MATERIAL SAFETY INFORMATION TADIRAN HIGH ENERGY LITHIUM BATTERY

MATERIAL SAFETY INFORMATION TADIRAN HIGH ENERGY LITHIUM BATTERY RUGGED AUTHORITY www.cord-ex.com

TECHNICAL NOTICE 2. Composition/Information on Ingredients Safety data sheet lithium batteries Substance CAS No. Approx. percent of total weight Hazard symbol R-phrases 1. Identification 1.1 Product Name: Tadiran High Energy Lithium Battery, or Sonnenschein Lithium Inorganic Lithium Battery Voltage: 3.6 Volts Chemistry System: Lithium thionyl chloride Chemistry System: Lithium thionyl chloride Anode: Lithium metal Cathode: Liquid, thionyl chloride 1.2 Company: 1.3 Tadiran Batteries GmbH Industriestr. 22 D-63654 Büdingen Emergency Telephone Number: +49(0)6042/954-599 Note: This safety data sheets refers to cells and batteries assembled from them Lithium Metal 7439-93-2 2-6 F, C 14/15-34 Thionyl Chloride 7719-09-7 18-47 C 14-34-37 Aluminium Chloride 7446-70-0 2-5 Lithium Chloride 7447-41-8 1-2 Carbon 7440-44-0 2-5 Steel, Nickel plated ---- 35-73 Glass ---- 0-2 PVC 9002-86-2 0-1 PMMA 9011-14-7 0-1 PTFE 9002-84-0 0-1 Hazard Symbols: C Corrosive F Highly flammable R-Phrases: R 14 Reacts violently with water R 14/15 Reacts violently with water liberating extremely flammable gases R 34 Causes burns R 37 Irritating to respiratory system Important Note: The material in this section may only represent a hazard if the integrity of the battery is compromised, or if the battery is physically or electrically abused. RUGGED AUTHORITY Document Reference THELB Rev. A 3

3. Hazards Identification Warning: Fire, explosion, and severe, burn hazard. Do not recharge, disassemble, heat above 100 C (series SL-500: 150 C), incinerate, or expose contents to water. Protection from charging: Whenever lithium batteries are not the single power source in a circuit the following measures recommended by Underwriters Laboratories are relevant. The cells should not be connected in series with an electrical power source that would increase the forward current through the cells. The circuit for these cells shall include one of the following: A. Two suitable diodes or the equivalent in series with the cells to prevent any reverse (charging) current. The second diode is used to provide protection in the event that one should fail. Quality control, or equivalent procedures, shall be established by the device manufacturer to ensure the diode polarity is correct for each unit, or B. A blocking diode or the equivalent to prevent any reverse (charging) current and a resistor to limit current in case of a diode failure. The resistor should be sized to limit the reverse charging) current to the maximums given in the data sheets. 4. First Aid Measures A. Electrolyte Contact Skin Eyes Respiratory system B. Lithium Metal Contact Skin Immediately flush with plenty of water for at least 15 minutes. If symptoms are present after flushing, get medical attention. Immediately flush with plenty of water for at least 15 minutes and get medical attention. With large quantities and irritation of the respiratory tract medical surveillance for 48 hours. Immediately inhale Cortisone Spray, e.g. Pulmicort. Remove particles of lithium from skin as rapidly as possible. Immediately flush with plenty ofwater for at least 15 minutes and get medical attention. 5. Fire - fighting measures A. Extinguishing Media During a fire with lithium batteries, copious amounts of cold water is an effective medium to prevent expansion of the fire. Do not use warm water or hot water. Lith-X (Class D extinguishing media) is effective on fires involving only a few lithium batteries. Do not use CO2 or Halon type extinguishers. Dry chemical type extinguishers have limited extinguishing potential B. Fire Fighting Procedures Use a positive pressure self-contained breathing apparatus if batteries are involved in a fire. Full protective clothing is necessary. During water application caution is advised as burning pieces of lithium may be ejected from the fire. Where the cells or batteries are not at the centre of the fire copious amounts of water may be supplied to the cells using a diffuser type nozzle so that the cells remain cool during the containment and extinguishing of the fire. A sprinkler system should be sufficient for this purpose the critical factor being that the lithium cells do not experience temperatures above the melting point of lithium. Small amounts of water should never be used such as the volumes contained within portable fire extinguishers. Standard dry powder extinguishers are ineffective. Halon extinguishers must not be used when fighting lithium fires as toxic gases may be generated during fire fighting. It should be noted that a hazard of hydrogen formation exists whenever hot lithium metal comes into contact with water. 6. Accidental release measures When the battery housing is damaged, small amounts of electrolyte may leak. Seal battery air tight in a plastic bag, adding some chalk (CaCO3) or lime (CaO) powder or Vermiculite. Electrolyte traces may be wiped off dryly using household paper. Rinse with water afterwards. Eyes Immediately flush with plenty of water for at least 15 minutes and get immediate medical attention. RUGGED AUTHORITY Document Reference THELB Rev. A 5

7. Handling and Storage Do not allow terminals to short-circuit. Storage preferably in a cool (below 21 C), dry area that is subject to little temperature change. Do not place near heating equipment, nor expose to direct sunlight for long periods. Elevated temperatures can result in reduced battery service life. 13. Disposal Considerations Dispose by incineration or burial at permitted waste treatment and/or disposal sites. Batteries do not contain hazardous materials according to EC directives 91/157/EEC and 93/86/EEC. For large quantities a disposal service is offered upon request. 8. Exposure controls / personal protection 9. Physical and chemical properties 14. Transport information Class 9 UN 3090: LITHIUM BATTERIES UN 3091: LITHIUM BATTERIES CONTAINED IN EQUIPMENT, or LITHIUM BATTERIES PACKED WITH EQUIPMENT Packing group: II Special provisions and packing instructions: 10. Stability and reactivity May rupture violently when heated above 150 C or when charged. 11. Toxicological information ADR, RID: IATA: IMDG-Code: 188, 230, 310, 636, P903, P903a A45, A88, A99, P903, P912, P918 188, 230, 310, P903 EmS: F-A, S-I Storage and segregation: Category A Refer to information under item 2. 12. Ecological information For more information see www.tadiranbatteries.de > site map > Transport Regulations 15. Regulatory information The batteries do not contain mercury, cadmium or other heavy metals. RUGGED AUTHORITY Document Reference THELB Rev. A 7

16. Other information NOTES: Tadiran Lithium Batteries are registered by Underwriters Laboratories, Northbrook, U.S.A. under file MH 12827. Further information is given in - Tadiran Lithium Battery Product Data Catalogue - Tadiran Lithium Battery Technical Brochure. For lithium batteries in general, Safety standard IEC 60086-4 applies. It contains detailed recommendations for manufacturers of equipment and users. Visit our web site under www.tadiranbatteries.de. Battery packs The design and assembly of battery packs require special skills, expertise and experience. Therefore it is not recommended that the end user attempt to selfassemble battery packs. It is preferable that any battery using lithium cells be fabricated by TADIRAN to ensure proper battery design and construction. A full battery assembly service is available from TADIRAN who can be contacted for further information. If for any reason, this is not possible, TADIRAN can review the pack design in confidence to ensure that the design is safe (in assembly and use) and capable of meeting stated performance requirements. The information contained herein is furnished without warranty of any kind. Users should consider these data only as a supplement to other information gathered by them and must make independent determinations of the suitability and completeness of information from all sources to assure proper use and disposal of these materials and the safety and health of employees and customers. RUGGED AUTHORITY Document Reference THELB Rev. A 9

NOTES: NOTES: RUGGED AUTHORITY Document Reference THELB Rev. A 11