Superintendent Rig Checklist

Transcription

1 Superintendent Rig Checklist Rig #: Operating Company: Well Name & #: Date/Time of Inspection: Inspected By: Company Man: Tool pusher: Driller: Ton Miles Logged and up to date: BOP Drill date and time: Crown-o-matic function tested: Pre-tour Safety Meeting Topic: Thrust limiter set and tested: J.S.A. available for present task: Authorized Personnel Sign Posted at entrance to site: DRILL SITE/LOCATION Visible rig identification sign erected at entrance to site road: And at all directional changes on site road: Hard Hat/Safety Glasses/Steel Toe Shoe Signs Posted at entrance to site and other prominent locations on site: No Smoking Area s Designated & Posted: Hard hats & Safety glasses available for visitors: Tool pusher s trailer Clean and organized: Tool pusher at rig location: Primary Muster area designated: Secondary Muster area designated: Supply storage house clean and organized: Crew change house clean: Work area s are maintained clean and free of debris and tripping hazards: Tool pusher shack clean and organized Hands living quarters clean All belts, gears, shafts and drives guarded Mud pump KEVLAR belt tightened correctly Pony rods seals in good shape and installed properly Pony Rods guards in place (DOWN) Pulsation dampeners charged to psi Proper nails installed in pop offs Ends of relief lines, high pressure lines, etc secured MUD PUMP AREA PUMP 1 PUMP 2 Y or N Y or N 1

2 Ends of mud vibrator hose snubbed Radiators clean and full of antifreeze Bolts on WPT s tight and all in place All lights working and not damaged WPT properly greased and reliefs verified to expel grease Module bolts torqued to spec with torque multiplier Torque Multiplier on site Liner washer pumps working and plumbed per SOP Oil level in Gear End Date oil last changed in gear ends Oil pressure on gear oil pumps psi psi WPT air pressure psi psi Mud pit gate closed with proper pins Mud pit gate in good shape Adequate personal protective equipment available: Employees using all required PPE Personal protective equipment properly stored PPE required warning signs erected Chemical hazard warning signs erected MUD PITS Eye wash station full and charged Eye wash station/emergency shower in a clean & sanitary condition All valves working and in good shape Centrifugals working with no leaks All pit agitators working and properly maintained All pit grating in good shape All pit access points covered with proper lids and not left open Adequate lighting provided General housekeeping kept clean and organized Adequate stairs with handrails Walkways free from obstruction and/or damage Shale shakers working properly Desander/Desilter working properly ALL Stairways and ladders secured All unused floor holes covered All electrical EP BOXES closed with ALL bolts in place 2

3 Electric wiring in good condition All handles, agitator boxes and floor obstructions painted with HIGH VIS paint Generators properly grounded GENERATORS Cover panels on electrical control boxes installed and closed. Insulating mats available at electrical panels Electrical wires properly strung Air compressors properly guarded Air storage tanks equipped with pop-off valve Lockout/Tag out devices available Adequate lighting installed General Housekeeping Wires not running along the ground Fire extinguishers located properly and not obstructed BOP stack properly stabilized All hydraulic lines connected Accumulator function tested tourly Accumulator unit properly located BLOW-OUT PREVENTER/KUMMY Accumulator bottles labeled with contents and pressured up Accumulator valves in appropriate position Accumulator free of leaks Accumulator remote properly hooked up Choke line secured Choke manifold accessible Choke manifold valves handles in place Kill line system connected and functional Derrick assembly pins in place Assembly pins secured with keepers Substructure assembly pins in place Substructure assembly pins secured with keepers Condition of derrick ladder DERRICK & SUBSTRUCTURE 3

4 SRL (Sala Block) in place and line retracted with rope tie off when not in use Climb assist device in place and used by derrickman. Full body harness with lanyard available and kept in good condition Derrick latching dog extension/retraction device working properly Crown section in proper position (Drilling or Moving) Latch dog visually inspected prior to loading derrick Crown sheave guards in place Crown sheaves greased Crown light working Dead line properly anchored Adequate lighting provided Derrick emergency escape line installed Derrick escape device on-line and ready for immediate access Emergency escape line adequately anchored All gauges working properly Wiggle steer working properly Filter warning lights on Blinds / Rams open & closed sign All safety papers posted OSHA poster in place Kill Sheet properly filled out Pipe handler controls operating properly Camera s and monitor in place and operating Drill Shack Clean and organized Rotary floor in good condition Driller at or near controls while in operation Weight indicator installed and visible Weight indicator visible to Driller DRILL SHACK & DRILL FLOOR Driller s controls properly labeled/identified Pipe slips & Dies in good condition, keepers in good condition Hydraulic hoist line in good condition and slings utilized when not in use Kelly cock wrench and safety valve accessible Disk assist brakes being used properly and not as a Hydromantic Drill Floor s General housekeeping Non skid material used around rotary 4

5 Hand rails installed and in good condition TOP-DRIVE Tourly inspection being conducted All rollers in good shape and adjusted properly All hydraulic lines in good shape Socks in place around hoses, secured at both ends and in good shape Free of Oil leaks Swivel packing not leaking and installed with big nut on top Proper Air pressure to brakes Carrier sheaves greased daily Wiggle steer working properly Working properly All safety cables in place Roll cylinders in good shape All bushings & pins greased All hydraulic pipe rack controls working Lined up properly with Top-drive Dies ground down Free of leaks Properly roped off Pipehandler tub drained and free obstructions Pipehandler being kept clean PIPE HANDLER Ends of pipe racks properly chocked Spacers used to separate layers of pipe Layers of pipe properly chocked Pipe racks are level and stable Employees not permitted on top of pipe Adequate lighting provided PIPE RACK AREA 5

6 6