Memory Foam Massaging Bath Pillow with Wireless Remote Control Instruction For Use and Warranty Information Model AB225
Memory Foam Massaging Bath Pillow with Wireless Remote Control Memory Foam Pillow Pillow On/Off Control Suction cups on back side of pillow holds firmly and safely to smooth bathtub surface Remote On/Off power button Wireless Remote Control 2-Speed Massage Settings and Personalized Intensity Control Mesh Storage Pocket for Remote
Congratulations and thank you for being a customer of Pretika! Before using your Soft Spa, please take a moment to get to know your Soft Spa Bath Pillow and how it works. After you remove the clear poly bag, you may notice a slight odor this odor can be common and is completely harmless. Allow the pillow to air-out and the odor will dissipate after 24 hours. How To Install or Replace Batteries Wireless Remote Control requires 3 AAA batteries (not included). To install or remove batteries: 1. Make sure Button is in the Off position. 2. Press Battery Compartment slide and pull back gently to release cover. 3. Carefully pull out batteries (if replacing) and insert 3 new AAA Alkaline Batteries. Use the markings in the battery compartment as a guide to position the (+) positive or (-) negative end of each battery. 4. Replace Battery Compartment cover, ensuring waterproof gasket is in place, by placing cover within the tracks and press cover closed. 5. To avoid leakage, check the batteries regularly for deterioration. Remove exhausted batteries and remove the batteries if the pillow is not to be used for a long time. 6. Pillow will not work if batteries are not placed in unit correctly. Pillow motor requires 4 AAA batteries (not included). To install or remove batteries: 1. Carefully unzip compartment closure of Micro-Fiber cover - open zipper slowly making sure that zipper tracks are free from outer material and inner PVC cover material. 2. Make sure On/Off Button (red) is in the Off (raised) position. 3. Remove waterproof battery compartment from cavity inside pillow.
4. Open cover to battery compartment cover by turning counter clockwise. 5. Carefully pull out batteries (if replacing) and insert 4 new AAA Alkaline Batteries. Use the markings in the battery compartment as a guide to position the (+) positive or (-) negative end of each battery. 6. Replace Battery Compartment cover, ensuring waterproof gasket is in place, by placing cover on compartment and turning clockwise. Do not over tighten. 7. Place battery compartment inside pillow cavity and zip Micro-Fiber cover closed. Close zipper slowly making sure that zipper tracks are free from outer material and inner PVC cover material. 8. To avoid leakage, check the batteries regularly for deterioration. Remove exhausted batteries and remove the batteries if the pillow is not to be used for a long time. 9. Pillow will not work if batteries are not placed in unit correctly. It is our experience that if a product uses batteries, many of the problems thought to be product defects are simply caused by weak batteries. To save any unnecessary inconvenience and expense, we encourage you to try replacement batteries before you return the product. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. To dispose of alkaline batteries, place in the trash (normal municipal waste). Recycling of batteries at your local recycling center is good for the environment. Remote Control Functions Each control functions are shown on the remote control with 8 custom massage intensity control settings Power Control Press for On / Press for Off Mode Control Press for Low Vibration Press for Hi Vibration settings Intensity Press for each desired setting to Control customized and target the massage How to Use Step 1 Press pillow on/off control button Step 2 Press remote on/off power button To conserve batteries, turn off pillow and remote after use. *If Pillow on/off button is not turned off after remote is turned off, pillow will beep alarm. Turn pillow off to stop beep alarm
Safety This bath pillow has been designed with your safety in mind. No pillow can guarantee your safety. Please use caution when you bathe. Follow these simple instructions: Wet bottom side suction cups before securing Press cushion firmly onto smooth, non porous surface, place against the upper back wall of the tub to secure suction cups to surface To lift-up suction cup gently lift each cup up one at a time do not pull-up on pillow After each use allow cover to dry, remove pillow, rinse cover thoroughly and hang dry Please be sure to use as directed. If pillow gets wet, simply remove from cover and allow sufficient time for Micro-Fiber cover to dry completely before using again. The maximum weight capacity is 20 lbs. (9.0 kgs) To Clean Micro-Fiber Cover After each use, simply wash by hand and air dry. Machine washable, delicate setting at warm temperature using mild detergent. Recommended to air dry only may tumble dry on delicate setting at a low temperature. Warning Suction cups will not securely attach to certain textured bathtub surfaces - please test before use. Keep bath tub surface clean. Caution: If you are using a pacemaker or are pregnant, consult a physician before using this FCC certified wireless remote appliance. The continued use of bath oils and other bath products may reduce the Bath Pillow s safety and appearance. Please use all safety precautions when entering and exiting the bath tub. Children should be attended by an adult while using. Bath Pillow is not to be used as a floatation device. Caution - Makeup, Dyes, and some cleaning products may stain pillow. Do not submerge Remote Control or Pillow in water. Do not attempt to repair Pillow there are no serviceable parts. For service, send the Pillow to the Pretika address shown in the Warranty section. Limited 90 Day Warranty Warranted from date of purchase against defects in material and workmanship. This warranty does not include damage to the product
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/tv technician for help.
as a result of misuse or accident. Some states do not allow the exclusion or limitation of incidental or consequential damages or allow limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary, from state to state. Pretika Corporation shall not be liable for any incidental or consequential damages arising out of defects in this product, whether or not caused by its negligence. During Warranty Period with Proof of Purchase (store receipt) Should your product become defective during the warranty period, package the item securely and return it prepaid/insured along with proof of purchase to: Pretika Corporation Warranty Repair Department 12215 Holly Street Riverside, CA 92509 To insure prompt repair, provide complete, legible name, address and phone number information and a note indicating the nature of the product defect. We will Repair or Replace (at our sole discretion) product at no charge. Outside Warranty Period Should your product become defective outside the warranty period or you do not have store receipt, package the item securely and return it prepaid/insured along with a check or money order payable to Pretika Corporation in the amount of $40.00 to cover handling and postage charges. Visit our website @ www.pretika.com See the innovative beauty, skin care, spa and personal care products from Pretika. Mail or fax orders to: Pretika Corporation 12215 Holly Street Riverside, CA 92509 (949) 481-8818 Fax (949) 481-8828 E-Mail Address: customerservice@pretika.com Go to www.pretika.com to see our innovative products.
Memory Foam Massaging Bath Pillow with Wireless Remote Control Pretika Corporation Riverside, CA 92509 p 949.481.8818 f 949.481.8828 e customerservice@pretika.com w www.pretika.com Facebook.com/pretikaskincare Twitter.com/pretikaskincare YouTube.com/pretikaskincare