801 Avenida Acaso, Camarillo, Ca. 93012 (805) 4940622 www.sdcsecurity.com Email: service@sdcsecurity.com 410/420 SERIES PUSH SWITCH (N/C) Contact Type: SPDT (Form C) (COM) (N/O) LAMP 28VDC MAX P:\INSTALLATION INST\Push and Key Switch\INST410420.vsd REV A 0311 Page 1
3580 Willow Lane, Westlake Village, CA 913614921 (805) 4940622 Fax: (805) 4948861 www.sdcsecurity.com Email: service@sdcsecurity.com MODEL 422 PUSH SWITCH 422GPE 422NGPE (N/C) Contact Type: SPDT (Form C) (COM) (N/O) LAMP 28VDC MAX P:\INSTALLATION INST\Push and Key Switch\INST 422.vsd 0305 Page 1
1 2 3 4 5 6 7 8 9 * 0 # PUSH TO EXIT 1 2 3 4 5 6 7 8 9 * 0 # PUSH TO EXIT SECURITY DOOR CONTROLS 801 Avenida Acaso, Camarillo, CA 93012 (805) 4940622 www.sdcsecurity.com Email: service@sdcsecurity.com MODEL 413NU & 423U PUSH SWITCH 160 SECOND ADJUSTABLE TIME DELAY When the button is pressed, the lock releases for 160 seconds. If pressed again during the lock release period, the unit will Retrigger starting a new release period. Input Voltage : 12/24VDC @90ma. Indicator : 12/24VDC @ 10/20ma Output Relay: DPDT Max Load : 30VDC @ 5 AMP 12/24VDC 423U TYPICAL WIRING 413NU 12/24VDC 160 SEC ADJ POT BLK /BLK /BLK COM B /BLK A VIO BLU COM 413NU OR 423U MANUAL RELEASE DEVICE BLK /BLK /BLK COM B /BLK A VIO BLU COM 413NU OR 423U MANUAL RELEASE DEVICE C MD31D FAIL SAFE REQUESTTOEXIT SENSOR DEVICE C MD31D FAIL SAFE REQUESTTOEXIT SENSOR DEVICE C V V C V V ACCESS CONTROL ACCESS CONTROL MD31D MD31D EMLOCK C C FAILSAFE LOCK FAIL SECURE LOCK ACCESS 413NU CONTROL OR 423U ELECTRIC STRIKE ACCESS 413NU CONTROL OR 423U P:\INSTALLATION INST\Push and Key Switch\INST413NU423U.vsd REV E 1013 Page 1
1 2 4 7 5 8 3 6 9 0 # * PUSH TO EXIT SECURITY DOOR CONTROLS 801 Avenida Acaso, Camarillo, Ca. 93012 (805) 4940622 Fax: (805) 4948861 www.sdcsecurity.com Email: service@sdcsecurity.com MODEL 413MN & 423M PUSH SWITCH FIXED 30 SECOND TIME DELAY This push to exit button is specifically intended for installation on Access Controlled Egress doors as described in the Boca code. A motion detector is the primary means of releasing a magnetic lock on the door. The push to exit button is intended, as a back up means of releasing the lock in the event there is a problem with the motion detector. When the button is pressed, the lock releases for 30seconds. If pressed again during the 30seconds lock release period, the unit will Retrigger starting a new 30second lock release period. TYPICAL WIRING 12/24VDC BLK /BLK /BLK COM B /BLK VIO BLU COM C A 413MN OR 423M MANUAL RELEASE DEVICE MD31D FAIL SAFE REQUESTTOEXIT SENSOR DEVICE 423M 413MN Input Voltage : 12/24VDC @90ma. Indicator : 12/24VDC @ 10/20ma Output Relay: DPDT Max Load : 30VDC @ 5 AMP C V V ACCESS CONTROL MOTION DETECTOR EMLOCK C FAILSAFE LOCK ACCESS CONTROL MODEL 413MN/423M PUSH TO EXIT SWITCH P:\INSTALLATION INST\Push and Key Switch\INST413M423M.vsd REV D 0213 Page 1
801 Avenida Acaso, Camarillo, Ca. 93012 (805) 4940622 www.sdcsecurity.com Email: service@sdcsecurity.com 414 & 424 PUSH SWITCH 424U 414NU Contact Type: DPDT (Form C) (COM) (COM) (N/O) (N/O) (N/C) (N/C) LAMP 28VDC MAX P:\INSTALLATION INST\Push and Key Switch\INST414424.vsd REV A 0608 Page 1
SECURITY DOOR CONTROLS 3580 Willow Lane, Westlake Village, CA 913614921 (805) 4940622 Fax: (805) 4948861 www.sdcsecurity.com Email: service@sdcsecurity.com MODEL 415N & 425 ON/OFF PUSH SWITCH 425 415N Contact Type: DPDT (Form C) (N/C) (COM) BLK GRN GRN (N/O) (N/C) (COM) (N/O) P:\INSTALLATION INST\Push and Key Switch\INST 415N425.vsd 0908 Page 1
3580 Willow Lane, Westlake Village, CA 913614921 (805) 4940622 Fax: (805) 4948861 www.sdcsecurity.com Email: service@sdcsecurity.com MODEL 460 REQUEST TO EXIT SWITCH Adjustable Timer 1 40 Seconds * With the jumpers as shown the red s are on in standby and the green s turn on when the relay is on. 1224 VDC * 1 COM1 COM2 2 Specifications Input Voltage: 12/24VDC Current: On: Idle60mA, Active 120mA Off: Idle10mA, Active60mA Outputs: 1 N.O., 1 N.C., 2 Amp @ 30VDC Switch Operating Environment 40 F to 160 F (40 C to 70 C) Dimensions 4.5" H x 2.75" W x 1.25" D (11.4 x 7 x 3.2 cm) Selectable Bicolor Illumination Status Relay Off Red, Green or None Relay On Red, Green or None Red On Standby Green On Relay Action Red On Relay Active Green On Standby Red Off Green Off P:\INSTALLATION INST\Push and Key Switch\INST460.vsd 0305 Page 1