EURO ECO / EURO deluxe DC 2 EURO ECO DC 2 EURO deluxe. Installation Manual DC 2. DC 2 - Control Unit conforms to DIN EN 12453

Transcription

1 EURO ECO / EURO deluxe DC EURO ECO DC EURO deluxe DC DC - Control Unit conforms to DIN EN

2 DC EURO ECO DC EURO deluxe Connection -phase 0VAC motor power supply C L N PE PE L N M remove bridge when installing build-in-starters connection for build-in-starters C L MS N PE power supply PE L N

3 DC EURO ECO DC EURO deluxe Turn power on Checking red light off green light on ready to operate running up door postion up stop middle running down door postion down turn power off 9

4 DC EURO ECO DC EURO deluxe RT running time GB D/F GB D/F D/F GB GB D/F 8 CT closing time AZ AZ AZ AZ Turn power on. Ready to operate.

5 DC EURO ECO DC EURO deluxe Program II keypad external timer transponder on radio control green light Program I on no testing sec. prewarning in-active geba article 0.LSE.OL 8,k Ω testing active min. prewarning active 0

6 DC EURO ECO DC EURO deluxe Turn power on Checking green light on turn power off Program on CT closing time off CT closing time 0 sec. go function off prewarning in-active testing in-active 8,k Ω CT closing time on CT closing time 0 sec. go function active prewarning active testing active Turn power on ready to operate.

7 DC EURO ECO DC EURO deluxe The door control DC EURO is designed for hold to run control of power operated doors. The basic version is designed for hold to run operation only, and you are not allowed to use the automatic function without using additional safety devices. Safety Directions In case of using DC EURO with a permanent mains connection, an all-pole main switch with an appropriate back-up fuse must be provided. Before operation, check whether the permissible mains voltage range of the device corresponds to the local mains voltage. Please note that the door control as well as the motor are for indoor installation only. During installation, initial operation, maintenance and testing of the DC EURO it is necessary to observe the safety and accident prevention regulations valid for the specific application. ly trained electrical craftsmen should work on electrical equipment. Appliance according to the regulations The door control DC EURO is provided for the operation of sectional-, rollershutter-, folding- and swingdoors. The manufacturer of the complete installation is responsible. He must take care that the relevant standards and guidelines (e.g. DIN 98, EN 00) have to be respected. He must take care that a technical documentation of the whole installation is made available. The technical documentation must be added to the door unit., operating and use of the unit against this manual or the described technical specifications causes danger for persons and produces a liability- and obligations release. National and regional precautions and standards for the installation, as well as safety precautions of local technical standards have to be respected. Technical data Model DC EURO deluxe DC EURO ECO Supply voltage 0VAC,VA 0VAC,VA Frequency 0 Hz 0 Hz Protection class IP IP Outputs motor x NO relay contact 0 V / A x NO relay contact 0 V / A x NO relay contact 0 V / A x unregulated supply voltage x unregulated supply voltage V DC, max. 0mA V DC, max. 0mA Wiring, mm² max., mm² max. Operating temperature - 0 C to + C - 0 C to + C

8 DC EURO ECO DC EURO deluxe Table of contents Security instructions and technical data p DC EURO ECO -phase 0VAC motor and build-in-starters p Layout p Programming p Optional programming radio control p Troubleshooting p DC EURO deluxe -phase 0VAC motor and build-in-starters p Layout p8 Status display p9 Programming p0- Troubleshooting p Connection and Accessories for DC EURO ECO and DC EURO deluxe Limit switches p KDT / M-Series T and KDT Pushbutton p M-Series T, emergency stop / KDT and ES Series p J-Series and J-Series with Stop p LS and LS Photobeams p Safety-edge Pro-Sec-O p9 Connection and Accessories for DC EURO deluxe only LS and LS Reflector p8 LS Photobeam and 8k Ω resistor p9 Signal light 0VAC and Court light 0VAC p0 Cody wiring and programming p- Transponder wiring and programming p- Radio control programming p-

9 DC EURO ECO DC EURO deluxe troubleshooting Status Display Status red LED Beep Action to take No,,, No,, Yes No,, Yes 8 Yes RT error Yes,, Safety top barrier No,, Yes 0 No, 9 Security active damaged active damaged Relais damaged active Safety top barrier damaged No Power control installation change module control DIP-switch position change safety edge control pre-wired electrical bridges 8 change photobeam control limit switches 9 change fuse contact dealer 0 change the safety top barrier

10 DC EURO ECO DC EURO deluxe troubleshooting Status red LED action to take x,, active x,,, damaged x x Security RT,,,, error No power,9 control installation change module control DIP-switch position change safety edge control pre-wired electrical bridges 8 change photobeam control limit switches 9 change fuse contact dealer 0 change the safety top barrier

11 DC EURO ECO DC EURO deluxe Connection Limit Switch open Limit Switch open No Limit Switches (bridged!) Limit Switch close Limit Switch close Prelimit Switch Prelimit Switch Limit Switch open Limit Switch open Limit Switch close Limit Switch close Prelimit Switch Prelimit Switch open remove bridges when installing build-in-starters open close close pre pre

12 DC EURO ECO DC EURO deluxe Connection accessories KDT Pushbutton C Stop DWN UP NO NO UP DWN Stop KDT Pushbutton / M-Series T C Stop DWN UP remove bridge when installing KDT Pushbutton NO NO UP DWN

13 DC EURO ECO DC EURO deluxe M-Series T NO Emergency Stop / KDT remove bridge ES Series C Stop DWN UP

14 DC EURO ECO DC EURO deluxe Photobeams LS V GND NA C - + RX TX - + (NO) LS V GND remove bridge GND RX VDD - + GND VDD N0 C O M - + TX

15 DC EURO ECO DC EURO deluxe LS Reflector V GND CND VDD ON CC () RX/TX LS Reflector BU BN remove bridge Cut BK WH GY - + V GND C NO UV UB RX/TX 8

16 DC EURO ECO DC EURO deluxe Court light (0 VAC) / Signal light light DC EURO deluxe Signal light (0 VAC) Signal S PE L N 0

17 DC EURO ECO DC EURO deluxe J-Series C Stop DWN UP P remove bridge when installing J-Series with Stop J with Stop C Stop DWN UP P

18 DC EURO ECO DC EURO deluxe Optional accessories for DC deluxe Cody. Wiring Keypad. DIP-switch / Program Programming mode on. Insert Codes (0 different Codes with or digits) programming Insert Code (e.g.) Confirm Status Display Beep

19 DC EURO ECO DC EURO deluxe. Programming mode off. Cancel Codes press micro push-button to choose press micro push-button two seconds code canceled / postion free

20 DC EURO ECO DC EURO deluxe LS V GND remove bridge - + RX - + C NO TX 8k V 8,kΩ SKS GND 8,kΩ Safety-edge Pro-Sec-O V SKS GR BN BN GR RX WH GND WH TX 9

21 DC EURO ECO DC EURO deluxe Transponder. Wiring V SKS GND IN IN. DIP-switch / Program Programming mode on

22 DC EURO ECO DC EURO deluxe. Programming max. 0 different Keys Key Nr. position Maximum 0 Keys. Programming mode off. Cancel Keys press micro push-button to choose press micro push-button two seconds key canceled / postion free

23 DC EURO ECO DC EURO deluxe Radio control (maximum 0 Transmitters). Plug in the RC Module. DIP-switch / Program programming mode on. Programming press one button for two seconds (or another transmitter) and so on. Maximum 0 Transmitters. = 0 = = and so on.. Programming mode off

24 DC EURO ECO DC EURO deluxe. Cancel Transmitters press micro push-button to choose press mirco push-button two seconds transmitter canceled / postion free The door control DC EURO is designed for hold to run control of power operated doors. The basic version is designed for hold to run operation only, and you are not allowed to use the automatic function without using additional safety devices.

25 DC EURO ECO DC EURO deluxe RT running time Program II Program I CT closing time Limit Switch open Limit Switch close safety module Pre-Limit Switch status display V / brown SKS / green green LED pushbutton radio control GND / white red LED Emergency light module V GND IN IN IMPULSE C STOP DWN UP OUT N L PE PE N L C UP DWN signal light light remove bridge marked with when installing build-in-starters 8

26 DC EURO ECO DC EURO deluxe Program DIP green LED radio control pushbutton Limit Switch open Limit Switch close Pre-Limit Switch red LED V / brown SKS / green GND / white light module Emergency V GND IMPULSE C STOP DWN N L PE PE N L C UP DWN UP light remove bridge marked with when installing build-in-starters

27 DC EURO ECO DC EURO deluxe Radio control (maximum 0 Transmitters).Plug in the RC Module pushbutton.programming mode on Press button > seconds red LED flashes fast.programming Press one button for two seconds red LED red LED flashes long once = stored (or another type of transmitter) and so on. Maximum 0 Transmitters..Programming mode off 0 seconds after the last programming the programm returns to standart mode..cancel all Transmitters Press button > seconds red LED flashes fast press button once more for > seconds red LED off = all transmitters cancelled

28 DC EURO ECO DC EURO deluxe X

29 DC EURO ECO DC EURO deluxe X

30 DC EURO ECO DC EURO deluxe X

31 DC EURO ECO DC EURO deluxe X