Owner s Manual & Safety Instructions

Similar documents
6 OFF ROAD LIGHT BAR

Component Size Weight Capacity

Owner s Manual & Safety Instructions

PUSH BUTTON KEY CABINET

Installation Precautions. Use Precautions. Specifications

Owner s Manual & Safety Instructions

Swing Arm Magnifying Lamp

CAMBELT TENSION GAUGE

Table of Contents. Safety... 2 Specifications... 3 Setup Parts List and Diagram Warranty Operation Maintenance

4 in 1 solar bird bath

Owner s Manual & Safety Instructions

1250 LB. CAPACITY MECHANICAL WHEEL DOLLY

Owner s Manual & Safety Instructions

p.t.o. Slip clutch Read this material before using this product. Failure to do so can result in serious injury. Save this manual.

25 GALLON PORTABLE OIL LIFT

Manual Operated Floor Jack

IMPORTANT SAFETY INFORMATION

SIDE-WIND, A-FRAME TRAILER JACK. Model Due to continuing improvements, actual product may differ slightly from the product described herein.

IMPORTANT SAFETY INFORMATION

Rio color changing solar light

Automatic Emergency Light

Owner s Manual & Safety Instructions

DISC BRAKE CALIPER TOOL SET

360 Watt Charge Controller

Manual Operated Floor Jack

Welding Clips. Model Due to continuing improvements, actual product may differ slightly from the product described herein.

1200W Paint DRYING Lamp

3 PC. SOLAR GARDEN LIGHT SET 92686

SPECIFICATIONS GENERAL SAFETY RULES PERSONAL SAFETY. Save This Manual TOOL USE AND CARE WORK AREA

will result in death or serious injury. could result in death or serious injury. Indicates a hazardous situation which, if not avoided,

IMPORTANT SAFETY INFORMATION

2 PIECE SOLAR LIGHT SET 93886

SUBMERSIBLE MINI-PUMP

Specifications. Important Safety Information

Model Due to continuing improvements, actual product may differ slightly from the product described herein.

SUBMERSIBLE PUMP. Model ASSEMBLY AND OPERATING INSTRUCTIONS

Solar mosquito killer

MINI AIR ANGLE DIE GRINDER

Owner s Manual & Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS

RECHARGEABLE 24 LED WORK LIGHT

flexible infrared thermometer

ANGLE DIE GRINDER KIT

rechargeable umbrella light

TURTLE SOLAR LIGHT 94412

For technical questions and replacement parts, please call

1000 Lb. Motorcycle Lift

Digital Auto Multi-Tester

POLISHER KIT Model 95030

Square Solar Garden Light 95706

SUBMERSIBLE POND PUMP

MOTORCYCLE LIFT AIR OPERATED - 1,200 LB. CAPACITY. Model ASSEMBLY AND OPERATING INSTRUCTIONS. Visit our website at:

Owner s Manual & Safety Instructions

Owner s Manual & Safety Instructions

1/2 Ton - 2 Stage Transmission Jack

BATTERY CHARGER WITH LCD DISPLAY

2 line price marking gun

TRAILER SPRAYER 25 GALLON WITH TRAILER

2,000 LB. REMOTE CONTROL UTILITY ELECTRIC WINCH

4 color Solar light. Model Due to continuing improvements, actual product may differ slightly from the product described herein.

BEARING ADAPTERS FWD/FRONT WHEEL. Model 45210

MOUNTABLE WALL SINK ASSEMBLY AND OPERATING INSTRUCTIONS

AIR COMPRESSOR 2 HP - 8 GALLON

Propane torch. Model Assembly And Operation Instructions

MOTORCYCLE LIFT RAMP

ELECTRIC PLATFORM SCALE

Owner s Manual & Safety Instructions

LUBRICATOR ASSEMBLY AND OPERATING INSTRUCTIONS Mission Oaks Blvd., Camarillo, CA Visit our Web site at

4 TIER STOCKER SERVICE CART

WOODEN SIDE PANEL KIT

MINIATURE ALUMINUM JACK STANDS (1 PAIR) Model 90892

HYDRAULIC SPRING COMPRESSOR SET

Owner s Manual & Safety Instructions

Owner s Manual & Safety Instructions

STEEL SIDE PANEL KIT. Model (FOR USE WITH MODEL FOLDABLE UTILITY TRAILER)

EIGHT GALLON PSI AIR COMPRESSOR

WHEEL KIT FOR 13 HP GENERATOR

4 AIR ANGLE GRINDER. Model ASSEMBLY AND OPERATING INSTRUCTIONS. Visit our website at:

Bucket Grease Pump ASSEMBLY AND OPERATING INSTRUCTIONS

PISTOL SHAPE SPOTLIGHT 500,000 CANDLE POWER ASSEMBLY & OPERATING INSTRUCTIONS Mission Oaks Blvd., Camarillo, CA 93011

WINDSHIELD REMOVAL KIT

PROPANE TORCH WITH TURBO BURNER

AIRPLANE. Model Set up and Operating Instructions. Visit our website at:

3-1/2 Digit LCD Multimeter with Tachometer Kit

Swing Back Trailer Jack

14.4 CORDLESS DRILL ASSEMBLY AND OPERATING INSTRUCTIONS

Owner s Manual & Safety Instructions

ELECTRIC LONG SHAFT DIE GRINDER 44141

Owner s Manual & Safety Instructions

ALUMINUM JACK. 3,000 lb. Jack Capacity & JACK STAND COMBO. Model ASSEMBLY AND OPERATING INSTRUCTIONS

SUBMERSIBLE DIRTY WATER PUMP

Owner s Manual & Safety Instructions

PNEUMATIC GARDEN STOOL

BATTERY OPERATED BI-PLANE

CORDLESS POWER SHEAR 19.2 volts 99735

2 GALLON COOLANT PUMP

4.8 VOLT RECHARGEABLE CORDLESS SCREWDRIVER

4-WHEEL CART ASSEMBLY INSTRUCTIONS Mission Oaks Blvd., Camarillo, CA Visit our Web site at

UTILITY WAGON WITH 1000 LB. CAPACITY

ELECTRIC HYDRAULIC GEAR PUMP

Transcription:

Owner s Manual & Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference. Visit our website at: http://www.harborfreight.com Email our technical support at: tech@harborfreight.com ITEM 95588 When unpacking, make sure that the product is intact and undamaged. If any parts are missing or broken, please call 1-800-444-3353 as soon as possible. Copyright 2006 by Harbor Freight Tools. All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included. Read this material before using this product. Failure to do so can result in serious injury. Save this manual.

Specifications Solar panel Battery Type Battery Rating Running time when fully charged Monocrystalline Silicon AA NiCd rechargeable 300mAh 8 hours Important Safety Information 1. Assemble only according to these instructions. Improper assembly can create hazards. 2. Wear ANSI-approved safety goggles during assembly. 3. Keep assembly area clean and well lit. 4. Keep bystanders out of the area during assembly. 5. Do not assemble when tired or when under the influence of drugs or medication. 6. Position battery in proper polarity and do not install batteries of different types, charge levels, or capacities together. 7. WARNING: The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (California Health & Safety code 25249.5, et seq.) 8. This product is not a toy. Do not allow children to play with or near this item. 9. Use as intended only. 10. Inspect before every use; do not use if parts are loose or damaged. 11. Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement. Page 2 For technical questions, please call 1-800-444-3353. Item 95588

Assembly Instructions Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product. Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. Assembly 1. Unthread the two screws on the battery cover and remove the battery cover. 2. Insert the AA battery into the battery housing paying attention to the polarity. 3. Replace the Battery cover and secure with the screws. 4. Set one of the Decorative LED Shapes (2) onto the Top Tube (3). Slide the Top Tube (3), into the Bottom Tube (4). Slide the Stake (5) onto the Bottom Tube (4). 5. Repeat steps 1-3 for the other two light sets. Functions Decorative LED Shape (2) Top Tube (3) Battery Cover (9) (On back of Solar Panel) Solar Panel (1) Power Switch (7) (On back of Solar Panel) Bottom Tube (4) Stake (5) Figure A Item 95588 For technical questions, please call 1-800-444-3353. Page 3

Operating Instructions Tool Set Up Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. 1. Decide where you want to place the Solar Light Set. Choose a location that receives full, direct sunlight a minimum of six hours a day. The location should not be near nighttime light sources such as porch lights or streetlights as this will cause the Solar Light Set to remain off. Note: During the day, the Solar Panel converts sunlight into electricity, recharging the battery. The amount of light the Solar Panel receives depends on placement of the Solar Light, geographic location and weather. If the weather is cloudy and the panel did not receive a full charge, the Solar Garden Light may not achieve the full hours of operating time. It will catch up on its own after two to three days of full sun. 2. Make certain that the path of the Stake (5) is clear of lines, cables and conduits. 3. Push the Stake (5) directly into the ground. Charging 1. The Solar Light Set will need to charge for at least twelve hours before using it for the first time. 2. Set the Power Switch to Off. 3. Allow to charge for two sunny days before use. General Operating Instructions 1. Move the Power Switch to Auto to activate the Solar Light. 2. The Light will automatically turn ON during the night. After the initial charge is set, check to see that the Light (2) is on by viewing the light at night or in a dark location. If the Light (2) is not lit, check the position of the Auto Switch and check that the Solar Panel has had full sunlight for 6 to 12 hours.

Maintenance Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product. To prevent serious injury from tool failure: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. 1. Clean regularly with a damp towel. Do not use any type of solvent for cleaning. Do not put too much pressure on the Light, Solar Panel or accessories while cleaning. Dry thoroughly. 2. WARNING! Make sure the Auto/ Off Switch is in its OFF position before performing any inspection, maintenance, or cleaning procedures. 3. BEFORE EACH USE, inspect the general condition of the tool. Check for: leaking, swollen, or cracked battery, loose hardware, misalignment or binding of parts, cracked or broken parts, and any other condition that may affect its safe operation. 4. After Use, wipe external surfaces of the tool with clean cloth. 5. Replace the battery every 12 months. a. Unscrew the screws holding the Battery Cover (9) in place and remove the Battery Cover from the Solar Panel (1). b. Remove the old battery. c. NiCd BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. Do not short, incinerate or open battery. d. Install a new NiCd AA, 300mAh battery into the Battery Compartment. Check that the battery is placed according to the correct polarity. e. Replace the cover and secure in place with the Screws. Troubleshooting Problem Possible Causes Probable Solutions Light will not turn on 1. Auto/Off Switch (7) not set to Auto. 2. Battery not allowed time for recharging via Solar Panel. 3. Solar Light is set near nighttime light sources such as porch lights or street lights. 4. Solar Panel is dirty and covered with dirt or dust. 1. Check position of Auto/Off Switch. 2. Check that Solar Panel has direct access to sunlight. Allow one to two days for a full charge. 3. Move Solar Light or change Solar Panel position. 4. Clean Solar Panel with a soft cloth. Item 95588 For technical questions, please call 1-800-444-3353. Page 5

PLEASE READ THE FOLLOWING CAREFULLY The manufacturer and/or distributor has provided the parts list and assembly diagram in this document as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto. Page 6 For technical questions, please call 1-800-444-3353. Item 95588

Parts List and Diagram Part Description Qty 1 Solar Panel 3 2 Decorative LED Shape 3 3 Top Tube 3 4 Bottom Tube 3 5 Stake 3 Part Description Qty 6 Battery 3 7 Power Switch 3 8 Screw 6 9 Battery Cover 3 4 5 3 7 1 9 6 2 8 Record Serial Number Here: Note: If product has no serial number, record month and year of purchase instead. Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Item 95588 For technical questions, please call 1-800-444-3353. Page 7

Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase. This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper installation, normal wear and tear, or to lack of maintenance. We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. This warranty is expressly in lieu of all other warranties, express or implied, including the warranties of merchantability and fitness. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise. If our inspection verifies the defect, we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will return repaired products at our expense, but if we determine there is no defect, or that the defect resulted from causes not within the scope of our warranty, then you must bear the cost of returning the product. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 (800) 444-3353 Page 8 For technical questions, please call 1-800-444-3353. Item 95588