Product Data. 95% AFUE Single Stage Furnace Upflow / Downflow / Horizontal. ama 58HDX COMFORT 95 DIRECT OR NON---DIRECT VENT CONDENSING GAS FURNACE

Size: px

Start display at page:

Download "Product Data. 95% AFUE Single Stage Furnace Upflow / Downflow / Horizontal. ama 58HDX COMFORT 95 DIRECT OR NON---DIRECT VENT CONDENSING GAS FURNACE"

Logan Brooks
6 years ago
Views:

COMFORT 95 DIRECT OR NON---DIRECT VENT 4 --- WAY MULTIPOISE CONDENSING GAS FURNACE 95% AFUE Single Stage Furnace Upflow / Downflow / Horizontal FLEXIBILITY S Dual certified venting (1 or 2 pipes)

1 COMFORT 95 DIRECT OR NON---DIRECT VENT WAY MULTIPOISE CONDENSING GAS FURNACE 95% AFUE Single Stage Furnace Upflow / Downflow / Horizontal FLEXIBILITY S Dual certified venting (1 or 2 pipes) Direct Vent furnace S 40 (1016 mm) high with wider cabinets, for ease of installation S Factory shipped for natural gas, with Propane Gas conversion kits available S Multipoise - Upflow/downflow/horizontal installation S Vent pipe can be run horizontally or vertically S Internal condensate drain system SERVICE S Self diagnostics S Entire blower assembly mounted on rails Product Data COMFORT S Adjustable timed blower Off delay S Thermal lined, one piece steel cabinet for noise reduction S 24 and 115 VAC humidifier terminal S Electronic air cleaner terminal S Insulated blower compartment EFFICIENCY S 95% AFUE, upflow / downflow S Up to 95%* AFUE, horizontal S Single stage gas valve operation S Single stage integrated control S Multispeed, permanently PSC blower motors S Induced draft blower S In -shot burners S California NOx approved QUALITY S Stainless steel primary heat exchanger S Stainless steel secondary heat exchanger S High temperature limit control prevents overheating S Dependable hot surface ignition with Silicon Nitride igniter S Flame roll-out sensors standard *See Furnace Specifications for clarification A09326 APPLICATION HAZARD Failure to follow this warning could result in personal injury or death This furnace is not designed for use in mobile homes, trailers, or recreational vehicles. C! WARNING CERTIFIED E D E S R T I G N I F I E D ama As an ENERGY STAR Partner, we have determined that this product meets the ENERGY STAR guidelines for energy efficiency. 1

2 FURNACE SPECIFICATIONS Model Number NATURAL GAS INPUT (btuh){ 60,000 80,000 80, ,000 HTG. CAP. (btuh) 58,000 77,000 77,000 96,000 AFUE* - Upflow / Downflow AFUE* - Horizontal NOx (Ng/J) <40 <40 <40 <40 TEMP. RISE DEGREES - o F( o C) (17-33) (19-46) (17-33) (17-33) VOLTS/HZ/PH 115/1/60 115/1/60 115/1/60 115/1/60 MIN./MAX. VOLTAGE 104/ / / /127 RATING PLATE AMPS TRANSFORMER (V.A.) GASPIPESIZE -In(mm) 1/2 (13 mm) 1/2 (13 mm) 1/2 (13 mm) 1/2 (13 mm) VENT SIZE^ 2 or 3 (51or76mm)OD 3 (76 mm) OD 3 (76 mm) OD 3 (76 mm) OD COOLING CAP FILTER SIZE - In (mm) (1 required) 16 x 25 x 1 16 x 25 x 1 16x25x 1(2) 16x25x1(2) DIMENSIONS - HEIGHT In (mm) 40 (1016) 40 (1016) 40 (1016) 40 (1016) DIMENSIONS - WIDTH X DEPTH - In (mm) 19 1 / 8 x29 (487 x 737) 22 3 / 4 x29 (573 x 737) 22 3 / 4 x29 (573 x 737) 2 x29 (622 x 737) WEIGHT - Lbs. (Kg.) 153 (69.3) 172 (78.0) 180 (81.6) 193 (87.5) * Capacity and AFUE in accordance with U.S. Government DOE test procedures. {Gas input ratings are certified for elevations to 2000 ft. (610 M). For elevations above 2000 ft. (610 M), reduce ratings 2% for each 1000 ft. (305 M) above sea level. In Canada, derate the unit 5% for elevations 2000 to 4500 ft. (610 to 1372 M) above sea level. ^ Vent size may vary depending on length, number of elbows, standard vent or direct vent. See Installation Instructions. MAX CFM s for Factory Washable Filters Filter Size (In. / mm) CFM 14 X x 635) X25 (406 x 635) X 25 (508 x 635) X 25 (610 x 635) 2500 Max CFM based on 600 FPM # CFM --- Cubic Feet per Minute airflow. Filter required for each return---air inlet. Airflow performance includes 1 (25 mm) washable (600 FPM max) filter media. Disposable filters are typically rated at 300 FPM and only allow half of the airflow when compared to 600 FPM filters. Example: 20 x 600 FPM = FPM = 1000 CFM. 2

3 ACCESSORIES Model Number Description Used With Models KGANP48011HW Gas Conversion Kits - Natural gas to propane conversion Kit. Allows field conversion to propane gas. KGAPN41011HW Gas Conversion Kits - Propane to natural gas conversion kit. Allows field conversion to natural gas. KGAFR0901P16 Filter Kits - External filter frame. 16 x25 (406 x 635 mm) KGAFR1001P20 Filter Kits - External filter frame. 20 x 25 (508 x 635 mm) P Condensate neutralizer kit - for condensing gas furnaces All if required KGAVT0801CVT KGAVT0701CVT 3 (76 mm) Concentric vent kit - allows single wall penetration for 2 pipe direct vent applications (90+). 2 (51 mm) Concentric vent kit - allows single wall penetration for 2 pipe direct vent applications (90+) KGAHA6201PSW High Altitude Pressure Switch Kit 060 KGAHA6301PSW High Altitude Pressure Switch Kit 080 KGAHA6401PSW High Altitude Pressure Switch Kit 100 KGASB0301P01 KGASB0401P02 Combustible Floor Base used without cased coil used KGASB0801P06 KGASB0501P03 KGASB0601P04 Combustible Floor Base used with cased coil used KGASB0701P05 KGADA0101PYN Downflow Coil Adapter used between furnace and coil Size Size Size Size Size Size Orifice Kit + (Qty. 5) Size Size Size Size Size Size 56 + Must be ordered from Replacement Components Division The direct-vent 4 -way multipoise gas furnace has been designed to work specifically with A -coils offered by Carrier. furnaces are not N -coil compatible. The following table shows our recommended furnace coils: These Model Evaporator Coil Coil Dimension - In. (mm) CA*MP3619ACA 29-3/4 x 22-7/8 x 20-5/8 (756 x 581 x 524) CA*MP4823ACA 29-3/4 x 22-7/8 x 20-5/8 (756 x 581 x 524) CA*MP4823ACA 29-3/4 x 22-7/8 x 20-5/8 (756 x 581 x 524) CA*MP6025ACA 35x24-1/2x20-5/8 (889 x 622 x 524) 3

4 BLOWER PERFORMANCE Model Number BLOWER SIZE IN. (mm) (DIA. x WIDTH) MOTOR H.P. (TYPE) 1 / 2 (PSC) 1 / 3 (PSC) 1 / 2 (PSC) 3 / 4 (PSC) MOTOR SPEEDS AIRFLOW DATA (CFM) Furnace External Static Pressing (in wc).10 ESP in wc.20 ESP in wc.30 ESP in wc.40 ESP in wc.50 ESP in wc.60 ESP in wc.70 ESP in wc.80 ESP in wc.90 ESP in wc 1.00 ESP in wc Furnace Motor Speed Selection Airflow - CFM LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH LOW MEDIUM LOW MEDIUM HIGH HIGH NOTE: (1) Data based on Bottom Only or One Side return. NOTE: (2) Gray area is above maximum temperature rise range. 4

5 DIMENSIONS - IN. (MM) Cabinet to Combustible Clearances TOP BOTTOM RH LH BACK FRONT FLUE 1 (25) 0 (0) 0 (0) 0 (0) 0 (0) 3 (76) 0 (0) 2 1 / 4 (57.2) 13 1 / 4 (336.6) TOP LEFT SIDE TRAP (KO) (COUNTERFLOW) AIR INTAKE (KO) (ALTERNATE) GAS VENT TRAP (KO) UPFLOW/HORIZONTAL THERMOSTAT (KO) E 4 13 / 16 (122.2) F 7 (177.8) G AIR INTAKE VENT H 6 11 / 16 ELECTRICAL (177.5) 1 1 / 4 (318) 1 1 / (27) / 16 (347.7) / 16 (34.9) (804.9) 1 3 / (758.8) / / 4 (730.3) 24 1 / (611.2) / /16 (439.7) 1 11 (503.2) / 16 (42.9) A B FRONT MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS FOR ALL UNITS - in (mm) REAR 0 FRONT (combustion air openings in 3 (76.2) furnace and in structure) Required For Service *24 (609.6) ALL SIDES Of SUPPLY PLENUM 1 (25.4) SIDES 0 VENT 0 TOP OF FURNACE 1 (25.4) *30 (762mm) clearance recommended for furnace removal. Horizontal position: Line contact is permissible only between lines formed by intersections of top and two sides of furnace jacket, and building joists, studs or framing. NOTE: Evaporator A coil drain pan dimensions may vary from furnace duct opening size. Always consult evaporator specifications for duct size requirements. Furnace is designed for bottom return or side return. Return air through back of furnace is NOT allowed. 1 1 / 4 (31.7) 21 5 / (549.3) / 8 (47.6 ) 24 (609.6) 4 7 / 8 (123.8) Drawing is representative, but some models may vary 2 7 / 8 (73) 4 5 / (109.5) / 8 (60.3 ) 1 1 / (27) / 2 (723.9) 18 1 / 2 3 / 4 (19.1) (469.9) TYPE D BOTTOM GAS (KO) RIGHT SIDE TRAP (KO) (COUNTERFLOW) C ELECTRICAL (KO) 23 1 / AIR INTAKE (KO) / 8 (587.4) (98.4) ALL DIMENSIONS: in (mm) (ALTERNATE) 1 3 / 4 13 / (30.2) (122.2) VENT (KO) TRAP (KO) 1 1 / 16 HORIZONTAL 29 7 / 8 (27) (758.8) 7 21 / 27 3 / 4 16 (690.6) 21 5 (177.8) (57.2) / 8 THERMOSTAT 9 13 / 16 (549.3) (249.2) 17 5 / 13 1 / / 16 (439.7) (336.6) (855.7) 1 11 / 16 (KO) (42.9) 40 (1016) Unit Capacity Cabinet Bottom Top A B C D E F G H KO = KnockOut 47 / 215 / 8 8 (123.8) (549.3) 17 / 8 24 (47.6) (609.6) / 8 (485.8) 17 5 / 8 (447.7) 2 1 / 8 (54) 14 3 / 4 (374.7) 2 1 / 2 (63.5) 9 1 / 2 (241.3) / 4 (577.9) 21 1 / 4 (539.8) 1 15 / 16 (49.2) 18 3 / 4 (476.3) 2 1 / 2 (63.5) 9 1 / 2 (241.3) / 4 (577.9) 2 (622.3) 21 1 / 4 (539.8) 23 (584.2) 1 15 / 16 (49.2) 7 / 16 (11.1) 18 3 / 4 (476.3) 23 (584.2) 2 5 / 8 (66.7) 2 1 / 4 (57.2) 11 3 / 8 (288.9) 12 1 / 4 (311.2) Specifications are subject to change without notice. A09268C 5

6 Copyright 2009 Carrier Corp. S 7310 W. Morris St. S Indianapolis, IN Printed in U.S.A. Edition Date: 09/09 Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations. Catalog No: ---02PD Replaces: ---01PD 6

Product Data. that this product meets the S 95% AFUE S Two -stage operation

Product Data. that this product meets the S 95% AFUE S Two -stage operation DIRECT VENT 4 -WAY MULTIPOISE CONDENSING GAS FURNACE 95% DOWNFLOW / HORIZONTAL ORIENTATIONS 93.5% UPFLOW ORIENTATION 95% Variable Speed Two -Stage Heating Furnace FLEXIBILITY S Supports two -stage cooling