ILLUSTRATED PARTS LIST MODEL NO CUST. CAT. NO. M125-97T POWERDRIVE PRODUCT NO teg.by Rev.

Transcription

1 ILLUSTRATED PARTS LIST MODEL NO CUST. CAT. NO. M5-97T POWERDRIVE PRODUCT NO Rev. 7

2 DECALS Decal, Operators Decal, Fender Decal, Deflect. Warning Decal, Replacement Decal, Engine Warning Decal, Drawbar Decal, Warning Decal, Bypass Decal, Chassis Hot Muffler Pad, Foot Pedal Decal, Battery Dnge/Poi Pad, Footrest, LH Decal, Saddle Brake Parking Manual Operator's (Euro) Decal, Warning Manual Operator's (Scan) Decal, Deck Sch Manual Operator's (E-Bloc) Decal, Brake/Clutch Symbol Manual Operator's (Baltic) Decal, BS Engine Decal, Hood WHEELS AND TIRES Cap Valve Tire Stem Valve Rim Asm " Front Tube Front (Service Item Only) Tire Front 5 x Fitting Grease (Front Wheel Only) Bearing Flange (Front Wheel Only) Cap Axle 50 x Tire Rear 8 x Tube Rear (Service Item Only) Rim Asm 8" Rear Sealant, Tire (0 oz. Tube) wheel_art_-tex NOTE: All component dimensions given in U.S. inches inch = 5.4 mm

3 SCHEMATIC 38 SCH RED A AMMETER (OPTIONAL) FUSE BATTERY RED SOLENOID STARTER M WHITE WHITE B S M G L A A ATTACHMENT CLUTCH (CLUTCH OFF) CLUTCH/BRAKE (PEDAL UP) GRAY REVERSE SWITCH (NOT IN REVERSE) 3 SEAT SWITCH (NOT OCCUPIED) NOTE YOUR TRACTOR IS EQUIPPED WITH A SPECIAL ALTERNATOR SYSTEM. THE LIGHTS ARE NOT CONNECTED TO THE BATTERY, BUT HAVE THEIR OWN ELECTRICAL SOURCE. BECAUSE OF THIS, THE BRIGHTNESS OF THE LIGHTS WILL CHANGE WITH ENGINE SPEED. AT IDLE THE LIGHTS WILL DIM. AS THE ENGINE IS SPEEDED UP, THE LIGHTS WILL BECOME THEIR BRIGHTEST. /WHITE BLUE BLUE FUEL LINE FUEL SHUT-OFF SOLENOID (IF SO EQUIPPED) RED LIGHT SWITCH IGNITION UNIT HOUR METER (OPTIONAL) ORANGE JUNCTION CONNECTOR CHASSIS HARNESS GRAY CHARGING SYSTEM OUTPUT 3 AMP 300 RPM SPARK PLUGS GAP ( PLUGS ON TWIN CYL. ENGINES) V POWER OUTLET (OPTIONAL) SHORTING CONNECTOR LIGHTING SYSTEM OUTPUT 5 AMP 300 RPM ALTERNATOR DIODE 8 VOLTS AC 300 RPM (CHARGING SYSTEM DISCONNECTED) 4 VOLTS AC 300 RPM (LIGHTS OFF) BROWN IGNITION SWITCH HEADLIGHTS POSITION CIRCUIT OFF M+G+A RUN/OVERRIDE B+A RUN B+A START B+S+A MAKE L+A 3 CHASSIS HARNESS CONNECTOR (MATING SIDE) 5 4 DASH HARNESS CONNECTOR (MATING SIDE) WIRING INSULATED CLIPS NOTE: IF WIRING INSULATED CLIPS WERE REMOVED FOR SERVICING OF UNIT, THEY SHOULD BE RE-INSTALLED TO PROPERLY SECURE YOUR WIRING. NON-REMOVABLE CONNECTIONS REMOVABLE CONNECTIONS

4 ELECTRICAL 3 TR0S Service Minder (If Equipped) Charge Indicator (If Equipped) (+) (-)

5 ELECTRICAL 3 NO. NO. DESCRIPTION Battery Bolt Hex Head /4-0 x 3/ Box Battery Switch Interlock Push-In Harness Socket Light w/45j Bulb Light Cable Starter Fuse Nut Keps Hex /4-0 unc Cable,Ground Switch, Seat Switch, Ign Key/Chain Switch Light/Reset Harness Ign. Dash Solenoid Screw Thdrol 5/-8 x 3/4 TYTT Harness Chassis Socket Asm Switch Interlock Clutch Cbl Cover Terminal Screw /4-0 x 3/ Harness Pigtail Switch Reverse Palnut /4 Lugs NOTE: All component dimensions given in U.S. inches inch = 5.4 mm 5

6 TRACTOR - - MODEL NO. M5-97T ( ), PRODUCT NO CHASSIS AND ENCLOSURES chassis-tex_tex LT PRED_

7 CHASSIS AND ENCLOSURES Emblem Dash Hood Lens LH Grille Lens RH Plate Engine Screw 5/-8 x 3/ Fender Nut Crown Lock 5/ Drawbar Screw THDROL 5/-8 x / Screw Cupholder Insert Reflection LH Air Duct Bracket Pivot Shield Browning Screw 3/8- x 3/ Screw /4 x / Crossmember Screw 0-4 x 5/ Bushing Steering Chassis Bushing Mtg. Fender Crgo Dash Lower Bolt 5/-8 x -/ Plug Screw 5/-8 x 3/ Nut Lock Hex Flange 5/ Console Asm. Deck Lift Washer 3/3 x -/4 x Ga Side Vent RH Side Vent LH Bolt 5/-8 x 3/ Rod Pivot Hood X-Piece Hood Stop Trim Ring Stud Fastener Spacer Fender Nut Lock 5/-8 unc Plug Mount Cargo Screw Hex Shield Chassis French LH Shield Chassis French RH Shield Upper Pedal Bolt 5/-8 unc x 3/ Shield Drawbar Insert Reflection RH NOTE: All component dimensions given in U.S. inches inch = 5.4 mm 7

8 TRACTOR - - MODEL NO. M5-97T ( ), PRODUCT NO DRIVE drive-tex_vatr_pedal_9_r4 8 8

9 DRIVE 40 Transaxle, Variator SD Pedal ( ) (Order parts from transaxle manufacturer.) Key Square Bolt Hex HS 3/8- unc x -/ Bushing Snap Washer 3/3 x 3/ x Ga Spring, Brake Rod, Brake Ring E Rod, Brake, Park Washer.793 x.37 x Cover, Foot Pedal Bolt 3/8- unc Idler Flat Nut Lock Idler V-Groove V-Belt, Drive Subasm. Shaft Pedal Brake Washer Nylon 3/3 x 3/ x Bolt Hex 5/-8 x Rod Bypass Nut Lock Hex Flange 5/ Screw 5/-8 x 3/ Screw Thdrol 5/-8 x / TYTT Pin Cotter /8 x 3/ Retainer Clip Spring, Return, Clutch Rod Control Nut Push Latch Brake Parking Strap Torque Variator Handle Park Brk Bolt 3/8- unc x -3/ Spacer Retainer Washer 3/3 x x 0 ga Link Clutch Ground Drive, Long Bellcrank Ground Drive Keeper. Bellcrank Bracket Brake Washer /3 x / x Washer 5/3 x -5/8 Ga Rocker Asm. Pedal Pedal Forward Pad Pedal Reverse Bearing Nylon Retainer Spring Washer Flat Screw Guard.Muffler Subasm. Link Rocker Pedal Bolt Hex 5/-8x Bracket Mount Keeper Idler Pulley Idler Groove Puller Idler Flat Bolt Pin Cotter Bolt RDHD Spacer Idler Arm Control Brake Nut Crownlock 3/8- unc Nut Push 8 mm NOTE: All component dimensions given in U.S. inches inch = 5.4 mm 9

10 ENGINE OPTIONAL EQUIPMENT Spark Arrester 4 85 engine-tex_bs_ Guard_assembly_

11 ENGINE 4 Engine B & S, Model No. R B (503030)(Order parts from engine manufacturer.) Muffler Keeper Belt Engine Pulley Engine Tank Fuel Cap Asm Control Throttle/Choke Screw #0 x.750 BOS Thread Fuel Line Spark Arrester Kit Clamp Hose Washer 7/ Nut Keps Hex /4-0 unc Gasket Screw Socket 5/-8 x Screw 3/8- x -/ Bolt Hex 7/-0 x 4 Gr Screw 3/8- x Washer 9/3 x 7/8 x Ga Screw Hexwsh Thdrol /4-0 x 3/ Screw 5/-8 x 3/ Shield Side LH Shiled Side RH Cover Eng. Pulley w/shld 38", 4" Palnut # Extension Drain Oil Screw, # , BOS NOTE: All component dimensions given in U.S. inches inch = 5.4 mm Engine Power Rating Information The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers) code J940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in accordance with SAE J995 (Revision 00-05). Torque values are derived at 300 RPM; horsepower values are derived at 300 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual on-site or net power). This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

12 STEERING ASSEMBLY steering-tex_stdhrs_ 53

13 STEERING ASSEMBLY Wheel, Steering Axle Asm., Front Spindle Asm., LH Spindle Asm., RH Bearing, Race Thrust Hardened Washer 5/3 x -5/8 x Ga Ring, Klip #T Cap, Spindle Washer, 5/3 x -/4 x Ga Washer, SLW ZD 3/ Nut, Crown Lock 3/8-4 unf Steering Shaft Plate Steering Boot, Steering Adapter, Wheel Steering Bearing Insert, Wheel Steering Washer x 3 x x Ga Screw 3/8- x 3/ Washer Lock 5/ Gear, Sector Plate Washer /3 x 3/8 x Ga Washer Hardened.793 x.37 x Bracket Upstop Bolt Shoulder Sector Pivot CFM Washer Thrust Sector Steering Nut Flange Lock 5/ Draglink, LH Draglink, RH Screw 5/-8 x 3/ Retainer Clip Spring Steering Bolt Hex Fghd 7/-4 x 3 Serr Bushing PM Front Axle Nut Lock Flange 7/-4 Gr Washer.5 x.505 x Bracket Deck Susp. Front Shaft Extension Steering Bolt Fin Hex 5/-8 x 3/4 w/patch Bearing Pinion Screw Head Sock Cap Gear NOTE: All component dimensions given in U.S. inches inch = 5.4 mm 3

14 MOWER DECK _Tex-LT_34_r3 9 4

15 MOWER DECK Deck Weldment Bolt Arm Suspension Clutch Asm. Manual Screw #0 x BOS Thread Palnut / Blade 38" Keeper Belt Engine LH Screw Sems 7/-0 x Keeper Belt Engine RH Shaft Assembly, Mandrel Keeper Belt Housing, Mandrel Pulley Idler Bearing, Ball, Mandrel Spring Return Bolt, Shoulder Manual Clutch Cable Nut, Crownlock 5/-8 unc Stud Fastener Bracket, Deflector Nut Lock Hex Flange Cap, Sleeve Screw 3/8- x 3/ Spring, Torsion, Deflector Baffle Vortex Nut, Push Screw /4-0 x Shield, Deflector Washer 9/3 x 7/8 x Ga Rod, Hinge Washer 3/3 x x Pulley, Mandrel Screw TT # / Nut, Toplock, Flanged Port Washout Bolt Carr. Sh. 3/8- x -/ Gr Cover Deck Fastener Shield Deck LH Washer Shield Deck RH Keeper Belt LH Mandrel Cover Cable Clutch Nut, Lock Flg. 3/8- unc Kit Strap Bungee Bolt Hex Wshr Rivet Spring Torsion Brake Screw 3/8- x / Spring Torsion Retainer Mandrel Assembly (Includes housing Screw /4-0 x 5/8 (key# 4), shaft assembly (key# 3), Arm, Idler and bearing (key# 5) only - pulley/ Spacer, Retainer nut/washer and blade bolt/washers Screw 3/8- x not included.) Guard, Tuv. Idler Replacement Mower, Complete Arm Brake Mower Arm Brake Mower Link Brake Handle Clutch Cable NOTE: All component dimensions given in U.S. inches V-Belt inch = 5.4 mm 5

16 MOWER LIFT * lift-tex_4 *Key 9 may be substituted for Key Shaft Asm., Lift Lever Asm., Lift RH Grip, Lever Spring Torsion Pin Cotter 7/ Bow Tie Lock Spring Lift Assist Washer Clear Zinc Pin Cotter 5/ Bow Tie Lock Link Lift Susp Mower Rear Screw 3/8- x Link Lift Susp. Front Mower Nut Centerlock 3/ Link Asm. Lift FXD Washer 5/3 x 5/ x Ga. NOTE: All component dimensions given in U.S. inches inch = 5.4 mm

17 SEAT ASSEMBLY seat-tex_.5sl_ Seat Bracket Pivot Fender Nut, Lock w/ins. 3/8- unc Spring, Seat Cprsn Bolt 5/-8 unc x 3/4 w/sems Pan, Seat Bolt, Shoulder 5/-8 x 5/ Nut, Lock 5/-8 unc Handle Slide Spring Latch Bolt Fin Hex 3/8- unc x 3/ Washer Winged Bolt 3/8- x,.5 OD NOTE: All component dimensions given in U.S. inches inch = 5.4 mm 7

18 0.0.7 BD