Removing and installing or replacing interior rearview mirror.

Similar documents
1 of 2 5/17/17, 1:22 PM

- MK7 Mirror Integration Kit - Installation Instructions

Removing and installing trim panel

Removing and installing moulded headliner

Rear seat. Rear seat, removing and installing. - Using screwdriver -2-, carefully lift headrest guides -3- out of rear backrest -1-.

Removing and installing/replacing all pistons (S54)

Dismantling and assembling automatic transmission (A5S560Z) (transmission removed)

The steering column is only available as a complete unit, without steering lock housing, as a replacement part.

All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabet code below.

Part Number: PT

TOYOTA Yaris Hatchback EC REARVIEW MIRROR Preparation

Toyota Yaris 2015 Frameless EC Mirror w/ Compass & HomeLink

American Honda Motor Co., Inc. Page 1 of 11

Toyota Prius C 2015 Frameless EC Mirror w/ Compass & HomeLink

How to remove and replace the Foonf/Fllo fabric

2006 Saturn Ion ACCESSORIES & EQUIPMENT Doors - Ion

Removing and installing front windscreen

Special tools required:

Remote engine start INSTALLATION INSTRUCTIONS

Telescopic Cover Support

GENUINE PARTS INSTALLATION INSTRUCTIONS

SCION xb EC REARVIEW MIRROR Preparation

TOYOTA COROLLA EC REARVIEW MIRROR Preparation

Generator, removing and

Convertible roof. Hall sensor, replacing. Preparatory work. Chapter title Header text. Positioning the hall sensor

Installation instructions, accessories - Bluetooth XC / Volvo Car Corporation Göteborg, Sweden

Installation instructions, accessories TV NTSC/PAL

GENUINE PARTS INSTALLATION INSTRUCTIONS

SECTION 9P DOORS CAUTION:

Replacing safety battery terminal (SBK)

2003 Chevrolet Blazer

* * APPLICABLE MODELS: 2014 > Mazda 3

Soumatrix speakers installation guide

Brake Shoe: Service and Repair Removal Procedure

Special tools required:

* * APPLICABLE MODELS: 2014 > Mazda 6

Rear trunk floor panel, complete

12V Chevrolet Silverado (W461-C) 12V GMC Sierra Denali (W461-G) Customer Service Guide

Audi > Q7 > Electrical Equipment 27 - Removal and Installation. Battery. Special tools, testers and auxiliary items required

* * APPLICABLE MODELS: 2017 > CX-5

Trim (general) Lower A-pillar trim, removing and installing

Disassembly. 1 Pull off the QUIK-LOK cable from the machine.

Jazzy 1122 Wheelchair Trainer: Owner s Manual

2011 Mercedes-Benz C350 Sport

INSTALLATION INSTRUCTIONS

57-1. Front door. Tools. Special tools and equipment. T Socket 3320/2 Bit insert for Socket T Assembly tool

1998 Chevy Truck S10/T10 P/U 2WD V6-4.3L VIN X Copyright 2013, ALLDATA 10.52SS Page 1

GENUINE FOG LIGHT BEZEL

Telescopic Cover Support

Removing and installing light switch unit

Replacing seal for slide/tilt sunroof frame

SCION xb AUTO-DIMMING MIRROR Preparation

TOYOTA SOLARA EC REARVIEW MIRROR Section I - Installation Preparation

Direct Shift Gearbox (DSG) Mechatronic unit J743, removing and installing. - Loosen bolts - arrows - of oil pan - A - in diagonal sequence and remove.

Soumatrix speakers installation guide

ALLDATA Online Dodge Truck RAM 1500 Truck 4WD V8-5.7L - Service and R... Page 1 of 10. Service and Repair

w w w. h d o n l i n e s h o p. d e VRSC TURN SIGNAL RELOCATION KIT GENERAL INSTALLATION -J03341 REV Kit Number Models

Volkswagen New Beetle Body - Exterior 64 Glass, Window regulators (Page GR-64)

Operating Instructions AC/Rechargeable Professional Hair Clipper

VRX938R 1. BEFORE STARTING 2. PACKAGE CONTENTS. English. Contents

Outside Rear View Mirror, Remove and Install

INSTALLATION INSTRUCTIONS

Remote engine start INSTALLATION INSTRUCTIONS

Hood. Hood, removing, installing and adjusting. Page 1 of 11

2003 Volkswagen Passat GL

2006 MINI Cooper SUSPENSION Wheels & Tires - Repair Instructions - Cooper (1.6L) R50/W10 & Cooper S

Child Safety ! WARNING: GENERAL SAFETY INFORMATION

TOYOTA RAV4/HV INTERIOR LIGHT KIT Preparation

Installation instructions, accessories RTI S80

GENUINE PARTS INSTALLATION INSTRUCTIONS

MANUAL FOR THE NM100 ADJUSTABLE SHORT SHIFTER

INSTALLATION INSTRUCTIONS

AR68.20-P-2150CW Disassemble/assemble center console

22-1 GROUP 22 MANUAL TRANSAXLE CONTENTS MANUAL TRANSAXLE... 22A MANUAL TRANSAXLE OVERHAUL... 22B

Service Manual Large Hi-Low MPS Date Code: 06/15 (Location under seat pan) Date Code

GENUINE Interior Lighting Kit

Take off case cover.

* * APPLICABLE MODELS: 2016 > CX-3

GENUINE ACCESSORIES INSTALLATION INSTRUCTIONS. ITEM QTY DESCRIPTION Usage Chart Service Part Number. 1 1 Mirror Assembly w/ Compass 1

REASSEMBLY IR INSTALL ROOF WIRE (a) Apply new double-sided tape to the roof headlining along the markings of the roof headlining.

Window Glass Front Door

3-1, Shinchi, Fuchu-cho, Aki-gun Hiroshima , Japan TEL : 81(82) FAX : 81(82) Technical

Trim panels on model 124 as of 07/

and SECOND STAGE REGULATOR TAL 502 (L) Rev. 0 MSA 2005 Prnt. Spec (I) Mat Doc

Technical Information

Installation Instructions

AR68.20-P-2150EC Disassemble/assemble center console

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

WINDSHIELD WIPERS AND WASHERS

Installation instructions, accessories - Bluetooth, swan neck microphone

Soumatrix speakers installation guide

2011 CHRYSLER 300C (Available) $23,450

INSTALLATION INSTRUCTIONS

Support legs. Installation and operating instructions

Document # 1556 Created 8/16/02 TOYOTA TUNDRA GENTEX COMP/TEMP MIRROR Section I Installation Preparation Part Number:

BODY PANELS LOCATION INDEX

Gearbox sectional drawing

Installation and Care Instructions

VRX925VD 1. BEFORE STARTING 2. PACKAGE CONTENTS. English. Contents

Transcription:

51 16 060 Removing and installing or replacing interior rearview mirror. Note: On version with remote control for central locking: If necessary, disconnect negative lead to battery, refer to 12 0... Note: There are five different versions of the interior rearview mirror: (A) (B) Version without cable (X) with full foot Version with cable (X) and with plug cover (C) Version without cable (X) and with mirror arm end caps (D) Version with cable (X) and with mirror arm end caps (E) Version with rain sensor and with mirror arm end caps Version with cable (X) for: - Automatic dim action (electro-chrome technology) for interior rearview mirror - Infrared remote control - Garage door opener - Rain sensor - Radio remote control Caution! Do not under any circumstances turn the interior rearview mirror when removing it. Twisting off the interior rearview mirror from the mirror mount will damage the rear catch. The mirror will wobble while installed if the rear catch is damaged. Do not snap out the interior rearview mirror (1) towards the rear (windshield breakage). Issue status (02/2004) Valid only until next CD is issued Copyright Page - 1 -

Removal of version (B): Version with automatic dim action (electro-chrome technology) for interior mirror and/or infrared remote control: Lever out plug cover and disconnect plug connection. Caution! Do not remove interior mirror (1) towards rear or by twisting (risk of damage). Snap out interior mirror (1) from mirror mount towards front by striking with ball of thumb and remove. 1. Twist mirror foot through approx. 45 and fit to mirror mount. 2. Turn mirror foot until it engages on mirror mount. Only replace with version with infrared remote control for central locking: Initialise all transmitters (key), Refer to Owner's handbook. Issue status (02/2004) Valid only until next CD is issued Copyright Page - 2 -

Removal of versions (C) and (D): Press end caps (1) towards mirror housing (2); this releases clip connection of both caps (1). Twist mirror (1) at an angle towards front and right/top. Swivel left shell (2) off ball neck in direction of arrow; this detaches the engagement clip (3) from the metal foot. Twist mirror (1) at an angle towards front and left/top. Swivel right shell (2) off ball neck in direction of arrow; this detaches the engagement clip from the metal foot. Unfasten plug connection (1). Issue status (02/2004) Valid only until next CD is issued Copyright Page - 3 -

Caution! Do not remove interior mirror (1) towards rear or by twisting (risk of damage). Snap out interior mirror (1) from mirror mount (2) towards front by striking with ball of thumb and remove. Clips (1) and retaining hooks (2) of end caps (3) must not be damaged, replace if necessary. 1. Twist mirror foot through approx. 45 and fit to mirror mount. 2. Turn mirror foot until it engages on mirror mount. Removal of version (E) with rain sensor: Press on end caps (1) and at same time press them apart; this releases clip connection of both caps (1). Issue status (02/2004) Valid only until next CD is issued Copyright Page - 4 -

Twist mirror (1) at an angle towards front and right/top. Swivel left shell (2) off ball neck in direction of arrow; this detaches the engagement clip (3) from the metal foot. Twist mirror (1) at an angle towards front and left/top. Swivel right shell (2) off ball neck in direction of arrow; this detaches the engagement clip from the metal foot. Unfasten plug connection (1). Pay attention to cable guide (2) for rain sensor. Caution! Do not remove interior mirror (1) towards rear or by twisting (risk of damage). When snapping out, do not damage control unit (3) for rain sensor. Snap out interior mirror (1) from mirror mount (2) towards front by striking with ball of thumb and remove. Issue status (02/2004) Valid only until next CD is issued Copyright Page - 5 -

Clips (1) and retaining hooks (2) of end caps (3) must not be damaged, replace if necessary. 1. Twist mirror foot through approx. 45 and fit to mirror mount. 2. Turn mirror foot until it engages on mirror mount. Issue status (02/2004) Valid only until next CD is issued Copyright Page - 6 -