LP 10 GENERATOR SPECIFICATION Power Rating (KVA) 10 Electric Power (KWe) 8 Rated Current (A) 14 No of Phases/Volts* 3/415 Dimensions (L X W X H, mm x mm x mm) 1760 x 900 x 1400 Fuel Tank Capacity (Litres) 250 Battery Capacity (AH) 99 System Voltage (VDC) 12 Weight (Kg) 750 Dry Weight (Engine-Kg) 220 ENGINE SPECIFICATION Engine Model AL485G1 Engine Max HP 24.8 Engine Rated HP 23.5 Aspiration Natural No of Cylinders 4 Bore & Stroke (mm x mm) 85*92 Displacement (Litres) 2.088 Compression Ratio 18:1 Fuels cons (Litre/hr)** 2.0 Lub oil Sumb Capacity (Litres) 8.5 Lub oil Consumption <0.15% Coolant Capacity (Litres) 6.0 Governing Class * Single Phase DG set is available optional from 10 KVA ** Fuel Consumption of Genset @75% of load is considering specific gravity of fuel 0.8355 at NTP condition, Tolerance will be +5% A1
ALTERNATOR SPECIFICATION Model Type Exciter type Voltage regulator Insulation PI 044E 4 pole Brushless AVR-AS480 Class H Temperature rise (ºC) 125 Bearing ±Single Voltage regulation ±0.5% Rated Voltage (V) 415 SPECIFICATION FOR STANDARD MANUAL PANEL 3pole MCB / MCCB Lube Oil Pressure Analogue Gauge Battery Charging Ammeter Running-Hour Counter Digital Multifunction meter Fault Indication (LED Type on Engine safety Unit) Voltage/Ampere/Frequency Low Oil pressure Battery Charger Failure High Engine Temperature Low fuel level Current Transformers of suitable rating Indications (LED): DG ON
Control Key switch for Start/Stop SPECIFICATION FOR STANDARD AMF PANEL 4 Pole Contactor for DG 4 Pole Contactor for MAINS MCB / MCCB for short circuit protection Monitoring of engine protection Alphanumeric LCD Display Supervision of Mains and DG voltage Mains and DG contactor interlock Features Provision for Remote start / stop Parameter setting by front panel key board Auto / Manual mode operation Programmable parameters / timers Voltage Multifunction meter Ampere Frequency Oil pressure Analogue meter Mains On Indication Lamps DG On Load on Mains
SMPS based battery charger with float boost charging. Manual mode controls DG start DG stop Load transfer POWER RATING Power rating as per Standard reference condition as per BS 5514/ISO 3046/ISO 8528 Reference condition (Dec C Ambient Temp) 27 Atmospheric Condition (KPA-750mm of Hg) 100 Humidity 60% - As per IS10002, ISO 3046 LP 15 GENERATOR SPECIFICATION Power Rating (KVA) 15 Electric Power (KWe) 12 Rated Current (A) 21 No of Phases/Volts* 3/415 Dimensions (L X W X H, mm x mm x mm) 1760 x 900 x 1400 Fuel Tank Capacity (Litres) 250 Battery Capacity (AH) 99 System Voltage (VDC) 12 Weight (Kg) 810 Dry Weight (Engine-Kg) 220 ENGINE SPECIFICATION Engine Model AL485G1 Engine Max HP 24.8 Engine Rated HP 23.5 Aspiration Natural
No of Cylinders 4 LP 15Bore & Stroke (mm x mm) 85*92 Displacement (Litres) 2.088 Compression Ratio 18:1 Fuels cons (Litre/hr)** 2.5 LP 15Lub oil Sumb Capacity (Litres) 8.5 Lub oil Consumption <0.15% Coolant Capacity (Litres) 6.0 Governing Class * Single Phase DG set is available optional from 10 KVA ** Fuel Consumption of Genset @75% of load is considering specific gravity of fuel 0.8355 at NTP condition, Tolerance will be +5% A1 ALTERNATOR SPECIFICATION Model Type Exciter typelp 15 Voltage regulator Insulation PI 044G 4 pole Brushless AVR-AS480 Class H Temperature rise (ºC) 125 Bearing ±Single Voltage regulation ±0.5% Rated Voltage (V) 415 SPECIFICATION FOR STANDARD MANUAL PANEL 3pole MCB / MCCB Analogue Gauge Lube Oil Pressure
Battery Charging Ammeter Running-Hour Counter Digital Multifunction meter Fault Indication (LED Type on Engine safety Unit) Voltage/Ampere/Frequency Low Oil pressure Battery Charger Failure High Engine Temperature Low fuel level Current Transformers of suitable rating Indications (LED): Control DG ON Key switch for Start/Stop SPECIFICATION FOR STANDARD AMF PANEL 4 Pole Contactor for DG 4 Pole Contactor for MAINS MCB / MCCB for short circuit protection Monitoring of engine protection Alphanumeric LCD Display Supervision of Mains and DG voltage Mains and DG contactor interlock Features Provision for Remote start / stop Parameter setting by front panel key board Auto / Manual mode operation Programmable parameters / timers
Voltage Multifunction meter Ampere Frequency Oil pressure Analogue meter Mains On Indication Lamps DG On Load on Mains SMPS based battery charger with float boost charging. Manual mode controls DG start DG stop Load transfer POWER RATING Power rating as per Standard reference condition as per BS 5514/ISO 3046/ISO 8528 Reference condition (Dec C Ambient Temp) 27 Atmospheric Condition (KPA-750mm of Hg) 100 Humidity 60% - As per IS10002, ISO 3046 LP 20 GENERATOR SPECIFICATION Power Rating (KVA) 20 Electric Power (KWe) 16 Rated Current (A) 28 No of Phases/Volts* 3/415
Dimensions (L X W X H, mm x mm x mm) 2100 x 950 x 1400 Fuel Tank Capacity (Litres) 250 Battery Capacity (AH) 99 System Voltage (VDC) 12 Weight (Kg) 900 Dry Weight (Engine-Kg) 220 ENGINE SPECIFICATION Engine Model AL485TG2 Engine Max HP 31.5 Engine Rated HP 29.5 Aspiration Natural No of Cylinders 4 Bore & Stroke (mm x mm) 85*92 Displacement (Litres) 2.088 Compression Ratio 18:1 Fuels cons (Litre/hr)** 3.4 Lub oil Sumb Capacity (Litres) 8.5 Lub oil Consumption <0.3% Coolant Capacity (Litres) 6.0 Governing Class * Single Phase DG set is available optional from 10 KVA ** Fuel Consumption of Genset @75% of load is considering specific gravity of fuel 0.8355 at NTP condition, Tolerance will be +5% A1 ALTERNATOR SPECIFICATION Model Type Exciter type Voltage regulator PI144D1 4 pole Brushless AVR-AS480
Insulation Class H Temperature rise (ºC) 125 Bearing ±Single Voltage regulation ±0.5% Rated Voltage (V) 415 SPECIFICATION FOR STANDARD MANUAL PANEL 3pole MCB / MCCB Lube Oil Pressure Analogue Gauge Battery Charging Ammeter Running-Hour Counter Digital Multifunction meter Fault Indication (LED Type on Engine safety Unit) Voltage/Ampere/Frequency Low Oil pressure Battery Charger Failure High Engine Temperature Low fuel level Current Transformers of suitable rating Indications (LED): Control DG ON Key switch for Start/Stop SPECIFICATION FOR STANDARD AMF PANEL 4 Pole Contactor for DG 4 Pole Contactor for MAINS
MCB / MCCB for short circuit protection Monitoring of engine protection Alphanumeric LCD Display Supervision of Mains and DG voltage Mains and DG contactor interlock Features Provision for Remote start / stop Parameter setting by front panel key board Auto / Manual mode operation Programmable parameters / timers Voltage Multifunction meter Ampere Frequency Oil pressure Analogue meter Mains On Indication Lamps DG On Load on Mains SMPS based battery charger with float boost charging. Manual mode controls DG start DG stop Load transfer POWER RATING
Power rating as per Standard reference condition as per BS 5514/ISO 3046/ISO 8528 Reference condition (Dec C Ambient Temp) 27 Atmospheric Condition (KPA -750mm of Hg) 100 Humidity 60% - As per IS10002, ISO 3046 LP 25 GENERATOR SPECIFICATION Power Rating (KVA) 25 Electric Power (KWe) 20 Rated Current (A) 35 No of Phases/Volts* 3/415 Dimensions (L X W X H, mm x mm x mm) 2100 x 950 x 1400 Fuel Tank Capacity (Litres) 250 Battery Capacity (AH) 99 System Voltage (VDC) 12 Weight (Kg) 955 Dry Weight (Engine-Kg) 220 ENGINE SPECIFICATION Engine Model AL485TAG3 Engine Max HP 36.9 Engine Rated HP 34.9 Aspiration Natural No of Cylinders 4 Bore & Stroke (mm x mm) 85*92 Displacement (Litres) 2.088 Compression Ratio 18:1 Fuels cons (Litre/hr)** 3.9 Lub oil Sumb Capacity (Litres) 8.5
Lub oil Consumption <0.3% Coolant Capacity (Litres) 9.0 Governing Class * Single Phase DG set is available optional from 10 KVA ** Fuel Consumption of Genset @75% of load is considering specific gravity of fuel 0.8355 at NTP condition, Tolerance will be +5% A1 ALTERNATOR SPECIFICATION Model Type Exciter type Voltage regulator Insulation PI144E1 4 pole Brushless AVR-AS480 Class H Temperature rise (ºC) 125 Bearing ±Single Voltage regulation ±0.5% Rated Voltage (V) 415 SPECIFICATION FOR STANDARD MANUAL PANEL 3pole MCB / MCCB Lube Oil Pressure Analogue Gauge Battery Charging Ammeter Running-Hour Counter Digital Multifunction meter Voltage/Ampere/Frequency Fault Indication (LED Type on Engine safety Unit) Low Oil pressure Battery Charger Failure
High Engine Temperature Low fuel level Current Transformers of suitable rating Indications (LED): Control DG ON Key switch for Start/Stop SPECIFICATION FOR STANDARD AMF PANEL 4 Pole Contactor for DG 4 Pole Contactor for MAINS MCB / MCCB for short circuit protection Monitoring of engine protection Alphanumeric LCD Display Supervision of Mains and DG voltage Mains and DG contactor interlock Features Provision for Remote start / stop Parameter setting by front panel key board Auto / Manual mode operation Programmable parameters / timers Voltage Multifunction meter Ampere Frequency Analogue meter Oil pressure
Mains On Indication Lamps DG On Load on Mains SMPS based battery charger with float boost charging. Manual mode controls DG start DG stop Load transfer POWER RATING Power rating as per Standard reference condition as per BS 5514/ISO 3046/ISO 8528 Reference condition (Dec C Ambient Temp) 27 Atmospheric Condition (KPA -750mm of Hg) 100 Humidity 60% - As per IS10002, ISO 3046 LP 30 GENERATOR SPECIFICATION Power Rating (KVA) 30 Electric Power (KWe) 24 Rated Current (A) 42 No of Phases/Volts* 3/415 Dimensions (L X W X H, mm x mm x mm) 2150 x 1050 x 1670 Fuel Tank Capacity (Litres) 250 Battery Capacity (AH) 99 System Voltage (VDC) 12 Weight (Kg) 1050 Dry Weight (Engine-Kg) 370
ENGINE SPECIFICATION Engine Model AL4102G1 Engine Max HP 48.3 Engine Rated HP 44.6 Aspiration Natural No of Cylinders 4 Bore & Stroke (mm x mm) 102*118 Displacement (Litres) 3.857 Compression Ratio 17.5:1 Fuels cons (Litre/hr)** 4.5 Lub oil Sumb Capacity (Litres) 8.5 Lub oil Consumption <0.15% Coolant Capacity (Litres) 11.0 Governing Class * Single Phase DG set is available optional from 10 KVA ** Fuel Consumption of Genset @75% of load is considering specific gravity of fuel 0.8355 at NTP condition, Tolerance will be +5% A1 ALTERNATOR SPECIFICATION Model Type Exciter type Voltage regulator Insulation PI144G1 4 pole Brushless AVR-AS480 Class H Temperature rise (ºC) 125 Bearing ±Single Voltage regulation ±0.5% Rated Voltage (V) 415 SPECIFICATION FOR STANDARD MANUAL PANEL
3pole MCB / MCCB Lube Oil Pressure Analogue Gauge Battery Charging Ammeter Running-Hour Counter Digital Multifunction meter Fault Indication (LED Type on Engine safety Unit) Voltage/Ampere/Frequency Low Oil pressure Battery Charger Failure High Engine Temperature Low fuel level Current Transformers of suitable rating Indications (LED): Control DG ON Key switch for Start/Stop SPECIFICATION FOR STANDARD AMF PANEL 4 Pole Contactor for DG 4 Pole Contactor for MAINS MCB / MCCB for short circuit protection Features Monitoring of engine protection Alphanumeric LCD Display Supervision of Mains and DG voltage Mains and DG contactor interlock
Provision for Remote start / stop Parameter setting by front panel key board Auto / Manual mode operation Programmable parameters / timers Voltage Multifunction meter Ampere Frequency Oil pressure Analogue meter Mains On Indication Lamps DG On Load on Mains SMPS based battery charger with float boost charging. Manual mode controls DG start DG stop Load transfer POWER RATING Power rating as per Standard reference condition as per BS 5514/ISO 3046/ISO 8528 Reference condition (Dec C Ambient Temp) 27 Atmospheric Condition (KPA -750mm of Hg) 100 Humidity 60% - As per IS10002, ISO 3046