4' Planar Suspended and Surface LED Light Level Outputs. Lumens Delivered. Efficacy (LPW)

Transcription

1 PLANAR S2E Series

2 The uniquely designed Planar from Metalumen features a slim sleek profile. While the over all body height is 2.2 inches [55mm] the actual edge viewed thickness is approximately 3/4 inches [20mm] making this luminaire less obtrusive when suspended. The luminaire s low visible profile, center-lamp optics and integrated one piece cross blade baffle brings a clean, contemporary aesthetic to architectural interiors. Planar is available can be continuous row mounted or individually suspended. Suspended

3 4' Planar Suspended and Surface LED Light Level Outputs Up to 50% Energy Savings Light Level Wattage Lumens Delivered Efficacy (LPW) Fluorescent Equivalent Energy Savings * L T8/T5 48% L T8/T5HO 36% L T8/2T5/T5HO 50% L T5HO 46% * Energy Savings based upon standard lamp/ballast combination using an equivalent S2E series with Opal Inlay

4 CONTROLS DIMMING Dimming lights by 50% = up to 40% lighting savings (uses only 60% of the energy required) A wide range of dimming options are available depending on sensor requirements or facility lighting control method. 0-10V control is standard. DALI, Lutron Eco-System and others are optional. Sensor Placement DAYLIGHT/OCCUPANCY SENSOR Up to 20% lighting energy savings Combination sensor for automatic ON/OFF control with ambient light sensing. If occupancy is detected within the sensor s coverage area, and if there is insufficient ambient light, the fixture will turn on. When occupancy is no longer detected and the time delay has elapsed, lighting automatically turns off. Time delay and light sensor are user adjustable. DAYLIGHT SENSOR Up to 20% lighting energy savings Optional low-profile user-adjustable integrated Daylight Sensors automatically adjust lumen output as ambient light levels change. Sensors are internally connected to 0-10V dimming OCCUPANCY Up to 20% lighting energy savings Optional low-profile integrated Occupancy Sensors automatically turn fixture ON or OFF depending on activity within the sensor area.

5 ENERGY & MAINTENANCE ANALYSIS Planar S2E LED/Fluorescent Comparison Room Size: 26 x 44' Ceiling Height: 10' Work Plane: 2.5' Reflectance: 80/50/20 # of fixtures: 15 S2E-2T8-4-SB (2) 32W F32T8/TL841 lamps 15 Fixtures Electronic Ballast 78 watts per fixture 5125 Delivered Lumens Input Power (Watts) Delivered lms/w % Energy Savings Planar S2E LED S2E-L35K-4-CSBO-L3 15 Fixtures Dimming Driver 48 watts per fixture 1.02 Watts/Sq.Ft Watts/Sq.Ft. 42 Horizontal Avg. Fc 18 Vertical Avg Fc 42 Horizontal Avg. Fc Horizontal Max Fc Horizontal Min Fc 18 3 Max/Min 3 18 Vertical Avg. Fc CRI Watts/Sq.Ft. 45 Horizontal Avg. Fc 19 Vertical Avg Fc All calculations are based on 4' fixtures.

6 ENERGY & MAINTENANCE ANALYSIS Input Output Customer Information Lighting System Energy Analysis Facility Information Project Name: Cost Per kwh $ Annual Operating Hours 3,650 Company: System Information Existing Proposed Luminaire Description (2) F32 T8 S2EL35K-4-L2 Input Watts Per Luminaire Quantity System Watts 1, System kw Annual kwh 4,271 2,628 Annual Energy Costs $ 512 $ 315 Monthly Costs $ 43 $ 26 Annual Energy Sales ($) $ 197 Annual Energy Savings (%) 38% Cost of Waiting (Monthly) $ 16 Annual Energy Costs per Lighting Systems $512 $500 $315 $400 $300 $200 $100 $0 $- Existing Proposed Note: These are estimated savings only. These annual and monthly savings are based on a number of variables and assumptions that could change over time. The actual savings derived by your firm may be higher or lower.

7 ENERGY & MAINTENANCE ANALYSIS Input Output Customer Information Project Name: Annual Maintenance Cost Estimator: 5 Year Breakdown Facility Information Annual Operating Hours 3,650 Company: System Information Existing System Proposed System Description of System (2) 32W T8 S2EL35K-4-L3 Quantity Type of Lamp Fluorescent, T8 LED Lamp Life (hrs) 20,000 60,000 Cost of Lamp $ 6.00 $ - Number of Lamps Per Fixture 2 8 Labor Cost to Spot Relamp per Lamp $ $ - Annual Lamp Maintenance Cost $ $ - Quantity of Lamps Replaced Annually 7 0 Ballast Type High Reactance High Reactance Ballast Life (hrs) 60, ,000 Cost of Ballast $ $ Number of Ballasts Per Fixture 1 1 Labor Cost to Change a Ballast $ $ Annual Ballast Maintenance Cost $ $ - Quantity of Ballasts Replaced Annually 6 Annual Maintenance Cost of System at Maturity $ $ - Summarized 5 Year Cost $ 2, $ - 5 Year Savings Summary $ 2, Year Average Annual Savings $ $500 $450 $400 $350 $300 $250 $200 $150 $100 $50 $0 5 Year Maintenance Cost Years Existing Maintenance Annual Maintenance Savings of 100% Proposed Maintenance

8 ENERGY & MAINTENANCE ANALYSIS Hundreds LED PAYBACK (YEARS) $50 $40 $30 $20 $10 $ - $(10) $(20) Years Payback = 1.14 Years SYSTEM ENERGY & MAINTENANCE COST SUMMARY Total Initial Fixture/ Installation Cost LED Traditional $4,275 $3,750 Total System kw Annual kwh 2,628 4,271 Cost of Energy per kwh $0.120 $0.120 kwh Inflation Rate (%/yr) 0.00% 0.00% Average Annual Energy Cost $315 $512 Average Annual Maintenance Cost Average Annual Energy + Maintenance Costs Average Annual Energy & Maintenace Savings $460 $0 $263 $315 $775 Savings Cost/Year Annual Cumulative LED Traditional 1st Year $197 $197 $315 $512 5th Year $372 $1,337 $315 $688 10th Year $460 $4,074 $315 $ Year Total Savings = $4,599 Cost LED Traditional $3,154 $7, % Savings including Ene rgy & Maintenance over 5 years PAYBACK ANALYSIS Average Annualized Savings Per Year Annual Energy Savings $197 Annual Lamp Maintenance Savings $263 Annual Combined Savings $460 Cost of Waiting (Monthly) $38 Simple Paybakc (years) 1.14 IRR (%) 87% $700 $600 $500 $400 $300 $200 $100 $0 Annual Operation Cost: Energy & Lamp Maintenance $315 LED $0 $512 $263 Traditional 10 Year Cash Flow (Energy & Lamp Main) $4,074 Energy Lamp Maintenance Calculation is based on actual LED fixture used in comparison to a 2-T8 FL fixture. Assumptions are $0.12 per KWh and 10 operating Hours/ day full power). These are estimated savings only. Annual and monthly savings are based on a number of variables and assumptions that could change over time. The actual savings derived by our firm may be higher or lower. Metalumen s business does not imply a warranty of performance or savings as calculated and shown within this document.

9 TYPICAL ROOM CALCULATIONS CLASSROOM 50'L x 30'W x 10'H Typical Classroom Calculation Summary Catalog Number S2EL35K-4-L2 Number of 4' Luminaires 21 Watts/4' Luminaires 35W Lumens/4' Luminaires 3778 Horizontal Light Level 34 Fc Vertical Light Level 15 Fc Spacing 28' Runs / 10' Spacing Lighting Power Density 0.49 W/SF % Better Than IECC % fc OFFICE 10'L x 12'W x 10'H Typical Office Calculation Summary Catalog Number S2EL35K-4-L2 Number of 4' Luminaires 2 Watts/4' Luminaires 35W Lumens/4' Luminaires 3778 Horizontal Light Level 24 Fc Vertical Light Level 9 Fc Spacing 8' Runs Centered Lighting Power Density 0.58 W/SF % Better Than IECC % fc

10 SPECIFICATIONS FLUORESCENT LED HOUSING Planar housings are precision manufactured of die formed, post painted 20-gauge steel. FINISH White textured polyester powder coated paint finish with 91% reflectance is the standard finish. OPTICAL SYSTEM Computer modeled, formed steel white ballast covers double as reflector system providing wide, horizontal indirect distribution. Precision reflectors allow for superior efficiencies of luminous performance. MOUNTING Solid stem 13mm (0.5 in) OD or steel aircraft cable complete with a Quick-Grip field adjustable suspension system provides for quick and easy on site alignment. INTEGRATED CONTROLS Daylight, Occupancy or Daylight/Occupancy Sensors. ENVIRONMENT Suitable for dry locations. LAMPING T8, T5 and T5HO BALLAST Electronic Instant Start (T8), Programmed Rapid Start, (T5/T5HO), 0-10V Dimming, DALI ELECTRICAL Integral, electronic ballast for T5 and T8 lamps at 120, 277 and 347 volts. Pre-wired for quick connection of individual sections and continuous runs to minimize installation time. No disassembly of the product is required. This product can accommodate up to three (3) T5 or (2)T8 lamps, provided by others. For multiple circuit, battery pack and emergency circuit wiring - consult factory. APPROVALS Certified to NRTL and IES testing standards. culus certified. WARRANTY Metalumen will warrant a one year parts and labour warranty. Warranty is valid if luminaire is installed and used according to specification. The Ballast will carry a standard 5 year warranty by the manufacturer. CRI 83 (3500K) LUMEN MAINTENANCE At an ambient operating temperature of 35 C the LED lifetime expectancy =>60 000hrs at L85. LUMEN PACKAGES Four Lumen Packages are available. DRIVERS Dimming drivers are standard on our entire LED product offering at 0-10V. Dimming is % range. Power factor is >90% with a Class 2 rating. APPROVALS Certified to NRTL and IES testing standards. All components are UL Registered or Listed. LM79/ LM80 compliant. WARRANTY Metalumen will warrant defective luminaires for 5 years from date of purchase. Warranty is valid if luminaire is installed and used according to specification. If defective, Metalumen will send replacement boards or drivers at no cost along with detailed replacement instructions and instructions on how to return defective components to Metalumen.

11 FLUORESCENT 205 [8.1] LED 205 [8.1] 55 [2.1] 55 [2.1] 85 [3.3] 85 [3.3] MODEL S2E SOURCE T8 / T5 / T5HO # OF LAMPS 1 1 Lamp 2 2 Lamps 3 3 Lamps (T5 / T5HO only) LENGTH 4/8 R 4ft / 8ft Continuous Rows OPTICS UP C Clear Dust Cover Blank Open Top OPTICS DOWN SB Solid Cross Blade Baffle SBO Solid Cross Blade Baffle w/ Opal Overlay FINISH WT C BALLAST E R D1 D2 White Textured Custom - Specify RAL# Electronic Instant Start (T8) Programmed Rapid Start (T5 / T5HO) 0-10V Dimming DALI CIRCUITRY 1 1 Circuit LR Left-Right Switching (2 Lamps) AS Alternate Switching IO In/Out Switching (3 Lamps) EM Emergency / Night Light B Battery Pack MOUNTING PA Aircraft Cable PT Aircraft Cable for T-Bar SS Solid Stem VOLTAGE Universal ( ) INTEGRATED CONTROLS Blank None D Daylight Sensor O Occupancy Sensor DO Daylight/Occupancy Sensor ORDER GUIDES MODEL S2E COLOR TEMP L30K L35K L40K LENGTH 4/8 R LED 3000K LED 3500K LED 4000K 4ft / 8ft Continuous Rows OPTICS UP C Clear Dust Cover Blank Open Top OPTICS DOWN SB SBO FINISH WT C Solid Cross Blade Baffle Solid Cross Blade Baffle w/ Opal Overlay White Textured Custom - Specify RAL# LIGHT LEVEL L L L L CIRCUITRY 1 1 Circuit EM Emergency / Night Light B Battery Pack MOUNTING PA Aircraft Cable PT Aircraft Cable for T-Bar SS Solid Stem VOLTAGE Universal ( ) INTEGRATED CONTROLS Blank None D Daylight Sensor O Occupancy Sensor DO Daylight/Occupancy Sensor Due to the Continuous Improvement Policy at Metalumen, we reserve the right to change our specifications without notice. 4' INDIVIDUAL SECTIONS Custom colors are available through standard RAL. 8' CONTINUOUS ROWS 12' 16' 20' Consult factory for other configurations.

12 Planar S2E Series Metalumen Manufacturing Inc. 570 Southgate Drive Guelph, Ontairo, Canada N1G 4P6 Toll Free: Tel: Fax: Mailing Address: PO Box 1779 Guelph, Ontario, Canada N1H 6Z9 All dimensions are nominal and subject to tolerances. We reserve the right to make changes that will not alter installed appearance, function or performance. These designs remain the property of Metalumen. We reserve the exclusive right to reproduce them and to manufacture the items illustrated herein. Some combinations may not be available, consult factory. Metalumen is a registered trademark. R Copyright 2014 Metalumen Manufacturing Inc. All rights reserved.