LED-Strip #57016 ENGLISH
Implied warranty Our product is manufactured under strict quality inspections. We deliver our products with implied warranty of two years. If you should have any cause for complains, please contact your local dealer from which you bought the product. He will handle the replacement, where applicable. The implied warranty will be affected by improper or incorrect usage of our product. Installation For technical support you can contact us directly: MÜLLER-LICHT International GmbH Goebelstr. 61/63 D-28865 Lilienthal Tel. +49 (0) 4298-93700 service@mueller-licht.de english 9
Security advice Please read this manual completely and store it safely. By passing the product to another person, please add this manual. Usage Not suitable for household room illumination. Only for decorative usage. The LED-strip is intended to use in homes The LED-strip is intended for mounting on wall, ground and roof The LED-strip is intended for use only on normal flammable environment The LED-strip is protected against penetration of solid matter, IP20 Security The LED-strip is only allowed to be powered by driver of the original accessory. Do not use the strip or cables, if damaged Please protect the cable in use against damage, if placed on the floor Please connect the line adapter only to approved power sockets (220-240 V 50/60 Hz) Please disconnect the line adapter from the power socket before cleaning or mounting of the LED-strip set 10 english
Security advice Application Do not look from close distance into the operating LED Do not look into the operating LED by a magnifier Do not use the LED-strip inside the color box or furled Do not use the Led-strip covered Do not connect the LED-strip to other strips or electric devices Battery Do never charge the battery! Risk of explosion! Protect children from the battery Do not throw the battery into fire or dismantle it Please remove an empty battery from the compartment Do not expose the battery to extreme conditions (e.g. heater, fire) Avoid contact to skin, eyes or mucosa with battery acid In case of contact to battery acid, please clean the affected areas with pure water and contact immediately a doctor Please replace the battery only with same or equivalent type Please contact immediately a doctor in case of a swallowed battery In longer times of non-use please remove the battery from the compartment english 11
Scope of delivery 1. LED-Strip 2. Remote control with battery (1x CR2025 3V) 3. 4x connectors 10 cm 4. 8x connector bridges 5. Repeater 6. Line adapter with cable 12 english
Mounting 1. Roll-off the strip and place it untwisted 2. You may cut the strip on the markings (scissor signs) 3. Mount the connectors bridges or connector-cables to connect the cutted parts 4. Connect the repeater to the strip (consider the arrow markings) 5. Connect the repeater to the line adapter 6. Connect the line adapter to the power socket 7. Remove the contact protection in the battery compartment 8. Start the LED strip by using the remote control 9. Advice: Receiver for the infrared-signals of the remote is the repeater. The remote control need a direct and barrier-free connection to the repeater. Max. distance 5-7 m. Battery replacement Please open the battery compartment on the side of the remote control by pushing the clamping pin by simultaneously extracting the compartment. Please always use an identical battery of type CR2025 3 V. Please consider correct poling by placing the battery in the compartment. The side of the positive pole is marked by (+) on the compartment. english 13
Technical details Model 57016 36 W 12 V DC 3 A RGB-digital Protection class II IP20 Line adapter: In: Out: Power: Protection class: II LPS37-120-3000-2 100-240 V 1,5 A 50/60 Hz 12 V 3 A 36 W Battery (remote control) 1x CR2025 3 V EMC? www. mueller-licht.de/ recycle If desired you can request the declaration of conformity for the CE sign via service@mueller-licht.de. Recycle LED-devices are not allowed to be placed in household garbage. Please recycle it. Please contact your local recycling agency for details. 14 english
Remote control Power + Speed, + Brightness - Speed, - Brightness Controlled IC-No. setting Autocycle mode White - - warmwhite 16 kind of static color choice 3 static color queue 7 static color queue Water move to left direction Water move to right direction Trail to left direction Trail to right direction 7 color futter Strobe Jump 7 color queue trail to single direction 16 color queue Open curtain Close curtain Trail to left, double direction Trail to left, double direction Horse race to left direction Horse race to right direction Together with the color- and mode-choice buttons (CS, C3, C7, C16), there are countless effect options. english 15
MÜLLER-LICHT International GmbH Goebelstr. 61/63 D-28865 Lilienthal Tel. +49 (0) 4298-93700 service@mueller-licht.de Nachdruck, auch auszugsweise, nur mit schriftlicher Genehmigung des Urhebers Irrtum und Änderung vorbehalten Full or partial reproduction subject to prior written approval Errors and changes are excepted 57016_LED-Strip_RGBdigital_MANUAL_004.pdf