AUGER HOUSING / IMPELLER ASSEMBLY SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 9 0 9 0 9 0 9 0 0 0
AUGER HOUSING / IMPELLER ASSEMBLY SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 -9 Pulley, Impeller 9-09 Bearing Assembly, Flange - Nut, Hex Flange /- 0- Bolt, Flat Head, Carriage /- x / 0-0 Bolt, Carriage /- x / 9-0 Nut, Cage /- -9 Housing, Auger 0-9 Bar, Scraper 0-9 Bracket, Corner Discharge - Base, Discharge Chute -0 Washer, Flat 0 0-00 Washer, Lock / 9 0- Screw, Hex Head /- x / 9- Screw, Hex Head / x 0 0-00 Nut, Hex Lock /-0 0 0 0-00 Nut, Hex Lock /- - Washer, Flat / 0-9 Skid Plate, RH 9- Washer, Nylon, Friction 0-0 Bolt, Carriage /- x / -00 Bolt, Shoulder /-0-0 Bearing Retainer, Plastic -9 Washer, Thrust, " 0-90 Bolt, Shear 9 0-9 Skid Plate, LH 0 9-0 Auger Assembly, RH 9-9 Auger Assembly, LH -99 O-Ring -00 Bushing, Flange / - Washer, Thrust / - Bearing, Thrust / -0 Shaft, Impeller - Washer, Thrust / - Bushing, Flange / 9 00- Screw, Hex Head /- x / 0 0 - Plug, Case - Housing, Gearbox, RH -9 Seal, Oil -0 Bushing, Flange, " 9- Key, Square / x / x / -9 Gear, Worm - Shaft, Auger - Housing, Gearbox, LH -0 Impeller Assembly 9 0- Screw, Hex Head /-0 x -/ 0 - Gasket, Gearbox -0 Pin, Roll / x -/ 9- Bearing, Auger 0 - Washer, Flat / - Kit, Shear (Contains each of Key Numbers and ) 0- Multi-Wrench NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty.
CONTROL PANEL / DISCHARGE CHUTE SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 0 9 9 0
CONTROL PANEL / DISCHARGE CHUTE SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 - Knob, Lever 0 - Screw #- x / - Control Assembly, Defl ector 0 0-00 Nut, Lock /- - Washer, Flat / -9 Control Assembly, Chute Rotater 0-9 Support, Pivot 00- Screw, Hex Head /- x / 9-0 Spring, Defl ector 9-9 Bolt, Shoulder 9- Washer, Flat / 0 0-00 Nut, Lock /-0 0-0 Bolt, Carriage /- 0 0-00 Nut, Lock /- - Chute Assembly - Defl ector Assembly 9- Seal, Defl ector - Rivet, Blind - Knob, Speed Control Lever 0 0-0 Bolt, Carriage /- x / - Washer, Flat / 0 - Screw #- x -/ -9 Control Assembly, Power Steering - Nut, Lock /- - Lever Assembly, Speed Control 9- Retainer, Hairpin 0- Rod, Upper, Speed Control 9 - Rod, Lower, Speed Control 0 - Clamp, Clean-Out Tool -99 Tool, Clean-Out NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty.
HANDLES SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 9 0 0 0 9
HANDLES SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 - Lever, Auger Control, RH -09 Lever, Traction Drive Control, LH 9-9 Nut, Cage /-0 - Bushing, Flange 9- Retainer, Hairpin - Screw, Hex Head - Rod, Interlock 9- Arm, Impeller Rod 9 9- Arm, Traction Rod 9- Panel, Control 0- Screw, Hex Head /- x -/ 0- Screw, Hex Head /- x -/ -0 Handle Tube, LH -0 Handle Tube, RH 0 0-00 Nut, Lock /- - Washer, Flat / -99 Knob, Handle -9 Rod, Auger Control 0- Rod, Traction Control 0 0- End, Control Rod 0-00 Nut, Hex, Jam /- 0- Bolt, Carriage /- x -/ 0- Handle Tube, Lower 0- Sleeve, Spring 09- Spring, Traction Drive -9 Spring, Auger Control 0- Screw, Hex Head /- x - Bushing, Pivot Lever 0 9-0 Console, Panel - Screw, Hex Head, Tapping #- x -/ - Screw, Hex Head, Tapping #- x / 9- Latch, Interlock - Bolt, Shoulder 0 0- Nut, Lock /-0 - Spring, Torsion - Spring, Interlock - Headlight, Halogen (Includes Bulb) - - 0-0 Bulb, Halogen 9 - Bezel, Headlight 0 09- Harness, Headlight (Halogen) -90 Nut, Cage /- 9- Lever, Interlock - Rod, Latch, Interlock - Rod, Arm, Interlock 0 0-9 Clip 9- Washer, Friction NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty.
DRIVE SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 0 9 9 0 9 0
DRIVE SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 - Screw, Hex Head /- x / 0 0-00 Nut, Lock /- - Washer, Flat 9 0-0 Screw, Hex Head /- x / 00- Bearing, Flange 0- Shaft, Auxiliary 9-0 Spacer, Plate 9-0 Plate, Auxiliary 9 00- Gear, Intermediate (/) 00- Gear, Pinion - Rod, Clutch 00- Shaft, Long, Hex -0 Pin, Pivot 0-0 Lever, Shifter / Wheel - Trunnion Bearing Assembly - Bracket, Pivot, Shift 9- Ring, Rubber Wheel 9-09 Plate, Rubber Wheel 9 0-00 Nut, Lock /- 0 - Hub, Rubber Wheel 0- Screw, Hex Head /- x / 0-9 Retainer, Hairpin 0- Spring, Bias 00- Gear, Axle ( Teeth) -9 Pin, Pivot Lever - Plate Assembly, Drive - Shaft, Axle - Shaft, Short Hex 9 0- Lever, Shifter Plate 0 0- Bracket, Shifter Support 0-0 Bolt, Carriage /- x / 9- Key, Square 9-09 Bearing, Flange 0- Plate, Drive Mounting -0 Spacer, Bearing -0 Pulley, Traction Drive - Nut, Lock /- -0 Washer, Flat 9 0 0-00 Washer, Lock / 0 9 0- Screw, Hex Head /- x / 00 00- Ring, Retaining 0 0-00 Washer, Lock, External Tooth / 90-9 Spring, Return -0 Pin, Roll NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty.
CHASSIS / ENGINE / PULLEYS SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 0 9 9 9 0 0 0 9
CHASSIS / ENGINE / PULLEYS SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 - Spring, Traction Idler 0- Pulley, Idler (-/) - - - Engine, Tecumseh, Model Number LHSA (For engine service and replacement parts, call Tecumseh Products at -00--0) 0-0 Screw, Hex Head /- x -/ 0 9-9 Washer, Flat 9 0-00 Nut, Jam, Lock /- -0 Pin, Idler Pivot 9 90-9 V-Belt, Traction Drive 0 0-00 Washer, Lock / 9 0-0 Screw, Hex Head /- x / 9-9 Impeller Arm / Pad Assembly 0-9 Retainer, Hairpin - Spring, Brake - V-Belt, Impeller Drive -0 Screw, Hex Head /- x -/ -0 Arm, Idler 0- Screw, Hex Head /- x -/ - Bushing, Idler Pivot 0 0- Pulley, Idler (-/) 0- Screw, Hex Head /- x 9- Spacer, Engine Pulley 0- Pulley, Engine, Traction Drive 9- Pulley, Engine, Impeller Drive 0 - Washer, Flat / 0- Washer, Lock, Helical / - Screw, Hex Head /- x -/ - Guide, Belt 9 - Belt Cover Assembly (Includes Toolbox Cover) 0-0 Cover, Toolbox 9 0-0 Screw, Hex Head /-0 x / 9- Bolt, Shoulder /- - Bellcrank Shifter 0-0 Screw, Hex Head /- x / - Arm, Auger Control 0 0-00 Nut, Lock /- 0- Bellcrank -0 Link, Speed Control 9 - Trunnion, Pivot Bracket 0-90 Nut, Cage /- 0 0-9 Hairpin, Cotter / x / 90- Pin, Pivot Bracket 0- Bracket, Bellcrank 0- Screw, Hex Head 0- Pivot Bracket, Impeller Idler Arm 0- Pan, Frame Bottom 0 0- Screw, Hex Head /- x / - Nut, Speed /- 9 0- Frame Assembly 0 0-0 Plate, Frame End 9- Shaft, Auger Control 0 0-9 Washer, Hardened - Roller - Ring, Crescent 00 00-0 E-Ring 0 0-00 Washer, Lock, External Tooth / - Power Cord NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. 9
WHEELS / DECALS SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 0 0 9 9 0 9 0 9 0
9-0 Wheel Assembly, ", Power Steering, LH - Pin, Klik / -09 Cover, Power Steering - Bolt, Shoulder #- x / 0- Capscrew, Hex Head, Flanged /- x -9 Bracket, Steering Cable, RH 9 - Bracket, Steering Cable, LH 0 0-0 Screw, Hex Head /-0 x / 9 0-0 Screw, Hex Head /- x / -9 Link, Steering Lever -0 Yoke, Steering 0- Pin, Steering Lever 9- Bellcrank 9- Bracket Assembly, LH Steering 9- Bracket Assembly, RH Steering - Pin, Steering Bellcrank 0-9 Retainer, Hairpin 0-9 Bracket, Steering - Driver, Wheel - Ring, Wire Retainer - Lobe, Wheel 9- Slide, Clutch 9-9 Spring, Clutch Slide 9-0 Lobe, Axle 9- Key, Square -9 Washer, Thrust (") 9 9-0 Bearing, Axle 0 - Spring, Return 9-0 Wheel Assembly, ", Power Steering, RH 0 0-9 Clip, Retainer 00 00- Ring, Retaining - Screw, Hex Head /- x / WHEELS / DECALS SNOW THROWER - MODEL NO. 0SBE (90000), PRODUCT NO. 9 9 00-0 - Decal, Danger - Decal, Husqvarna - Decal, Danger, Defl ector - Decal, Danger - Decal, Husqvarna, 0SB - Decal, Instruction -9 Decal, Traction Lever -00 Decal, Auger Lever 9 - Decal, Speed Control -9 Decal, Remote Defl ector 9-0 Decal, LH Trigger 9-0 Decal, RH Trigger -9 Decal, Husqvarna, Crown - - - Decal, Lowe's Service (not shown) - - 9-9 Owner s Manual NOTE: All component dimensions given in U.S. inches. inch =. mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty.