Physical Technical Testing Institute Ostrava-Radvanice. Type Examination Certificate

Similar documents
PF SERIES PUMPS PFS ATEX VERSION (INCLUDES M6A, M6XA, M10X MOTORS & SPK) OPERATION & PARTS MANUAL

IBExU Institut für Sicherheitstechnik GmbH

Instruction Manual. Ex-Time 40 / 50

Instructions for installation, service and maintenance 1. INTRODUCTION APPLICATION TECHNICAL DATA, IDENTIFICATION...

Capacitive level sensors CLS 23

PK-I-Ex. Fire resistance class Circular: EI60S, EI90S, EI120S Square: EI90S, EI120S. Systemair Fire Dampers for Explosive Areas.

IECEx Certificate of Conformity

PF SERIES PUMPS PFS ATEX VERSION (INCLUDES M6A, M6XA, M10X MOTORS & SPK) OPERATION & PARTS MANUAL

ATEX/IECEx Coil Manual Type 200 and 300 Series Coils for EH70 Series Solenoid Valves Issue , Released December 13, 2017

ToughPIX 2300XP Series INSTRUCTIONS FOR SAFE OPERATION

Marine Fire and Gas Dampers

ECO-TOP POWER FLAMEPROOF THREE-PHASE INDUCTION MOTORS (FRAME SIZE ) PRODUCTS CATALOG English. electric motors. rev. 01

IBExU Institut für Sicherheitstechnik GmbH An-Institut der Technischen Universität Bergakademie Freiberg

IECEx Certificate of Conformity

The product and any acceptable variation thereto is specified in the Annex to this certificate and the documents therein referred to.

p max (see table of performances) Q max (see table of performances) bar Maximum flow l/min see par

SFI SPECIFICATION 35.2 EFFECTIVE: DECEMBER 29, 2014 *

Guideline No.: E-03(201806) E-03 MOTORS. Issued date: June 7, China Classification Society

Resistance Thermometers Model TR602, for Flat Surfaces Model TR603, for Pipe Surfaces

Systemair Fire Dampers

Guideline No.: E-03(201610) E-03 MOTORS. Issued date: October 28,2016. China Classification Society

Category II 1 G only applies to the Constructional Variants shown in table 15.2 of annex 1.

SPOOL VALVES solenoid air operated 1/4 to 1/2 tapped body and NAMUR for integrated pilot

Gachot Ball Valve Type V16 carbon steel / reduced bore / DN 8 to DN 200

Reg No: 1999/027771/07 ACCREDITED AND APPROVED TEST LABORATORY IN TERMS OF ARP 0108: REGULATORY REQUIREMENTS FOR EXPLOSION PROTECTED APPARATUS

IECEx Certificate of Conformity

Protection & Safety Equipments For Storage Tanks. Pressure / Vacuum Relief Valves, Flame Arresters, Free Vent, Gauge Hatch.

IECEx Certificate of Conformity

ATEX instruction for APP / PAH PAHT G 2-90 / PAH Tech

SFI SPECIFICATION 18.1 EFFECTIVE: JUNE 17, 1999 *

COMMISSION REGULATION (EU) No /.. of XXX

Endress+Hauser Wetzer GmbH+Co. KG Obere Wank Nesselwang Germany. Field Temperature Transmitter itemp, Types TMT82, TMT84 and TMT85

COMMISSION REGULATION (EU) / of XXX

INDUSTRY PROCESS AND AUTOMATION SOLUTIONS. Technical Bulletin

SITRANS P measuring instruments for pressure

Explosion-proof Solenoids ATEX. II 2 G / II 2 D EEx dm IIC T4, T5, T6. Catalogue 8735/GB. Maximum photo

EXAMINATION CERTIFICATE

IECEx Certificate of Conformity

ATEX instruction APP S 674 pumps APP S , APP S and APP S

Van Puijenbroek Texti& CE TYPE EXAMINATION CERTIFICATE Nr

PAB Atex-certified centrifugal pumps

USER MANUAL FOR THE BULKHEAD LIGHT FITTING, TYPE /..

EU-Mexico Free Trade Agreement EU TEXTUAL PROPOSAL

TB range of empty sheet metal enclosures. R S Sindair K~'

Draft COMMISSION DECISION

Number: TEPEx.RS.067 Rev : 02 Date: Manufacturer General safety information s Purpose Degree of protection 2.

Operation & Maintenance Manual

THE NETHERLANDS (N E D E R L A N D) COMMUNICATION. Approval number: E4-3R Extension number: 00

Solenoid System. The coil is also in conformity with 94/9/EC ATEX for electrical apparatus of group II, category 3 (Ex na II 3 GD T4 or T5).

Resistance Thermometers Model TR217, with Spring-Loaded Probe Tip

TECHNICAL BULLETIN. Sandvik MB670 Bolter Miners

Control and Terminal Box Type A21-**-*****

Swing Check Valve AKR/AKRS. PN DN 80/80 bis 300/250 Pressure Seal Design Flanged/Butt Weld Ends. Type Series Booklet

EX-REPAIR AND MAINTENANCE RECEPTACLES

Operating Instructions

SFI SPECIFICATION 1.1 EFFECTIVE: NOVEMBER 9, 2001 *

maviroll A highly efficient roll-door solution for internal applications Beyond doors, a concept!

ILED Dorado. User Manual

TECHNICAL CERTIFICATE

Shut-off dampers. Type AK-Ex. For low-leakage shut-off of volume flows in potentially. explosive atmospheres (ATEX) PD AK-Ex 1.

Type AK-Ex FOR LOW-LEAKAGE SHUT-OFF OF VOLUME FLOWS IN POTENTIALLY EXPLOSIVE ATMOSPHERES (ATEX)

SFI SPECIFICATION 1.2 EFFECTIVE: FEBRUARY 9, 2006* PRODUCT: Multiple Disc Clutch Assemblies for Vehicles with Naturally Aspirated Engines

Technical Information

IECEx Certificate of Conformity

K - Flow Meter with Float

Body: Seat disc: Anod. aluminium body NBR. Connection / Orifice Flow factors Temperature values ( C)

SFI SPECIFICATION 1.3 EFFECTIVE: MAY 23, 2000 * PRODUCT: Nitro-Methane Drag Race Multiple Disc Clutch Assemblies

Attachments. Explosion-proof actuators. For opening and closing multileaf dampers installed in potentially explosive atmospheres (ATEX) 09/2017 DE/en

INSTALLATION AND SERVICE INSTRUCTIONS FOR 2000 SERIES FLAMEPROOF XENON AND FLUORESCENT BEACONS

Pumps and pumping units SL i & Micro C

ABB MEASUREMENT & ANALYTICS DATA SHEET. Series and Katharometer power supply units

ILED Aquarius Illuminated Windsock. User Manual

EVZ Series (Small body) Explosion protected luminaire Operating Instructions

ANNEX MOTOR VEHICLES AND EQUIPMENT AND PARTS THEREOF. Article 1. Definitions

Homepage > Products > External Louvres & Dampers > Multileaf dampers > Attachments > Type Explosion-proof actuators. Type Explosion-proof actuators

2000 Series Flameproof Xenon and Fluorescent Beacons Installation and Service Instructions

Approval mark PL HCR 1a A

PTV TECHNICAL PRESCRIPTIONS. ELASTOMERIC SEALS: Part 1: Vulcanized Rubber FOR. Impartial institute for the monitoring of construction products

POINT CIRCLE-H LIGHTS PTPS LED TOUCHDOWN & POSITIONING SYSTEM LIGHTED TD/PM CIRCLE & H MARKINGS

IQL Helios Area-/Streetlight. User Manual

1. Description Design Front panels - vanes setting Flow directions Dimensions and weights... 8

ISO 3679 INTERNATIONAL STANDARD. Determination of flash point Rapid equilibrium closed cup method

SERIES 670E End-of-Line Deflagration Flame Arrester

WBS 3000 Water Bottom Sensor for fuel oil and chemical storage tanks Installation and Operating Instructions

EF SERIES EFS ATEX VERSION (INCLUDES OPTIONAL S4A MOTOR & SPK) OPERATION & PARTS MANUAL

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS SOLAS LED Luminaire ATEX & IECEx

Flameproof Enclosures

GACHOT TYPE V16 BALL VALVES CARBON STEEL / FULL BORE / DN 8 TO DN 150

Resistance thermometer Model TR10-E, for additional thermowell

Official Journal of the European Union. (Non-legislative acts) REGULATIONS

MT/T Translated English of Chinese Standard: MT/T COAL INDUSTRY STANDARD

Tubular frames for piping group III (further as frames) are used to secure HVAC piping into walls and partitions.

ANNEX MOTOR VEHICLES AND MOTOR VEHICLES' PARTS. Article 1. General Provisions

SFI SPECIFICATION 35.1 EFFECTIVE: AUGUST 26, 2008 *

BALL VALVE DOUBLE BLOCK & BLEED design RSD BB type TRUNNION MOUNTED, ANTISTATIC,FIRE SAFE DESIGN API607,API6FA

Explosion proof electric motor For Fuel dispensing application. Main characteristic

Installation and Service Instructions for EX Series Explosion-proof Switches

Threaded Resistance Thermometers Model TR10-C, with Fabricated Thermowell Model TW35

CETOP POSITION PAPER PP 07

MANUAL FOR INSTALLATION AND OPERATING

Transcription:

Physical Technical Testing Institute Ostrava-Radvanice Type Examination Certificate Equipment Intended for use in Potentially Explosive Atmospheres Directive 94/9/EC (3) Type Examination Certificate Number:, FTZU 06 ATEX 0339X (4) Equipment: (5) Manufacturer: (6) Address: Control damper type RKM or RKTM, RKKM and RKKTM kircular including spiro design) MANDíK, a.s. Hostomice 555, 267 24 Hostomice, Czech Republic (7) This equipment or protective systemand any of acceptable variation thereto is specified in the schedule to this certificate and the documents therein referred to.. (8) The Physical Technical Testing Institute, ce.rtifies that this equipment or protective system has been found to comply with the Essential Health and Safety Requirements relating to the design and construction of Category 2 equipment, which is intended for use in potentially explosive atmospheres given in Annex II to the Council Dire~tive 94/9/EC. The examination and test results are recorded in cqnfidential Report N 06/0339 dated December 2006 (9) Compliance with Essential Health and safety requirements bas been assured by compliance with: EN 13463-1 :2001; EN 13463-5:L2003 (10) If the sign "X" is placed after the certificate number, it indicates lhat the equipment or protective system is subject to special conditions for safe use specified in the schedule to this certificate. (11) This TYPE EXAMINATION CERTIFICATE relates only to the design, exa~il!.ation and testing of the specified equipment or protective system in accordance to the directive 94/9/EC. Further requirements of the Directive apply to the manufacturing process~ and supply of this equipment or protective system. These are not covered by this certificate. (12) The marking of the equipment or protective system shall include following: @ II 2G c This Type Examination Certificate is valid till: 31.12. 2011... ~ Responsible perso~ Dipl. Ing. Šindler Jaroslav Head of certification body This certificate is granted subject to the general conditions of the Physical Technical Testing Institute. This certificate may only be reproduced in its entirety and without any change, schedule included. FTZÚ. Pikartská 7.71607 Ostrava Radvanice. tel +420 595 223 III. fax +420 596 232672. e-mail: ttzii@tlzii.cz

Physical Technical Testing Institute Ostrava-Radvanice (13) Schedule (14) Type Examination Certificate N FTZÚ 06 A TEX 0339X (15) Description of Equipment: The control dampers are regulating closures in pipelines of air conditioning. The control dampers are produced in circular and square series in sizes according to drawings. The construction is made of zinc-plated or stainless steel plate point welded. The dampers are produced in sealed (tight) or normal (untight) design. The regulation is usually carried out manually. The whole design of damper is interconnected and provided with earthing terminal. The possibly used explosionproof electrical apparatus is verified separately and doesn't form part of damper. (16) Report No.: 06/0339 14 + 2 pages (17) Special conditions for safe use: The explosion-proof electrical apparatus installed together with the control damper must comply the hazardous area classification according to 60079-10 outside and inside of control damper. (18) Essential Health and Safety Requirements: Covered by standards mentioned in (9) of this certificate. Responsible person: <=-- Date of issue: 22.12. 2006 ~ Dipl. Ing. Sindler Jaroslav Head of certification body Numberofpages:3 Page:28 This certificate is granted subject to the general conditions of the Physical Technical Testing Institute. This certificate may only be reproduced in its entirety and without any change, schedule included. FTlÚ. PikartskÚ 7. 716 07 Ostrava Radvanice. tel +420 595 223 III, fax +420 596 232 672. e-mail: fizu0)fizu.cz

Physical Technical Testing Institute Ostrava-Radvanice (13) Schedule (14) Type Examination Certificate N FTZÚ 06 A TEX 0338X (19) LIST OF DOCUMENTATION on 30.11.2005 Drawing No.0313-1102-xxx... aon on 07.12.2005 30.11.2005 11.12.2006 a Instruction for use No. 009 on 01.12.2006 Risk analysis No. 009 Page: 3/3 FTZÚ. Pikartská 7.71607 Ostrava Radvanice, tel +420 595 223 III. fax +420 596 232 672, e-mail: ItZU@ltZlI.CZ