Commercial & Industrial Retrofit 2017 Compressed Air Incentive

Transcription

1 Commercial & Industrial Retrofit 207 Compressed Air Incentive Section A: CUSTOMER INFORMATION Customer Name Electric Account Number Rate Application Number Facility Address City State Zip Code Service Location Identification Mailing Address (if different from above) City State Zip Code Contact Person/Title Telephone Number Incorporated? (Check one.) Yes No Exempt Please Assign Payment to Contractor. Customer Signature: Additional Information Section B: CONTRACTOR INFORMATION Incentive Payment Preference (Check one.) Check Bill Credit Pay Contractor Contractor Name Contact Person/Title (Print) Contact Person Signature Mailing Address City State Zip Code Telephone Number Additional Information Incorporated? (Check one.) Yes No Exempt Section C: DOCUMENT APPROVALS PRE-INSTALLATION INSPECTION Utility Signature PRE-APPROVAL OFFER Technical Review - Utility Signature Utility Signature Amount of Incentive Offer ($) Offer Valid Through: By signing and dating below, customer accepts this Incentive offer and agrees to the Utility Terms and Conditions available from your Utility. Pursuant to a Commission order, customers also agree that the utility alone may capture all kw and kwh savings and any ISO-NE capacity payments resulting from this energy efficiency project. This agreement is contingent upon continued approval and authorization by the Commission to recover said amounts from the System Benefits Charge. The Incentive, in conjunction with all other sources of funding, cannot exceed the total project cost. Customer Signature: : POST-INSTALLATION INSPECTION Utility Signature Total Project Cost ($) Amount of Incentive ($) Customer Signature MANAGEMENT APPROVAL Utility Signature

2 Air Incentive Calculation RETROFIT COMPRESSED AIR INCENTIVE WORKSHEET Item Horsepower (A) Hours of Operation Code Additional (Yes or No) Incentive ($) per HP 2 (B) Air Incentive ($) (A X B) Ex ,950 VSD Y $ X $200 = $5,000 Note: Vendor quote or proposal required for Incentive. Additional Primary Incentive Calculation- see Table (only applicable if storage code above = Y ) Item *Minimum Required (A) Maximum Eligible (B) Existing (C) Minimum New Required (D) = A - C Maximum New Eligible (E) = B - C ** to be installed (F) Incentive F x $2.75 (not to exceed E) Ex x $2.75 = $633 *System must meet Minimum (A) to be eligible for Incentive ** capacity over Maximum (E) is not eligible for Incentive Total Incentive Codes & Requirements 2 High Efficiency Air Incentive per HP Type Code # Minimum Gallons per ## Maximum Gallons per Incentive Per Horsepower 5 to to to 75 Variable Speed Drive VSD 2 3 VSD $70 $200 $80 # Minimum Gallons per recommended by the Compressed Air Challenge ## This is the maximum gallons eligible for incentives. Installed capacity may be larger. Notes. These Prescriptive Incentives apply to single, oil flooded compressed air systems only. Multiple and /or oil free air compressor systems may be eligible for a Custom Incentive but must pass a benefit-cost test. 2. These Prescriptive Incentives apply to air compressors with nameplate ratings > 5 HP and < 75 HP. Air compressors > 75 HP may be eligible for a Custom Incentive. Air compressors rated in kw shall be converted to HP as follows: kw / = HP 3. The rated HP of the replacement air compressor shall not exceed the existing air compressor rated HP by more than 0%. Existing compressors replaced with a new, larger compressor (> 0%+/-) will be reviewed under the New Equipment & Construction Program. 4. These Prescriptive Incentives apply to variable speed control (VSD) compressors. 5. These Prescriptive Incentives apply to air compressors with an operating pressure of 45 psi or below. s with higher operating pressures may be eligible for a Custom Incentive. 6. Minimum air storage requirements as specified in the Compressed Air Incentive form must be met and may include existing air storage to meet the requirement. 7. Air compressor must operate a minimum of 2,000 hours a year. 8. Air compressors with VSDs must have as a minimum a 3% impedance series reactor in its AC power input connection.

3 Instructions for completing the Retrofit COMPRESSED AIR Incentive Worksheet General Notes:. A vendor proposal is required for an Incentive and must include the Compressed Air Plant Proposal Information found on page three in these instructions. 2. The Compressed Air Incentive must be completed and the Incentive approved prior to purchasing and installing the equipment. 3. s under 5 HP are not eligible for Incentives. 4. s over 75 HP are not eligible for a prescriptive Incentive but may be eligible for a Custom Incentive. 5. Invoices will be required for payment of Incentives. 6. The Incentive, in conjunction with all other sources of funding, cannot exceed the total project cost. Eligibility Requirements: To be eligible for Incentives, the equipment must meet the following requirements: s. Nameplate horsepower of compressors must be equal to or greater than 5 HP and less than or equal to 75HP. s with manufacturers ratings only in kilowatts will be assumed to have horsepower ratings equal to kw rating (motor only) / Existing compressor being replaced must use modulating control. s with other control methods must use the Custom Incentive process. 3. Prescriptive Incentives are only applicable to single compressor systems. Multiple compressor systems of any size that serve a common distribution system may submit applications as a Custom Incentive. Projects that have multiple and comprehensive measures shall be processed as a Custom Incentive. 4. Prescriptive Incentives are only applicable to compressors with an operating pressure of 45 psi or below. s with higher operating pressures shall be processed as a Custom Incentive. 5. Prescriptive Incentives are only applicable to oil flooded Rotary Screw s. Other compressor types may be eligible for an Incentive as a Custom Incentive project. 6. control shall be Variable Speed Drive (VSD). 7. s must operate a minimum of 2000 hours a year. 8. Air compressors with VSDs must have as a minimum a 3% impedance series reactor in its AC power input connection.. Primary storage is required on all compressors receiving incentives. 2. Incentives are only available for air storage tank(s) in association with new compressor equipment installations. Dryers. New dryers being installed are not eligible for Incentives.

4 Calculation of Incentives. Refer to the back side of the Incentive application entitled Retrofit Compressed Air Incentive Worksheet to determine the following incentives as applicable: Air Incentive. Enter air compressor nominal horsepower (from manufacturer s data) in column (A). 2. Enter the air compressor capacity (acfm) (manufacturers rating at the actual compressor operating pressure.) 3. Enter the compressor control code found in Table ¹ Codes & Requirements. 4. Enter if additional storage is to be provided (yes or no). 5. Enter Incentive ($) per HP in column (B) found in Table ² High Efficiency Air Incentive per HP. 6. To calculate the air compressor Incentives multiply the Horsepower from column (A) by the Incentive per HP from column (B). Additional Primary Incentive. In column A, calculate the Minimum Required (gals) by multiplying the Minimum Gallons per for the compressor type found in ¹ Codes & Requirements. Table by the cfm noted in the Incentive Calculation. 2. In column B, calculate the Maximum Eligible (gals) by multiplying the Maximum Gallons per for the compressor type found in ¹ Codes & Requirements. Table by the cfm noted in the Incentive Calculation. 3. In column C enter any existing storage (gals). 4. In column D, calculate the Minimum New Required (gals) by subtracting the Minimum Required, column A from the Existing, column C. 5. In column E, calculate the Maximum New Eligible (gals) by subtracting the Maximum Eligible, column B from the Existing, column C. 6. In column F, enter the to be installed (gals). 7. To calculate the Incentive multiply the to be installed, column F by $2.75/gal. Note that the gallons stated in to be installed, column F can not exceed the Maximum New Eligible, column E. Total Retrofit Compressed Air Incentive. Calculate the total Incentive by summing the Air and Incentives. Post-Installation: Utility Representative must verify that:. The single compressor has been installed and operating as follows: a. System operating pressure psi b. Original primary storage capacity gallons c. Additional primary storage capacity gallons d. Total primary storage capacity gallons e. Final gallons per compressor f. Verify compressor manufacturer, compressor model, horsepower, and rated 2. The compressor matches the Incentive Application information. If the equipment has changed from what was approved for the initial Incentive offer, the substituted equipment specifications must be submitted and reviewed by the utility to verify compliance with technical requirements and approved before an Incentive is considered. 3. The invoice or proof of payment has been submitted. 4. The Utility Representative & Customer have signed & dated the post installation inspection block on the Incentive form.

5 COMPRESSED AIR PLANT PROPOSAL INFORMATION The following information shall be included in the proposal requesting an Incentive. Please describe the major components of the existing compressor and compressed air system. Existing Description (Manufacturer & Model) Rated HP & cfm Operating Pressure (psi) Type Hours Loading (% ) Ex: Gardner Denver Modulating 50 HP Model: #ABCDEF 50hp psi Mod 00 hrs 5,200 hrs/yrs 0hr@90% 30hr@30% 50hr@60%. 2. Proposed Description (Manufacturer & Model) Rated HP & acfm Operating Pressure (psi) Type Hours Loading (% ) Ex: Gardner Denver Modulating 50 HP Model: #ABCDEF 50hp psi VSD 00 hrs 5,200 hrs/yrs 0hr@90% 30hr@30% 50hr@60%. The following information shall also be included in the proposal: How many shifts and how does production vary? What is the current system pressure at the furthest point from the compressor? psi What is the minimum pressure required for proper equipment operation? psi Any significant operational problems Inadequate pressure Yes No Moisture or air quality Yes No Production problems due to pressure fluctuations Yes No Other Age Cooling Medium (air, chilled water) Leak Identification and Remediation of Last Leak Survey if Any Survey Provider and Survey Type (eg ultrasonic) Estimate Leak Level from Survey Follow-up Leak Remediation Efforts For Compressed Air Challenge technical and training information please visit