Installation Contactors RIC, RAC

Transcription

1 Installation Contactors RIC, RAC 1 Characteristics Rated operational current: A Coil voltages: UC 24, 36, 230 V / AC 400 V Hum-free (UC versions) 2 4 contacts NC or NO Extendable with auxiliary contacts Double break contacts Status indicator RAC with manual actuating (On-Off-Auto) 2 Ordering code 2.1 Two-pole contactors Contacts / RIC25 2 NO -200/ 2 NC -020/ 1 NC + 1 NO -110/ 2 CO RIC / -020/ -110/ 2.2 Four-pole contactors Contacts RIC25 RIC40 RIC63 RAC25 4 NO RIC25-400/ AC48V AC400V RIC RIC63-400/ RAC25-400/ 4 NC RIC25-040/ AC400V RIC40-040/ RIC63-040/ 2 NC + 2 NO RIC25-220/ AC400V RIC40-220/ RIC63-220/ 2.3 Auxiliary contacts Contacts RIC-AUX* 2 NO RIC-AUX20 2 NC RIC-AUX02 1 NC + 1 NO RIC-AUX11 * RIC-AUX are compatible to RIC 25/40/63 only Vs;'Sc 1/6

2 3 Mounting If several contactors are mounted side by side, the spacer RIC-DIST should be installed after every second contactor for purpose of heat dissipation. 3.1 Mounting position 4 Pin assignment RIC RAC RIC-AUX RICxx RIC-AUX 20 RICxx RIC-AUX 02 RICxx RIC-AUX 11 RICxx-400 RICxx-040 RICxx-220 RICxx Vs;'Sc 2/6

3 5 Technical information 5.1 General data Mechanical data Mounting Connection Protection class Housing material DIN rail Screw terminals IP20 Technyl PA6 Module width Dimensions W x H x D [mm] 17.5 x 65.5 x x 65.5 x x 65.5 x x 65.5 x 85 8 x 65.5 x 85 Conductor cross-section main terminals, rigid [mm 2 ] Conductor cross-section main terminals, flexible [mm 2 ] Conductor cross-section coil terminals, rigid / flexible [mm 2 ] Torque main terminals [Nm] Torque coil terminals [Nm] Weight [g] 140 / Environmental conditions Storage temperature -30 C C Operating temperature -5 C C Relative humidity 95%, non-condensing 5.2 Electrical data Supply UC UC RIC25 UC RIC25 AC RIC40 UC RIC63 UC Rated voltages U N [V] 24, 36, , 36, , , 230 Frequency [Hz] DC, DC, DC, DC, Operating voltage range x U N Coil consumption [VA/W] 2.1 / / / / 5 5 / 5 Make delay [ms] Brake delay [ms] Main contacts Rated voltage [V] 400 Thermal current AC1, I th [A] Inrush current 100 ms [A] Operational voltage [V] Mechanical endurance 3 x 10 6 Electrical endurance AC-1 at I th 2 x x x x x 10 3 Electrical endurance AC-3 at I th 3 x x x x x 10 3 Electrical endurance DC-1 at I th 1x10 5 1x10 5 1x10 5 1x x Vs;'Sc 3/6

4 Contact material AgNi AgNi AgSnO 2 AgSnO 2 AgNi Minimal load at 24 V [ma] Distance of open contacts [mm] Max. back-up fuse [A] Typical performance AC RIC25 RIC40 RIC63 Rated operational current AC-1 [A] Rated operational current AC-7a [A] Rated operational current AC-3 [A] Rated operational current AC-7b [A] Rated operational current AC-4 [A] DC 9 (NO) 6 (NC) 0.37 (NO) 0.25 (NC) RIC25 RIC40 RIC63 Contacts in series Rated op. current DC-1 24 V [A] Rated op. current DC-1 48 V [A] Rated op. current DC V [A] Rated op. current DC V [A] Rated op. current DC-3 24 V [A] Rated op. current DC-3 48 V [A] Rated op. current DC V [A] Rated op. current DC V [A] Rated op. current DC-5 24 V [A] Rated op. current DC-5 48 V [A] Rated op. current DC V [A] Rated op. current DC V [A] Rated op. current DC V [A] Rated op. current DC 110 V, L/R 40 ms [A] Lamp loads Maximum number of lamps per contact at 230V, utilization category AC-5a. The following information applies to cycles. Load Incandescent lamps and halogen lamps Power [W] Current [I] RIC25 RIC40 RIC Vs;'Sc 4/6

5 Load Transformators for low-voltage halogen lamps (electromagnetic and electronic) Compact fluorescent lamps with internal ballasts Fluorescent lamps with external electromagnetic ballasts LED-Lamps Power [W] Current [I] RIC25 RIC40 RIC x x x x x x x Power supplies for LEDs N: Number of lamps or power supplies - - N = 2,4 A / In N = 3,8 A / In N = 11 A / In N = 18 A / In In: Current consumtion per lamp or power supply 6 Operation The contactor RAC can be manually locked in the position On or Off. In position Auto, the contactor is conventionally operated with the coil Vs;'Sc 5/6

6 7 Dimensions *optional sealing cover: RIC-SEAL20, RIC-SEAL25, RIC-SEAL40-63 *optional spacer RIC-DIST 8 Standards IEC/EN , VDE 0660 Low voltage switchgear - general establishments IEC/EN Low voltage switchgear - control circuit devices and switching elements IEC/EN 61095, VDE 0637 Electromechanical contactors for household and similar purposes CE, RoHS Vs;'Sc 6/6