MISSING PARTS??? call Extang at

Similar documents
Tool Box. Rear (tailgate clamp) Front (cab clamp) Front (cab clamp) Rear (tailgate clamp) Front (cab clamp) Rear (tailgate clamp) Front (cab clamp)

MISSING PARTS? call Extang at

2016 Toyota Tacoma INSTALLATION SHEET

1/2 Socket Wrench 3/16 Allen Wrench

The Trifecta 2.0 truck bed cover comes fully assembled. Note any damaged or missing components before installing.

Left and Right Side Rail Assemblies PARTS INCLUDED IN YOUR KIT. You may want to lay them out in this manner for accessibility.

100mm. Part# AA Rev CUSTOMER SUPPORT: Wash truck bed.

100mm. Part# 31BZ0001 Rev CUSTOMER SUPPORT: Wash truck bed.

Do NOT tow your vehicle from the rear with any Extang bed cover on your truck. Special Instructions for Alternative Brackets IMPORTANT NOTICE

INSTALLATION SHEET. PARTS INCLUDED IN YOUR KIT 1 Pair rails (L&R) Roll top assembly Bulkhead seals (1x 1/4 & 1x 3/4 thick) (1x 1/4 & 1x 1/4 thick)

INSTALLATION SHEET. PARTS INCLUDED IN YOUR KIT 1 Pair rails (L&R) Roll top assembly Bulkhead seals (1x 1/4 & 1x 3/4 thick) (1x 1/4 & 1x 1/4 thick)

WITH LEER S EXCLUSIVE FOR YOUR RECORDS DATE PURCHASED: SERIAL NUMBER: LEER RETAILER:

Make sure the rail is clamped square as shown. Start at the front, and place the first clamp approx 6 to 9 inches back.

RAM BOX INSTALLATION SHEET

NOTE! Tighten the clamps after the first week of driving with the cover, and periodically check all clamps for a secure fit.

2017 JOBBER APPLICATIONS

INSTALLATION INSTRUCTIONS

Owners & Installation Manual. READ INSTRUCTIONS - Failure to assemble cover properly will void warranty.

Installation Instructions EZ Roll Tonneau

INSTALLATION SHEET. TOOLS RECOMMENDED 9/16 Wrench or socket 7/8 Drill bit & drill (optional)

INSTALLATION INSTRUCTIONS AND OWNER S MANUAL

INSTALLATION INSTRUCTIONS AND OWNER S MANUAL

INSTALLATION SHEET Any damaged or missing parts? Parts will be shipped to you directly. Call Mon - Fri 5:30 am - 4 pm Pacific Time

Installation Instructions EZ Roll Tonneau

Owners & Installation Manual. Read Instructions - Failure to assemble cover properly will void warranty.

Installation Instructions EZ Roll Tonneau

Owners & Installation Manual

Installation Instructions EZ Roll Tonneau

Installation Instructions EZ-Fold Tonneau

Shur-Co. Owners & Installation Manual. READ INSTRUCTIONS - Failure to assemble cover properly will void warranty.

Installation Instructions SRC Over-Size Tire Carrier Jeep Wrangler/Unlimited Part # 2743

Installation Instructions EZ Roll Tonneau

INSTALLATION INSTRUCTIONS

Installation Instructions EZ Roll Tonneau

Installation Instructions EZ Roll Tonneau

INSTALLATION INSTRUCTIONS

Installation Instructions ZipRail Tonneau

Installation Instructions Tri-Fold Folding Tonneau

Genesis and Genesis Elite Tri-Fold Tonneau Cover

Owners & Installation Manual

INSTALLATION INSTRUCTIONS

Owners & Installation Manual. Read Instructions - Failure to assemble cover properly will void warranty.

Installation Instructions ZipRail Tonneau

INSTALLATION INSTRUCTIONS

OWNER S MANUAL. Sentry & Sentry CT THREE YEAR WARRANTY. Phone: ( ) Fax: (605) SAFETY INSTRUCTIONS

OWNER S MANUAL. Sentry & Sentry CT THREE YEAR WARRANTY. Phone: ( ) Fax: (605) SAFETY INSTRUCTIONS

BRJK07R4, BRJK07R2, BTJK07R4, BTJK07R2, BRJK11R4, BRJK11R2, BTJK11R4, BTJK11R2

PARTS LIST: Components. ` Bi-Fold Tonneau Cover

Cargo Cover. Installation Instructions. For: Wrangler Part Number: Installation Tips WARNING

Installation Instructions

OWNER S MANUAL Kellen Gross Dr., Yankton SD Phone: TRUXEDO ( ) Fax: (605) Web Site:

11309 INSTALLATION INSTRUCTIONS

Instruction Manual. SaltDogg Spreader Hopper Poly Electrical 0.65 cubic yards. Table of Contents. General Information. Vehicle Requirements: WARNING

Please visit for the latest version of these installation instructions.

BRJK07R4, BRJK07R2, BTJK07R4, BTJK07R2, BRJK11R4, BRJK11R2, BTJK11R4, BTJK11R2

Duster Deck Cover Installation Instructions

Owner s Instruction and Safety Manual. cargo. Nomad and Flatbed

Please visit for the latest version of these installation instructions.

Please visit for the latest version of these installation instructions.

Installation Instructions Tigertop

***Please follow instructions for ease of installation and correct fit.***

Jeep Wrangler TJ Bedrug/BedTred Interior Installation Instructions

Please visit for the latest version of these installation instructions.

Owner s Instruction and Safety Manual. pet trailer. Burley Tail Wagon. Burley Tail Wagon model shown (Stroller Kit and Kickstand are Sold Separately)

Rocket. Two Seat Bicycle Trailer. Model Number ACIS99ROCKTBLU

Highrise/Ambassador Belt-Positioning Booster Instruction Manual

INSTALLATION INSTRUCTIONS MOUNTING KIT GENERAL MOTORS Chevrolet Silverado/GMC Sierra 2500HD & 3500HD

Instruction Manual 15K - Fifth Wheel Hitch Part Number 6030 & 6031

INSTALLATION INSTRUCTIONS MOUNTING KIT FOR ELITE SERIES

Installation Instructions Supertop for Truck

WR Air Accessory Mounting Brackets

DF Ford F Short Bed 2009-Current

Please visit for the latest version of these installation instructions.

BRJK11F2, BTJK11F2, BRJK07F2, BTJK07F2, kit

Installation Instructions Supertop for Truck

Jeep Wrangler TJ Bedrug/BedTred Interior Installation Instructions

Installation Instructions

Installation Instructions HOSS Hardtop Cart Only

Instruction Manual. SHPE1500 Salt Dogg Spreader Hopper Poly Electrical 1.5 cubic yards

BX Jeep Liberty Renegade 2012 Jeep Liberty Sport Installation Instructions

Please visit for the latest version of these installation instructions.

Please visit for the latest version of these installation instructions.

Installation Instructions TrekStep

Installation Instructions Trektop NX

Two Seat Bicycle Trailer

Installation Instructions Tigertop

INSTALLATION INSTRUCTIONS MOUNTING KIT FOR ELITE SERIES

Please visit for the latest version of these installation instructions.

Required Tools: Phillips screw driver to remove original soft top. Torx sockets are required to completely remove the original soft top hardware.

Please visit for the latest version of these installation instructions.

Replacement Parts List

INSTALLATION INSTRUCTIONS MOUNTING KIT GENERAL MOTORS 88-98; Classic; 1500/2500/3500 (6 and 8 BEDS)

Please visit for the latest version of these installation instructions.

ITEM # V LITHIUM-ION CHARGER MODEL #KRC Español p. 6. ATTACH YOUR RECEIPT HERE Serial Number. Purchase Date

Installation Instructions READ THOROUGHLY BEFORE BEGINNING Signature Series Rail Kit Dodge Ram Trucks-all, including Mega-cabs

Installation Instructions

Please visit for the latest version of these installation instructions.

Please visit for the latest version of these installation instructions.

Installation Instructions Trektop NX

Installation Instructions

Transcription:

The SOLID FOLD top comes fully assembled. Note any damaged or missing components before installing. 1 2 Place assembled cover over cab end of truck box. MISSING PARTS??? call Extang at 1-800-877-2588 Any required parts will be shipped to you directly. (DO NOT return whole kit to store) Wash truck bed. 3 Unfold the cover fully and adjust position over the truck bed for proper cab/tail alignment. Carefully refold the cover without shifting its position on the truck bed. Extang Corporation 5400 S. State Road Ann Arbor, MI 48108 734 677-0444, Fax: 734 677-8409 Register your warranty at: extang.com Item No. 83000-30-1601 RH Extang Corp., 2016 Printed in U.S.A.

4 If your truck has a bed cap or bedliner that covers the metal bed wall flange, you will need to remove enough so that all the clamps make solid contact. 5 Ensure clamp is positioned under bed wall flange. Hand tighten until clamp contacts, tighten an additional two turns. Trim only enough of the bed cap edge or liner wall so clamp contacts bottom of metal flange. 100mm Do not secure to only lip of bedliner or wall cap. Use Wrench or! 6 With tailgate open and front clamps secure, completely close the cover. 7 Slide rear clamp out to the bed wall. Pull rear clamp down and hook under bottom edge of bed wall flange. 8 It is convenient to drive with the SOLID FOLD cover open. Release the rear clamps and fold the cover forward. Fold the cover forward and fasten BOTH straps in the middle section to the front rail. IMPORTANT: Before folding the second section of the cover, rear clamps must be stowed securely into rail. Remove any snow or foreign matter before folding cover. IMPORTANT NOTICE While driving, cover must be completely flat and secure with all four clamps in the closed position or completely folded up (all panels) and secured at the cab. DO NOT DRIVE with cover in partially opened position. To remove foreign matter from panel hinges, remove one end cap and slide panels apart. Reassemble after cleaning. Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409 Visit us at: extang.com

Replacement Parts NOTE: To order replacement parts, it's best to contact our Customer Service Department for assistance, to ensure getting the correct part for your vehicle application. When ordering, xxx represents the 3-digit suffix, as referenced on the sales receipt or vehicle application list. Customer Service Department: 800-877-2588. Female Buckle Kit 31830002 Cab Clamp Assembly 1034 Tie Down Kit 31831010 83xxx-60 Cab Rail 83xxx-63 Tail Clamp Assembly 1035 1042 83xxx-61 Cab Hinge Cap Kit 31830010 83xxx-64 Hinge 32560669 83xxx-62 Latch Pocket Cover 31831020 Spacer Pad 32622500 Extang Corporation 5400 S. State Road Ann Arbor, MI 48108 734 677-0444, Fax: 734 677-8409 Tail Rail Side Rail * Tail Hinge Cap Kit 31830020 Specify: Year, Make, Model, Long-bed or Short-bed, Driver or Passenger side. Register your warranty at: www.extang.com Extang Corp., 2016, Printed in U.S.A.

Special Instructions for Alternative Brackets SUPPLEMENT to INSTALLATION INSTRUCTIONS Dodge Dakota 08 11 CAB CLAMP Add clamp plate as shown here TAILGATE CLAMP Hook clamp directly into factory rail Adjust tension by moving tension nut into handle 1/2" 5/8" Nissan Frontier 2005 CAB CLAMP Add clamp plate as shown here TAILGATE CLAMP All other Cargo Management equipped trucks CAB CLAMP TAILGATE CLAMP Add clamp plate as shown here Extang Corporation 5400 S. State Rd. Ann Arbor MI 48108 734-677-0444, Fax: 734-677-8409 Register your warranty at: Extang Corp., 2016, Printed in U.S.A.

READ CAREFULLY - KEEP IN A SAFE PLACE PLEASE ATTACH AND SAVE YOUR SALES RECEIPT. ACTIVATE YOUR warranty ONLINE AT ExTANg.COm. EXTANG LIMITED WARRANTY WARRANTY DURATION: Extang offers three years of coverage from the date of purchase. Warranty is limited to original purchaser of truck bed cover and is non transferable. WARRANTY CONDITIONS: This warranty is against defective materials or workmanship. The warranty is void if the product has been damaged by accident, unreasonable use, neglect, improper service/installation/removal, modifications, normal wear and tear or other causes not arising out of defective materials or workmanship. Consequential and incidental damages are not covered under this warranty. WARRANTY EXCLUSION: Warranty is void if defect in materials and workmanship is not reported in writing within 30 days of discovering a defect. Warranty does not cover the cost of shipping, including the cost of returning the product for warranty service or inspection. Warranty does not cover scratches and dents to bed cover. Warranty further excludes damage to bed cover as a result of placing, storing, or hauling objects on top of bed cover. Warranty will be void if shipping damage is not reported in writing within 3 business days of purchase. THE FOLLOWING CONDITIONS WILL ALSO VOID THE WARRANTY: OVERLOADING OF CARGO Cargo should not touch the tonneau at any point. Protrusions in the tarp will stress the fabric. Cargo may shift while traveling and cause it to push against the fabric or panels and damage it. DRIVING WITH PANELS OPEN OR IMPROPERLY SECURED Prior to vehicle operation, clamps must be tightly secured so that clamp lips tightly grip the inner bedside metal surface. OPEN POSITION: Tonneau must be completely folded and secured with BOTH buckles. CLOSED POSITION: Tonneau must be completely flat and secured at all 4 clamps. Top of tonneau MUST be free of foreign material including snow and ice before opening panels or severe damage may result. Do NOT tow your vehicle from the rear with any Extang tonneau cover on your truck. PERFORMANCE: Provided all warranty conditions are met Extang will either repair or replace (at Extang s option) the product or component. Extang may require the original item to be returned postage prepaid for final determination. Extang reserves the right to substitute and offer the respective warranty discount on an entire replacement system or provide other remedies than those listed in this warranty for discontinued products or other reasons. A return authorization number must be obtained from our customer service department prior to returning any product. Shipping charges will apply for any repair or replacement. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state. RECHARGEABLE TRUCK BED UTILITY LIGHT The Max Tailgate creates a tight seal along sides and bottom of your tailgate to keep out dust, rain and snow. Quick and easy to install: just cut, peel and stick. The e-light 500 is an all-new revolutionary lighting system that fully illuminates the entire bed of your truck with ease. Universal in nature, the e-light 500 has been designed to work from any location inside the truck bed, and can be recharged on the go. Order today, direct from our customer service department: 1-800-877-2588 5400 S. STATE ROAD, ANN ARBOR, MI 48108 VOICE: 734-677-0444 or 1-800-877-2588 FAX: 734-677-8409 EMAIL: info@ extang. com WEB SITE: extang.com Item No. 0193-7.15 RRE Printed in U.S.A.

SOMETHING DAMAGED? MISSING PARTS? CALL US FIRST 800-877-2588 WE CAN HELP YOU QUICKLY AND EASILY OVER THE PHONE RAPID RESPONSE OVERNIGHT DELIVERY Tonno Model: Experienced Customer Service staff to answer all your tonneau questions CUSTOMER SERVICE HOURS: 8:30 TO 5 EST, MONDAY - FRIDAY Purchase Date: Lot Code: Lot code can be found on underside of cover. AMERICA S # 1 SELLING TONNEAU Part No.0032-1212RRE Printed in U.S.A.