G 2000 QT English (06/04)

Transcription

1 G 2000 QT

2 High Pressure Washer Operator Manual Overview... 3 Precautions... 4 Assembly Instructions... 5 Operating Instructions... 6 Using the Accessories... 7 Working with Detergents... 8 Shut Down and Clean-Up... 9 Taking a Break... 9 Winterizing and Long-Term Storage... 9 Cleaning Tips Optional Cleaning Accessories Troubleshooting Specifications Max. Operating pressure 2000 PSI Water volume 2 GPM Detergent suction GPM Engine 4 HP Tecumseh LV 148 Part No Serial No. Kärcher Customer Support USA Kärcher Customer Service CDN

3 Model G 2000 QT OVERVIEW Item Description 3

4 IMPORTANT PRECAUTIONS Read First! 4

5 ASSEMBLY INSTRUCTIONS 5

6 OPERATING INSTRUCTIONS 6

7 USING THE ACCESSORIES Warning TO AVOID SERIOUS INJURY, NEVER POINT SPRAY NOZZLE AT YOURSELF, OTHER PERSONS OR ANIMALS. 7

8 WORKING WITH DETERGENTS 8 Caution Never use: Bleach, Chlorine products and other corrosive chemicals. Liquids containing solvents (i.e., paint thinners, gasoline, oils). Tri-sodium phosphate products. Ammonia products. Acid-based products. These chemicals will harm the unit and will damage the surface being cleaned.

9 SHUTTING DOWN & CLEAN-UP SHUTTING DOWN TAKING A BREAK... five minutes or more MAINTENANCE INSTRUCTIONS WINTERIZING AND LONG-TERM STORAGE few seconds Caution: Failure to follow the above directions will result in damage to the pump assembly and accessories. 9

10 CLEANING TIPS 10 Deck Cleaning House Siding (with or without detergent) Cement Patios, Brick and Stone Cars, Boats & Motorcycles

11 CLEANING TIPS continued Barbecue Grills, Outdoor Power Equipment & Gardening Tools Patio & Lawn Furniture Recommendations OPTIONAL CLEANING ACCESSORIES 11

12 TROUBLESHOOTING No gasoline. - Fill gas tank. Low oil level - Add oil. Engine is not primed. - Push primer ball three times. Engine throttle is not in correct position. - Position the throttle to FAST. Pressure built up in the high pressure washer. - Squeeze the trigger to release the pressure. 12 Diameter of garden hose is too small. - Replace with a 3/4 inch garden hose. Water supply is restricted. - Check garden hose for kinks, leaks and blockage. Not enough inlet water supply. - Open water source full force. Water inlet filter is clogged. - Remove filter and rinse out in warm water. Spray wand is in low pressure position. - Turn spray wand tip to high pressure position. Not enough inlet water supply. - Turn water on full force. Check garden hose for kinks, leaks or blockage. Pump is sucking air. - Check that hoses and fittings are air tight. Turn off machine and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Water inlet filter is clogged. - Remove filter and rinse out in warm water. Spray nozzle is obstructed. - Blow out or remove debris with a fine needle. Calcified gun, hose or spray wand. - Run distilled vinegar through detergent suction tube. Detergent suction tube not properly connected to the machine. - Check connection. Detergent is too thick. - Dilute detergent. For best results, use Kärcher detergent. Detergent filter valve is at lowest setting. - Set detergent filter valve to a higher setting. Filter on detergent suction tube is clogged. - Run warm water through filter to remove debris. Damaged or clogged detergent suction tube. - Remove obstruction or replace detergent suction tube. Spray wand is in high pressure position. - Turn spray wand tip to low pressure position. Spray nozzle is obstructed. - Blow out or remove debris with fine needle.

13 TROUBLESHOOTING continued Loose fittings. - Tighten fittings. Missing/worn rubber washer. - Insert new washer. Spray wand not properly attached. - Insert the spray wand into the trigger gun. Carefully press in against the spring tension and twist into the locked position. Broken o-ring or plastic insert. - Call Kärcher customer service hotline and order repair kit Pump is sucking air. - Check that hoses and fittings are air tight. Turn off machine and purgepump by squeezing trigger gun until a steady flow of water emerges through the nozzle. Loose fittings. - Check that all fittings are tight. Water seals are damaged or worn. - Call service center. Thermal protection device is activated. - Thermal protection device will auto reset. Oil seals are damaged or worn. Call service center. WARRANTY USA WARRANTY CDN Kärcher Customer Support USA 13 Kärcher Customer Service CDN

14 Manual del Operador Generalidades Precauciones Instrucciones de Ensamblaje Instrucciones de Operación Uso de los Accesorios Trabajo con Detergentes Tomando un descanso Preparación para el Invierno y Almacenaje de Largo Plazo Sugerencias de Limpieza Accesorios de Limpieza Opcionales Localización de Fallas Mecánicas Especificaciones Presión de operación 2000 PSI Volumen de agua 2 GPM Aspiración de detergent GPM Motor 4 HP Tecumseh LV 148 Part No Serial No. Kärcher En USA Kärcher En Mexico