NEBULA CRUISER The Nebula cruiser is a 2 ft. long R/C quadcopter constructed of durable lightweight materials. It is extremely stable, maneuverable and capable of performing barrel rolls in midflight. Model no. 5F63DFB
PLEASE READ ALL INSTRUCTIONS CAREFULLY AND PRIOR TO FIRST USE CAUTION: For ages 14+. CHOKING HAZARD SMALL PARTS. Keep away from children. Keep Drone at least 6 ft. away from other objects while in flight. Never fly the Nebula Cruiser near people or animals as this may result in injury. Do not fly in winds in excess of 4 mph. Do not expose any part of the Nebula Cruiser or remote to water or moisture. Only use the Lithium battery included with this kit in the Nebula Cruiser. Never leave the charging battery unattended. Only charge the battery in a clean, dry and cool location away from children. Do not expose batteries to heat or water. Remove and disconnect all batteries when not in use. Recycle batteries according to State and local regulations. Do not use battery if the surface temperature feels hot or exceeds 104 degrees. Allow battery to cool prior to use or prior to charging. Do not use battery if it is damaged. Nebula Cruiser 1
Remote Battery Installation: Insert 4 AA Batteries according to the polarities marked inside the battery compartment Lithium Battery Removal and Charging Instruction: The lithium rechargeable battery pack that will need to be charged before first use. Charge Time = approx. 30 min. Fly Time = up to 10 min. Step 1 Open battery compartment located at top center of Nebula Cruiser. Gently remove battery and disconnect cords. *Be careful not to pull or twist cords as this could damage the connection. Step 2 - Plug the lithium battery into the USB Charging Cable, then into USB wall adapter or USB port on your computer. 2
Charging continued * A red indicator light will illuminate on the USB plug to show that a charge is occurring. Never leave battery unattended while charging. Step 3- The red indicator light will turn off once full charge has been achieved. Do not charge the battery beyond this point. Step 4 - Disconnect USB cable from all connections. Step 5 Reinsert lithium battery into Nebula being careful when handling the cords. Reattach battery compartment door. Flying the Nebula Cruiser: 1. Move power switch on the Cruiser to the "ON" position. 2. Move power switch on the remote to the "ON" position. * Tip - Make sure the throttle lever is at the lowest position. 3. Place cruiser on a flat, level surface with front facing in the same direction you are. 4. Synchronize remote to the Cruiser by moving the left speed control lever maximum up and maximum down in one movement. The remote will beep once and the Cruiser lights will stop blinking if sync was successful. Move left speed control stick slowly upward to desired altitude Move left speed control stick slowly downward to land Move the right direction control stick left or right to move cruiser clockwise or counter clockwise. While ascending, move the right direction control stick forward, backward, left or right to control direction of flight. 3
Flip Control: *Tip - Make sure the nebula cruiser is hovering at least 9 feet from the ground before attempting flips. While hovering, move directional control stick in any extreme direction and press the flip button. Nebula Cruiser will flip in the direction that the joystick is pointed. Trimming and calibrating: Flight adjustments may be needed depending on environment, ground surface, wind, etc. To trim and calibrate your Nebula Cruiser, run these tests and make adjustments just as your aircraft becomes airborne (within 12" from the ground). 1. To correct spin, slowly tap the "Direction Trim" switch in the direction you wish the Nebula Cruise to go. 2. To correct forward or backward movement, tap the "Forward and Backward Trim" switch in the direction you want the Cruiser to go. Tap the Trottle Trim switch to accomplish same forward or backward movement. 3. To correct excessive movement to the left or right, tap the "Side Trim" switch in the direction you want the Nebula Cruiser to go. Troubleshooting: Issue Solution 1 Solution 2 Solution 3 After trim adjustments, craft continues to fly sideways or out of control Check to make sure propellers are assembled onto correct motors. Check to make sure no hair, string, etc. is caught in the propeller Check propeller to make sure they turn freely and are not damaged Aircraft does not take off After hard landing, propeller does not spin Reset syncronization (see instr. pg. 3) Inspect propeller and replace any propeller that is damaged Install fully charged batteries into drone and remote If propeller does not turn, there may be damage to the rotor. Contact manufacturer for replacement Make sure you are within the 12 feet range and there is not obstruction or interference Replacement parts are available for purchase directly from the dealer or at www.odysseytoys.com For additional questions or support please contact care@odysseytoys.com 4