Installing the Side Rockers

Similar documents
M GT 2005 up Mustang ENGINE START Push-Button INSTRUCTION SHEET

LEXUS RX/RXh RUNNING BOARDS Preparation

TOYOTA COROLLA ILLUMINATED DOOR SILLS Preparation

LEXUS GX TOWING HITCH Preparation

Item C& D Not Applicable C

GENUINE MUD FLAP (REAR)

LAND ROVER DISCOVERY 3/ SPARE WHEEL CARRIER

GENUINE PARTS INSTALLATION INSTRUCTIONS

LEXUS RC 350/RC-F ILLUMINATED DOOR SILLS Preparation

TrailGator REAR BUMPER INSTALLATION INSTRUCTIONS Runner

Depress each tab as you pull the bezel off. The bezels are tight. L.H. shown.

TOYOTA 4RUNNER CROSS BARS Preparation

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

HITCH INSTALLATION INSTRUCTIONS TOW XC 40 VOLVO MODEL/ TRIM YEARS: 2 1/2 HOURS to Present PARTS & SUPPLIES: TOOLS REQUIRES: INSTALLATION TIME:

M-7210-Z3 Focus Short-Throw Shifter (fits 2000-April 2002) INSTALLATION INSTRUCTIONS

TOYOTA COROLLA ILLUMINATED DOOR SILLS Preparation

James Barone Racing Aftermarket Parts and Accessories

GENUINE PARTS INSTALLATION INSTRUCTIONS

M-9603-FST FOCUS ST COLD AIR INTAKE KIT INSTALLATION INSTRUCTIONS

BX Honda CR-V Installation Instructions

INSTALLATION INSTRUCTIONS CATCH CAN KIT

Lingenfelter Signature Series Camaro Rocker Covers

TOYOTA PRIUS 2004 TVIP V2 (GBS ADD ON) Section I Installation Preparation

INSTALLATION INSTRUCTIONS

Forge Motorsport BMW N54 Diverter Valves

TOYOTA RAV4/HV INTERIOR LIGHT KIT Preparation

INSTALLATION INSTRUCTIONS TRAILER HITCH MAIN HARNESS KIT

Conflicts None. TOYOTA TUNDRA 2017 Black Laser Cut Grille. Part Number: Accessory Code: BG3000. General Applicability

2 nd Generation Sport Trac LED 3 rd Brake Light Replacement Project By Kevin Collins

INSTALLATION INSTRUCTIONS

Roll Bar (MMRB-6.1 to -6.7)

GENUINE PARTS INSTALLATION INSTRUCTIONS

401B/1KDB CoolRite/FreezeRite Installation Manual I003

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

54531/ FORD FUSION

GENUINE PARTS INSTALLATION INSTRUCTIONS

REAR STEEL BUMPER INSTALLATION INSTRUCTIONS Runner

VW New Beetle Convertible. Top Hydraulics Removal Instructions


MOUNT BRACKET PARTS and HARDWARE: Installation parts with * come loose in hardware kit bag. Other parts are preassembled

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Ford Mustang GT-Style Fog Light Kit Parts List: Quantity: Tool List:

SCION FR-S FOG LIGHTS

Part Number: TTU-BGB14-DRL TTU-BGP14-DRL

GENUINE PARTS INSTALLATION INSTRUCTIONS

YOUR 2011 STI & WRX SEDAN HARDWARE CONSISTS OF: GUIDE TO INSERTS PROVIDED: HOW TO REMOVE STOCK FASTENERS:

PRELIMINARY INSTALLATION INSTRUCTIONS. 8 Wire ties. PARTS LIST CD Changer Attachment Kit (sold separately): P/N 08B26-S9V-100A

Installing Custom Puddle Lamps 2009 Subaru Forester

TOYOTA 4RUNNER COLD AIR INTAKE FJ CRUISER Preparation

INSTALLATION INSTRUCTIONS

Part Number: T4R-2N1. Hardware Bag Contents. General Applicability Models with factory fog light. Conflicts -

Audi C6 A6 RS-style Grille Installation Tutorial

Ford Mustang V6 OEM-Style Fog Light Kit Parts List: Quantity: Tool List:

*70200BAG1* 70200BAG FORD F150 GRILLE LIGHT MOUNT

GENUINE PARTS INSTALLATION INSTRUCTIONS

Instructions for Front Midrange Installation in BMW 3 Series/M3 Coupe, Cabrio without Harman Kardon Audio System (E46)


PART NUMBER: H630SSJ000. Kit Contents: A. Amplifier with Bracket (1) D. Badge (2) with push nuts (4)

Ref Qty Part Description Part Number -1- Kit ( ) Contents:

SCION tc 2005 FRONT END MASK Preparation. Part Number: PT

INSTALLATION INSTRUCTIONS


Assist Step Kit Installation (Side Assist Step)

Drag Race Roll Bar (MMRB-6, -7)

TOYOTA VENZA 2009 TRAILER WIRE HARNESS Procedure

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Installation For Technicians Only Toyota Tundra Extended Cab By Gilbert Gutierrez. Vehicle information

igen2500 and ipro2500 IGNITION COIL RETROFIT GUIDE

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

LEXUS GS 350/450h ILLUMINATED DOOR SILLS Preparation

Performance Air Intake, 2015+

54531/ FORD FUSION

P/N Rev 01 04/14-1- NOTE: If you are ordering hinges for your rear doors, order and/or

INSTALLATION INSTRUCTIONS FOR THE MOTOR TRIKE GL1500 RAKE KIT

Curt Mfg. Trailer Hitch and Hoppy Wiring Kit Installation Instructions

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

TOYOTA Matrix XM SATELLITE RADIO Preparation

TOYOTA CAMRY HANDS FREE BLU LOGIC Preparation

Main Lift Cylinders. Level of difficulty: Not very hard, only a number of steps involved requires some patience, but is very rewarding!

TOYOTA TUNDRA TVIP V4 Preparation

INSTALLATION INSTRUCTIONS

If technical support is required, please contact Advent Technical Support at

FOG LAMPS INSTALL KIT

Part Number: T4R-2N1. Hardware Bag Contents. General Applicability Models with factory fog light

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

TOYOTA SIENNA TRAILER WIRE HARNESS Preparation

VW Shift Paddle Kit Installation Instructions

Remove black panel shown. Save 6 retaining pins for re-install later. Pry up on center part of pin first. Then pry out entire retaining pin.

INSTALLATION GUIDE PHANTOM TM SUBWOOFER SYSTEM. FOR BMW 3-SERIES SEDAN (F30) ver. 10/2016 DO-IT-YOURSELF 2 OUT OF HOURS F30 SEDAN

INSTALLATION INSTRUCTIONS CATCH CAN KIT

PART NUMBER: H630SXC001. Kit Contents: A. Amplifier with Bracket (1) D. Badge (2) with push nuts (4)

GENUINE MUD FLAP (FRONT)

Transcription:

Page 1 of 12 Installing the Side Rockers The Prius PLUS Performance side rockers are without a doubt the easiest parts to install of the 7-piece package. It should take you no more than 20 minutes per side. Step 1 Apply masking tape at the following areas of your front and rear doors to protect from inadvertent scratches when removing the OEM side rocker and installing the PLUS side rocker. Apply masking tape on bottom of door to prevent scratches Step 2 Remove 4 plastic plugs from underneath the side rocker. These are disposable as the new hardware bags include brand new plugs. If they are hard to budge, it's okay to break/chip them out of the body.

Page 2 of 12 Plastic plugs x4 Then remove 4 large push pins. Save these large push pins for later re-installation. Large push pins x4 These are the approximate location of where the plastic plugs and large push pins are located:

Page 3 of 12 Locations of plastic plugs and large push pins Remember to retain the large push pins for later re-installation. Step 3 Use a 10 mm socket to remove two 10 mm bolts from the front and underneath the front of the side rocker. 10 mm bolt at front of side rocker

Page 4 of 12 10 mm underneath front of side rocker Step 4 Use a 10 mm socket to remove two 10 mm bolts from the back and underneath the back of the side rocker. 10 mm at the back of the side rocker

Page 5 of 12 10 mm bolt beneath back of side rocker Remove the fastener from the OEM mud flap at the indicated location and discard the mud flap and fastener once they are free: Remove fastener with a trim removal tool or simply a flathead screwdriver

Page 6 of 12 Discard OEM mud flap If the OEM mud flap is troublesome to remove, you can just cut it out with a garden pruner and pry out the fastener. The hardware bag includes a new replacement fastener. Step 5 Use a Phillips screwdriver to remove 2 Phillips screws from the side rocker located near the front and rear doors: Remove Phillips screw from side rocker near front door

Page 7 of 12 Remove Phillips screw from side rocker near rear door Step 6 Gently pull the OEM side rocker away from the vehicle. The side rocker is secured with push clips, so just start from the back and pull the rocker out until you reach the front. There is a total of 9 clips you need to disengage: Starting from the back, gently pull the side rocker away from the vehicle

Page 8 of 12 The side rocker is secured to the body by 9 push clips OEM side rocker removed Step 7 Retrieve 9 new push clips from the hardware bag and install them into the PLUS side rocker in their corresponding holes:

Page 9 of 12 Install new clips onto the PLUS side rocker Make sure the clips are snapped into place and float inside their holes without falling out. Once all 9 clips are securely on the PLUS side rocker, it's time to re-install. Step 8 Position the PLUS side rocker so that each of the 9 clips installed in step 7 are aligned with their corresponding holes on the vehicle. Starting from the center, push the clips into their holes with gentle force and work yourself outward. If done correctly, you should hear a snapping sound confirming successful engagement with the vehicle. Install the PLUS side rocker

Page 10 of 12 Step 9 Re-install the 2 Phillips screws that were removed from step 5. Re-install two Phillips screws Step 10 Re-install the 10 mm bolts that were removed earlier from the front of the OEM side rocker in step 3. Replace the two 10 mm bolts that were removed from the front of the OEM side rocker earlier

Page 11 of 12 Step 11 Locate new mud flap from the PLUS side rocker package and then install using 10 mm bolts that were removed earlier from the back of the OEM side rocker in step 4. Slide the PLUS side rocker through the slit on the new mud flap and then install new fastener clip through mud flap and into the vehicle mount: New mud flat installed Step 12 Retrieve new plastic plugs from hardware bag and reinstall them into the installation positions as noted in step 2. Locate the large push pin fasteners that were removed earlier and re-install them into the positions noted in step 2.

Page 12 of 12 Prius PLUS Performance side rocker installed