RD5/RD6 ROTARY MOWER Published 01/11 PART'S MANUAL SECTION 88 An Operator's Manual was shipped with the equipment. The Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ,UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. If the Operator's Manual isnot with the equipment, contact your dealer or Bush Hog to obtain a Free copy before operating the equipment. BUSH HOG 2501 Griffin Ave. Selma, AL 36703 Parts Ordering 1-800-304-2836 www.bushhog.com 2011 Alamo Group Inc.
PARTS ORDERING GUIDE The following instructions are offered to help eliminate needless delay and error in processing purchase orders for the equipment in this section. 1. The Parts Section is prepared in logical sequence and grouping of parts that belong to the basic machine featured in this manual. Part Numbers and Descriptions are given to help locate the parts and quantities required. 2. The Purchase Order must include the name and address of the person or organization ordering the parts, who should be charged, and if possible, the serial number of the machine for which the parts are ordered. 3. The Purchase Order must clearly list the quantity of each part, the complete and correct part number (be sure to include all periods), and the basic name of the part. 4. The Manufacturer reserves the right to substitute parts where applicable. 5. Some parts are unlisted items which are special production items not normally stocked and are subject to special handling. Request a quotation for such parts before sending a Purchase Order. 6. The Manufacturer reserves the right to change prices without prior notice. For maximum safety and to guarantee optimum product reliability, always use genuine BUSH HOG Parts. The use of inferior replacement parts may causepremature or catastrophic failure which could result in serious injury or death.direct any questions regarding parts to: BUSH HOG 2501 Griffin Ave. Selma, AL 36703 www.bushhog.com Contact Us 800-304-2836 2011 Alamo Group Inc.
PART NAME INDEX A FRAME STANDARD ASSEMBLY...88-1-1 A FRAME STANDARD ATTACHMENT...88-1-2 BLADE BAR ASSEMBLY...88-1-3 DRIVELINE ASSEMBLY (MFD. BY COMER)...88-1-4 DRIVELINE ASSEMBLY ( MFD. BY BONDIOLI & PAVESI)...88-1-5 GEARBOX ASSEMBLY...88-1-6 GEARBOX ATTACHMENT (SHIELDING)...88-1-7 FRONT AND REAR DEFLECTORS...88-1-8 TAILWHEEL ASSEMBLY...88-1-9 WHEEL ASSEMBLY CASTER FORK...88-1-10 DECALS, SAFETY AND LOGO...88-1-11 2011 Alamo Group Inc.
A FRAME STANDARD ASSEMBLY 1 00766591 2 FLAT REAR BRACE 2 00764839 2 BAR, A-FRAME 3 00748598 1 HEXB 3/4-10 UNC 5-1/2 PL5 4 00757953 1 BUSHING 1-1/4X7/32X3 A-FRAME 5 00037200 1 LOCKNUT 3/4-NC TLM PLC 6 00757949 1 TOPLINK 2011 Alamo Group Inc. 88-1-1
A FRAME STANDARD ATTACHMENT 1 00603500 2 ASY,CAT.1 HITCH PIN W/LW & NUT 2 ---------- 2 LOCKWASHER 3 ---------- 2 HEX NUT 4 2196 2 CLIP, LYNCH PIN 13/32 DIA. 5 37107B12 1 CLEVIS PIN, TOP LINK - CAT. I 6 37107B13 1 PIN, HAIR CLIP 7 02030700 17 HHCS, 1/2-13NC X 1-1/4 PL5 8 00001800 19 TOPLOCKNUT, 1/2-13 NC PL 9 00785955 1 DECK WELDMENT for RD5 00786237 1 DECK WELDMENT for RD6 2011 Alamo Group Inc. 88-1-2
RD5 RD 6 BLADE BAR ASSEMBLY 1 00787299 1 WLDMT, BLADE BAR (RD5) 00787325 1 WLDMT, BLADE BAR (RD6) 2 00781341 2 BLADE, FAN CCW, 22-1/2 CTR-TIP (RD5) 00785567 2 BLADE, FAN CCW, 25-1/2 CTR-TIP (RD6) 3 00781320 2 BLADE BOLT 7/8 DIA X 3 LG 4 00761535 2 WASHER, 7/8 STR PLAIN 5 00750226 2 NUT, TOPLOCK 7/8 NF PLC 6 00786548 1 BLADE BOLT KIT (FOR 2 BLADES) 2011 Alamo Group Inc. 88-1-3
DRIVELINE ASSEMBLY (MFD. BY COMER) Comer Brand Name on Shielding. NOTE: If part numbers 50063617 or 00787393 are present on the outer shielding you must order parts from the 50069229 B&P Driveline. The Comer Driveline Implment Yoke has a recessed holes that the Shear Bolt Head and locknut fit down inside. THIS DRIVELINE MANUFACTURED BY COMER. BEFORE ORDERING REPAIR PARTSFIRST DETERMINE IF THE DRIVELINE IS A COMER OR A BONDIOLI & PAVESI MANUFACTURED DRIVELINE. THIS DRIVELINE REPLACED BY 50069229 DRIVLENE ASSY. MANUFACTURED BY BONDIOLI & PAVESI. 00768174B 1 DRIVELINE, SP 1 00764500A 1 ASSY,YOKE COLLAR - COMPLETE 2 00756231 2 CROSS & BEARING KIT SERIES 40 3 00777329A 1 YOKE, 1-3/8 BORE SP 4 N/A 1 YOKE & OUTER TUBE 5 N/A 1 YOKE & INNER TUBE 6 00759169 1 PIN ROLL 8MM X 60MM 7 00759165 1 PIN ROLL INNER TUBE 8 00779534 1 COMPLETE SHIELD KIT 9 00774079 1 SLIDE COLLAR REPAIR KIT 10 00764507 1 RETAINER, INNER COLLAR 11 00764506 1 RETAINER, OUTER COLLAR 12 00754330 6 SHIELD BOLT, NYLON 2011 Alamo Group Inc. 88-1-4
DRIVELINE ASSEMBLY (MFD. BY BONDIOLI & PAVESI) 2 The B&P Driveline Implement Yoke is round. 9 3 4 5 8 1 B&P Brand Name on Shielding. 6 NOTE: If part numbers 50063617 or 00787393 are present on the outer shielding you must order parts from the 50069229 B&P Driveline. THIS DRIVELINE MANUFACTURED BY BONDIOLI & PAVESI. BEFORE ORDERING REPAIR PARTS FIRST DETERMINE IF THE DRIVELINE IS A BONDIOLI & PAVESI OR A COMER MANUFACTURED DRIVELINE. THIS DRIVELINE REPLACES THE 00768174B DRIVLENE ASSY. MANUFACTURED BY COMER. 10 7 50069229 1 DRIVELINE ASSEMBLY, B&P 1 50064902 1 ASSY,YOKE COLLAR - COMPLETE 2 64694 2 CROSS & BEARING KIT 3 78577 1 ROLL PIN 8MM X 60MM OUTER TUBE 4 78578 1 ROLL PIN 8MM X 55MM inner TUBE 5 81447 1 YOKE 1/3/8 BORE W/ GREASE FITTING 6 50064911 1 SHIELD SUPPORT, OUTER 7 50064912 1 SHIELD SUPPORT, INNER 8 50064645 1 BALL COLLAR KIT 9 63946 6 GREASE FITTING 10 50069227 1 SHIELD KIT, COMPLETE 2011 Alamo Group Inc. 88-1-5
RD5 RD 6 GEARBOX ASSEMBLY 00786192 1 GEARBOX ASSY,- 40HP 540 RPM, 1:1.47 RATIO 2 0656220003 1 COVER,INPUT GEARBOX 3 00757683 1 COVER,OUTPUT GEARBOX 4 00564700 1 SHAFT,INPUT - SMOOTH 5 00786196 1 KIT,ROLLER BEARING 6 00786197 1 KIT,BEVEL GEAR 7 00786198 1 KIT,SHIM 8 00758692 1 NUT,FLANGE HEX SLOTTED 9 00758654 1 PLUG,VENT 1/2-14 10 00565000 1 PLUG,SOLID 1/8-27 11 7192 1 SNAP RING, DRIVE SHAFT RETAINER 12 00786214 1 SEAL, OIL 40 X 54 X 9.5 13 00786213 1 SEAL, OIL 34.9 X 54 X 11 2011 Alamo Group Inc. 88-1-6
GEARBOX ATTACHMENT 1 3236776 1 SAFETY SHIELD 2 00785574 1 GEARBOX SHIELD INNER SUPPORT RING 3 00023500 4 FLATWASHER, 5/16 TYPE,AW,ZP 4 00035900 4 5/16 X 3/4 HHCS 5 02845500 4 BOLT, 5/8 X 2 PL5 6 00756077 4 5/8 HARDENED WASHER 7 00695100 5 NUT,5/8 NC TOPLOCK 8 7A81324 1 SHEAR BOLT 9 00001800 1 LOCKNUT 10 7192 1 SNAP RING, DRIVESHAFT RETAINER 2011 Alamo Group Inc. 88-1-7
GUARD ASSEMBLY 1 50071639 1 DEFLECTOR, FRONT RD5 50071640 1 DEFLECTOR, FRONT RD6 2 02030700 17 HHCS, 1/2-13NC X 1-1/4 PL5 3 00001800 19 TOPLOCKNUT, 1/2-13 NC PL 4 00002700 18 FLATWASHER 1/2 5 00785669 1 BAND REAR RD5 00785681 1 BAND REAR RD6 2011 Alamo Group Inc. 88-1-8
TAILWHEEL ASSEMBLY 1 00780829 1 WLDMT, TAILWHEEL BEAM 2 ------------ 1 SEE (CASTER FORK & WHEEL ASSY) 3 00764375 2 CAPSCREW 1/2 NC X 3-1/4 PL5 4 00001800 19 NUT, 1/2-13 NC PL,TOPLOCK 5 00695100 5 NUT,5/8 NC, TOPLOCK 6 00600700 1 CAPSCREW 5/8 NC 3-1/4 PL5 7 00780878 3 RIVET, 3/16 POP X 15/32" G.R. 8 00776031 1 CANISTER, OPERATORS MANUAL 2011 Alamo Group Inc. 88-1-9
WHEEL ASSEMBLY & CASTER FORK 1 00776224 1 FORK CASTER ASSEMBLY 2 15B2000 1 WASHER SAE 1 1/4 PLATED 3 00036900 1 PIN-COTTER 1/4 X 2-1/2 4 00776211 1 BOLT SPINDLE M24 x 2 x 186 5 00776212 1 NUT, SPINDLE M24 X 2 6 00761453 2 BUSHING, SINTERED IRON 7 00772082 1 GREASE FITTING M8 X 1 8 00756760 1 WHEEL ASSEMBLY 16 X 4 2011 Alamo Group Inc. 88-1-10
DECALS - SAFETY AND LOGO 00781352 1 SHEET, SAFETY DECAL (Items 2, 4, 5, 11, 19) 00787356 1 RD5 SHEET DECAL, LOGOS (Items 1, 3, 6, 7, 8) 00787357 1 RD6 SHEET DECAL, LOGOS (Items 1, 3, 6, 7, 8) 1 D395 1 IMPORTANT, Replace Blades in Pairs 2 00776678 1 DANGER, Shear Bolt Length 3 D590 1 LUBE, Lubrication Points 4 D388 1 DANGER, Driveline Hazard 5 D389 1 DANGER, General Multi-Hazard 6 D559 1 WARN / IMPORTANT, Use Genuine Parts 7 ------------ 2 LOGO Bush Hog Logo Decal (Order Logo Decal Sheet) 8 50068911 1 RD5 Model Decal 50068912 1 RD6 Model Decal 9 2738332 2 REFLECTOR, Red Reflectors 10 n/a 1 SERIAL PLATE Serial Number Plate 11 00756004 1 DANGER, Shield Missing (Not Shown) 12 0320034 1 REFLECTOR, SMV Triangle 13 00776031 1 Canister, Operators Manual 14 50068908C 1 Operator s Manual 15 10058000 3 Bolt 16 00024100 3 Flatwasher 17 02959924 3 Locknut 18 D137 1 ROTATION, Blade Rotation Decal 19 D554 2 DANGER, Thrown Objet Shield Missing 2011 Alamo Group Inc. 80-1-11
2501 GRIFFIN AVE. SELMA, AL 36703 (334) 872-6261 (334) 874-2700 PARTS ORDERING 1-800-304-2836 FAX 1-800-572-1784 WWW.BUSHHOG.COM