Offset Solar LED Umbrella

Transcription

1 Item #0178 Offset Solar LED Umbrella The schematics in this manual are for assembly and operation illustration only. They may differ from the umbrella s actual appearance. Owner s Manual

2 Package Contents Before beginning product assembly, make sure all contents are present. Compare parts with package contents list and diagram. If any part is missing or damaged, do not attempt to assemble the product or return to the place of purchase. Contact our customer service toll free at for replacement parts or further instructions. M A D B E C F G H I J K L PART DESCRIPTION QUANTITY A Main Parasol Assembly 1 B Base - Upper 1 C Base - Lower 1 D Swivel Cover 1 E Base Pole 1 F Swivel Mechanism 1 G Bolt 8 H Washer 8 I Threaded Knob 1 J Handle 1 K Hex Wrench 1 L Cover 1 M Solar Panel 1 Page 2

3 Setup and Operation CAUTION: Do not use sharp tools or equipment such as a knife or scissors when removing the protective material, as it may damage the product. WARNING: Read the entire instructions before beginning and follow the steps outlined. Failure to assemble and install as instructed could result in the umbrella tipping over causing personal injury and/or property damage. 1 4 G H G H Step 1: Insert the plug into the socket under the solar panel. D 2 E Please note: Always assemble all parts loosely before finally tightening the bolts. Step 2: Put the solar panel on the top of umbrella and hide the plug and wire inside the groove at the top of umbrella. Then turn the solar panel clockwise. Do not over tighten. 3 B F These holes can be used to permanently affix the base to a solid surface. Note: Screws and bolts not included. Step 4: Assemble base by placing Swivel Pole Mechanism (F) on the assembled Base (BC). Position Base Pole (E) and Washer (H) in line with (F) as shown. Fasten all 8 Bolts (G) with Hex Wrench (K) as indicated in inset drawing. J C Step 3: Insert Upper Base (B) into Lower Base (C) Page 3

4 Setup and Operation D C 5 A E 6 Please note: Always assemble all parts loosely before finally tightening the bolts. I F These holes can be used to permanently affix the base to a solid surface. Note: Screws and bolts not included. Step 6: Put the solar umbrella in direct sunlight to charge the batteries for 8 hours before the first use. J INFORMATION: Please remove the plastic film on the solar panel. This protective film is to prevent damage during shipping. Failure to remove the film will result in the solar panel not functioning properly. Step 5: Insert Main Parasol Assembly (A) into assembled base. Lock in place with Treaded Knob (I). Insert Handle (J) as indicated (see insert). YOU MUST CHARGE BATTERIES BEFORE FIRST USE. Please note that batteries can discharge if they are left unused or uncharged for a long period of time. We recommend you charge your solar umbrella for at least 8 hours in direct sunlight before the first use. Failure to charge the batteries will result in premature dimming of the lights in your new solar umbrella. MAKE SURE THE LIGHT SWITCH IS IN THE OFF POSITION WHEN CHARGING THE SOLAR PANEL (see illustration at right). For everyday normal use, turn on the light switch at nighttime when you want to use the solar light and turn off the light switch after every use. IMPORTANT: MAKE SURE THE LIGHT SWITCH IS IN THE OFF POSITION IN THE DAYTIME FOR THE SOLAR PANEL TO RECHARGE THE BATTERIES. Page 4

5 Setup and Operation 7 Step 7: Squeeze trigger before attempting to raise or lower the parasol. Step 7: Squeeze trigger before attempting to raise or lower the parasol. 8 Step 8: Rotate crank handle clockwise to extend the parasol fully Page 5

6 Setup and Operation 9 Step Step 9: 9: Squeeze Squeeze trigger trigger and and slide slide Step 9: Squeeze trigger the the handle handle slide up up or or down down to to adjust adjust the handle up or down angle angle to adjust of of the the parasol. parasol. angle of the parasol IMPORTANT NOTICE: IMPORTANT NOTICE: Before attempting to to turn Before attempting to the turn the parasol, squeeze down the parasol, squeeze the down the lever with your foot the lever with your foot to to release the mechanism. to release the mechanism Step 11: Squeeze Step 11: Squeeze Step 10: Rotate crank Step handle 10: Rotate crank handle trigger before attempting trigger before attempting anti-clockwise to close anti-clockwise the parasol. to close the parasol. to lower the parasol to lower the parasol to its closed position. to its closed position. IMPORTANT NOTICE: Before attempting to turn the parasol, squeeze down the lever with your foot to release the mechanism. Page 6

7 Battery Replacement We recommend that you change the batteries in your solar light umbrella every year or when you feel the light output is diminished. Use only three (3) AA size Ni-MH 1600mAh rechargeable batteries from any major retailer. Install only new batteries of the same type in your product. Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause batteries to leak. 1 Do not mix old and new batteries. Do not mix Alkaline, Nickel Cadmium or Lithium rechargeable batteries. Do not dispose of batteries in fire. Batteries should be recycled or disposed of as per state, provincial and local guidelines. Tools required: Phillips head screw driver (not included) 2 Step 1:Twist counterclockwise and remove the solar panel from the top of the umbrella. 3 Step 2: Pull the plug out of the socket under the solar panel. Pull by holding the plug, not by pulling on the wires. 4 Step 3: Place the solar panel upside down on a flat, non-abrasive surface to avoid scratching. Remove four (4) screws on the bottom case. Step 4: Carefully open the bottom case and set aside. Replace the battery, matching the +/- on the battery with the +/- on the battery case. 5 Step 5: Carefully replace the bottom case. Align the screw holes and replace the screws. Do not over tighten the screws Page 7

8 Care & Maintenance CANOPY CARE INSTRUCTIONS: Simply clean the umbrella canopy with a soft brush and mild detergent. Do not machine wash. Do not iron. Air-dry the canopy thoroughly before storing for extended periods of time. Make sure the canopy is completely open during drying process to prevent shrinkage. If the painted finish should become chipped or scratch exposing bare metal remove any surface rust and treat with a suitable touch up paint. If the parasol is not to be used for long periods during the winter, store inside or under a suitable cover. Before putting into storage, ensure all of the items are clean and dry. Warnings and Cautions DANGER: Keep children out of the assembly area during assembly. WARNING: Read the entire instructions before beginning and follow the steps outlined. Failure to assemble and install as instructed could result in the umbrella tipping over causing personal injury and/or property damage. WARNING: To prevent damage to the canopy, open the umbrella facing the opposite direction that the wind is blowing. WARNING: Do not use this umbrella during periods of high winds and rain. Failure to do so may result in personal injury and/or damage. CAUTION: Assemble and use umbrella on a flat surface. CAUTION: Placement of the umbrella over or near a swimming pool can cause premature fading of the canopy. This is not covered under the warranty. CAUTION: Close the umbrella and use the canopy ties when umbrella is not in use. CAUTION: Schematics in this manual are for assembly and operation illustration only. They may differ from the umbrella s actual appearance. Do not use the parasol until all of the screws and fixing are tight and the parasol is fully assembled. Periodically check the tightness of all fixings. Do not let children play with or around this parasol. Care must be taken when opening or closing the parasol to ensure that you do not trap or pinch your fingers or clothing. When raising the parasol please be aware of overhanging power cables, laundry lines and overhanging branches. Page 8

9 Replacement Parts Description Picture Solar Panel Cover Page 9

10 Limited Warranty JAY TRENDS MERCHANDISING INC. LIMITED ONE (1) YEAR WARRANTY Jay Trends warrants your new outdoor Solar Umbrella product will be free from defects in material and workmanship for one (1) year from the date of purchase. Conditions and Limitations Jay Trends warrants its products against manufacturing defects to the original purchaser only, and is subject to the following conditions and limitations: This factory warranty is non-transferable and may not be extended what-so-ever by any of our representatives. The product must be assembled, maintained, and operated in accordance with the printed instructions accompanying it. This limited warranty does not cover damages caused by misuse, lack of maintenance, grease fires, hostile environments, accident, alterations, abuse or neglect and parts installed from other manufacturers will nullify this warranty. Discoloration to plastic parts from chemical cleaners or UV exposure is not covered by this warranty. Any damages to the product due to weather damage, hail, rough handling, damaging chemicals or cleaners will not be the responsibility of Jay Trends. Olefin fabric is covered for thirty (30) months against defects in material or workmanship. This limited warranty does not cover any scratches, dents, painted finishes, corrosion or discoloring by heat, abrasive and chemical cleaners, nor chipping on porcelain enamel parts, nor any components used in the installation of the product. Should deterioration of parts occur to the degree of non-performance (rusted through or burnt through) within the duration of the warranted coverage, a replacement part will be provided. The bill of sale or copy will be required when making any warranty claims from Jay Trends. All parts replaced under the Limited One (1) Year Warranty Policy are subject to a single claim. Jay Trends will not be responsible for the installation, labor, or any other costs related to the re-installation of a warranted part, and such expenses are not covered by this warranty. Jay Trends reserves the right to have its representative inspect any product or part prior to honoring any warranty claim. Jay Trends shall not be liable for any transportation charges, labor costs, or export duties. Replacement Parts In the event that an item has been lost or damaged either by the manufacturer or in shipping you may request a replacement. Replacement parts are not available for all units and only given at Jay Trends discretion. We will assess any damage and find a solution, which could include ordering and shipping a replacement to you. No replacements are available for discontinued items or repackaged (open box) products. Please call Jay Trends Customer Service at for replacement parts before returning the damaged item. Please have the following information, which can be found in your instruction manual, ready before you call Customer Service. 1. Model Number of Item # 2. Lot Code Number # 3. Shipping Address 4. A picture of the damaged item may be requested. 5. Pictures should be sent to custserv@jaytrends.com Jay Trends Merchandising Inc Meilleur, Suite 101 Montreal, QC H2N 3E3, Canada Customer Service: in USA & Canada custserv@jaytrends.com Sunbeam logo is a trademark of Sunbeam Products, Inc. used under license. Distributed by Jay Trends Merchandising Inc. Page 10