Shock Absorber TTX for Honda CRF 0R HO 990 Spare Parts List
Safety Precautions Note! The shock absorber is a very important part of the vehicle and will therefore affect the stability of the vehicle. Read and make sure that you understand the information in this manual and the mounting instructions before you use this product. If you have any questions regarding installation or maintenance please contact your nearest Öhlins dealer. Öhlins Racing AB can not be held responsible for any damage to the shock absorber, vehicle, other property or injury to persons, if the instructions for installing and maintenance are not followed exactly. Warning! This product was developed and designed exclusively for a specific vehicle model and should only be installed on the intended vehicle model in its original condition as delivered from the vehicle manufacturer. This product contains pressurized nitrogen gas (N ). Do not open, service or modify this product without proper education (authorized Öhlins dealer/distributor) or proper tools. After installing this product, take a test ride at low speed to make sure that your vehicle has maintained its stability. Safety Symbols In this manual, mounting instructions and other technical documents, important information concerning safety is distinguished by the following symbols: The Safety Alert Symbol means: Warning! Your safety is involved. Warning! The Warning Symbol means: Failure to follow warning instructions can result in severe or fatal injury to anyone working with, inspecting or using the shock absorber, or to bystanders. Caution! The Caution Symbol means: Special precautions must be taken to avoid damage to the shock absorber. Note! The Note Symbol indicates information that is important regarding procedures. Note! When working on this product, always consult your Vehicle Service Manual. This Manual should be considered as a part of the product and should therefore accompany the product throughout its life cycle. Öhlins Racing AB. All rights reserved. Any reprinting or unauthorized use without the written permission of Öhlins Racing AB is prohibited. Printed in Sweden.
Figure 9 9 0-009-0 Lock nut - 00-0 Washer - 009-09 Stop washer - 0-0 Piston ring - 00- O-ring - - Shim stack See spec. card - 0- Piston - - Shim stack See spec. card -9 009-0 Stop washer -0 009-0 Bleed washer - 009-0 Spacer Plastic 009-0 Spacer Plastic 09-0 Spacer Aluminium - 0- Shaft jet assy - 0-0 Adj. needle - 00- O-ring - 000- Shaft - 0- Adj. shaft - 0-0 Adj. shaft 09-0 Seal head assy - 00-0 Stop rubber -9 0-0 Washer -0 0-0 Seal - 00- Back-up ring - 09-0 Shim - 00- Bushing - 0-0 Seal head - 00-0 Scraper - 00- O-ring - 00-0 Circlip - 00- End cap 0
Figure - 00- Bump rubber - 9-0 Spring clip - 009-0 Stop cup - 0- Bracket - 00- O-ring - 0-0 Adj. screw - 0-0 Circlip Figure - 0-9 Spacer ball joint - 00-0 Seal ball joint - 00-0 Circlip - 00- Ball joint - 00- Screw - 00-0 Seal washer - 0-0 Cylinder head - 00-9 O-ring
Figure - 00-0 Spring platform clamp - 00- Screw - 00-0 Spring platform - 00-0 O-ring - 00-0 Cylinder tube - 00- O-ring - 00-0 Seal head holder
Figure - 00- O-ring - 000-0 Reservoir - 009-0 Sticker Warning - 009- Sticker Ö TTX - 00- O-ring - 000-0 Reservoir piston - 000-0 Teflon band - 00- O-ring -9 00-0 Reservoir top assy -0 00-9 O-ring - 000-0 Screw - 009-0 Circlip 9 0
Figure Compression/ Rebound assy - 0-0 Circlip - 00-0 Adjustment needle - 00-0 Ball - 0-0 Spring - 00-9 O-ring - 00-0 O-ring -a 00-0 End piece adj. Compression -b 00- End piece adj. Rebound - - Washer See spec.card -9 - Shims See spec.card -0a 0- Valve adjuster Compression -0b 0- Valve adjuster Rebound - 0-0 Check valve shim a b - 0009-0 Circlip - 0-0 Check valve housing - 0-0 Check valve spring 9 0a 0b
Öhlins Spare Parts List TTX_HO 990 Issued 0-0- 0 Öhlins Racing AB Your Öhlins retailer: Öhlins Racing AB Box SE-9, Upplands Väsby Sweden Phone: + (0) 90 0 00 Fax: + (0) 90 0 0 www.ohlins.com