tahoe/Avalanche/Suburban (07-13) / GMC Sierra (07-13), 6 800081-MPX GMC/Chevy 2015 7 800082-MPX Sealed Beam 8 800083-MPX Tundra (07-13) 9 800077-MPX Dodge 1500/2500/3500 2014 + Control Module 1 800080-MPX Control Module Main Harness 1 53470-MPX Main Harness 2 761321 3/16 Connector 3 53614-N ¼ fuse tab 4 53615-N 3/16 mini fuse tab Controllers 1 53495-MPX Controller for Wing Blade 2 53282-MPX Controller for Straight Blade 3 53326-MPX Controller for V Blade Page 3 www.arcticsnowplows.com
Multiplexing Multiplexing Power Units 16 53494-MPX M3593-WING Power Unit Kit (include control module, main harness, circuit breaker, power cables, hoses) 17 53531-MPX V Plow Power Unit Kit (include control module, main harness, circuit breaker, power cables, hoses) 18 53532-01-MPX M3593 Power Unit Kit Single Chain Kit (include control module, main harness, circuit breaker, power cables, hoses) 19 53532-02-MPX M3593 Power Unit Kit Dual Chain Kit (include control module, main harness, circuit breaker, power cables, hoses) 20 53533-MPX M35493 Power Unit Kit Kit (include control module, main harness, circuit breaker, power cables, hoses) Power Cables Required for Multiplexing Installations 21 51335-22-M 22 Battery Cable 22 51335-56-M 56 Battery Cable 23 53477-B 90 Ground Cable 24 53478-B 90 Power Cable 25 53608-N Circuit Breaker 135 AMP Plow Lights Compatible to Multiplexing System 26 800075 Sealed Beam AXV Light 27 800076-D Dual Bulb Lights Arctic Equipment Manufacturing Corporation reserves the right under its product improvement policy to change construction or design details and furnish equipment when so altered without reference to illustrations or specifications used. Page 4 www.arcticsnowplows.com