Maintenance. Lubricants and Fluids Maintenance Minder General Information... Maintenance Main Items... Maintenance Sub Items...

Transcription

1 Maintenance Lubricants and Fluids Maintenance Minder General Information Maintenance Main Items Maintenance Sub Items

2 Lubricants and Fluids For details of the lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Overhaul, Installation, etc.) contained in each section. Lubrication Points Lubricant A Engine Honda Motor Oil: American Honda P/N , Honda Canada P/N CA66806 Use 5W-20 motor oil. Look for the API certification seal on the oil container as shown below. Make sure it says For Gasoline Engines. SAE Viscosity: See chart. B Automatic transmission Honda Automatic Transmission Fluid (ATF-Z1): American Honda P/N , Honda Canada P/N CA66689 Always use Honda ATF-Z1. Using a non-honda ATF can affect shift quality. C Transfer assembly Hypoid gear oil GL4 or GL5 Use a SAE 90 or SAE 80W-90 viscosity hypoid gear oil, API classified GL4 or GL5 only Viscosity SAE 90: above 0 F ( 18 C) SAE 80W-90: below 0 F ( 18 C) D Rear differential Honda VTM-4 Differential Fluid: P/N E Brake system (including VSA lines) Honda DOT 3 Brake Fluid: P/N Always use Honda DOT 3 Brake Fluid. Using a non-honda brake fluid can cause corrosion and decrease the life of the system. F Brake booster clevis pin Multipurpose Grease G Battery terminals H Pedal linkage I Fuel fill door J Hood hinges and hood latch K Tailgate hinges L Sparetiretraybolt M Caliper piston boot, caliper pins, and boots Honda Caliper Grease: P/N 08C30-B0234M N Rear brake shoe linkage Molykote Grease 44MA O Power steering system Honda Power Steering Fluid: P/N Always use Honda Power Steering Fluid. Using any other type of power steering fluid or automatic transmission fluid can cause increased wear and poor steering in cold weather. P Air conditioning compressor Compressor Oil: DENSO ND-OIL 8 (P/N PR7-A01) for refrigerant HFC-134a (R-134a) Q Cooling system Honda Long Life Antifreeze/Coolant Type 2: P/N OL API CERTIFICATION SEAL Recommended Engine Oil Engine oil viscosity for ambient temperature ranges 3-2

3 NOTE: Lubricate all hinges, latches, and locks once a year. In corrosive areas, more frequent lubrication is necessary. O A H D L P Q J K B G M E C F J N M I L 3-3

4 Maintenance Minder General Information Maintenance Display The maintenance minder is an important feature of the information display. Based on engine operating conditions and accumulated engine revolutions, the Ridgeline s onboard computer (PCM) calculates the remaining engine oil life. The system also displays the code for other scheduled maintenance items needing service. INFORMATION DISPLAY MAINTENANCE MINDER INDICATOR 3-4

5 Service Information 1. The remaining engine oil life is displayed (A) as a percentage on the information display. To see the current engine oil life, turn the ignition switch to ON (II), then push and release the SELECT button repeatedly until the engine oil life is displayed. 3. When the remaining oil life is less than 5 percent, the maintenance message SERVICE DUE NOW, along with the items shown in SERVICE DUE SOON display. At this point, the indicated maintenance must be performed as soon as possible. The service message alternates between SERVICE and DUE NOW repeatedly. A 2. When the remaining engine oil life is at 15 percent or less, the maintenance message SERVICE DUE SOON, along with the maintenance items currently requiring service are displayed. The service message alternates between SERVICE and DUE SOON repeatedly. 4. When the remaining oil life is 0 percent, the display shows a SERVICE PAST DUE message. The service message alternates between SERVICE and PAST DUE repeatedly. Complete list of maintenance main items A (see page 3-7). Complete list of maintenance sub items B (see page 3-8). A B NEGATIVE MILEAGE 5. If the indicated maintenance is not performed the display shows SERVICE DUE NOW message, then the display will show negative mileage for example 34MI. This means that the indicated maintenance item should have been performed 34 miles ago. (cont d) 3-5

6 Maintenance Minder General Information (cont d) Resetting the Engine Oil Life Indicator 1. Turn the ignition switch to ON (II). 2. Press the SELECT button repeatedly until the oil life is displayed (if oil life is more than 15 %) or the maintenance message is displayed (if oil life is less than 15 %). 3. Press the RESET button for about 10 seconds. You will see a service message to reset the maintenance item code(s) MAINT RESET. NOTE: If the required service is performed and the display is not reset, or if the display is reset without performing the service, the system will not show the proper maintenance levels. This can lead to serious mechanical problems because there will be no record of when maintenance is needed. The engine oil life and the maintenance items may be reset independently only with the HDS. NOTE: If you are resetting the display when the oil life is more than 15 %, or if the maintenance message SERVICE DUE SOON is displayed, make sure the maintenance items requiring service have been performed before resetting this display. 4. Select the appropriate answer, MAINT RESET N (NO) or MAINT RESET Y (YES) by pressing the SELECT button repeatedly. N or Y is displayed on the outside temperature display. 5. Select the MAINT RESET Y (YES) and press the RESET button again to reset the engine oil life to

7 Maintenance Main Items If the message SERVICE DUE NOW does not appear more than 12 months after the display is reset, change the engine oil every year. NOTE: Independent of the maintenance messages in the information display, replace the brake fluid every 3 years. Inspect idle speed every 160,000 miles (256,000 km). Adjust the valves during services A, B, 1, 2, or 3, only if they are noisy. Symbol Maintenance Main Items A Replace engine oil (see page 8-6). Engine oil capacity without oil filter: 4.0 L (4.2 US qt). B Replace engine oil and oil filter (see page 8-7). Engine oil capacity with oil filter: 4.3 L (4.5 US qt). Check front and rear brakes (see page 19-4). Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts. Check parking brake adjustment (see page 19-7). Check the number of clicks (10 to 12) when the parking brake pedal is pressed with 294 N (30 kgf, 66 lbf) of force. Inspect tie-rod ends, steering gearbox, and gearbox boots (see page 17-8). Check rack grease and steering linkage. Check boots for damage and leaking grease. Check fluid lines for damage or leaks. Inspect suspension components (see page 18-3). Check bolts for tightness. Check condition of ball joint boots for deterioration and damage. Inspect driveshaft boots (see page 16-4). Check boots for cracks and boot bands for tightness. Inspect brake hoses and lines including VSA (see page 19-33). Check the master cylinder and VSA modulator-control unit for damage and leakage. Inspect all fluid levels and condition of fluids. Engine coolant (see page 10-6). Automatic transmission fluid (ATF) (see page ). VTM-4 rear differential fluid (Honda VTM-4 Differential Fluid) (see page 15-47). Power steering fluid (see page 17-12). Brake fluid (see page 19-9). Windshield washer fluid. Inspect exhaust system (see page 9-7). Check catalytic converter heat shields, exhaust pipes, and muffler for damage, leaks, and tightness. Inspect fuel lines (see page ) and connections (see page ). Check for loose connections, cracks, and deterioration; retighten loose connections and replace damaged parts. NOTE: According to state and federal regulations, failure to do the maintenance items marked with an asterisk ( ) will not void the customer s emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability. 3-7

8 Maintenance Minder Maintenance Sub Items Number Maintenance Sub Items 1 Rotate tires, and check tire inflation and condition. Follow the pattern shown in the Owner s Manual. 2 Replace air cleaner element (see page ). If the vehicle is regularly driven in dusty conditions, replace the element every 15,000 miles (24,000 km). Replace dust and pollen filter (see page 21-58). If the vehicle is driven mostly in areas that have high concentrations of dust, pollen, or soot in the air, replace every 15,000 miles (24,000km). Replace the filter whenever airflow from the heating and air conditioning control system is less than normal. Inspect drive belt (see page 4-31). Look for cracks and damage, then check the position of the drive belt auto-tensioner indicator. 3 Replace automatic transmission (see page ) and transfer (see page ) fluid. Driving in mountainous areas at very low vehicle speeds or trailer towing results in higher transmission and transfer fluid temperatures. This requires transmission fluid changes more frequently than recommended by the Maintenance Minder. If the vehicle is regularly driven in these conditions, replace the transmission and transfer fluid every 30,000 miles (48,000 km). Automatic transmission fluid capacity: 3.1 L (3.3 US qt), use Honda automatic transmission fluid (ATF-Z1). Transfer fluid capacity: 0.43 L (0.45 US qt), use hypoid gear oil GL4 or GL5. 4 Replace spark plugs (see page 4-22). Use IZFR5K11 (NGK) or SKJ16DR-M11 (DENSO). Replace timing belt (see page 6-20). If the vehicle is regularly driven in very high temperatures (over 110 F, 43 C), or in very low temperatures (under 20 F, 29 C), or towing a trailer, replace every 60,000 miles (USA models)/100,000 km (Canada models) and inspect water pump (see page 10-5). Inspect the valve clearance (cold) (see page 6-8). Intake: mm ( in.), Exhaust: mm ( in.). 5 Replace engine coolant (see page 10-6). Capacity (including the reservoir tank): 6.2 L (1.64 US gal), use Honda Long Life Antifreeze/Coolant Type 2. 6 Replace VTM-4 rear differential fluid (see page 15-47). Driving in mountainous areas at very low speeds, towing a trailer, or frequently driving fully loaded results in a higher level of mechanical (shear) stress to fluid. This requires differential fluid changes more frequently than recommended by the Maintenance Minder. If you regularly drive your vehicle under these conditions, have the differential fluid changed at 7,500 miles (12,000 km), then every 15,000 miles (24,000 km). Capacity: 2.64 L (2.79 US qt), use Honda VTM-4 Differential Fluid. 3-8