/99 LIONEL. Lionel Route 66 Cafe Owner s Manual

Transcription

1 /99 LIONEL Lionel Route 66 Cafe Owner s Manual

2 Congratulations! Congratulations on your purchase of the Lionel Route 66 Cafe. This Lionel illuminated accessory is made of sturdy plastics, vinyl, and features both interior and exterior illumination. The Route 66 Cafe can be placed in any Lionel O or O-27 three-rail layout and is designed to operate at 12 to 18 volts alternating current. Table of contents Assembling your Route 66 Cafe Parts breakdown 3 Wiring the Route 66 Cafe 4 Connecting the parking lot lights 5 Installing the caveman, pumps, and sign 6 Maintaining and servicing your Lionel Route 66 Cafe Replacing your Route 66 Cafe s lamps 7 Lionel Service 8 2

3 Assembling your Route 66 Cafe T here are a few components you will need to install on your Route 66 cafe. Check to make sure you have all of the following: 1 Caveman with bone Part No. 6SP Oil drum Part No. 6SP red fuel pump Part No. 6SP entrance sign Part No. 6SP green fuel pump Part No. 6SP parking lights Part No. 6SP Oil can display case Part No. 6SP

4 Wiring your Route 66 Cafe Your Lionel Route 66 Cafe will illuminate best from 12 to 18 vac. It can be powered with track power or a separate accessory power supply. Connect the two insulated wires (included) from track power or a separate accessory power supply to the spring clips on the bottom of the Route 66 Cafe as shown below. To connect the wires to the spring clips, insert a wire into each of the two spring clips on the base of the cafe. It s easy! Depress the spring clip with your finger and insert the bare end of the wire into the exposed opening. Release the spring clip. Give the wire a little tug to make sure it s secure. Repeat these steps with the other spring clip. Track or accessory power NOTE: Do NOT hook your Route 66 Cafe to a SC-1. You will damage the SC-1 due to an amperage overload. 4

5 Connecting the parking lot lights To install your parking lights you will have to flip over your route 66 cafe and remove the four screws shown in the diagram below. Next, feed the leads from the parking lights through the keyed holes in the base and insert the keyed lamp base into the matching keyed hole in the Cafe base. Connect one lead from each parking light into one of the spring clips on the bottom of the base. Take the other two leads and place them into the other spring clip. NOTE: You do not need to worry about getting the same lead from each parking light. Choosing either lead will work, (polarity does not matter). Place the leads from the parking lights between the posts (See Diagram) and hold in place by attaching the wiring protective plates with the four screws you removed earlier. Your parking lights are now secure. Wires Lamp pole Keyed Wiring protective plates One wire from each lamp installed in both clips. Wires from lamp Posts Bottom of Route 66 Cafe One side of Cafe shown 5

6 Installing Caveman, pumps, and cafe sign The installation of the caveman with bone is very simple. Insert the caveman with bone into the holes located under the dinosaur s neck as shown in the diagram below. Press in until the feet of the caveman are flush to the ground. For installation of the gas pumps simply press into the holes located on either side of the caveman with bone. Installation of the entrance sign requires only pressing into the two holes located in front of the caveman with bone. The oil drum and the oil can display case can be placed anywhere on your route 66 cafe. You are now ready to illuminate your Route 66 cafe. To do this, simply flip the switch mounted by the rear of the cafe to the ON position. Install the barrel and oil can rack were you choose on your Route 66 Cafe 6

7 Replacing your Route 66 Cafe s lamps Five bulbs illuminate your Route 66 Cafe. During the course of normal operation, they may require replacement. To replace the lamps in the parking lights, disconnect the leads from the spring clips on the bottom of the base. Also remove the wiring protective plate. Then pull the lamp shade straight off. Finally, pull the lamp and leads straight out. DO NOT TWIST. The replacement lamp part number is , which is avaiable from your authorized Lionel service center or the Lionel Customer Service Department. In order to replace the bulb inside of the cafe, you must remove the three screws on the bottom of the base shown on the diagram below. After you have removed the screws, pull that piece out from the bottom. You can then twist and pull the expired bulb (Part Number ) and replace it with a new one. Insert back into the house and screw to secure. You will be unable to replace the lamps located in the bone or fuel pumps. If you need a new caveman with bone or fuel pump, please contact either the Lionel Customer Service Department or an authorized Lionel service center. Twist and pull out bulb Lionel part No

8 Limited Warranty/Lionel Service This Lionel product including all mechanical and electrical components, moving parts, motors and structural components, except for light bulbs, is warranted to the original consumer-purchaser, for 1 year against original defects in materials or workmanship when purchased through an authorized Lionel merchant. This warranty does NOT cover normal wear and tear, light bulbs, defects appearing in the course of commercial use, or damage resulting from abuse or misuse of the product by the purchaser. Transfer of this product by the original consumer-purchaser to another person voids this warranty. Modification of this product voids this warranty. Any warranted product which is defective in original materials or workmanship and is delivered by the original consumer-purchaser to Lionel L.L.C. or an authorized Lionel L.L.C. service center, together with proof of original purchase, will at the option of Lionel L.L.C. be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted. Any products on which warranty service is sought must be sent freight or postage prepaid, as transportation and shipping charges are not covered by the warranty. IN NO EVENT SHALL LIONEL L.L.C. BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. This limited warranty gives you specific legal rights, and you may have other rights which vary from state to state. INSTRUCTIONS FOR OBTAINING SERVICE If service for this Lionel L.L.C. product is required, bring the item, along with your dated sales receipt and completed warranty information to the nearest Authorized Lionel Service Center. Your nearest Lionel Service Center can be found by calling Lionel, or by contacting our If you prefer to send it back to Lionel L.L.C. for factory repair, you must first call or FAX or write to Customer Service, P.O. Box 748 New Baltimore, MI stating what the item is, when it was purchased and what seems to be the problem. You will be sent a return authorization letter and label to assure your merchandise will be properly handled upon receipt. Once you have received your return authorization and label, make sure that the item is packed to prevent damage during shipping and handling. We suggest that you use the products original packaging. This shipment must be prepaid and we recommend that it be insured. Please make sure you have followed all of the above instructions carefully before returning any merchandise for service. You may choose to have your product repaired by one of our Authorized Lionel Service Centers after its warranty has expired. Areasonable service fee will be charged. WARRANTY INFORMATION Please complete the information below and keep it, along with your dated sales receipt. You must present this and your dated sales receipt when requesting warranty service. NAME ADDRESS PLACE OF PURCHASE DATE OF PURCHASE PRODUCT NUMBER PRODUCT DESCRIPTION 1998 LIONEL LLC, CHESTERFIELD MI UNITED STATES OF AMERICA