NET- System Automatic Sliding Door Operator NABCO's Advanced Technology to enhance comfort and safe operations of automatic doors.
For Pedestrians' safety and comfort Idler pulley with spring tensioner Battery unit (option) Door operation is available at power failure or in an emergency Electric lock controller (option) Door hanger igh durability and less noise are achieved by adopting aluminum rollers with urethane rubber coating Aluminum rail base Ensuring accurate assembly of equipment Electric lock (option) Fail-secure type or Fail-safe type Timing belt with low noise 1
NABCO NET- System NABCO NET- is the advanced system of automatic door to provide the complete entrance. NET- adopts CAN* transmission and PDA with the sophisticated application. Easier installation and maintenance together with upgraded functionality and higher safety are realized. NET- Non NET- Non CAN wiring Non NET- switch Extended adapter adding contact input /output CAN transmission network Automatic sliding door * CAN stands for Controller Area Network. It is a serial communication protocol standardized by ISO, and used in auto industry, etc. CAN has such features as simple connection, high reliability and real-time transmission. Electric lock Electric lock Controller Controller Geared motor Communication adapter NET-T an application for PDA Controller Microcomputer equipped original software Environment-friendly design including lead-free soldering Various kinds of setting can be operated remotely Applying for emergency-open or emergency-close (option) Door stopper Power switch module On-off switch for maintenance Connector for Communication adapter Geared motor Thermal protector equipped brushless DC motor Mono-composition of precise hypoid reduction gear
Door Operator for NET- Standard Sliding N-60 N-7 N-10 -S Surface mount -N Concealed side / flat bar mount -S Surface mount -N Concealed side / flat bar mount -F -S Surface mount -N Concealed side / flat bar mount -F12, -F1 N-20 Telescopic Sliding N-60, N-7, N-10 -D2S -D2 Surface mount Circular Sliding N-7, N-10 Eu Wide range of doors NET- door operators are available from less than 60kg to up to 20kg. N-60 For lighter doors such as stores N-7 For medium doors such as office buildings N-10/N-20 For heavy doors up to 10kg/20kg such as large buildings igh-power brushless DC motor Door hanger structure The hanger rail made of stainless steel attached to the aluminum rail base and the durability was enhanced. The quieter operation is also realized by adopting resin coated aluminum rollers in the door hanger. Door hanger structure Urethane rubber coated aluminum roller igh-performance, compact and powerful motor provides smooth and comfortable atmosphere to passers-by. Thermal protector Thermal protector prevents a damage to the door operator. When the excess load is detected, the door operator will have the door slow down. As far as operation continued, passers-by can walk through. After the excess load removed, the door speed will recover automatically. anger rail with stainless steel Components N-7S Basic Set Bi-parting accessory 3
NET-T, an application for PDA NET- System adopts NET-T which works as an application for PDA compatible with Windows Mobile 6. NET-T, the exclusive application allows PDA to set and adjust sliding door through communication adapter with Bluetooth wireless connectivity. (To be used by NABCO sales distributors) Functions All settings are selectable and visible with NET-T. All information is transmitted to the application. Precise setting and simplified adjustment are available. (fig.1 Digital control allows for monitoring the controller status. (fig.2 All information is recorded and viewable. (fig.3 PDA, personal degital assitant P ipaq 112 Synchronizing data with a PC Up-to-date information stored on the PDA (fig.1 Menu item (fig.2 Monitoring (fig.3 Data storage (fig.3 Maintenance information Optional devices APS-N20 Advanced Program Switch APS-N20 makes sliding doors much convenient to use. With color LCD, automatic doors can be easily operated in the most suitable way. APS-N1 Advanced Program Switch Because of a low-profile device, APS-N1 is available for surface mounting. SKD-2 Electric Lock EOS Emergency Operating System SKD-2 and KD-N controller SKD-2 is a compact electric deadbolt lock for sliding door. Fail-secure type and Fail-safe type are available. This lock is controlled by KD-N controller with NET- System. Easier installation and improved reliability are achieved. EOS controller and battery unit EOS operates sliding door at a power failure or in an emergency condition. EOS controller and battery unit are required for the operation of EOS emergency control. If a power failure or EOS controller receives an emergency signal, the system will operate the door either open or close using the power from the battery unit.
Specification Standard sliding Door Type Door Operator Type Applicable Door Mass x Door Qty (kg) Applicable Door Area : DW D (m²) Applicable Door Width : DW (mm) Applicable Door eight : D (mm) Ratio of Door eight / Width : D / DW Power Supply Average Door Operation Speed (m/sec) Maximum Endurance Wind Speed (m/sec) Dimension(mm) N-60 7 x 1 2.2 N-7 0 x 1 2.8 h 60 ~200 Max. 4.0 Single N-10 120 x 1 10 x 1*² 3.3-0V AC %, 0/60z, A 0.4 or less (Adjustable) *¹ 1 power source power on/off switch N-20 20 x 1 1200 ~30 Max. 3.0 0V AC %, 0/60z, A N-60 60 x 2 1.8 N-7 8 x 2 2.6 Bi-Parting 60 ~200 Max. 4.0 120 x 2 10 x 2 *² - 0V AC %, 0/60z, A 0.4 or less (Adjustable) *¹ 1 N-10 3.0 N-20 20 x 2 900 ~270 Max. 3.0 0V AC %, 0/60z, A *¹ Operation speed between 0 mm and 600 mm *² Only for N-10 F1 Concealed side mount for Alminum sash N-60N/7N 94 or for Stainless steel sash N-60N/7N/10N 97 or 0 or guide rail opening width clear opening width DW width DW +600 (door stroke) 1 0 0 or 128 or +600 0 DT h=170 128 or 2 +600 6 6 12 DT h=200 3 3 Surface mount N-60S/7S/10S 0 for Stainless steel sash N-7F/10F12/10F1 97 or for Stainless steel sash N-20 6. or 36 72 42 8 h=10 12 or 6 6 h=200 236 or h=330 DT 0 0 2 DT 12 6 DT 6 2 +600 3 +600 3 +00 +300
Telescopic sliding Circular sliding The National Museum of Art, OSAKA N-60*¹ 0 x 2 1.6 00~600*² Single N-7 6 x 2 2.1 00~800*² N-10 0 x 2 2.4 00~00*² - Max. 4.2 N-60*¹ 40 x 4 1.4 00~0*² 0V AC %, 0/60z, A 0.38 or less (Adjustable) 0.3 or less (Adjustable) 1 Bi-Parting N-7 x 4 1.9 00~60*² N-10 0 x 4 2.2 00~00*² *¹ Indoor use only *² When applying to Framed Door N-7 7 x 1 Single Bi-Parting N-10 N-7 N-10 0 x 1 7 x 2 0 x 2-762 ~67 *¹ Max. 2438 *¹ Max. 3.0 0V AC %, 0/60z, A 0.4 or less (Adjustable) *¹ When applying to Tempered glass Door Dimension(mm) power source Dimension(mm) h 60 or 1 2 DW 2 DW 2 2 DW1 DW 1 1 +600 60 or D power on/off switch R (from door center) DW DW width opening width clear opening width Surface mount -D2S -D2 EU 200mm or h=27 h=280 h=20 12 170 R (for access panel outside) 3 R (for access panel inside) +600 +600
Sensors MS-N01 M Search Full color LED display, Replacement time display Self-diagnosis function, Eco mode Anti-snow/insects mode, Anti-vibration mode Independent 72 spots, Doorway area monitoring for unique door design, Contact-free touch function, Measure against insertion mode Detection method Motion / Presence Detection (Near Infrared reflection method) Mounting height 2.0m4.0m Detection area W 2.9m D 1.8m (Mounting height 2.2m) Power supply/ 120mA or less at 12VDC Power consumption Output rating NET- connector Detection area Mounting height 1 2 3 4 6 G Dimensions (mm) 6 I A B C D E F 26 40 Detection area size (reference value) Mounting height(m) 2.0 2.2 2. 3.0 3. 4.0 A B 0 390 1 430 120 480 10 80 170 670 200 770 C D E F G I 60 960 1300 1600 1220 20 2640 720 0 1430 1820 130 2320 2900 820 1200 1620 2070 130 2630 3300 980 1,10 1440 1,680 190 2,270 2490 2,920 1840 2,10 3160 3,690 3960 4,620 13 1920 290 3320 240 42 280 The above values are obtained when the area adjuster is set at zero degree. Mass : 260g is-n4000 isearch - Independent 72 spots - Eco mode Detection method Motion / Presence Detection (Near Infrared reflection method) Mounting height Max. 4.0m Detection area Max. W 2.m x D 1.31m [Mounting height 2.4m] Power voltage 12V DC % Current consumption 1mA or less Output rating NET- connector NP-/NP-LB Beam Sensor Simple and reliable Detection area (mm) Mounting height Dimensions (mm) 8 13 1 2 3 4 6 12 G I Detection area (mm) Mounting hole128-130mm Ceiling thickness2-2mm Mass : 330g 12 A B C D E F Detection area size (reference value) Mounting height (m) A B C D E F G I 2.0 9 27 460 660 870 1,090 860 1,630 2,080 3.0 4.0 140 4 690 98 1,300 1,63 1,280 2,430 3,090 18 4 9 1,3 1,730 2,180 1,700 3,240 4,120 1 11.6 Model NP-B NP-LB *1 Detection method Motion / Presence Detection (Near Infrared reflection method) Distance between photocells Max..0m Max. 8.0m *1 NP-LB works with the exclusive controller. 2 14 MassNP-B 120g NP-LB 230g Display on NET-T Area setting (MS-N01) Preset selection Real-time monitoringfor confirmation of detection area AIR field The detection area can be set spot by spot. (=AIR field) Easy and accurate adjustment are available. Preset for sliding door, circular door and folding door are available. Standby During test, Active AIR fields become green and Detected AIR fields become pink. Accessibility Innovations Company Address Phone Fax : JA Kyosai Bldg., 7-9, irakawacho 2-chome, Chiyoda-ku, Tokyo, 2-0093, Japan : +81(0)3-213-117 : +81(0)3-213-1173 https://nabco.nabtesco.com/en/ ISO9001 / ISO14001 Certified For further details, please contact: All specifications herein are subject to change without notice