IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction. The most updated information on this Certificate of Listing is available online at pld.iapmo.org Effective Date: May 2017 -Rev. 1/9/2018- Void After: May 2018 10500 Seymour Ave. Franklin Park, IL 60131-1259 Identification: Each product shall bear permanent and legible markings to identify the manufacturer. This marking shall be the trade name, trademark, or other mark known to identify the manufacturer. The product shall bear the appropriate IAPMO R&T certification mark. The product may also bear either "Lead Free" or "Low Lead" above or in close proximity to the IAPMO R&T certification mark. Characteristics: Products may include any pipe, pipe fitting, solder, flux, or other plumbing products providing water for human consumption. Products listed below are to be installed in accordance with the manufacturer's instruction. These products have been verified with weighted average lead content <=0.25%; Solder and flux lead content <=0.2%. Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory. This recognition has been granted based upon the laboratory's compliance to the applicable requirements of ISO/IEC 17025. Products are in compliance with the following standard(s): Section 1417(d) of the Safe Drinking Water Act This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material, manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing. Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc. Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.
The lead content requirements of Section 116875 of the California Health & Safety Code NSF/ANSI 372-2016 Vermont Lead Reduction Law (Vermont Act 193)
MODELS: Note: Models are in compliance with Section 1417 (d) of the Federal Safe Drinking Water Act effective January 4, 2014. EAF-100 EAF-150 EAF-200 EAF-225 EAF-250 EAF-275 EAF-350 EAF-350-ISM EBF-550 EBF-555 EBF-750 EBF-755 ETF-500 ETF-660 ETF-700 ETF-770 MCR-101CA MCR-102CA MCR-103CA MCR-104CA MIX-135A SF2100 SF2150 SF2200 SF2250 SF2300 SF2350 SF2400 SF2450 EAF-700 Gooseneck electronic faucet, AC Adapter powered EAF-750 Gooseneck electronic faucet, battery powered ETF-80 W / Bak - Chk - Tee ETF-80 W / Mechanical Mix Valve ETF-80 W / Optimix Valve ETF-80 W / Thermo Mix Valve EBF-85 W / Bak-Chk - Tee EBF-85 W / Mechanical Mix Valve EBF-85 W / Optimix Valve EBF-85 W / Thermo Mix Valve EBF-187 W / Bak-Chk - Tee EBF-187 W / Mechanical Mix Valve Page 3 of 5
EBF-187 W / Optimix Valve EBF-187 W / Thermo Mix Valve ETF-470A Check Valve Kit EBF-600 W / Thermo Mix Valve ETF-600 W / Bak - Chk - Tee ETF-610 W / Bak - Chk - Tee ETF-610 W / Mechanical Mix Valve ETF-610 W / Optimix Valve ETF-610 W / Thermo Mix Valve EBF-615 W / Bak - Chk - Tee EBF-615 W / Mechanical Mix Valve EBF-615 W / Optimix Valve EBF-615 W / Thermo Mix Valve EBF-625 EBF-650 W / Bak - Chk - Tee EBF-650 W / Mechanical Mix Valve EBF-650 W / Thermo Mix Valve EBF-655 ETF-711 (W and B-P-LT) ETF-800 ETF-880 W / Bak - Chk - Tee ETF-880 W / Mechanical Mix Valve ETF-880 W / Optimix Valve SENSO EAF-900 ETF-880 W / Thermo Mix Valve Basys MIX-60-A MIX-100-A MIX-110-AA MIX-135-A ESF-40-S (w/bak-chk-tee) ESF-40-SH (w/bak-chk-tee) EFX-1XX.XXX.XXXX EFX-2XX.XXX.XXXX EFX-3XX.XXX.XXXX EFX-6XX.XXX.XXXX EFX-8XX.XXX.XXXX Faucets with Soap Dispensers. COMBO FAUCET SOAP DISPENSER ESD-1501 EAF-150-ISM ESD-1500 ESD-2001 EAF-275-ISM ESD-2000 ESD-2101 SF-2150 ESD-2100 Page 4 of 5
ESD-501 EFX250.500.0000 ESD-500 ESD-601 EBF-615 ESD-600 ESD-701 EAF-750-ISM ESD-700 ESD-801 EBF-85 ESD-800 Suffix: 1st X Body Type: 1=High, 2=Mid, 3=Low, pedestal,6=low + Integrated base, 8 = Wall 2nd X=Power: 0=Hardwire, 5=Battery, 7=Solar, and 8=Turbine 3rd X=Crowns: 0=Bowed, 5= Solar, 6=Display, and 7=Solar Display 4th X=Mix: 0=None 1= Mechanical, Below Deck (for EFX-3XX and EFX-6XX Series only) 2= Thermostatic, Below Deck (for EFX-3XX and EFX-6XX Series only) 5= Mechanical, Integral Side (for EFX-1XX and EFX-2XX Series Only) 5th X=Sensing: 0=Active IR and 1=Capacitance 6th X=Flow Rate: 0=0.50 gpm Spray, 12=1.5 gpm Aerated and 3=1.5 gpm Laminar 7th X=Battery Type: 0=Alkaline and 1=Lithium 8th X=Trim Plate: 0=None, 1=4-inch and 2=8-inch 9th X=Voltage Adapter: 0=None/ 1=US Plug, 2=UK Plug, 3=EU Plug, 4=Box-type 10th X=Drain Pop-up: 0=No and 1=Yes 11 th X=Finish 0=CP and 1=PVDSF Page 5 of 5