Handy, robust and mobile: Indispensable for the vehicle check
Tire valve activator On the safe side with testing technology from Bosch Successful Service depends on correct values. Using efficient testing technology, the test on the vehicle quickly provides meaningful results. For mobile check and exact setting of core vehicle system functions, Bosch Diagnostics, with its robust small tester range, offers the workshop particularly handy and reliable solutions. Timesaving tire valve activator for Schrader systems On vehicles with tire pressure monitoring, the KTS diagnostics tester and the tire valve activator can be used to very quickly assign the wheels in the control unit. This assignment is always necessary for tire valves with a Schrader system. The time expended for activation of the tire valves and detection at the KTS is a maximum of 8s/wheel. Without the tire valve activator, the time required for manual sensor detection and assignment at the KTS, on the other hand, can be up to 15 min/wheel. Equipment supplied Tire valve activator, 9 V battery, packaging, operating instructions Order number 1 687 200 663 "Testers from Bosch impress with their reliability and sound workmanship."
Pocket sensor ETZ 003.09 Stroboscopic lamp ETZ 005.01 Handy pocket sensor for better performance and longer service life Correct ignition timing has a crucial influence on the engine fuel consumption, power and service life. Order number 0 684 101 309 Indispensable stroboscopic lamp with Xenon flash lamp for dynamic ignition adjustment For effective measurement and checking of Basic setting of the ignition distributor Advance angle Centrifugal advance Vacuum advance mechanism Order number 0 684 101 501 Xenon light Housing a visible light flash even in bright room sturdy plastic, insensitive to engine oil and fuel Power supply Weight Cable length Vehicle electrical system 6 V and 12 V 0.75 kg 1.5 m Cable 1.5 m Weight 0.5 kg Clip-on sensor can be clamped over the ignition cable in any desired form; independent of direction.
Volt-ampère tester ETT 011.00 Versatile tester for starter and alternator checks Robust and suitable for the workshop Large, easily readable analog displays Easy to operate Built-in load resistance Self-contained Two units in one: V-A tester and load resistor To trace faults in the vehicle electrical system, it must be possible to measure current (A) and voltage (V) and the specified regulated voltage (V) of alternators and regulator cutouts. The ETT 011.00 combines the necessary test functions in a single unit. So easy to test with the ETT 011.00 The unit is connected by clips and clamp-on probes; complex releasing of cables is no longer required. The load resistor steplessly regulates the exactly defined load of DC and three-phase current alternators and controllers. Equipment supplied Connecting cable for voltage measurement (3 m), connecting cable with current clamp-on probe (3 m), 2 connecting cables for current measuring circuit and for load resistor (3 m), wire basket for cables Order number 0 684 101 100 V-A tester with load resistor ETT 011.00 Power supply 6, 12, 24 V 3 voltage measurement ranges 0... 3.2 V 0... 16 V 0... 32 V 3 current measurement ranges 5... 0... + 50 A 10... 0... + 100 A 100... 0... + 1000 A Dimensions of tester W x H x D 294 x 160 x 200 mm Dimensions of wire basket W x H x D 100 x 160 x 195 mm Weight 6.5 kg
Lambda closed-loop control tester ETT 018.10 Pressure-loss tester EFAW 210 A Reliable control tester for setting and testing the lambda closed-loop control on Jetronic/Motronic systems Measurement of the pulse duty factor on K-, KE-Jetronic, LFR systems and Ecotronic, the integrator voltage on L-, LU-, LH- and L3-Jetronic, of the lambda sensor signal and of the KE-Jetronic actuator current, lambda closed-loop control simulation, cordless Equipment supplied Lambda control tester, connecting cable, adapter cable (6.3 mm blade terminal) Special accessories Various adapter cables for sensor plug connections Tester for localization of pressure loss in internalcombustion engines With the Bosch pressure-loss tester, the fault is localized quickly and precisely and the exact cause determined. Equipment supplied Pressure-loss tester EFAW 210 A, high-pressure test hose, crankshaft-tdc detector, test nozzle for adjusting the tester Special accessories Various adapters for plug connections Order number 0 681 001 901 Order number 0 684 101 810 Dimensions (W x H x D) 147 x 160 x 200 mm Weight 1.8 kg Power supply via vehicle battery Measurement type Measuring ranges Resolution Voltage 0... 12 V 0.1 V measurement 0... 1.2 V 0.01 V Pulse duty factor 0... 50% 1% measurement 0... 100% 2% Current measurement 20... +20 ma 1 ma Housing impact-resistant rubber jacket Dimensions (WxHxD) 300 x 130 x 130 mm Measuring range 0 100 % pressure loss Application for all reciprocating piston and rotary piston engines Scale 270 Required air pressure min. 4 bar (water separator in compressed-air system)
Digital multimeter MMD 301 and MMD 302 Universal digital multimeter for numerous measuring types Equipment supplied MMD 301 Basic device, test cable with test probes (red/black), fine-wire fuse Equipment supplied MMD 302 Basic device, test cable with test probes, connection clips, rubber protective cap with stand, two dry cells (fitted) Order number MMD 301 0 684 500 301 MMD 302 0 684 500 302 MMD 301 and MMD 302 MMD 301 MMD 302 Direct and alternating voltage measurement yes yes Direct and alternating current measurement yes yes Resistance measurement yes yes Acoustic continuity test yes yes Diode check yes yes Capacitor check --- yes Frequency measurement --- yes Automatic measurement range switchover --- yes MIN/MAX operating mode, recording and saving minimum and maximum measured values --- yes RELD operating mode, display of difference between current and stored measured values --- yes HOLD function to,freeze the display --- yes Separately fused 10 A measurement input --- yes Dimensions (W x H x D) 140 x 70 x 30 mm 200 x 98 x 52 mm Weight 250 g 250 g
Our knowledge, your success. Bosch Diagnostics Diagnostics the key to the automotive workshop of the future. Motor vehicle systems are becoming increasingly complex; the demands placed on qualified diagnosis in workshops are rising. For professional service on modern vehicles, Bosch provides everything at one stop, perfectly coordinated: test technology, software, technical training and hotline, supplemented by parts in initial equipment quality. ESI[tronic] Software for Test technology matched Service training Technical hotline diagnostics and service to each workshop type knowledge as a factor support from the system Simple operation Optimized combination of for success developer Rapid access hardware and software for Comprehensive training Support in difficult Modular structure rapid troubleshooting, programme for auto- technical situations Comprehensive market qualified repair and high motive workshops Skills covering all brands coverage time savings Practical training and manufacturers Continually updated PC-based, test technology courses Universal operation re- of the latest generation Highly qualified trainers gardless of manufacturer with extendable modules with a great deal of practical experience
Bosch skilled partner for workshop business ECU Diagnostics KTS AA-DG/MKT2 WAW 4553 GB 11.05 The right to make changes of a technical nature and to alter the range on offer is reserved. Developments from Bosch stand for innovative progress in automobile manufacturing Geared to the growing proportion of electronics in the vehicle, Bosch offers workshops the suitable test technology for all sizes of company and service concepts. Sturdy, innovative, state-of-the-art automobile technology: computer-assisted diagnosis systems help in finding any fault more quickly and more reliably. The modular layout using future-oriented technologies enables broad networking and efficient use of comprehensive information from the ESI[tronic] software. Mobility and user-friendly user guidance support the workshop in reliable and timesaving diagnosis. Engine System Testing FSA Emission Analysis BEA Dieselsystemprüfung EPS Battery Service BAT Brake Testing BSA Where to find Original Bosch Quality: Wheel Alignment FWA Air Conditioning Service ACS Robert Bosch GmbH Automotive Aftermarket D-76227 Karlsruhe I www.bosch-diagnostics.de