1. General Information

Transcription

1 MH-55 Dimensions

2 1. All specifications may vary, always consult DBT Australia Pty Limited to obtain current information before applying critical loads. Capacities Tractive effort, Maximum Winch (Front) Max un-braked trailer mass Max braked trailer mass Capacity of tow hitch Loading Chart (Safe Travel Loads) 36,500 kg 20,000 kg 25,000 kg Consult DBT 38,750 kg kg Maximum Load (kg) Distance From Face Weight Unladen with full tanks Maximum Laden 45,500 kg 100,500 kg Fork motion Times Lift to full raised position Lower fully to floor Roll forks fully back Roll forks fully forward Engine Cooling system Cooling fan Engine Make/model Displacement Maximum power. 7.0 seconds 4.0 seconds 5.0 seconds 7.0 seconds Diesel Injected, Turbo charged, 4 cycle Water based radiator Hydraulic driven fan Caterpillar C7 7.2 litre 171 kw

3 Stall Speeds Converter stall Full stall Hydraulic stall 2300 rpm 2100 rpm 2250 rpm Fuel Consumption At full power Average mine duty 45 Litres/hr Litres/hr Start System Starter motor type Non Flameproof Electric 24V Exhaust Conditioner Non Flameproof Catalytic Converter Spark Arrester Transmission Power shift with Fwd/Rev mod Electronic Control Make/model Dana Speeds, forward and reverse 4 Gear ratios 5.805, 2.440, 1.390, Torque Converter Make/model Mounted in trans Single element Dana integral 14.0 Axles Outboard planetary Front axle make/model Dana 21D Rear axle make/model Dana 19D centre Dana 21D wheel ends Diff. type Bevel gear and pinion Diff. lock type Front POSI TORQUE Diff. lock type Rear POSI TORQUE Overall ratio :1

4 Wheels/Tyres - Standard Size Inflation media Chains Solid 54 O/D x 28 wide Solid Optional Hydraulic Systems Steering Brakes Lift PTO Tank type Tank pressure Closed centre MPa Closed centre MPa Open centre MPa Open centre MPa Sealed and pressurised 50 kpa Hydraulic Filtration Main system Steer/brake system Optional return PTO Return 10 micron Replaceable with bypass Pressure10 micron Replaceable with bypass In line, 25 micron Main Control Pump Make Std pump output Gear Open centre Parker 228 lpm Steer& Brake Pump Make Std pump output. Pressure compensated piston Closed centre Parker 106 lpm Engine Fan Pump Make Gear Open centre Parker

5 Cylinders Rods Counterbalance valves Cushion stops Double acting Case hardened and hard chromed Lift & Tilt Steering & Tilt Steering System Control valve Actuation Unloader valve Crossover relief Closed centre Orbital (steering wheel) 20.7 mpa 21.7 mpa Accumulator - Steering Piston Quantity x capacity 1 x 5.9 litre Operating Pre charge pressure 6.2 MPa Control System Control valve Open centre Actuation Remote Electro Hydraulic pilot (Lift & Tilt) Remote Hydraulic pilot (Auxiliaries) Main relief MPa Service / Brake Hydraulic System Control valve Actuation Operating pressure Reverse modulating Closed centre Foot pedal 0 to MPa

6 Accumulator - Brakes Quantity x capacity Piston 1 x 2 litre Service Brake Totally enclosed, liquid cooled POSI STOP Make/ model Dana /25150 Application Spring Applied Hydraulic Release Location Each wheel end built into axle Park Brake Totally enclosed, liquid cooled POSI STOP Make/ model Clark /25150 Application Spring Applied Hyd. Released Location Each wheel end built into axle Steering Centre articulated, hydraulic Articulation Bearing type and size Degrees of turn either side Bush and Pin (top), bush (bottom) Fully sealed 45 degree Oscillation Clark rear axle mounted trunnion Degrees up and down from horizontal 7.5 degree Driver Seating Suspension Cross-seated Adjust spring / shock absorb.

7 Canopy FOPS Protective device Electrical system (NON FLAMEPROOF) Voltage Polarity Battery (Enclosure) Battery (Isolator) Component Protection Battery Supply Fusible Link Battery Isolator 24 V Negative ground Stainless Steel 300A IP54 Safety System System type Standard shutdowns Optional shutdowns Cat Engine Management System IQAN Monitoring with Digital Readout E/Stop Door Open Interlock High Methane Fire Suppression Lights Number /location 2 front, 2 rear Non Flameproof Alternator Drive Belt Driven 24VDC, 50A Caterpillar Service Capacities Hydraulic tank Fuel tank Transmission/converter oil Drop box oil Engine crankcase oil Engine cooling system water Axle oil (each) 400 litres 400 litres 40 litres 8 litres 22 litres 60 litres 60 litres

8 Vehicle Speeds 1st gear 2nd gear 3rd gear 4th gear 3 kph 7 kph 12 kph 20 kph Maximum Tractive Effort 1st gear 2nd gear 3rd gear 4th gear 36,500 kg 15,200 kg 8,700 kg 4,950 kg Grade Ability Front to rear 1:4 Side to side (empty) 1:4 Side to side (Laden) 1:8 WARNING Overloading equipment could cause personal injury, death or equipment damage. Due to configuration or options these weights can vary up to 20%. DBT Australia Pty Limited recommends that relevant standards and safety procedures should always be used when operating this equipment. Removal of a protective canopies, doors, interlocks and structures etc., could cause serious injury of death. It is mandatory to correctly torque all fasteners. All specifications are subject to change without notice. Options (others available on request) Fire Suppression System Auto Lubrication System Non Flameproof Electrical System Flameproof Version Tow Chains Wheel Chains Load Indication Gauge Contact your local DBT representative for further information on our diesel powered product line.