INSTALLATION INSTRUCTIONS

Size: px

Start display at page:

Download "INSTALLATION INSTRUCTIONS"

Megan Carroll
6 years ago
Views:

1 INSTALLATION INSTRUCTIONS Accessory Application Publications No. AII ODYSSEY Issue Date SEP 2004 PARTS LIST Compact Subwoofer Kit: P/N 08A39-5E Flange bolt, 6 x 12 mm Subwoofer 3 Cushion tapes Owner s manual 3 Cushion Subwoofer Attachment Kit: P/N 08B39-SHJ-100 Fuse label Subwoofer harness Subwoofer bracket TOOLS AND SUPPLIES REQUIRED #2 Phillips screwdriver Flat-tip screwdriver Stubby Phillips screwdriver 8 mm and 10 mm, Combination wrenches 8 mm and 10 mm, 14 mm Sockets Isopropyl alcohol Tape measure Ratchet Shop towel Subwoofer switch 21 Wire ties 2004 American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 08B39-SHJ of 11

2 Illustration of the Subwoofer Installed on the Vehicle Without Navigation System INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by do-it-yourselfers. 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Place the shift lever in the N (Neutral) position. 3. Disconnect the negative cable from the battery. If the vehicle you are working on is equipped with a navigation system, go to step 7; otherwise, continue with step Remove the center panel (nine clips and disconnect the connectors) B S (9) With Navigation System CENTER PANEL B 5. Remove the pocket (two bolts, two clips). S (2) B BOLT POCKET B 2 of 11 AII (0409) 2004 American Honda Motor Co., Inc - All Rights Reserved.

3 6. Remove the audio unit (three self-tapping screws, two clips, and disconnect the vehicle connector). 9. Remove the audio unit (two bolts, two clips). S (2) S (6) S (2) SELF-TAPPING SCREW AUDIO UNIT B If the vehicle you are working on is not equipped with a navigation system, go to step 10; otherwise continue with step Place the shift lever in the N (Neutral) position. BOLT 10. Remove the damper arm cover and disconnect the arm. GLOVE BOX AUDIO UNIT B S (9) DAMPER ARM CENTER PANEL B GLOVE BOX B 8. Remove the center panel (nine clips and disconnect the connectors) American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 3 of 11

4 11. Open the glove box and remove the two stoppers by releasing the two retaining tabs. Remove the two screws that fasten the glove box, and remove the glove box. 13. Pull out the weatherstrip around the right kick panel. Remove the right kick panel (two clips). S (2) WEATHERSTRIP GLOVE BOX STOPPERS (2) SCREWS (2) RIGHT KICK PANEL Y RETAINING TAB B 14. If equipped, remove the seat under box. 12. Remove the right front door sill trim (three clips). S (3) DOOR SILL TRIM UNDER BOX Y B 4 of 11 AII (0409) 2004 American Honda Motor Co., Inc - All Rights Reserved.

5 15. If equipped, remove the under seat box bracket (four screws). 18. Remove the passenger s seat front rail cover (one clip and one retaining tab). RAIL RETAINING TAB Y RETAINING TABS (2) FRONT RAIL SCREW S (4) B 16. Remove the passenger s seat rear rail upper cover (four clips). 19. Remove the passenger s seat side rail cover (four clips and two retaining tabs). REAR RAIL UPPER 20. Remove the right side lower cover (one clip, one retaining clip and remove from the stud). STUD RAIL B RIGHT SIDE LOWER 17. Remove the passenger s seat rear rail cover (four clips) B 2004 American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 5 of 11

6 21. Remove the left side dashboard lower cover (one clip, one retaining clip and remove from the stud). 23. Remove the driver s lower cover (one self-tapping screw, seven clips, and three retaining tabs). STUD HOSE RETAINING TABS (3) LEFT SIDE DASHBOARD LOWER B 22. Pull out the cup holder. Remove the four selftapping screws and disengage the two retaining clips, then pull out the center lower cover toward you. remove the clip from the vehicles harness, disconnect the two vehicle harness connectors and remove the center lower cover. CUP HOLDER 24. Remove the six clips and the three retaining tabs, and remove the instrument side panel. S (6) S (7) SELF-TAPPING SCREW DRIVER S LOWER B RETAINING TAB SELF-TAPPING SCREWS (4) CENTER LOWER SHOP TOWEL S (2) B INSTRUMENT SIDE PANEL INSTRUMENT SIDE PANEL FLAT-TIP SCREWDRIVER B 6 of 11 AII (0409) 2004 American Honda Motor Co., Inc - All Rights Reserved.

7 25. Remove the switch panel (four clips, pull out the switch panel out disconnect the vehicle connectors). (4) Routing the Subwoofer Harness 27. Route the subwoofer harness. Without Navigation: Insert the 20-pin connector of the subwoofer harness into the 20-pin connector of the vehicle at the audio opening and route it to the glove box opening. Secure the subwoofer harness with a wire tie to the vehicle harness. Attach the 7.5 A fuse label to the subwoofer harness fuse case. SWITCH PANEL 20-PIN AUDIO 20-PIN 26. Remove the switch lid (two retaining tabs) Y FUSE CASE LX LOCATION EX LOCATION 50 mm 7.5A FUSE LABEL GLOVE BOX B SWITCH LID Route the 5-pin connector side from the subwoofer harness as shown and secure it to the vehicle harness with four wire ties. SWITCH RETAINING TAB B 5-PIN B 2004 American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 7 of 11

8 Secure the subwoofer harness to the vehicle bracket with the three cushion tapes. Route the 5-pin connector side from the subwoofer harness as shown and secure it to the vehicle harness with four wire ties. POCKET TAPE B 5-PIN B With Navigation: Insert the 20-pin connector from the harness into the vehicle 20-pin connector at the audio unit opening, and route the 20-pin connector toward the glove box opening. Secure the subwoofer harness with a wire tie to the vehicle harness. Attach the 7.5 A fuse label to the subwoofer harness fuse case. Secure the subwoofer harness to the vehicle bracket with the three cushion tapes. 20-PIN FUSE CASE AUDIO UNIT TAPE TAPE B 20-PIN AUDIO UNIT GLOVE BOX 7.5A FUSE LABEL B 8 of 11 AII (0409) 2004 American Honda Motor Co., Inc - All Rights Reserved.

9 28. Route the 8-pin connector side from the subwoofer harness as shown and secure it to the vehicle harness with five wire ties. 30. Turn up the floor carpet and pull out the 8-pin connector from the subwoofer harness out from under floor carpet opening under the passenger s seat. GLOVE BOX Turn up the carpet. 8-PIN 8-PIN SIDE B B 29. Continue routing the 8-pin connector side from the subwoofer harness along the vehicle harness and secure the harness with four wire ties. Turn up the carpet. 31. Secure the subwoofer harness to the vehicle harness with one wire tie near the floor carpet opening. 32. Route the 5-pin connector side from the subwoofer harness along the vehicle harness and secure to the vehicle harness with two wire ties. 5-PIN FRAME 8-PIN B B 33. Continue routing the 5-pin connector side of the subwoofer harness along the vehicle harness and secure it to the vehicle frame with two wire ties American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 9 of 11

10 34. Install the subwoofer switch into the hole in the switch lid. Connect the 5-pin connector from the subwoofer harness to the subwoofer switch. 5-PIN Installing the Subwoofer 36. Using scissors cut one cushion in half then cut the cut piece in half again. Attach the cut pieces two halves to the subwoofer bracket. (cut in half.) (cut in quarter.) EX LOCATION LX LOCATION SWITCH (half) (quarter) B B 35. Secure the subwoofer harness with two wire ties to the vehicle harness. 37. Attach two full cushions to the subwoofer bracket in the area shown. 38. Remove and retain the four screws from the subwoofer. SCREW (Reuse.) B W 10 of 11 AII (0409) 2004 American Honda Motor Co., Inc - All Rights Reserved.

11 39. Secure the subwoofer to the subwoofer bracket with the four screws you removed. 41. Connect the 8-pin connector from the subwoofer harness to the subwoofer. 40. Install the subwoofer assembly to the vehicle under the passenger s seat bracket using the bracket four 6 x 12 mm flange bolts. SCREW (Reuse.) 6 x 12 mm FLANGE BOLT B 6 x 12 mm FLANGE BOLT B 8-PIN B 42. Check that all wire harnesses and cables are routed properly and all connectors are plugged in. 43. Reconnect the negative cable to the battery. 44. Enter the customer s radio anti-theft code and reset the radio station presets. 45. Reset the clock. 46. Check the operation of the subwoofer according to the Owner s Manual supplied with the subwoofer. 47. Reinstall all removed parts. NOTE: Whenever the battery is disconnected, the driver s AUTO window function is disabled. 48. Start the engine. Push down on the driver s window switch until the window is fully open, then hold the switch for 2 seconds or more. 49. Pull up on the driver s window switch to close the window completely, then hold the switch for 2 seconds or more. 50. Test the AUTO window function American Honda Motor Co., Inc - All Rights Reserved. AII (0409) 11 of 11

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS Accessory Application Publications No. CASSETTE/IN-DASH 6 DISC/ AII 27341 MP3 ODYSSEY Issue Date ATTACHMENT KIT SEP 2004 PARTS LIST Player Attachment Kit (sold separately): P/N