INSTALLATION INSTRUCTIONS

Size: px

Start display at page:

Download "INSTALLATION INSTRUCTIONS"

James Knight
5 years ago
Views:

1 INSTALLATION INSTRUCTIONS Accessory S P/N 08E10-TK8-100 Application 2011 ODYSSEY Publications No. AII Issue Date SEP 2010 PARTS LIST 2 Ambient lights Illustration of the Ambient Lights Installed on the Vehicle Ambient light harness 13 Wire ties 2A FUSE AE Fuse label INSTALLATION TOOLS AND SUPPLIES REQUIRED Isopropyl alcohol Shop towel Diagonal cutters Trim Tool Set (SOJATP2014) (Available through the Honda Tool and Equipment program. On the in, click on: Service/Service Bay/Tool and Equipment Program, then enter the number under Search. Or call ) 10 mm Open end wrench Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by do-it-yourselfers. 1. Make sure you have the anti-theft code for the audio unit and navigation system if equipped then write down the radio station presets. 2. Disconnect the negative cable from the battery American Honda Motor Co., Inc. All Rights Reserved. AII (1009) 08E10-TK of 5

2 3. Remove the front passenger s under cover (three clips and two pins). 5. Remove the driver s dashboard side panel (three clips, four retaining tabs, and one pin). 3 S FRONT AE 4 RETAINING TABS 2 S BE 4. Remove the passenger s dashboard side panel (three clips, four retaining tabs, and one pin). Routing the Ambient Light Harness 6. Using isopropyl alcohol on a shop towel, thoroughly clean the fuse case where the fuse label will attach. Attach the 2A fuse label to the fuse case on the ambient light harness. FUSE CASE FUSE LABEL (2A ) 4 RETAINING TABS 3 S BE AE 2 of 5 AII (1009) 2010 American Honda Motor Co., Inc. All Rights Reserved.

3 7. Plug the ambient light harness 12-pin connector into the driver s fuse box. VIEW FROM FRONT 9. Install the ambient light to the hole in the dashboard as shown. FUSE BOX Plug in here. FUSE BOX Turn. 12- CONNECTOR 8. Secure the ambient light harness to the vehicle harness with one wire tie AE BRAKE PEDAL 10. Route the ambient light harness to the center console as shown AE 2- CONNECTOR BRAKE PEDAL CENTER CONSOLE AE AE 11. Plug the ambient light harness 2-pin connector into the ambient light American Honda Motor Co., Inc. All Rights Reserved. AII (1009) 3 of 5

4 12. Secure the ambient light harness to the vehicle frame and vehicle harness with two wire ties. FRAME 14. Route the ambient light harness along the vehicle harness, and secure it to the vehicle harness with two wire ties. BRAKE PEDAL CONNECTOR AE 13. Route the ambient light harness through the center console, and secure it to the vehicle harness with three wire ties. SIDE SIDE AE 15. Route the ambient light harness along the vehicle harness, and to the blower motor. Secure the ambient light harness to the vehicle harness with two wire ties. OPENING CENTER CONSOLE AE SIDE BLOWER MOTOR AE 4 of 5 AII (1009) 2010 American Honda Motor Co., Inc. All Rights Reserved.

5 16. Secure the ambient light harness to the vehicle harness with three wire ties. OPENING 18. Reinstall the passenger s dashboard side panel. 2- CONNECTOR 3 S AE 17. Install the ambient light to the passenger s under cover as shown. Turn BE 19. Move the passenger s under cover near the dashboard, plug the ambient light harness 2-pin connector into the ambient light, and reinstall the passenger s under cover. 20. Check that all wire harness and cables are routed properly and that all connectors are plugged in. 21. Reinstall all removed parts. 22. Reconnect the negative cable to the battery. 23. Enter the anti-theft code for the audio unit and navigation system if equipped and reset the radio station presets. 24. Reset the clock on vehicles without navigation AE 2010 American Honda Motor Co., Inc. All Rights Reserved. AII (1009) 5 of 5

INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS Accessory S P/N 08E10-TP6-100 Application 2010 ACCORD CROSSTOUR Publications No. AII 41935 Issue Date NOV 2009 PARTS LIST TOOLS AND SUPPLIES REQUIRED Ambient Light Kit Ambient