TECHNICAL OFFER. 1. CATERPILLAR PACKAGE OVERHAULED GENSET TYPE: C175-16, 2725KVA Prime Power, Build 2007, Original, Serial Number WYB00115, SMU 9725

Transcription

1 TECHNICAL OFFER 1. CATERPILLAR PACKAGE OVERHAULED GENSET TYPE: C175-16, 2725KVA Prime Power, Build 2007, Original, Serial Number WYB00115, SMU Engine Technical Data: Maker: Caterpillar Inc. Type Of Engine: Four-Stroke, Diesel Fuel Application: Power Generation, Prime Power. Cylinders Arrangement: Vee Type No. Of Cylinders: 16 Cylinder No. Of Strokes: four Strokes Bore: 175 mm Stroke: 220 mm Displacement: L Aspiration: Turbocharged Aftercooled Compression Ratio: 16.7:1

2 Genset Output: Revolutions Per Minute: 2725 KVA ekw (Prime) 1500 RPM Service Letters Completed at Overhaul by CUESI PS43242 Replace Water Pump PS43256 Removing Power Module for Fuel Control Valve PS43279 Rework Oil Sensing Hose Adapter PS43366 Rework Fuel Lines PS52157 Relocate Air Inlet Temperator Sensor PS43399 Inspect Cluster Gear Stub Shaft PS43669 Inspect / Rework / Replace components within Electronic Thermostat As. PS43820 Update Crankshaft, Damper Adapter, Damper, Connecting Rod Bearing,Connecting Rod PS53424 Replace Oil Cooler Install Updated Tube As-Fuel (Resolve CPI: ) Complete 50Hz Conversion - Qty 16 Cylinder Pack Gp / Qty 4 Turbocharger Gp Test Report Available Complete Repaint 2. Air Inlet System: Air cleaner; 4x Dual element with service indicator Aftercooler core Turbocharger 3. Exhaust System Dry Exhaust Manifold 4. Fuel System Primary fuel filter w/integral water separator & secondary filter. Fuel cooler. Fuel priming pump. Flexible fuel lines. 5. Starting System Dual 24-volt starting motor Battery with rack & cables (dry); 24V, 75 amp charging alternator. 6. Cooling System: Coolant drain line with valve Coolant level sensor SCAC cooling

3 Jacket Water and AC inlet/outlet flanges Caterpillar Extended Life Coolant (To be filled by customer) 7. Lubrication System: Oil cooler. Lubricating oil. (To be filled by customer) Gear type lube oil pump. Oil filter and dipstick. Oil drain lines with valve Fumes disposal Electrical 24V Pre Lube Pump 8. Governing System: CATERPILLAR ADEM IV governor. 9. Mounting System: Rails - Engine / generator 10. Generator Technical Data: Voltage: Frequency: Speed: Insulation: No. of Bearing: Alignment: Excitation: Over Speed Capability: 2725 kva, 0.8 P.F. 400 Volts 50 Hz 1500 RPM Class "H" Double Bearing Flex coupled Wave Form: Voltage Regulator: Voltage Regulation: TIF: Less than 50 THD: Less than 5% Circuit breaker: Permanent Magnet Excitation 150% of Synchronous speed CAT digital voltage regulator (CDVR) with KVAR/PF control, 3-phase sensing Less than ± 0.5% (steady state) Less than ± 1% (from no load to full load) Not installed. Bussbar connection in Right hand extention box, or Rear

4 11. Control Panel: EMCP3.3 (Electronic Modular Control Panel 3.3) EMCP 3.2 / EMCP 3.3 (Option) Single location customer connector point True RMS metering, 3-phase Controls - Run / Auto / Stop control - Speed Adjust - Voltage Adjust - Emergency Stop Pushbutton - Engine cycle crank Digital Indication for: - RPM - Operating hours - Oil Pressure - Coolant temperature - System DC volts - L-L volts, L-N volts, phase amps, Hz - ekw, kva, kvar, kw-hr, %kw, PF (EMCP 3.2 / 3.3 ) Shutdowns with common indicating light for: - Low oil pressure - High coolant temperature - Low coolant level - Overspeed - Emergency stop - Failure to start (overcrank)

5 Programmable protective relaying functions: (EMCP 3.2 & 3.3) - Under and over voltage - Under and over frequency - Overcurrent (time and inverse time) - Reverse power (EMCP 3.3) MODBUS isolated data link, RS-485 half-duplex (EMCP 3.2 & 3.3) Options - Vandal door - Local annunciator module - Remote annunciator module - Input / Output module - RTD / Thermocouple Modules - Monitoring software 12. Rating Information PRIME 2180 ekw 2725 kva 50 Hz 1500 rpm 400 Volts RATING DEFINITIONS AND CONDITIONS Meets or Exceeds International Specifications: AS1359, CSA, IEC , ISO3046, ISO8528, NEMA MG 1-22, NEMA MG 1-33, UL508A, 72/23/EEC, 98/37/EC, 2004/108/EC Prime - Output available with varying load for an unlimited time. Average power output is 70% of the prime power rating. Typical peak demand is 100% of prime rated ekw with 10% overload capability for emergency use for a maximum of 1 hour in 12. Overload operation cannot exceed 25 hours per year. Prime power in accordance with ISO3046. Prime ambients shown indicate ambient temperature at 100% load which results in a coolant top tank temperature just below the alarm temperature. Ratings are based on SAE J1349 standard conditions. These ratings also apply at ISO3046 standard conditions. Fuel rates are based on fuel oil of 35º API [16º C (60º F)] gravity having an LHV of kj/kg (18,390 Btu/lb) when used at 29º C (85º F) and weighing g/liter (7.001 lbs/u.s. gal.). Additional ratings may be available for specific customer requirements, contact your Cat representative for details. For information regarding Low Sulfur fuel and Biodiesel capability, please consult your Cat dealer. 13. Dimensions:

6