Professional Nickel-Cadmium Products

Transcription

1 Professional Nickel-Cadmium Products

2 PAG Powerman Batteries. 12V to 30V 7Ah Battery Packs for Location Lighting. Power for Location Lighting The PAG Powerman is a 7Ah Ni-Cd battery pack designed to provide a robust and reliable source of power for hand-held location lighting. The Powerman is uniquely styled with many original features. The outer case is tough, lightweight, and designed with rounded corners and edges for comfort during use. Unique Carrying Arrangement The Powerman is worn rather than carried, by virtue of a unique arrangement that comprises an adjustable shoulder strap (included) and a waist belt that features a curved body pad (available separately). The weight is distributed evenly as the battery pack is held firmly but comfortably against the users side. An anti-slip device in the body pad prevents the battery slipping around the waist belt during use. High-Quality Cells The PAG Powerman contains specially selected cells of superior quality which provide excellent voltage hold-up characteristics and, therefore, extended run-time. Protective Features The PAG Powerman features a red LED end-of-discharge indicator which flashes with increasing rapidity approximately three minutes prior to the end of discharge. The battery is protected from over discharge by an 'ODP' circuit. This facility prevents cell reversal, the most common cause of premature battery failure. The circuit is reset by simply pressing the 'ODP Reset' button on the top panel (this must be done prior to charging). Charging The Powerman should be fastcharged with PAG ACS chargers, which extend battery cycle life beyond anything that can be achieved using systems of other manufacturers. PAG 30V AR Series chargers are recommended for charging all Powerman batteries. > 30V Powerman with Body Pad Model 9353 Model Voltage Capacity Connectors Dimensions Weight V 7.0Ah 2 x XLR-4 (M) 166 x 240 x 81mm 4.25kg V 7.0Ah 2 x XLR-4 (M) 166 x 240 x 81mm 4.50kg V 7.0Ah 1 x XLR-4 (M) 257 x 240 x 81mm 6.30kg V 7.0Ah 1 x XLR-4 (M) 257 x 240 x 81mm 7.30kg 9353 PAG Powerman Body Pad 2 POWERMAN BATTERIES

3 Specifications. > PAG Powerman Batteries Output Connectors: 12V & 13.2V Models: 2 x XLR-4 Connectors 24V & 30V Models: 1 x XLR-4 Connector Pin Connections: XLR-4 pin connections as follows: Pin 1 Negative (-) Pin 2 No connection Pin 3 No connection Pin 4 Positive (+) NOTE: other output connectors are also available, to special order only. Construction: PAG batteries have welded cell interconnections of low-resistance nickel strap. The case for these models is designed to protect the cells from impact damage. The pack is non user-serviceable. Cells: Premium grade Nickel-Cadmium sealed rechargeable cylindrical cells. Voltages: Model V nominal, (10 cells connected in series, nominal voltage 1.2V per Model V nominal, (11 cells connected in series, nominal voltage 1.2V per Model V nominal, (20 cells connected in series, nominal voltage 1.2V per Model V nominal, (24 cells connected in series, nominal voltage 1.2V per Capacity: Nominal capacity of 7 amperehours, measured at the five hour rate. Operating Temperature Range: Optimum discharge efficiency is achieved within the temperature range 0ºC to +40ºC. Charge Time: Charge times will vary depending on the battery voltage and its state-of-charge. Over Discharge Protection: All models incorporate the PAG ODP circuit which has been designed to prevent over-discharge of the Powerman battery, and thus extend it s life. A warning light flashes with increasing frequency before the ODP circuit trips. Thermal Protection: The output socket becomes isolated if cell temperature exceeds 70 C and can be reset when the temperature falls. Re-set by pressing the ODP Reset button. Short Circuit Protection: The battery is protected against short circuit and excessive current loads by means of a 20mm cartridge type fuse rated T10A (anti-surge). A spare fuse is supplied in an additional holder. Shoulder Strap: The detachable shoulder strap supplied has provision for length adjustment and includes a moulded shoulder pad. Body Pad: The Powerman Body Pad and waist belt assembly (Model 9353) is available separately and recommended for extended periods of use. Dimensions (H x W x D): 12V & 13.2V Models: 166 x 240 x 81mm 24V & 30V Models: 257 x 240 x 81mm Weight: Model 9339: 4.25kg. Model 9338: 4.50kg Model 9342: 6.30kg Model 9330: 7.30kg > 12V and 13.2V Powerman batteries feature dual XLR-4 (M) output connectors > All Powerman batteries feature detachable shoulder straps > The Powerman Body Pad Model 9353 is recommended for extended periods of use > PAG 30V AR Series chargers are recommended for charging all PAG Powerman batteries (see Page 9), using charge adaptor Model 9449 SPECIFICATIONS 3

4 PAG 12V to 30V Ni-Cd Chargers. 30V AR Series Ni-Cd Battery Chargers. PAG ACS Charging The 30V AR Series of microcomputer-controlled fast-chargers operates under the control of PAG ACS, the world s most advanced charging system. The foremost achievement of PAG ACS is the ability to fast-charge, accurately and safely, Ni-Cd batteries of any manufacture. PAG ACS does not require sensors within the battery pack, the two charging wires carry all the feedback information necessary for accurate charge termination. PAG ACS is so accurate that it extends the working life of a battery beyond anything that can be achieved using other systems. Autoranging The Autoranging (AR) facility adapts the charge program to sequentially fast-charge Ni-Cd batteries within the ranges 12V to 31.2V, 1.7Ah to 10Ah. However, 30V AR Series chargers are optimised to fastcharge 24V to 30V battery packs or belts, via front XLR-4 (M) sockets. A 30V 7Ah Pagbelt IC2 or Powerman will be fast-charged in less than two hours. Recovery Charge The Recovery Charge program can be activated to regain capacity which has been lost as a result of extended storage or use under adverse conditions. Maintenance Charge This feature monitors the battery after the main charge program and automatically maintains it in a state of full-charge until the battery is removed from the charger. Worldwide Operation 30V AR Series chargers incorporate switch-mode power supply technology which adjusts automatically to enable operation wordwide. Capacity 2Ah 4Ah 6Ah 7Ah 8Ah 10Ah Charge Time* 0.5 hours 1.0 hours 1.5 hours 1.75 hours 2.0 hours 2.5 hours *These times are approximate only, and assume the battery is fully discharged. Model: Connectors: Size: Weight: 9763 PAG AR301 1 x XLR-4 (M) 78 x 142 x 240mm 1.07kg 9765 PAG AR304 4 x XLR-4 (M) 78 x 142 x 240mm 1.07kg PAG 30V Chargers at a Glance. PAG AR301 24V to 30V Charger Model x XLR-4 connector For Ni-Cd batteries only 78 x 142 x 240mm / 1.07kg PAG AR304 24V to 30V Charger Model x XLR-4 connectors For Ni-Cd batteries only 78 x 142 x 240mm / 1.07kg 4 30V AR SERIES CHARGERS

5 Specifications. > PAG 30V AR Series Chargers Battery Connections: PAG AR301 Model x XLR-4 Connectors PAG AR304 Model x XLR-4 Connectors Range of Batteries Charged: Nickel-Cadmium batteries of reputable manufacture, having nominal voltages of between 12V and 30V, and nominal capacities of between 1.7Ah and 10Ah. Main Charging Programs: Fast-charge program under PAG ACS microcomputer-control. Recovery charge program manually selectable. Ancillary Charging Programs: Balancing charge; self-adjusting maintenance charge (automatically entered after charging). Self Test Program: The microcomputer constantly monitors the operation of the charger, which is shut down to a safe condition should any of the tests fail. Input Supply: V or V AC, autoselected. Frequency 50Hz to 60Hz. Maximum power consumption 240W. Output Protection: Charger protected against short circuit, open circuit, excess battery voltage and reverse battery voltage. AC Mains Failure Protection: Should mains failure occur during a charging program, or whilst the charger is connected, it will shut down to a safe condition. Safety: Designed to comply with electrical safety standards EN and EN Class 2 (double insulated) UK mains lead fitted with 1" fuse to BS1362 rated 5A. Operating Temperature Range: 0 C to 40 C (+32 F to +104 F). Overall Dimensions (H x W x D): 78 x 142 x 240mm (3.1" x 5.6" x 9.5") Weight: 1.07kg (2.35lbs). Typical Battery Charging Times: Capacity 2Ah 4Ah 6Ah 7Ah 8Ah 10Ah Charge Time 0.5 hours 1.0 hours 1.5 hours 1.75 hours 2.0 hours 2.5 hours These times are approximate only, and assume that the battery is fully discharged. Charging times will be less if battery is partially charged at the beginning. General Information. > Service A full after-sales support service is provided by PAG throughout a product s lifetime, which includes servicing, repairs and technical advice. PAG maintains a worldwide network of Authorised Service Centres. These facilities have a wealth of specialist knowledge, which is the result of PAG s 40 years of experience. Using PAG s Authorised Service Centres is the only way to ensure the continuation of the quality standard for which you first chose PAG products. For servicing outside of the UK contact your nearest PAG Agent via the PAG website at For servicing in the UK contact the PAG Service Department: service@paguk.com Telephone: +44 (0) Address: PAG Ltd. 565 Kingston Road Raynes Park London SW20 8SA United Kingdom > Warranty PAG products have earned a reputation throughout the world for excellence in quality, reliability and performance. The PAG Warranty reinforces this reputation by guaranteeing each product for a period of 18 months, unless otherwise stated. PAG chargers have a 2 year warranty. Refer to the product Instruction Manual for full warranty terms and conditions. > Trademarks The following are trademarks of PAG Ltd: PAG Professional Broadcast Equipment, Time Battery Power & Time Display SuperPack Pagbelt PAG ACS AR Series 2 PAG Pulsar PAG Quasar PAG Cube PAG ipc PAG Freelancer PAG Power Plate PAGlok Connector Paglight Softstart PowerArc PowerMax All third party trademarks are acknowledged as such. PAG Ltd. retains the right to change the specifications contained herein without notice SPECIFICATIONS 5

6 Your Partner in Power TM Professional Broadcast Equipment PAG Ltd. 565 Kingston Road Raynes Park London SW20 8SA United Kingdom E sales@paguk.com T +44 (0) F +44 (0) PAG is a UK distributor for Angenieux, Cartoni, Chrosziel, Tiffen and Transvideo PAG Ltd.