auart gepruft Sicherheit egelma ge od o s be wac g 000W Intelligent Single Output attery Charger P000 series SPECIFICTION SFETY & EMC (Note 3) SFETY STNDRDS WITHSTND VOLTGE ISOLTION RESISTNCE EMC EMISSION MODEL P000 P0004 P00048 OOST CHRGE VOLTGE 4.4V 8.8V 57.6V FLOT CHRGE VOLTGE Vfloat 3.8V 7.6V 55.V OUTPUT CURRENT 60 34.7 7.4 OUTPUT RECOMMENDED TTERY 00 ~ 600h CPCITY(MP HOURS)(Note 4) 0 ~ 350h 60 ~ 75h TTERY TYPE LEKGE CURRENT FROM TTERY (Typ.) Open & Sealed Lead cid <m VOLTGE RNGE FREQUENCY RNGE 0 ~ 64VC 47 ~ 63Hz 7 ~ 370VDC POWER FCTOR (Typ.) 0.5/30VC 0.8/5VC at full load INPUT EFFICIENCY (Typ.) 85% 88% 8% C CURRENT (Typ.) /5VC 5./30VC INRUSH CURRENT (Typ.) 5/5VC 50/30VC LEKGE CURRENT <3.5m / 40VC 6 ~ 8V 3 ~ 35V 64.5 ~ 6.5V OVER VOLTGE PROTECTION Protection type : Shut down o/p voltage, repower on to recover OVER TEMPERTURE SHORT CIRCUIT REVERSE POLRITY Shut down o/p voltage, recovers automatically after temperature goes down YES, protected by internal circuit YES, protected by internal circuit REMOTE CONTROL Open: Normal work Short: Stop TTER NKS banks ( & ) FUNCTION FST CHRGE / 3 / 8 stage selectable CHRGER OK Relay contact rating(max.): 30V/ resistive ; "Short" when the unit is working properly, "Open"when the unit is failure or the protection function is activating OUTPUT OK Relay contact rating(max.): 30V/ resistive ; "Short" when the battery is full, "Open" when the battery is still charging TEMPERTURE COMPENSTION y NTC, compensate both banks at the same time WORKING TEMP. 0 ~ 60 (Refer to "Derating Curve") WORKING HUMIDITY 0 ~ 0% RH noncondensing ENVIRONMENT STORGE TEMP., HUMIDITY 40 ~ 85, 0 ~ 5% RH noncondensing TEMP. COEFFICIENT ± 0.05%/ (0 ~ 50 ) VIRTION 0 ~ 500Hz, G 0min./cycle, 60min. each along X, Y, Z axes OTHERS NOTE EMC IMMUNITY UL6050, TUV EN6050, EC TP TC 004 approved I/PO/P:3KVC I/PFG:KVC O/PFG:0.5KVC I/PO/P, I/PFG, O/PFG:00M Ohms / 500VDC / 5 / 70% RH Compliance to EN5503 (CISPR3), EN60003,3, EC TP TC 00 Compliance to EN60004,3,4,5,6,8,, EN5504, light industry level, criteria, EC TP TC 00 MTF 7.4K hrs min. MILHDK7F (5 ) DIMENSION 300*84*70mm(L*W*H) PCKING 3.5Kg; 4pcs/5Kg/.83CUFT www. tuv.com ID 000000000 File Name:P000SPEC 0805
3 5 7 4 6 8 0 000W Intelligent Single Output attery Charger P000 series Mechanical Specification Case No. 804 Unit:mm 300 70 55 7.6 7 ON/OFF SWITCH 0 LED Loading Indicator ON OFF { 84 70 48 INLET ir flow direction C INPUT 6.5 LED Loading Indicator Status Table Status Color Red Steady bnormal status Full Flashing Control Pin No. ssignment( ) : HRS DF0DPDS or equivalent 7 5 3 0 8 6 4 Mating Housing Terminal HRS DF0DS or equivalent HRS DF**SC or equivalent Pin No. Function Description, 3,4 RY3 RY4 RY3 : attery ank OK relay. Relay contact rating(max.) : 30V/ resistive. ; "Short" when the battery is full, "Open" when the battery is still charging. RY4 : attery ank OK relay. Relay contact rating(max.) : 30V/ resistive. ; "Short" when the battery is full, "Open" when the battery is still charging. RY5 : Charger OK relay. 5,6 RY5 Relay contact rating(max.) : 30V/ resistive. ; "Short" when the unit is working properly, "Open" when the unit is failure or the protection function is activating. 7 NTC / GND : Temperature sense GND Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the 8 NTC(5K Ω) charging voltage. RTH If the temperature sensor is not used, the charger still works normally.,0 Remote ON/OFF function. RC / RC Turn the output on and off by electrical or dry contact between pin 0 (RC) and pin (RC). "Open" : Normal work ; "Short" : Stop charging File Name:P000SPEC 0805
000W Intelligent Single Output attery Charger P000 series lock Diagram PFC : 5KHz PWM fosc : 60KHz I/P EMI FILTER CTIVE INRUSH CURRENT LIMITING RECTIFIER & PFC POWER SWITCHING RECTIFIER & FILTER NK (V) NK (V) PFC CONTROL UX POWER PWM CONTROL FN OTP CURRENT DETECTION MCU REVERSE DETECTION /8 STGE SELECT REMOTE CONTROL RC ank OK RY3 ank OK RY4 Charger OK RY5 Derating Curve 00 80 60 LOD (%) 40 0 0 0 0 0 30 40 50 60 70 (HORIZONTL) Curve MIENT TEMPERTURE ( ) Stage 3 Stage Start Start Vfloat Charge Voltage Charge Voltage 00% 00% Charge Current Constant Current Constant Voltage 0% Charge Current Constant Current Constant Voltage Float 0% Color of LED Loading Indicator stage stage attery Full Color of LED Loading Indicator stage stage stage 3 State Constant Current P000 4.4V P0004 P00048 60 34.7 7.4 8.8V 57.6V Suitable for leadacid batteries (flooded, Gel and GM) and Liion batteries (lithium iron and lithium manganese). State Constant Current Vfloat P000 4.4V 3.8V P0004 8.8V 7.6V P00048 60 34.7 7.4 57.6V 55.V Suitable for leadacid batteries (flooded, Gel and GM) and Liion batteries (lithium iron and lithium manganese). File Name:P000SPEC 0805
000W Intelligent Single Output attery Charger P000 series 8 Stage Pulse Soft Start Constant Current Constant Voltage nalysis Recondition Float Maintain Charge Voltage Charge Current stage stage stage 3 stage 4 stage 5 stage 6 stage 7 stage 8 Color of LED Loading Indicator Suitable for leadacid batteries (flooded, Gel and GM). stage (Pulse) and stage "(Soft Start) provide battery rescue function.,3, or 8 Stage Select ()The charger features user selectable,3, or 8 stage charging. The charging profile is selected by moving the slide switch on the back panel. Switch Right Middle mode stage charging 3 stage charging RY3 RY3 RY4 RY4 Left 8 stage charging ()Please choose the "3 stage" selection when the charger is used to charge the batteries and power the loads in the same time. RC RC 0 attery attery Function Manual.Remote Control The charger can be turned ON/OFF by using the "Remote Control" function. etween RC(pin0) and RC(pin) SW Open SW Short Charger ON OFF RY3 RY3 RY4 RY4 RC 0 RC SW attery attery File Name:P000SPEC 0805
000W Intelligent Single Output attery Charger P000 series.two attery anks (/8 stage only) The charger may be hooked up two battery banks ( and/or ). Connect the battery bank(s) as below. If you are connecting battery banks in the same time, keep in mind that they must share a common ground. NOTE: The charger will charge bank first then bank if both channels are connected. attery attery attery attery 3.Charger OK Relay(RY5) Charger Normal work Failure or the protection function is activating etween pin5 and pin6(ry5) ON (Short) OFF (Open) RY3 RY3 RY4 RY4 RC RC 0 attery attery RY5 4.Output OK Relay(RY3 & RY4).ank OK (RY3) ank etween pin and pin(ry3) attery Full ON (Short) OFF (Open).ank OK (RY4) ank etween pin3 and pin4(ry4) Color of LED Color of LED RY3 RY3 RY4 RY4 attery Full ON (Short) RC RC 0 OFF (Open) attery attery RY4 RY3 File Name:P000SPEC 0805
000W Intelligent Single Output attery Charger P000 series 5.Temperature Compensation Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the charging voltage. If the temperature sensor is not used, the charger still works normally. RY3 RY3 RY4 RY4 RC RC 0 attery attery NTC The temperature sensor can either be attached to the battery or placed in its surrounding environment. File Name:P000SPEC 0805