Kit Contents 1x Carry case, 1x Instruction manual, 1x Charger, 1x SpotterXtreme

Transcription

1 Instruction manual

2 2! Important! It is essential that you read carefully the instructions and safety information in this manual before operating the. Kit Contents 1x Carry case, 1x Instruction manual, 1x Charger, 1x Carry Case Instruction manual Instruction Manual Lithium-ion Battery Charger

3 3! Warning! Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in equipment damage and/or serious injury. Contents Kit Contents Components ,5,6 Quick Start Guide Specifications Available Accessories Cleaning and Maintenance Intended Use Operating Instructions Day Use Night Mode Attaching Additional Power Supply Capturing Video with the Technical Information Safety Information General Disposal Battery Disposal Contact Details Guarantee

4 4 Fig. 1 Mains Charging Socket LCD Screen Zoom Lever Focus Lever Fig. 2 LED Infrared Intensity Knob Fig. 3 Power/Mode Switch Mid Low Off High OFF/ Daylight mode Power off/battery Charge Night mode

5 5 Fig. 4 Video Output 3.5mm 4 Pin Socket External Battery Supply Socket (battery sold separately) Tripod Mount & Shoulder Strap Additional Strap Insert Fig. 5 Charging Indicator Lithium-ion Battery Charger Battery Charger DC Plug

6 6 Fig. 6 Warning Harmful emitted infrared light output. NEVER look directly into the illuminator. Infrared LED Intensity Knob ZOOM FOCUS Zoom Control Lever Focus Control Lever Fig. 7 Infrared LED Lens Camera Lens Handle Zoom/Focus Levers

7 7 Quick Start Guide 1. Remove by the handle from the hard carry case. 2. The battery inside the must be charged before use. Note battery must be charged for 8 hours or until the red light on the mains adaptor turns green. 3. Connect the lithium-ion battery charger to the wall socket. 4. Connect the lithium-ion battery charger DC plug into the charging socket. (See pg4, Fig 1) Note Only use the mains battery charger supplied. 5. Wait for charging indicator LED to change from red to green. 6. Disconnect the lithium-ion charger from the before turning it on. 7. Turn the on by switching the power/mode button to the desired setting. (See pg4, Fig 1&3) Note When in night mode LED infrared intensity will need to be changed depending on the distance of the area that requires illumination. 8. Point the toward your desired area. 9. Manually focus the by adjusting the focus lever. (See pg6, Fig 6&7) 10. The zoom lever can then be adjusted to required magnification; refocus as needed to gain the best picture possible.

8 8 Specifications Illumination Recording connection Zoom Display Field of View (FoV) Identification Range Operational run time Up to 500 meters (550 Yards)* AV out socket (3.5mm 4pin jack) 20x optical zoom 3.5 LCD screen 25 at minimum zoom 500 meters (550 Yards)* Up to 20 hours approx. (2.2Hrs on max IR) FoV 500m range Net Weight 1300g Operating temperature -20 to 60 C (-4 to 140 F) 20hrs run time Functions Zoom to 20x LED intensity control Manual focus Day setting KG 1300g *Range subject to weather conditions Available Accessories External battery pack Carry strap Car charger 3.5mm 4 pin A/V cable Heavy duty case These can be purchased separately. Please contact your NiteSite distributor for details and prices. -20 to 60 C Simple controls

9 9 Cleaning and Maintenance! Warning There are no serviceable parts on the. Do not attempt to disassemble as this will invalidate the guarantee. Please contact your NiteSite Distributor or our Customer Service department for all servicing requirements.! Caution Do not immerse in water or use solvents, alcohol or abrasive chemicals/liquids. To get the most from the, keep the infrared LED lens cover clean and free from debris. Use a dry camera lens or micro fiber cloth to wipe excess dust from the lens areas. Use a clean damp cloth to gently clean the housing and lenses. Avoid getting any liquid into any of the sockets.! Caution Be careful when cleaning the infrared lens cover. Do not clean too vigorously as this can damage the lens cover. The is not water proof (only water resistant). Always cover the equipment in rainy conditions. After use and during transportation store the in the carry case provided.

10 10 Intended Use The has many practical applications including use as a security monitor, leisure activities and some military tactical operations. The is fully BS8484 compliant and is ideal for lone workers. The is suitable for use in daylight. During darkness the will achieve night vision capability of up to 500 meters. Persons using the under the age of 16 must be supervised by an adult. NiteSite does not bear responsibility for the use of this product in countries or territories where the law prohibits its use. It is the sole responsibility of the operator to comply with the laws and regulations of the country or territories where the is used. Operating Instructions To get the best results from your follow these instructions. Day Use The is designed for daylight use as well as lowlight or zero light conditions. To operate the in daylight conditions. 1. Ensure battery is fully charged. 2. Turn on the to the day mode. 3. In this position there is no infrared light emitted from the LED s. 4. Point the toward the area to be viewed. 5. Gently adjust the focus lever to gain a clear image on the screen. 6. The zoom lever can then be adjusted to the required magnification; refocus as needed to gain the best picture possible.

11 11! Caution Do not point the at direct sunlight. The camera could be damaged. Night Mode The uses infrared light to illuminate the camera s field of view, there is no need for ambient light to get great results from the. 1. Ensure battery is fully charged. 2. Turn on the to the night mode setting. See pg4, Fig 3 3. Turn the infrared LED intensity knob to low. See pg4, Fig 2 4. Point the toward the intended area. 5. Focus using the lever until the best image is achieved. See pg6, Fig 6&7 6. The zoom lever can then be adjusted to the required magnification, refocus as needed to gain the best image. 7. Depending on the distance to the area of interest you may need to adjust the infrared LED intensity knob. See pg4, Fig 2 Note If the LCD screen has a white area in the centre (white out), there is too much infrared light being emitted and the intensity should be adjusted accordingly. Adjusting the zoom and refocusing will also reduce whiteout.

12 12 Operating Instructions cont. Attaching additional power supply. An additional Lithium-ion Battery Pack can be purchased to allow longer usage between recharging. Note Always fully charge the additional battery when new as the battery is supplied in a discharged condition. 1. Connect the battery to the socket located at the base of the s handle. (See pg5, Fig 4) 2. Stow the battery securely ensuring no excess pressure or tension is placed on the battery cable or socket. 3. The will use the power from external batteries extending the total operational time of the unit. Capturing video from the output. The is fitted with a video and audio output socket (AV). This will enable an external monitor or video capture device to be connected directly to the. The 3.5mm 4 pin socket can only to be used with a compatible audiovideo cable. Connect the 3.5mm 4pin jack to the unit. (See pg5, Fig 4) Connect the cable to a capture/monitor device. Note Please refer to the manufactures instructions for the intended capture/monitor device to ensure compatibility and correct use. Follow the operating instructions for the intended capture/monitor

13 13 device connected. The capture device will record the image as seen on the screen. The has an analogue 4:3 ratio output. Note Never plug the lithium-ion battery charger DC plug into the external DC power supply socket as this will not charge the internal battery. Technical Information 1. Infrared LED frequency 850nm. 2. Lens 5:100 (20x zoom) ratio lens (manual operation only). 3. Lithium-ion polymer battery 3500mAh 11.1v. 4. AV output socket 3.5mm 4 pin v DC socket for external battery inch LCD screen v 0.5 amp lithium-ion battery charger. 8. Variable infrared LED output v DC charging socket (only use the lithium-ion battery charger provided). 10. Fully charged battery provides up to 20 hours of continuous use on low infrared LED intensity and up to 2.2 hours on full power.

14 14 Safety Information! Warning Never look directly into the infrared LED lens (See pg6, Fig 7). The unit can emit very high concentrated non-visible infra-red light which can be hazardous to the human eye. Always follow the safety precautions given in IEC and IEC Persons using the NiteSite equipment under the age of 16 must be supervised by an adult. Do not attempt to make any repairs to the NiteSite equipment as this will void any guarantee and could cause personal injury and may cause further damage to the NiteSite equipment. Do not store any part of the NiteSite equipment near open flames or other forms of excessive heat. The NiteSite equipment is made of durable ABS plastic and could melt and catch fire. Working safely with NiteSite equipment is only possible when following the manufacturers instructions contained in this booklet. NiteSite users should comply with all laws and adhere to safe working practices. General Disposal UK: Waste electrical products should not be disposed of with household waste. Separate disposal facilities exist. For your nearest facilities, please contact your local authority for details. Battery Disposal Dispose of batteries in an environmentally friendly way. Certain regions may regulate the disposal of batteries. Please consult your local authority. In EC countries batteries must be recycled according to guideline 91/157/EEC! Warning 1. Only use the NiteSite recommended Lithium-Ion battery charger. 2. Do not dispose of the battery into an open fire. 3. Do not immerse in water or salt water, always store in a cool, dry environment that is away from metal objects like pins, nails, keys, jewellery, coins, etc. 4. Do not leave near a heat source such as a fire or heater. 5. Do not connect the directly to an electrical socket outlet. 6. Do not transport the with any metal objects described in no Do not strike or throw against hard surfaces. 8. Do not pierce the housing with a nail or sharp object. Caution 1. Do not use or leave the in very high temperatures (i.e.: in direct sunlight or in a vehicle in extremely hot weather.) Otherwise the battery can overheat, self-combust, or its performance will degenerate and its service life will be shortened. 2. Do not use in a location where static electricity is evident or the safety circuitry may be damaged. 3. In case the battery electrolyte gets into the eyes due to leakage DO NOT rub the eyes! Rinse with copious amounts of clean water and seek medical attention immediately. Failure to do so may result in permanent damage to the eyes or loss of sight. 4. If the gives off an odour, generates undue heat, becomes misshapen or abnormal during use, recharging, or storage immediately place it in a contained vessel such as a metal box. DO NOT continue to use the. Dispose of it properly. 5. In case the handle becomes contaminated with debris of any kind during use, clean with a dry cloth. Otherwise, power failure may occur due to a poor connection. 6. Be aware that discarded batteries may catch fire. Dispose of the properly. 7. DO NOT take the case apart or tamper with it in any way.

15 15 Contact Details Customer Service NiteSite Ltd Unit 13 West Lane Full Sutton Airfield Stamford Bridge York, YO41 1HS United Kingdom Phone +44 (0) Fax +44 (0) E: W: Office hours Monday to Friday 8.30am - 5pm GMT Guarantee Your 1 year guarantee - help us to help you. Your new NiteSite equipment comes with a 12 month guarantee protecting you against electrical and mechanical breakdown. Please see terms and conditions below. It is important to register the purchase of your product in order to ensure that you receive prompt and efficient assistance in the event of it requiring attention during the guarantee period. Important: You must register within 30 days to validate the guarantee. NiteSite guarantee conditions We at NiteSite undertake that if within 12 months of the date of purchase the NiteSite equipment or any part thereof is proved to be defective by reason only of fault of workmanship or materials, we will, at our discretion repair or replace the same FREE OF ANY CHARGE for labour, materials on condition that: 1) You are the original purchaser and not an assignee or subsequent purchaser of the equipment. 2) The product has been used in accordance with the manufacturers operating and maintenance instructions. 3) The product has not been serviced, maintained, repaired, taken apart or tampered with by any persons not authorised by NiteSite. 4) All service work under this guarantee must be undertaken by the NiteSite customer service department. 5) Any product or defective part replaced shall become the property of NiteSite. Please Note! A) This guarantee is in addition to your statutory and other legal rights. B) NiteSite will return product by courier within 28 days of receipt. C) The company s liability under this warranty is limited to the said repairs or replacement and shall under no circumstances extend to any financial losses alleged to have been suffered by the claimant. D) In the event of repairs or replacement being made under the terms of this warranty in the circumstances where the opinion of the company the defect has not been caused by the company s materials or workmanship then the company reserves the right to charge the claimant at its current hourly rates and list prices in respect of any employees time and any replacement parts. E) No authority has been given to any person, firm or company, to vary the terms of this warranty. The guarantee does not cover the following: 1) Damage resulting from transportation. 2) Damage resulting from improper use or neglect. 3) Consequential damage resulting from unauthorised repair work.

16 NiteSite Ltd Unit 13 West Lane Full Sutton Airfield Stamford Bridge York, YO41 1HS United Kingdom P: +44 (0) E: W: