VECTIS - VINIS - DUO www.tecnoma.com
VINIS, DUO and VECTIS 3 sprayers with different designs to answer every specific need. VINIS Pump + turbine + boom on the front DUO Spraying unit on the 3 point linkage with an articulated trailer behind VECTIS Pump on the front / turbine + boom behind
A modern design to optimize application, with a miture of ergonomics, performance and environmental respect. Chassis Lift arm linkage on VECTIS A reliable design to resist intense use in any conditions. Fabricated steal chassis Polyester coating and epoy primer for etreme chemical resistance Linkage Created to maimize stability and steering. VINIS: articulated drawbar for tight turning DUO: 3 point linkage spraying unit with an articulated trailed tank VECTIS: Link arm hitching with rotating drawbar and longitudinal settings Ales Multiple settings to adapt the equipment to any vineyard. 2 cranked half ales sliding into an ale holder => track width and clearance settings Longitudinal setting for the ale position Articulated drawbar on VINIS Cranked sliding half ale
Tanks The tanks were designed to minimize residual spray and to facilitate the rinsing management. The tank assembly has a smooth ergonomic shape to preserve the vegetation whilst driving through the crop. High density polyethylene rotomoulded tanks, for rigidity and durability with smooth inner tank walls to limit waste residues for easy cleaning VINIS and DUO tanks: --Main tank: 600 l and 800 l --Rinsing tank 55 l and 70 l Narrow VECTIS tanks: --Main tank: 800 l and 1000 l --Rinsing tank: 85 l Standard VECTIS tanks: --Main tank 1000 l and 1200 l --Rinsing tank: 120 l 15 l built-in hand wash tank Variable pressure agitation to keep an even miture 2 rotating washing nozzles for complete flushing Eternal tank gauge on the front right hand side Centralised sump to ensure total emptying Tank equipment Main and rinsing tanks on VECTIS Fan Fan efficiency is essential for a good quality application. Maimum output with a turbine as close as possible to the hands and canons. VINIS and DUO: 450mm fan on the front. 26hp required VECTIS: 450mm or 560mm fan on the rear. 26hp or 35hp required Steel fan housing for maimum air speed Fan may be disengaged due to a dog clutch system Free wheel between the pump and the fan to avoid overrun vibrations Belt drive fan with automatic tensioner on the belt: gas ram keeping the right tension at all time Oil bath bearing gearbo with outside oil gauge giving durability and easy access for maintenance 8 output air manifold with equal distribution Automatic belt tensioner VECTIS turbine column
Easy operating area A water circuit for all uses with a centralised and ergonomic easy operating area. Accessible suction filter for daily cleaning Chemical induction and can wash Variable agitation Spraying controls Main tank cleaning with 2 rotary washing nozzles Ability to clean the boom water circuit without any returns to the main tank Options: --Gravity Autonet: sequential tank dilution system driven from the cab --Integrated Autonet: sequential tank dilution through the water pump and driven from the cab (only for VECTIS) Centralised operating area Rinsing tank Induction hopper and can wash (option) Electric tractor circuit Transfert valve Gravity or integrated Autonet Main tank Pump and filters Self priming piston diaphragm pump. High and regular flow for good agitation and application. VINIS & DUO: Piston diaphragm pump PM150 giving 70 l/min and 15 bars VECTIS: Piston diaphragm pump PM190 giving 105 l/min and 15 bars 500 micron filling filter 594 micron suction filter with a none return valve: the filter may be cleaned with a full tank Lav Ton: rotary washing nozzle Option: 365 micron pressure filter
Regulation Pressure gauge Regulation and distribution are the main keys for an evenly distributed spray along the boom. REGULAIR: regulation by manual pressure adjustment with pneumatic regulator. A simple and ergonomic control on every sprayer function with joystick: Section control Regulation (dependant on equipment and options) Boom movement (dependant on equipment and options) In cab joystick to manage the sprayer REGULAIR guarantees good pressure stability during spraying and automatically compensates the section cut off without any calibrated return adjustment. 100 mm diameter pressure gauge Boom sections control by TECNOMA s solenoid valves Semi continuous circulation for fast section closing and opening Regulation returns go to the pump suction for a perfect control of the tank returns Pneumatic air regulator REGULAIR
Regulation valve for DPAE VITITRONIC DPAE regulation Regulation proportional to the forward speed (DPAE). The regulation valve adapts the spray and flow according to the forward speed to apply the same rate anywhere on the vineyard. How it works: Rate setting in l/ha Speed sensor fitted to tractor or sprayer wheel Pressure sensor on the boom Flow regulation according to the pressure and the speed Spraying control bo in the cab Easy adaptation to various plantation widths and heights 20 fields records: surface, volume and distance travelled VITITRONIC control bo for DPAE
The spray The right dose in the right place while reducing atmospheric drift. Pneumatic: Every gun is equipped with an fied internal diffuser in the centre to ensure an evenly distributed circular spray pattern Polyethylene hands and cannons: can be adapted to any vineyard with a high shock resistance 3 dimensional settings for the hands Monostop: DCV and individual cut off system PreciJet: Application control and drift reduction. A spraying system which allows you to reduce chemical quantities without reducing chemical application to the plant. Air flow assisted face by face spraying system. Polyethylene tube: light, robust and shock resistant Cone shape tube: fluidity through the rows and equal speed and volume from the top to the bottom of the air output. Retractable attachment with automatic return in case of collision 26 hp turbine: low power and fuel consumption Linear air flow all the way up: equal application 1250 mm high for standard PreciJet: 4 nozzles / face with orientation adjustment and height settings MonoStop Nozzle holder with anti-drip DCV Hollow Cone ceramic nozzles: perfect rate control and durability VITISIT boom with pneumatic equipment Pneumatic 4 finger hand with DCV and MonoStop Face by face PreciJet equipment Option: 1 670 mm high for PreciJet with 5 nozzles
Key points: Equal application and air distribution along the boom Optimum spray penetration into the canopy Perfect rate control thanks to ISO nozzles Air speed control depending on vegetation density Spray localisation according to vegetation height Possibility to work without air assistance (usually at the beginning of the season) Optimized air flow: PreciJet uses low air volume. 450 mm turbine and 26 hp: low power and fuel consumption Atmospheric and ground drift reduction: chemical rate reduction without reducing application to the plant Booms NARROW equipment Pneumatic assistance: Linear air flow for good penetration into the vegetation and canalized spray spectrum. Polyethylene tube with a conic profile giving a uniformed air repartition along the boom Different types of booms and spraying equipment to adapt your sprayer to any vineyard type. TECNOMA booms are fitted on the turbine housing with either manual or hydraulic height control (dependant on equipment and options). NARROW equipment: Pneumatic 4 hands and 4 cannons Adjustable cannons are fitted on a fied boom Compatible with VINIS, DUO and VECTIS VITIFIX: Pneumatic 4 hands and 4 cannons Cannons fitted on a horizontal runner: manual position setting Manual cannon orientation settings Compatible with VINIS, DUO and VECTIS VITIFIX
vitisit VITISIT: Pneumatic 4 hands and 4 cannons Cannons fitted on a hydraulic horizontal runner: left and right are independently hydraulically adjusted Manual cannon orientation setting Compatible with VINIS, DUO and VECTIS MANUAL VITIMOBIL: Pneumatic 4 hands and 4 cannons HYDRAULIC VITIMOBIL with PreciJet equipment 2 manual lateral folding arms with safety system Cannon position setting along the boom Manual cannon orientation setting Compatible with VINIS, DUO and VECTIS HYDRAULIC VITIMOBIL: Pneumatic: 4 hands and 4 cannons Precijet: 4 PreciJets face by face, sliding along the boom to spray 2 complete rows from 1,5m to 2,5m plantation width 2 hydraulic independent lateral folding arms Compatible with VINIS, DUO and VECTIS with pneumatic equipment Compatible with VINIS and VECTIS with PreciJet equipment VITIVARIO VG with PreciJet VITIVARIO and VITIVARIO VG: Pneumatic: 4 hands and 4 cannons PreciJet: 4 or 6 PreciJets face by face, sliding along the boom to spray 2 or 3 rows. From 1,5m to 4,5m plantation width with 4 PreciJets and from 1,5m to 2,5m plantation width with 6 PreciJets 2 hydraulic independent lateral folding arms mounted on a horizontal runner giving hydraulic lateral setting at all times Compatible with VINIS, DUO and VECTIS with pneumatic equipment Compatible with VINIS, DUO and VECTIS with 4 PreciJets Compatible with VECTIS with 6 PreciJets Booms Total width unfolded Total width folded VITIFIX 2000 mm 1500 mm VITISIT II 3400 mm 2200 mm MANUAL VITIMOBIL HYDRAU- LIC VITIMOBIL 3720 mm Ø 3720 mm Ø Height between boom and ground on VINIS 1640 mm on VECTIS 1900 mm on VINIS 1640 mm on VINIS 1640 mm Lifting setting 400 mm 400 mm 400 mm 400 mm VITIVARIO de 5600 to 6550 mm Ø on VECTIS 1900 mm 400 mm
Chassis, turbine and water circuit Booms Options Description VINIS 600 VINIS 800 DUO 600 DUO 800 Chassis Design Turbine boom and pump on the front Spraying unit (turbine, boom and pump) on the 3 point linkage with an articulated trailer behind VECTIS 800e VECTIS 1000e VECTIS 1000 Pump on the front Turbine and boom behind VECTIS 1200 450 mm - 26 cv - PreciJet Turbine 450 mm - 26 cv 560 mm - 35 cv - Pneumatic Clutch type Manual clutch Oil bath bearing gearbo and automatic tensioner on the belt Transmission Oil bath bearing gearbo and automatic tensioner on the belt Free wheel between the pump and the fan 2 cranked half ales slinding into an ale holder 2 cranked half ales slinding into an ale holder Ale 2 longitudinal ale settings 4 longitudinal ale settings Tyres 185/65 R15 185/65 R15 205/70 R15 235/70 R15 Mud guard Ø Serie (depend on configuration) Drawbar Articulated drawbar 3 point linkage Link arm hitching Main tank 600 l 800 l 600 l 800 l 800 l 1000 l 1200 l Remote drain Lav Ton 2 Agitators 2 4 Rinsing tank 55 l 70 l 55 l 70 l 85 l 120 l Hand wash tank Pump PM150 de 70 l/min PM190 de 105 l/min Filtration 500 micron filling filter 594 micron suction filter with nne return valve Regulation REGULAIR, constant pressure regulation Pressure gauge Distribution Sections Serie 15 l Ø100 mm TECNOMA solenoid valves 2 setions Step Ø Serie Hydraulic lift Serie with PreciJet Ø Serie with PreciJet Hydraulic NARROW equipment VITIFIX VITIMOBIL Hydraulic command by circuit selection (ecept VITIFIX and manual VITIMOBIL) Pneumatic equipment (4 hands et 4 cannons) Pneumatic equipment (4 hands et 4 cannons) Pneumatic equipment (4 hands et 4 cannons) VITISIT II Pneumatic equipment (4 hands et 4 cannons) Pneumatic equipment or PreciJet HYDRAULIC VITIMOBIL Pneumatic Pneumatic or PreciJet 4 faces 4 faces VITIVARIO Pneumatic equipment or PreciJet 4 faces Pneumatic equipment or PreciJet 4 or 6 faces Hydraulic lift Serie with PreciJet Hydraulic control Circuit selection - 2 double acting control valves or 1 double acting and 1 single acting control valves (depend on booms) (No hydraulic control on VITIFIX and manual VITIMOBIL) Articulated drawbar Ø Step Ø Ø Tyres 26.1200 R12 26.1200 R12 26.1200 R12 2912.515 205/70 R15 235/70 R15 2912.515 Ale Ø Double ale with 165/70 R14 Bogie with 6910 Induction hopper Can wash Spirovit Pressure filter 365 micron pressure filter Sections 4 sections instead of 2 Sequential dilution Gravity Autonet Gravity Autonet Integrated Autonet Hose reel and hand lance Pressure setting from the cab with REGULAIR DPAE regulation VITITRONIC Other pneumatic equipment TELESIT for cannons PreciJet length VITIMOBIL etensions Hydraulic lift ED hydraulic distribution 1670 mm - 5 nozzles instead of 1250 mm - 4 nozzles Etension for 4780 mm boom Ø Etension for 4780 mm boom total width total width Hydraulic lift with single acting or double acting control valve from the tractor with pneumatic equipment
Join us on http://fr-fr.facebook.com/groupe.tecnoma DIMENSIONS VECTIS VINIS H1 H1 L2 L1 L3 L2 L1 L3 L5 DUO H1 L4 L3 L1 L2 L1 Total length L2 L3 L4 Total width L5 Tank width H1 Tank height VINIS 600 2530 1655 to 1755 875 to 775 1090 990 990 185/65 R15 VINIS 800 2680 1760 to 1830 920 to 850 1200 990 990 185/65 R15 DUO 600 2990 2340 650 1090 990 990 185/65 R15 DUO 800 3140 2490 650 1200 990 990 185/65 R15 VECTIS 800e 2790 1940 850 1244 1050 1050 185/65 R15 VECTIS 1000e 2790 1940 850 1257 1090 1050 205/70 R15 VECTIS 1000 2995 2050 945 1250 1210 1200 235/70 R15 VECTIS 1200 2995 2050 945 1390 1210 1200 235/70 R15 Tyres Tecnoma Service A worldwide network Dealer stamp Genuine parts available on CD and all the NOZAL nozzles range. www.nozal.fr january 2012 S.A.S. - Capital 1 174 400 euros - R.C.S. EPERNAY B 350 484 309-54 rue Marcel PAUL - F - 51206 EPERNAY CEDEX Tél. 33 (0)3 26 51 99 99 - Fa 33 (0)3 26 51 83 51 - Site : www.tecnoma.com - Email : tecnoma@tecnoma.com