INSTALLATION INSTRUCTIONS Accessory P/N 08U89-TK6-111 Application 2012 FIT Publications No. AII 45981 Issue Date AUG 2011 PARTS LIST Armrest console Armrest cover Bolt cover Floor bracket Washer bolt, 10 x 30 mm Console bracket Owner s manual 4 Washer bolts, 6 x 25 mm 2 Self-tapping screws 2 Center console bolt covers Base spacer TOOLS AND SUPPLIES REQUIRED Flat-tip screwdriver Pushpin Drill 3 mm and 8 mm Drill bits File Phillips screwdriver 20 mm Hole saw 10 mm, 12 mm, and 14 mm Sockets Ratchet Clip remover Eye protection (safety goggles, face shield, etc.) 10 mm Combination wrench Torque wrench 2011 American Honda Motor Co., Inc. All Rights Reserved. AII 45981 (1108) 08U89-TK6-1000-91 1 of 5
INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by do-it-yourselfers. 4. Place the new armrest cover on the seat and install the 10 x 30 mm washer bolt. Note the direction of the armrest cover. Install the bolt cover over the bolt; engage the back tab first. STAMPED ON THE BACK If the vehicle is equipped with an armrest, continue with step 1, otherwise go to step 5. 1. Remove the armrest bolt cover. 10 x 30 mm WASHER VEHICLE 811802AR TAB STAMPED ON THE BACK 2. Remove the bolt to remove the armrest. Set the armrest aside, it will not be reused. 3. Remove and discard the two vehicle bolts. 861704AR VEHICLE S DRIVER S SEAT 861703AR 2 of 5 AII 45981 (1108) 2011 American Honda Motor Co., Inc. All Rights Reserved.
5. Remove the center console cover (three retaining tabs). 7. Remove the center console: Move the select lever to the N position. Remove the two front clips. Remove and discard the rear bolt insulator, and remove the bolt. Gently pull the center console back, and carefully remove it. INSULATOR CLIPS Reuse. 3 RETAINING TABS 742301AR 6. With M/T, remove the shift knob. SELECT LEVER Move to the N position. 742003CR 8. With the vehicle on level ground and the wheels blocked, release the parking brake. Remove the parking brake bracket (two bolts). SHIFT KNOB S Reuse. 752308AR (Not reused) 760401AR 2011 American Honda Motor Co., Inc. All Rights Reserved. AII 45981 (1108) 3 of 5
9. Install the floor bracket under the parking brake cables and reinstall the two bolts. Torque the bolts to 22 N m (2.2 kgf m, 16 lbf ft). S (reused) 11. While wearing eye protection, drill the four pierced marks on the inside of the center console to 8 mm. First drill with a 3 mm drill bit, and finish with an 8 mm drill bit. Remove any burrs from the edges of the holes with a file. VEHICLE PANEL DRILL BIT: 3 mm 8 mm FLOOR FLOOR CABLES CABLES 4 MARKS 861705AR SIDE VIEW REAR VIEW 760402AR 10. On the bottom of the center console, locate the six preset marks. Use a pushpin to pierce the center of each mark. PUSHPIN 12. While wearing eye protection, drill the two pierced marks on the sides of the center console to 20 mm. First drill with a 3 mm drill bit, and finish with a 20 mm hole saw. Remove any burrs from the edges of the holes with a file. Drill from the outside. 2 MARKS 6 PRESET MARKS HOLE SAW BIT: 20 mm DRILL BIT: 3 mm 861706AR 760403AR 4 of 5 AII 45981 (1108) 2011 American Honda Motor Co., Inc. All Rights Reserved.
13. Install the armrest console to the center console using two 6 x 25 mm washer-bolts and the console bracket. WASHER- S, 6 x 25 mm SELF- TAPPING SCREWS 15. Remove the pocket from the center console. 2 CLIPS (reused) POCKET Remove. BASE SPACER 2 WASHER- S, 6 x 25 mm 2 S SECTION VIEW FLOOR 760501CR 760701AR 14. Install the base spacer to the armrest console using two self-tapping screws. 16. Carefully reinstall the center console using the two clips removed in step 7 and two 6 x 25 mm washerbolts from the kit. 17. Install one center console bolt cover on each side of the center console. 18. (M/T) Reinstall the shift knob. 19. Reinstall the center console cover and pocket. 2011 American Honda Motor Co., Inc. All Rights Reserved. AII 45981 (1108) 5 of 5