MODEL NO. NPS-6-- --0666 Standard Features CSA and NEMA 3R (UL50) 1800 Amps @ 24Volt / 900 Amp @ 48Volt back up power Solid steel frame and shelf construction with 2 high sub-frame platform. Available with a 4 and 6 platform. integrated roof top solar shield with retractable roof lifting anchors 1200 Amp Tin-plated copper bus bar ( Positive and Negative) Integrated thermal insulation management system on all panels and door Top and bottom knock-outs for easy access and installation of DC loads and other accessories. Hilti anchor bolts with pre-drilled mounting holes The Granite Outdoor Battery Enclosure was designed by Canadians for Canadians. Specifically intended for our extreme weather conditions, the Granite Series Cabinet is an ideal enclosure for stand alone or expanded battery applications. The compact design allows for 900 Amps at 48Volts in an innovative low profile cabinet design. An ideal choice to expand your power requirements at a low cost with minimal effort. Service providers will save time, money and valuable real-estate by expanding power at your WIC s or wireless shelters. Our low profile design allows you to pass local height restrictions while maintaining the ability to expand by 20 batteries per cabinet. The Granite offers the best flexibility and reliability on the market. Cable management restraints for proper and clean cable routing 4 Welded steel battery trays ( capacity 5 strings for reliable battery redundancy) All exterior hardware are made from rust resistant stainless steel including lockable handles and lifting anchors Earth ground connection point, DC/AC input conduit punch out Complete with all battery cables and inter-cell bus connectors with individual Anderson connectors pre-wired to +24V or 48V configuration.
Mechanical Cabinet Dimensions Inches: 55.75H x 42W x 30D MM:.1416H x 1067W x 762D Weight with Batteries: 3200 lbs Enclosure:..11 Gage Steel welded steel frame and 16 Gage Panels and door Electrical Input voltage:...120 or 240VAC single phase (air conditioner and heater) Output voltage: 24 or 48VDC Recommended Breaker: 15Amp time delay breaker Environmental Outdoor Temperature :.-40C to 46C( -F to F) Backup Cabinet Capacity Number of Batteries: 20 Battery Amp Hr. Range:..will accept 105 amp hr to 190 amp hr block Battery part numbers: C&D TEL12-105F C&D TEL12-160F C&D TEL12-180F Maximum Battery Capacity @ 48Volts to 1.75 Volts @ 25C. 8 Hour Rate:..905A 10 Hour Rate: 870A Standards CSA:.C22.2 No 60950-00 UL:.Std.No. 60950-2000 Seismic: Designed to Zone 4 Cabinet:.NEMA 3R (UL50) Standard Components Solid steel frame and shelf construction Solid steel 2 high sub-frame platform Integrated roof top solar shield with retractable roof lifting anchors 1200 Amp Tin-plated copper bus bar ( Pos and Neg) Integrated thermal insulation management system on all panels and door Top and bottom knock-outs for easy access and installation of DC loads and other accessories. Hilti anchor bolts with pre-drilled mounting holes Cable management restraints for proper and clean cable routing 4 Welded steel battery trays ( capacity 5 strings for reliable battery redundancy) All exterior hardware make from rust resistant stainless steel including lockable handles and lifting anchors Earth ground connection point DC/AC input conduit punch out Complete with all battery cables and inter-cell bus connectors with individual Anderson connectors pre-wired to +24V or 48V configuration. Optional Components Heating & Cooling Air conditioning:..4000btu to 6000TBU Optional heater: 600W AC & DC powered NEMA 3 Filter fans ( CSA/UL) Others AC & DC service Light with on/off switch GFCI convenience outlet 120VAC single phase Work table with manual holder Smoke detector and alarm contact points BIX punch down block and Dry C contact block High temperature monitor switches
Solar Shield / Lifting Bolts Environmental Built in Solar Shield with retractable lifting bolts for easy roof top and pedestal installation Panels and Doors colour matched removable panel and doors 3 point door latching with L handle latch NEMA 3 rubber gaskets 180 degree hinges Grounding bars to subfram All doors and panels made for 16 gauge steel Secure Lock Closed Loop Kooltronics Heating and Air-conditioning 115VAC/1/60Hz.,3000 BTUH CFC-Free Refrigerant EMI/RFI Suppressor M/Seal Mounting System Two Stage Thermostat Condenser Impeller Speed Controller Audible Noise 74.7dBA @ 3Feet NEMA 12 &3R Rating UL/CUL Listed Cooling Plenum / Tray Standard 2 Plinth 3 point Locking door latching with L handle Tamper resistant latch 304 Stainless steel #4 finish ( polished) Standard 2 Pedestal with optional 4 and 6 Snow Pedestals Built in Cooling plenum with work station tray
C&D TEL180F DESIGN FEATURES Battery Configuration
TEL12-160F and TEL12-80F PERFORMANCE CABINET SYSTEMS