The Premcor Refining Group, Inc. Delaware City Refinery 4550 Wrangle Hill Rd. EXHIBIT A Delaware City, DE 19706

Transcription

1 DRAFT Permit: APC-2004/0721-CONSTRUCTION (NSPS) Two Package Boilers The Premcor Refining Group, Inc. Delaware City Refinery 4550 Wrangle Hill Rd. EXHIBIT A Delaware City, DE ATTENTION: Andrew Kenner Vice President and General Manager Dear Mr. Kenner: Pursuant to the State of Delaware Regulations Governing the Control of Air Pollution, Regulation No. 2, Section 2, approval of the Department of Natural Resources and Environmental Control (the Department) is hereby granted for the construction of two (2) package boilers, each with a design heat input rating of 216 million BTU per hour at the Delaware City Refinery, 4550 Wrangle Hill Road in Delaware City, Delaware, in accordance with the following documents: Application submitted on Form No. AQM 4 dated February 15, 2004 signed by Franklin R. Wheeler; Letter dated March 17, 2004 addressed to Secretary John Hughes and signed jointly by Franklin R. Wheeler for Motiva Enterprises (Motiva) and Bruce Jones for The Premcor Refining Group, Inc. (Premcor) requesting transfer of all Motiva s permits to Premcor; Letter dated April 23, 2004 addressed to Franklin Wheeler of Motiva Enterprises, LLC and Bruce Jones of The Premcor Refining Group, Inc. and signed by Secretary John Hughes; and Secretary s Order No A-00 issued, 2006 (placeholder for new Secretary s Order if amended permit is issued). The permit is issued subject to the following conditions: 1. General Provisions 1.1. This permit expires on November 30, The project shall be constructed in accordance with the application described above. If any changes are necessary, revised plans must be submitted and supplemental approval issued prior to actual construction Representatives of the Department may, at any reasonable time, inspect this facility The applicant shall, upon completion of the construction, installation, or alteration, request that the Department grant approval to operate.

2 1.5. A separate application to operate pursuant to Regulation No. 2 does not need to be submitted to the Department for the equipment or process covered by this construction permit. Upon a satisfactory demonstration by an on-site inspection that the equipment or process complies with all of the terms and conditions of this permit, the Department shall issue a Regulation No. 2 Operation Permit for this equipment or process Premcor may not commence start-up of the package boilers prior to the date six weeks before the anticipated startup of the FCU regenerative WGS 1.7. The provisions of Regulation No. 2 Sections 2.1 and 11.3 shall not apply to the operation of equipment or processes for the purposes of initially demonstrating satisfactory performance to the Department following construction, installation, modification, or alteration of the equipment or processes. The applicant shall notify the Department sufficiently in advance of the demonstration and shall obtain the Department s prior concurrence of the operating factors, time period, and other pertinent details relating to the demonstration The owner or operator shall not initiate construction, install, or alter any equipment or facility or air contaminant control device which will emit or prevent the emission of an air contaminant prior to submitting an application to the Department pursuant to Regulation No. 2, and, when applicable Regulation No. 25, and receiving approval of such application from the Department; except as authorized by this permit or exempted in Regulation No. 2 Section 2.2 of the State of Delaware Regulations Governing the Control of Air Pollution. 2. Emission Limitations 2.1. Except as provided in Section below, air contaminant emission levels from each boiler shall not exceed those specified by the State of Delaware Regulations Governing the Control of Air Pollution and the following: Volatile Organic Compound (VOC) Emissions VOC emissions shall not exceed pound per million BTU (lb/mmbtu) and 4.4 tons per rolling 12 month period; Nitrogen Oxides (NOx) Emissions NOx emissions shall not exceed lb/mmbtu on a rolling 3-hour average basis NOx emissions from both boilers, in the aggregate, shall not exceed 24.9 tons per rolling 12 month period; Particulate Matter (PM) Emissions PM emissions shall not exceed lb/mmbtu and 6.1 tons per rolling 12 month period;

3 Sulfur Dioxide (SO 2 ) Emissions SO 2 emissions shall not exceed lb/mmbtu and 21.2 tons per rolling 12 month period; Carbon Monoxide (CO) Emissions CO emissions shall not exceed lb/mmbtu and 66.9 tons per rolling 12 month period; Ammonia (NH 3 ) Emissions Any SCR installed in accordance with Condition 3.2. shall be designed to meet the NO x emission rate in Condition with an ammonia slip of less than 10 ppmvd corrected to 3% O The opacity from any of the package boilers shall not be greater than 20% opacity for an aggregate of more than 3 minutes in any 1 hour or more than 15 minutes in any 24 hour period Odors from this source shall not be detectable beyond the plant property line in sufficient quantities such as to cause a condition of air pollution. 3. Operational Limitations 3.1. The Company shall not burn in the package boilers any fuel that contains hydrogen sulfide (H 2 S) in excess of 0.10 gr/dscf (162 ppm); 3.2. It is anticipated that the Company can satisfy the emission limitations without the installation and operation of selective catalytic reduction ( SCR ). If the Company elects, however, to install and operate an SCR system, the Company will do so in accordance with Condition At least 60 days prior to the initiation of construction, the Company shall submit to the Department the identification of the vendors and the design specification for the equipment to be installed. If the design of the NOx control system includes SCR, then the Company s submittal pursuant to this paragraph shall also include additional information concerning the appropriate NOx emission limitations to be achieved by the SCR, and after consultation between the company and the Department, any appropriate revisions to the NOx emission limitations shall be incorporated in Condition Within 30 days of completion of construction of a package boiler, the Company shall submit to the Department copies of the operating procedures governing normal operations of the equipment. 3.4 At all times, including periods of startup, shutdown, and malfunction, the Company shall maintain and operate the equipment and processes covered by this Permit, including all structural and mechanical components of all equipment and

4 processes and all associated air pollution control equipment in a manner consistent with good air pollution control practices for minimizing emissions. 4. Testing and Monitoring Requirements 4.1. Within 60 days after achieving the maximum production rate at which the two package boilers will be operated, but not later than 180 days after initial startup of the two package boilers, the owner or operator shall conduct performance tests for all pollutants listed in Condition 2.1 and furnish the Department with a written report of the results of such performance test(s) in accordance with the following general provisions: One original and 2 copies of the test protocol shall be submitted a minimum of 45 days in advance of the tentative test date to the address in Condition 6.3 The tests shall be conducted in accordance with the State of Delaware and Federal requirements The test protocol shall be approved by the Department prior to initiating any testing. Upon approval of the test protocol, the Company shall schedule the compliance demonstration with the Air Surveillance Branch. The Department must observe the test for the results to be considered for acceptance, unless the Department determines in advance, in writing, that the test need not be observed. Further, the Department may in its discretion determine based on its observation of the test that it need not observe the entire test The final results of the testing shall be submitted to the Department within 60 days of the test completion The final report of the results shall be submitted in a format approved by the Air Surveillance Branch, and signed by a corporate official, or his designee, whose signature shall constitute his own, and employer s certification of compliance, clearly indicating each applicable term and condition of the permit, and whether the test(s) fulfilled the permit condition. The results must demonstrate that the emission unit is operating in compliance with the applicable regulations and conditions of this permit; if the final report of the test results shows non-compliance the owner or operator shall propose corrective action(s). Failure to demonstrate compliance through the test may result in enforcement action The performance tests required to determine compliance with the NO x emission limit shall be conducted in accordance with the methods specified in 60.46b(e) for units firing natural gas The Company shall maintain and operate a continuous emissions monitoring system (CEMS), and record the output of the system, for measuring NO x emissions discharged to the atmosphere.

5 4.4. The CEMS shall be installed and calibrated by satisfying the requirements of the Performance Specifications No. 2 in Appendix B of 40 CFR Part 60. The QA/QC procedures for the CEMS shall be established in accordance with the procedures in Appendix F of 40 CFR Part The CEMS shall be operated and data recorded during all periods of operation of the affected facility except for continuous monitoring system breakdowns and repairs. Data is recorded during calibration checks, and zero and span adjustments The 1-hour average nitrogen oxides emission rates measured by the continuous nitrogen oxides monitor shall be expressed in parts per million and shall be used to calculate the average emission rates. The 1-hour averages shall be calculated using the data points required under 60.13(b). At least 2 data points must be used to calculate each 1-hour average The procedures under shall be followed for installation, evaluation, and operation of the continuous monitoring systems When NO x emission data are not obtained because of continuous monitoring system breakdowns, repairs, calibration checks and zero and span adjustments, emission data will be obtained by using standby monitoring systems, Method 7, Method 7A, or other approved reference methods to provide emission data for a minimum of 75 percent of the operating hours in each steam generating unit operating day, in at least 22 out of 30 successive steam generating unit operating days The Company shall continuously monitor the fuel gas flow to each package boiler and sample the fuel gas once per operating day to obtain the higher heating value of the fuel gas. Compliance with Condition shall be based upon the information collected pursuant to this condition and the NOx emissions monitoring results determined in accordance with this section Compliance with Condition 3.1 shall be based upon Premcor s fuel gas monitoring requirement using quality assurance hydrogen sulfide (H 2 S) Continuous Monitoring System (CMS) Compliance with Condition 2.3 shall be based upon conducting weekly qualitative visible emissions evaluations if one or both boilers are operating. If any opacity is observed, the Company shall conduct a visible emissions evaluation using RM 9 of 40 CFR part 60, Appendix A Compliance with Condition 3.4 shall be based on information available to the Department concerning the Company s actions with respect to such events, and shall include the Department s review of all available facts and circumstances including, but not limited to, monitoring results, opacity observations, review of operating and maintenance procedures, and inspection of the source.

6 5. Record Keeping Requirements 5.1. The owner or operator shall maintain all records necessary for determining compliance with this permit in a readily accessible location for 5 years and shall make these records available to the Department upon written or verbal request The rolling 12 month total emissions for each pollutant shall be calculated and recorded each month in an easily accessible format for each pollutant listed in Condition The Company shall record and maintain records of the amounts of each fuel combusted during each day and calculate the refinery fuel gas annual capacity factor for the reporting period. The annual capacity factor is determined on a 12 month rolling average basis with a new annual capacity factor calculated at the end of each calendar month The Company shall maintain records of the following information for each steam generating unit operating day: Calendar date Identification of the periods when the calculated 3-hour average NO x emission rate is in excess of the standard, with the reasons for such excess emissions as well as a description of corrective actions taken Identification of the periods for which pollutant data have not been obtained, including reasons for not obtaining sufficient data and a description of corrective actions taken Identification of the times when emission data have been excluded from the calculation of average emission rates and the reasons for excluding data Identification of F factor used for calculations, method of determination, and type of fuel combusted Identification of the times when the pollutant concentration exceeded full span of the continuous monitoring system Description of any modifications to the continuous monitoring system that could affect the ability of the continuous monitoring system to comply with Performance Specification 2 or Results of daily CEMS drift tests and quarterly accuracy assessments as required under appendix F, Procedure Records of weekly qualitative emission observations noting the presence or absence of visible emissions and Method 9 evaluations when emissions were observed. 6. Reporting Requirements 6.1. Emissions in excess of any permit condition or emissions which create a condition of air pollution shall be reported to the Department immediately upon discovery

7 by calling the Environmental Emergency Notification and Complaint number, (800) In addition to complying with Condition 6.1 of this permit, the Company shall satisfy any reporting required by the Reporting of a Discharge of a Pollutant or an Air Contaminant Regulation, within 30 calendar days of becoming aware of an occurrence subject to reporting pursuant to Condition 6.1. Further the Department may in its discretion require the Company to submit reports not otherwise required by the Regulation. All reports submitted to the Department pursuant to this Condition shall be submitted in writing and shall include the following information: The name and location of the facility; The subject sources that caused the excess emissions; The time and date of the first observation of the excess emissions; The cause and expected duration of the excess emissions; For sources subject to numerical emission limitations, the estimated rate of emissions (expressed in the units of the applicable emission or operational limitation) and the operating data and calculations used in determining the magnitude of the excess emissions; and The proposed corrective actions and schedule to correct the conditions causing the excess emissions Emissions on the same day from the same emission unit may be combined into one report. Emissions from the same cause that occur contemporaneously may also be combined into one report The Company shall submit an electronic copy of all required reports to the Department s compliance engineer assigned to the Refinery Semi-annual reports for the preceding six month period shall be submitted to the Department by July 31 and January 31 and shall include the following information: Information concerning any noncompliance with any emission limitation or operating standard identified in this permit, not otherwise reported pursuant to Condition Identification of the periods for which required emission data have not been obtained, including reasons for not obtaining sufficient data and a description of corrective actions taken Identification of the times when emission data have been excluded from the calculation of average emission rates and the reasons for excluding data Quarterly CEMS reports for the preceding quarter shall be submitted to the Department for the CEMS required by this permit by January 31, April 30, July 31 and October 31 of each calendar year and shall include: a report of excess emissions

8 quarterly audit results data capture for the period details of out of control periods identification of the times when the pollutant concentration exceeded full span of the continuous monitoring system description of any modifications to the continuous monitoring system that could affect the ability of the continuous monitoring system to comply with Performance Specification 2 or One original of all required reports shall be sent to the address below: Air Quality Management Section Division of Air and Waste Management 156 South State Street Dover, DE One copy of all required reports shall be sent to the address below: Program Manager Engineering & Compliance Branch 715 Grantham Lane New Castle, DE Administrative Conditions 7.1. This permit shall be made available on the premises 7.2. Failure to comply with the provisions of this permit may be grounds for suspension or revocation. Sincerely, DRAFT Program Manager Engineering & Compliance Branch