Overview: Packing List:

Transcription

1 CLEANING COMPANION

2 Overview: The Cleaning Companion is a portable, self-contained unit designed to make daily maintenance of your facility easier. This unit includes the following features: Custom fit tool slots and open storage area keeps accessories, spray bottles, wipes, etc. well organized. Push-button bottle fill chemical management with built-in drip tray. Front-mounted hose wrap for supply hose. Built-in battery charger with illuminated plug. Side molded-in hooks for wet-floor sign storage. Chemical selector knob with lighted on/off switch Easy fill large-mouth fill port is set at a convenient height. Capacity for 3 product refills. Each refill has a built-in, sealed, maintenance-free dilution control tip. Security locking mechanism available. Locking front caster. Strain-free supply hose connection. Molded-in clear water gauge. Large, heavy-duty no mark casters. Packing List: Cleaning Companion 7.5 Gallon water reservoir (integral) Spray gun w/ 2 settings 15 ft. discharge hose (installed) 12-volt battery Battery charger (installed) Telescoping handle Instruction manual Cleaning process card 18 Floor Squeegee 05/ of 7

3 Initial Setup: The battery is shipped charged, but NOT installed. - To install the battery, remove the four screws on the back cover. - Connect the red wire to the red terminal on the battery. Note: if the unit begins to run, turn it off with the switch on the front. - Replace the back cover onto the unit. The unit should be charged overnight before putting into service to make sure that the battery has full charge! Attach the spray gun to the discharge hose. Remove the black cap from the water fill port (it rotates counter clockwise to open). Fill the tank to line with cool clear tap water and replace cap. Remove the existing caps shipped and replace with a RDI Cap and the appropriate tip inserted in the top of the cap. (See Tip Chart) Initial Priming In order for the Machine to Prime correctly, you must have a product in place! - Set the nozzle on the spray gun with the silver stainless steel side pointing away from the user. - Set the selector to the desired product. - Turn the switch ON. The power switch is lighted when it is in the on position. - Direct the spray nozzle into a container or drain. Run until a steady spray pattern is established. Washroom Cart Tip Selection Product Dilution Tip Colour Spray & Wipe #1 Powerhouse 1 to 8 Cleaner Blue Bottle Fill #2 Sparkle #4 Sunbeam 1 to 16 Orange Bottle Fill 1 to 32 Purple Bottle Fill 1 to to 150 Light Orange #5 Quato 15 Disinfectant Cleaner 1 to 25 Aqua #7 Quato 44 CLEANING COMPANION 1 to 64 1 to 150 Concentrate Bottle tip in cap. Pink Non Acid #9 WS9 Bowl Cleaner 1 to 64 Pink Odor #12 Aromx Eliminator 1 to 4 No Tip Bottle Fill Neutral #16 Quato 78+ Disinfectant 1 to 128 Reddish Purple Cleaner #19 Paramount Ultra Lean Tips are: Glass Cleaner Neutral Floor Cleaner Disinfectant Cleaner & Germicide Super H 2 O2 Citrus Concentrate Light Orange Olive Green Reddish Purple 1 to 64 1 to 32 Reddish Purple Light Orange - When you release the trigger, the pump should stop almost immediately. If it does not, operate the unit longer as it is not fully primed. Turn the selector to the products and repeat. WASHROOM CART Normal Operation: The power switch is lighted when it is in the on position. The pump will run when the trigger on the spray gun is pulled and stop when it is released. The valve on the outlet of the spray gun selects betwith the 2 attached spray nozzels. Apply product with the S nozzle [stainless steel side (silver)]. The R nozzle [bronze side (brass)] is for rinsing. The rinse is a fine spray pattern, while the stainless is a courser pattern. To apply cleaning solution you must use the stainless steel side for proper dilution. The pump will run for approximately 3 hours on a fully charged battery. The charger cannot be used to run a Cleaning Companion that has a fully discharged battery. Pink Purple SW078 05/ of 7

4 To select which chemical you would like to use, point selector switch to desired chemical using arrow on selector switch. (See Diagram) To select the rinse mode, place selector switch arrow to the position that is straight up from the chemicals. (See Diagram) REFER TO THE FOLLOWING CLEANING PROCESS INFORMATION FOR DETAILED CLEANING PROCEDURES Operation of Side Bottle Filling Feature: 1. Make sure machine is primed and the power switch is in the on position. 2. Select product you would like to fill bottle with. 3. Insert down tube of bottle fill unit into your ready to use container. 4. Depress blue button until ready to use container has reached desired height. Charging the Unit: The charger will recharge a fully discharged battery (pump will not run) overnight (10-12 hours). The charger is charging the battery when the 3-pronged plug is illuminated. The charger is permanently connected to the battery. It should be left plugged into an outlet any time the cleaner is not in use. This will maintain the battery in the fully charged condition. If the cleaner is stored without being plugged in, the battery will drain over a 1 to 2 year period. If the battery is drained, it can be restored with the charger and no damage is done to either the charger or the battery. 05/ of 7

5 Maintenance: Daily: 1. Run 1-2 gallons of clear water through the pump while the selector is in the rinse position (Run approximately 2 to 4 minutes). NOTE: FAILURE TO RINSE THE PUMP AFTER USE WILL VOID THE WARRANTY ON THE PUMP. 2. Rinse both spray nozzles and accessories while you are rinsing the pump. 3. Turn the unit off with the switch. Relieve the pressure in the discharge hose by pulling the trigger on the spray gun after the switch has been turned off. 4. Check the unit for any damage or leakage. 5. Plug the unit into a 110 volt outlet to recharge the battery. 6. If unit is going to be stored where it can freeze, drain the water reservoir and run the pump until there is no more water in the system. Allow the system to thaw before you start the pump. Troubleshooting: 1. If the spray is weak or there is no spray. The pump does not operate at full flow if there is air in the system. Air can enter the system from several sources: a. Out of water fill the water reservoir and prime the system. b. Out of chemical replace the chemical container and prime the system. c. Foot valve is clogged clean or replace the foot valve in the reservoir. To access the foot valve, remove water fill cap and pull tube out of the tank. 2. The pump does not contain any field serviceable parts. It should run for 800 to 1000 hours with no maintenance needed. If leaks occur in the pump, it needs to be replaced. Contact your sales representative for a replacement. 3. Pump pulses. There is a pressure switch in the pump. If the pump is pulsing, this switch is cycling and the life of the pump will be greatly reduced. a. Make sure there are absolutely no air leaks in the system. b. Make sure all connections are tight and there are no water leaks in the system. c. Make sure it is properly primed and have chemical running through the system. d. The switch can be adjusted. Adjust pressure switch as a last option, serious damage can occur by adjusting the pressure switch. It is best to have the switch adjusted by taking to a professional service department. To adjust the switch, remove the blue cover. In the black end of the pump there is a hole. Using a 5/64 hex wrench, turn the screw in the hole CW until the pump operates smoothly. Then turn it an additional ½ turn. If you adjust the switch too far, the pump will leak and need to be replaced. 05/ of 7

6 Warranty Information Cleaning Companion The Cleaning Companion is sold with a full parts and labour warranty. 1 year parts warranty 30 days parts and labour warranty This warranty covers the Cleaning Companion machine with the exception of wear items. Wear items are materials that simply wear out after time and usage. No amount of maintenance will stop them from being consumed. Wear items include gaskets, wheels, cords, hoses, switches, filters, bearings, carbon brushes or other items deemed as a wear item by the manufacturer. This full parts and labour warranty is effective for 30 days from date of delivery. For a full one-year from date of delivery all parts, with the exception of wear items, will be replaced at no charge for the part. This one-year warranty does not cover labour, shipping or handling charges that may apply. This warranty covers manufacturers defects in workmanship. This warranty does not apply to any machine that has had: Damage incurred during shipment or caused by accident. Incompatible or corrosive chemicals used through it. Lack of proper maintenance. Misuse, negligence, abuse, fire or use of the product for other than its intended purpose. Modification of machine from its original condition, service parts installed or repairs performed by anyone other than authorized distributor or service center. Need prompt service on this or any other machine? ask for customer service service@swish.ca Contact your local Location 05/ of 7

7 05/ of 7