Low Cost and High Efficiency CO 2 Mobile Air Conditioning system for lower segment cars Carloandrea Malvicino Centro Ricerche Fiat Strada Torino 50-10043 Orbassano Italy carloandrea.malvicino@crf.it - 00390119083260 BCOOL Consortium BCOOL - Low Cost and High Efficiency CO 2 Mobile Air Conditioning System for Lower Segment Cars - is a project funded by the EU in the 6th framework Consortium Main Objectives Development of a low cost and high efficiency air-conditioning system based on CO 2 (R744) for A, B and similar vehicles (low C class or LCV) In kind contribution: Definition of agreed methods to assess: performance fuel annual consumption environmental impact 1
B COOL Prototypes CRF Fiat Auto: Fiat Panda 1.2 l gasoline with automatic air conditioning system FORD: Ford KA 1.3 l gasoline with manual air conditioning system Project Scheduling Agreed Assessment Procedures Prototype Systems bench validation October 2006 Final Vehicle demonstrators End - August 2008-0 3 6 9 12 15 18 21 24 27 30 33 36 39 42 1 st Vehicle demonstrators March 2007 Dissemination & Exploitation Kick Off - March 2005 - Technical,Technological and Environmental analysis 2
The procedure has been developed within the EU cluster Highly efficient air conditioning systems with near zero green house gas emissions and elimination of hydro fluorocarbon (HFC) Two projects form the cluster: BCOOL: Low Cost and High Efficiency CO 2 Mobile Air Conditioning System for Lower Segment Cars TopMacs: Thermally OPerated Mobile Air Conditioning Systems The procedure is conceived as a proposal for a common method to qualify the Mobile Air Conditioning System so to compare systems based on different approaches or technologies. The procedure is under examination in the framework of the UNEP initiative named EcoMAC and of ACEA (EU Car Manufacturers Association) 35 140 Test Chamber with no irradiation lamps Temperature ( C) 30 25 20 15 10 5 0 Outlet Temperature Cabin Temperature Speed 0 500 1000 1500 2000 Time (min) A modified NEDC cycle is used Cycles with and without A/C are performed The fuel consumption is calculated as: 1 st ECE consumption/2 + EUDC consumption + 2 nd ECE consumption/2 All tests are carried out with the engine hot 120 100 80 60 40 20 0 Speed (km/h) Thermal Manikins to assess comfort Thermal regulation of the climatic chamber Driver Fan Rolling bench Emissions and Consumption measurement system Test Conditions Mean European Summer Climate Conditions 28 C 50% R.H Test => Cabin Set Point: 20 C Severe Summer Conditions 35 C 60% R.H Test => Cabin Set Point: 23 C Mid Season Conditions 15 C 70% R.H Test => Cabin Set Point: 20 C 3
4.0 Fuel additional comsumption (l/100 km) 3.5 3.0 2.5 2.0 1.5 1.0 0.5 ECE EUDC NEDC Example of Fuel A/C consumption measurements Consumption vs temperature EUDC Overconsumption (l/100 km) 2.5 2.0 1.5 1.0 0.5 0.0 10 15 20 25 30 35 40 Test Temperature (deg) Fuel consumption per 100 km Test @ 28 C Test @ 35 C 0.0 0.0 2.0 4.0 6.0 8.0 ECE Overconsumption (l/100 km) EUDC Overconsumption (l/h) 1.6 1.4 1.2 1.0 0.8 0.6 0.4 0.2 Hourly Fuel consumption Test @ 28 C Test @ 35 C 0.0 0.0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 ECE Overconsumption (l/h) A Figure of Merit, based on the Operative Temperature measurements, has been introduced to exclude systems with poor performance. Skin Elements Relative Humidity and Air Temperature sensors The Operative Temperature takes into account the effect of air flow, irradiation and air temperature on thermal exchange The CRF manikin is based on the skin elements concept where each sensor measures the: Operative Temperature Air temperature Relative Humidity Local air speed A specific model of the human thermoregulatory system allows the evaluation of different clothing and metabolism 4
New Car Buyer's vote on HVAC 8.7 8.5 8.3 8.1 7.9 7.7 R 2 = 0.7859 7.5 5.0 5.5 6.0 6.5 7.0 7.5 8.0 8.5 9.0 Figure of Merit Application of the criteria to a panel of vehicles tested following the procedure to assess the fuel consumption of a MAC system Fuel Overconsumption (l/100 km) Correlation of the Figure of Merit with the New Car Buyers vote on HVAC 4.5 4.0 3.5 3.0 2.5 2.0 1.5 1.0 0.5 Vehicles not accepted Test @ 28 deg Test @ 35 deg Acceptability threshold 0.0 4 5 6 7 8 9 Figure of Merit LCCP (Life Cycle Climate Performance) assessment System Mass Vehicle Mission LCCP (eq. kg CO2 / vehicle) 3000 2500 2000 1500 1000 500 0 HFC-134a MAC South Europe MAC fuel consumption Fuel Consumption => CO 2 emissions North Europe direct emission indirect (fuel) Calculation (example) R-744 MAC South Europe North Europe A procedure to assess the LCCP has is under refinement to compare the environmental impact of MAC systems Direct GHG emissions + CO 2 emissions = LCCP Inputs (example) Direct emissions input: - annual HFC leakage: 20 g/a - End of Life: 20 % - Lifetime services: 5 Inputs: - annual HFC leakage - End of Life - Lifetime services at 35 C at 28 C HFC-134a 2.2 1.0 R-744 2.3 0.8 5
Safety Assessment A procedure to evaluate the safety issue has been proposed and it is under validation Scheme of cabin CO 2 concentration measurements Preliminary results have been obtained measuring the concentration of CO 2 in the cabin of a Fiat Panda and of a Ford Ka C (% vol.) C Feet C head C mean 4 3.5 3 2 nd Threshold 2.5 weak narcotic effect after 60 min of exposure 2 1.5 1 st Threshold slight breathing increase 1 0.5 0 0 500 1000 1500 2000 2500 3000 t (s) Ventilation OFF Recirculation OFF 200 g CO 2 released 1 Passenger System Design A model of the system has been developed using the tool Modelica to identify the best architecture in terms of efficiency and cost The Fiat Panda System model has been completed, the Ford Ka model is under completion The first results show that the BCOOL system will have an average efficiency similar to the present R134a system NEDC simulation Simple scheme of a CO2 A/C system 6
Demonstrator set up The integration on the vehicle is under completion: the vehicles will be equipped with the two different versions of the system before the end of 2006 The first results on vehicles will be produced before March 2007 and will be confidential The first publishable results will be available after October 2007 A second generation of demonstrators will be realised before March 2008 Costs No information can be disclosed at this stage of the activity 7
8 Thank You!