STRONG PARTNERS. TOUGH TRUCKS Low Level Order Pickers L02.0M, L02.0, L02.0L 2 000 kg
LO2.0M, LO2.0, LO2.0L Specification data is based on VDI 2198 Equipment and weight: Weights (line 2.1) are based on the following specifications: Complete truck with forks, as in the line (row) 4.22, Vulkollan drive wheel and load rollers.
c Q NOTE: The condition of the vehicle and how it is equipped, as well as the nature and condition of the operating area affect specifications. If these specifications are critical, the proposed application should be discussed with your dealer. h 14 1 147 419 Values refer to a truck equipped with servo power steering, battery as in line 6.4, Forks as in line 4.22 For LO2.0M high speed (12,5 km/h) consult your TM - TC for details 201 I 2 109 y l 1 m 2 s x z h 13 h 3 Values determined by wheel friction, if climbing ramps frequently (within 1 h), consult your salesman 1,5 Ton with single load roller wheel Ast Subtract 40 mm with 300 Ah battery, add 50 mm with 500 Ah battery Drive mode and setting related b 1 b 5 b 12 e Gradeability is limited to truck's geometry W a l l 6 Ast = W a + l 6 -x + a (see lines 4.33 & 4.34) a = 200 mm RC - Pull container SP - Short pull rod LP - Long pull rod PR - Pull rod UK Forks: LO2.0M: * When fork raised - 103 mm ** Battery compartment affect this value: with 300 Ah - 40 mm / with 500 Ah + 50 mm 55 x 170 x 1 181 mm long Notice Care must be exercised when handling elevated loads. When the carriage and/or load is elevated, truck stability is reduced. Operators must be trained and adhere to the instructions contained in the Operating Manual. Hyster products are subject to change without notice. Lift trucks illustrated may feature optional equipment. Fork spacing: Inside to inside: Dependent on forks feature: b 5 - (2 x e) Outside to outside: See table above: b 5 Safety: This truck conforms to the current EU requirements.
NOTE: The condition of the vehicle and how it is equipped, as well as the nature and condition of the operating area affect specifications. If these specifications are critical, the proposed application should be discussed with your dealer. h 14 c x h 1 h 4 Values refer to a truck equipped with servo power steering, battery as in line 6.4, Forks as in line 4.22 h 12 s h 3 For LO20 and LO20L high speed (12,5 km/h) consult your TM - TC for details h 7 m 2 m 1 h 13 1,5 Ton with single load roller wheel 202 y z Add 65 mm with 560 Ah battery l 1 Drive mode and setting related I 2 b 2 460 l Gradeability is limited to truck's geometry b 1 b b5 b 10 b 11 12 e W a l 6 Ast Ast = W a + l 6 -x + a (see lines 4.33 & 4.34) a = 200 mm UK - Pull rod UK S - Short pull rod LP - Long pull rod Forks: LO2.0, LO2.0L: Values affected by larger battery with 560 Ah + 65 mm ** All values for Y - X - Wa - apply with lowered forks. When forks are raised by 120 mm, these dimensions are reduced by 70 mm. 55 x 180 x 1 156 mm long Fork spacing: Inside to inside: Dependent on forks feature: b 5 - (2 x e) Outside to outside: See table above: b 5 Notice Care must be exercised when handling elevated loads. When the carriage and/or load is elevated, truck stability is reduced. Operators must be trained and adhere to the instructions contained in the Operating Manual. Hyster products are subject to change without notice. Lift trucks illustrated may feature optional equipment. Safety: This truck conforms to the current EU requirements.
Product Features L02.0M L02.0 L02.0L Fixed platform lift with forks for ground level picking. Fixed platform for ground level picking, with independent fork lift. Rising platform for ground level, first and second level picking, with independent fork lift. Dependability All welded steel box construction to protect against impact collision in tough operating environments. Sturdy front bumper protection options. Robust pull-rod design. Productivity Powerful 4 kw AC drives motor with high performance acceleration / braking and travel speed. Automatic proportional speed reduction on cornering. Choice of 4 preset drive programmes. Acceleration and braking can be matched to the stop and go activity required for each application. Raised under-clearance on LO2.0M enhances ramp capability. Electronic power assisted tiller arm steering. Centre rider position. Anti-pinning device, active for driver operation. Ergonomics Angled hand-grips, dual lift/lower buttons. LO2.0 - LO2.0L: Independent fork lift (platform remains at constant low height). Cushioned rubber floor mat with integral foot presence detection switches. Wider, longer drive platform provides increased comfort operator stance and allows easier pass through, to optimise picking on both sides. Padded high back rest with integral handgrips. Extensive onboard storage facilities. Slow speed advance/reverse buttons with automatic straight ahead travel feature. Cost of ownership Fully enclosed, AC drive motor with in built thermal protection. IP54 protection. Choice of battery capacities from 300 Ah to 620 Ah Warehouse management: Key-pad (option). Serviceability CANbus system and diagnostic control. Digital Diagnostic Indicator (DDI). Vertical or lateral battery extraction. PIN code access with integral shock meter (option).
TM Strong Partners, Tough Trucks, for Demanding Operations Everywhere. Hyster supplies a complete product range, including Warehouse trucks, IC and Electric Counterbalanced trucks, Container Handlers and Reach Stackers. Hyster is committed to being much more than a lift truck supplier. Our aim is to offer a complete partnership capable of responding to the full spectrum of materials handling issues: Whether you need professional consultancy on your fleet management, fully qualified service support, or reliable parts supply, you can depend on Hyster. Our network of highly trained dealers provides expert, responsive local support. They can offer cost-effective finance packages and introduce effectively managed maintenance programmes to ensure that you get the best possible value. Our business is dealing with your materials handling needs so you can focus on the success of your business today and in the future. Hyster Europe, Flagship House, Reading Road North, Fleet, Hants GU51 4WD, England. Tel: +44 (0) 1252 810261 Fax: +44 (0) 1252 770702 Email: info@hyster.co.uk http://www.hyster.co.uk A division of NACCO Materials Handling Limited. 04/08/TLC Printed in England Form No. 901230/1 Hyster,, Vista and Monotrol are registered trademarks of Hyster Company in the United States and in certain other countries. TM, Fortens TM, Pacesetter VSM TM, DuraMatch TM, DuraMatch Plus TM, TouchPoint TM, TouchControl TM, EZXchange & HSM TM are trademarks of Hyster Company in the United States and in certain other countries.