Scope of Supply / Major Bill of Materials

Transcription

1 Scope of / Major Bill of Materials The following table summarizes major scope of supply for this project. The tables also include a list of major parts that will be provided by customer/others. Additional details are provided in the General Arrangement (GA) drawing. Base Generator Set Group ID#00 Engine, Alternator, Base, Oil System 00 Engine: Waukesha VHP-7044GSI, EPA- Certified, 200RPM, 50eKW with engine driven radiator. 0 Engine Controls & Interface: Waukesha Engine ECU & Auxiliary I/O Box 02 Genset base frame 03 Alternator, KATO 6P6-3300, 6-Pole, 2- bearing, 200RPM, 80DegC rise (40DegC ambient), IP-23 Enclosure, PMG, Class H insulation, 600VAC/480VAC duel voltage capable 04 Coupling Renold 05 Lube Oil Makeup Tank Approx. 50 Gallon, with level indication Mounted on platform Cooling System Group ID#50 Cooling System 50 Engine-driven Radiator 5 Coolant piping, flanged connections: Engine to Radiator 52 Coolant

2 Fuel System Group ID#75 Fuel System 75 Inlet gas train, including: Regulator, manual shutoff value, solenoid valves. For Natural Gas fuel supply (wellhead). 76 Gas supply piping From customer connection point on enclosure of enclosure to gas train, and from gas train to engine inlet Exhaust System Group ID#250 Exhaust System Note: Fuel cleaning/ conditioning equipment upstream of Genset is by others 250 Exhaust Catalyst: -3-way catalyst, provided as part of EPAcertified engine 25 Silencer - Carbon steel - Drain, fitting (no drain valve) - Industrial Grade 252 Exhaust stack 4 extension with rain cap 253 Exhaust Flex & Connections: -Engine to Catalyst - Catalyst to Silencer - Silencer to stack 254 Exhaust Supports: - Structural frame to support catalyst and silencer from Genset platform 255 Nut/bolt/gasket kits as required

3 Enclosure Group ID#425 Generator Enclosure CUST 425 Working Platform: - Engine skid recessed-mounted into working skid - Non-slip diamond plate floor - Mounting of Radiator, Gen controls, fuel scrubber, batteries and charger, other Gen auxiliary equipment and controls - Maximum 2 /44 wide - Lifting eyes for (6) point pick - Designed to accommodate drop over, weather-proof enclosure. 426 Spill Containment for engine coolant & oil Incorporated into 427 Weather-proof Enclosure, including: - Lift-off frame, for (6)-point rig on/.lift off from base/platform - Removable lifting eyes - Bolt-on connection to platform/base - (2) single access doors - () double access door - 25-year TPO Roof working platform See GA for details

4 Electrical Group ID#450 Electrical Distribution and Controls 450 Main Generator Circuit Breaker - Front access only through double doors on alternator end of Genset - NEMA 3R rated AF insulated case circuit breaker, Fixed mounted, 600/480VAC NEMA 3R, 65k AIC, UL89 - LSIG trip, neutral sensor, 24VDC shunt trip, Form C aux contacts - Copper ground bus - Metering CT s and PT s - CB open & close control by Deep Sea 860 Controller 45 Cable connection, 600/480V, 2000A Alternator output to Main CB, protected in steel wire way 452 Exterior cable connection - Copper bus with NEMA pads/holes designed to accept customer cables and lugs (size, qty TBD) 453 Deep Sea Genset Controller, Model 860, Gen start/stop/shutdown, sync, island, load share (other Deep Sea Gens) & utility parallel (adj. base load) modes of operation. 454 Transformer - kva, connected to output of generator set - 600V:20/208V 455 Load Center 20/208V 3P/4W - 00A - For AC battery charger, lighting, receptacles 456 Light rail wiring tray located at top of enclosure, EMT conduit drops and fittings 457 Convenience Receptacles GFCI, () double socket each side of Gen container, () near breaker/control cabinet Designed for cable entry from ground level, at side of enclosure near double doors. Mounted in breaker cabinet. Harness connection to Engine I/O Box Plug in breakers as required for 20V & 208V accessories

5 458 Interior lighting, incandescent, 20 VAC 459 DC/emergency lighting each side of container, above access/escape doors with timer. 460 Exterior lighting (2) elevated lights to maintain light at ground level, pre-wired and installed but shipped loose. 46 Light switches with weatherproof covers 462 Flush mount emergency stop with break glass NEMA 3R, shipped with extra contact blocks. 463 Engine Starting Batteries 464 Battery Charger 465 Battery Box with spill containment Testing Group ID#475 Production Testing 475 Labor and materials for 4-hour load test at.0 Run test on natural gas. pf 476 Alarm and shutdown verification testing Shipping Group ID#525, 550 Shipping / Prep / Freight / Warranty 525 Freight in of engine & generator 526 Loading of all equipment on customer provided truck(s) 527 Freight to jobsite Opt 550 Warranty: 2/8 months from date of shipment - EPIRED