THERMAL SHOCK TEST REPORT

Transcription

1 Report No. :DH A Version:A THERMAL SHOCK TEST REPORT Company :FLIP CHIP OPTO. INC. Address :No.185, Kewang Rd., Longtan Dist., Taoyuan City 325, Taiwan (R.O.C.) Model Name :Apollo 600-B Lot Number :No.1, No.2, No.3 Date Received :OCT 01, 2015 Date Tested :NOV 24, 2015 TESTING LABORATORY IS ACCREDITED BY: ISO accredited in respect of laboratory is approved by TAF Certificate No.:L ISTA certified laboratory (ID: ST-9389) WE HEREBY CERTIFY THAT: The test(s) shown in the attachment were conducted according to the indicating procedures. We assume full responsibility for the accuracy and completeness of these tests and vouch for the qualifications of all personnel performing them. Name Signature Date Test Engineer Nancy Chang Dec 01, 2015 Manager General Lee Dec 01, 2015 NOTE: 1. This report will be invalid if reproduced in part or altered in any way. 2. This report refers only to the specimen(s) submitted to test, and is invalid if used otherwise. 3. This report is ONLY valid with the examination seal and signature of this institute. 4. The tested specimen(s) will only be preserved for thirty days from the date issued, if not collected by the applicant.

2 Reliability Engineering Group Page 1 of 10 TABLE OF CONTENTS 1. GENERAL INFORMATION 1.1 DESCRIPTION OF UNIT THERMAL SHOCK TEST 2.1 TEST EQUIPMENT LABORATORY AMBIENCE CONDITION REFERENCE DOCUMENT TEST CONDITION SUMMARY OF TEST... 3 ATTACHMENTS... 4

3 Reliability Engineering Group Page 2 of GENERAL INFORMATION 1.1 DESCRIPTION OF UNIT Manufacturer:FLIP CHIP OPTO. INC. Model name: Apollo 600-B Lot number:no.1, No.2, No.3 Sample quantity:each lot 1 piece, total of 3 pieces

4 Reliability Engineering Group Page 3 of TEMPERATURE CYCLING TEST 2.1 TEST EQUIPMENT Model Serial Number Calibration Date ESPEC TPC-222M APR14, LABORATORY AMBIENCE CONDITION Temperature:25 C ± 5 C Relative humidity:55 % ± 15 % (RH) 2.3 REFERENCE DOCUMENT The test is based on customer specification 2.4 TEST CONDITION Temperature range:-40 C to +125 C Duration of exposure:15 minutes exposure at each temperature extreme Transfer time:10 seconds Number of cycles:1000 cycles 2.5 SUMMARY OF TEST Visual inspection of sample surfaces showed no abnormity. Functional check is performed by customer.

5 Reliability Engineering Group Page 4 of 10 Attachment 1:Photo of setup Test equipment Setup

6 Reliability Engineering Group Page 5 of 10 Attachment 2:Photo of units before and after test No.1 0 cycle 100 cycles 200 cycles 300 cycles 400 cycles 500 cycles

7 Reliability Engineering Group Page 6 of 10 No cycle 700 cycles 800 cycles 900 cycles 1000 cycles Blank

8 Reliability Engineering Group Page 7 of 10 No.2 0 cycle 100 cycles 200 cycles 300 cycles 400 cycles 500 cycles

9 Reliability Engineering Group Page 8 of 10 No cycle 700 cycles 800 cycles 900 cycles 1000 cycles Blank

10 Reliability Engineering Group Page 9 of 10 No.3 0 cycle 100 cycles 200 cycles 300 cycles 400 cycles 500 cycles

11 Reliability Engineering Group Page 10 of 10 No cycle 700 cycles 800 cycles 900 cycles 1000 cycles Blank << The Following Blank >>