Food Processing Vaportight

Size: px

Start display at page:

Download "Food Processing Vaportight"

Virginia Fleming
5 years ago
Views:

PROJECT DTE TYPE NOTES REV: /5/08 - High Lumen Packages, up to 9,00Lm Delivered - mbient operating temps as Low as -0C(-0F) and as High as +0C(+0F) (Temps Vary by Configuration.

melt or burn) - Polycarbonate Lens: Clear / Frosted - 0 Year warranty NSF IP65 IEC 59 IP66 IEC 59 IP67 IEC 59 NEM X 5V DISCLIMER: lthough KURTZON has prepared the information contained in this

Whilst the information is considered to be true and correct at the date of publication, changes in circumstances after the time of publication may impact on the accuracy of the information.

1 PROJECT DTE TYPE NOTES REV: /5/08 - High Lumen Packages, up to 9,00Lm Delivered - mbient operating temps as Low as -0C(-0F) and as High as +0C(+0F) (Temps Vary by Configuration. Verify in Energy Data Section) - NSF pproved - IP65 / IP66 / IP PSI hosedown - UL 598 Wet Location - Marine grade 6 stainless steel latches & Mounting brackets - NemaX - UL 5V Rated (will not melt or burn) - Polycarbonate Lens: Clear / Frosted - 0 Year warranty NSF IP65 IEC 59 IP66 IEC 59 IP67 IEC 59 NEM X 5V DISCLIMER: lthough KURTZON has prepared the information contained in this document with all due care, KURTZON does not warrant or represent that the information is free from errors or omission. Whilst the information is considered to be true and correct at the date of publication, changes in circumstances after the time of publication may impact on the accuracy of the information. The information may change without notice and KURTZON is not in any way liable for the accuracy of any information printed and stored or in any way interpreted or used. ORDERING GUIDE Series Lumen Package CCT Lens Voltage Controls Mounting Sensors Options FP-SEG-70 -SERIES - LUMEN PCKGE - CCT - LENS 6 - CONTROLS 8 - SENSORS (Not Required) FP-SEG-70 LO: Row of Low Flux LED's 8 CRI: CP: Clear Polycarbonate DIM: 0-0V % OCC MW: Microwave Occ Sensor (Internal ' MX) LO: Rows of Low Flux LED's 80 = 000K CCT FP: Frost Polycarbonate DIM5: 0-0V 5% OCC H: Highbay Occ Sensor (End Mount 0'-0') HI: Rows of High Flux LED's 85 = 500K CCT CPD Diffused Clear Poly DLI: DLI % OCC L: Lowbay Occ Sensor (End Mount 8'-0') 80 = 000K CCT FPD Diffused Frost Poly LUTRON: (Specify Type) DL/OCC H: Daylight & Highbay Occ Sensor (End Mount 0' MX) 850 = 5000K CCT /ED: Circuit Switching DL/OCC L: Daylight & Lowbay Occ Sensor (End Mount 8' MX) + CRI: UNV: (0-77 Vac) 5 - VOLTGE OTHER: (Must Specify) OTHERS: Must Specify 95 = 500K CCT HV: (7-80 Vac) 7 - MOUNTING (Not Required) 9 - OPTIONS (Not Required) = 000K CCT CMH: Chain Mtg Hooks PXW: Program to Specified Wattage (Replace X with Watts) Not available in "HI" lumen package M5: 5 Mtg racket SCM: Single Conduit Stem DCM: Dual Conduit Stem PXL: Program to Specified Lumens (Replace X with Lumens) 0kV: 0kV Surge Protection (one per specified circuit) WP: Wire Cord W/Plug must provide specs. WHIP: Flex whip installed must provide specs EM0: 0W Integral Emergency Driver (Specify Voltage & Switching) FF: Fuse & Fuse Holder (One per Specified Circuit)

2 REV: /5/08 SPECIFICTIONS HOUSING: Injection molded,.5 thick Hole Free White Fiberglass body with a 5V Flame Rating LENS: Injection molded Heavy gauge smooth or ribbed polycarbonate material available Clear or frosted. Secured by Captive Stainless Steel cables. REFLECTOR: Standard (9%) High Reflectance white gauge metal. Formed wiring cover for rigidity. Removable without tools or screws. GSKETS: One piece urethane extruded foam with smooth surface. LTCHES: Eight (8) 6 Stainless Steel over-center latches secure lens to housing. MOUNTING: Provided with () mounting brackets for suspending (cables by others). See mounting options for other configurations. LEDS: Commercially available in a wide variety of Color Temperature (CCT), FLUX, and CRI. Highly efficient and consistent color maintained to SDMC for color critical applications. 50/L70 and compliant with Zhaga recognized hole patterns. Consult factory for LED options or configurations not listed below. DRIVERS: Standard Universal Voltage Class drivers are 0-0v Dimmable to % for most LED configurations. They come with at least.5kv surge protection, have less than 0% THD at max load, allast Factor Greater than.95 and are programmable to match specific lumen or wattage requirements. Drivers with higher input voltage ratings are available, consult factory for driver specifications. INSTLLTION: Two sealed / inch trade size conduit entry points located at each end. See options for pre-wired whips or cords. LISTINGS: NSF Listed for food zones. IP67 rated for dust and water ingress. Suitable for 500 PSI high pressure hosedowns. UL listed per UL_598 for wet locations. Nema x rated. Drivers and LEDs are covered by a 5 year warranty, the remaining fixture is covered by a 0 year warranty. PRODUCT DRWINGS SEG 70 REFERENCE DIMENSIONS 5.0".5" SURFCE MOUNTING LOCTIONS 6.8" LENS OPTIONS: CLER CRYLIC (RIED) FROSTED CRYLIC (RIED) CLER POLYCRONTE (RIED) FROSTED POLYCRONTE (RIED) CLER CRYLIC (SHLLOW) FROSTED POLYCRONTE (SHLLOW) (8) STINLESS STEEL LTCHES WITH TMPERPROOF FSTENING () SS MOUNTING RCKETS (OPTIONL) -C-L-SEG 70 DWG DTE: /8/07

3 REV: /5/08 ENERGY DT ENCLOSURE SIZE LED PCKGE DIMMING SELECTION CRI STD SEG 70 (PROX¹ DELIVERED LUMENS) CLER LENS FROST LENS MIENT TEMP LUMENS¹ WTTS² EFFICCY³ (Lm/W) LUMENS¹ WTTS² EFFICCY³ (Lm/W) MINIMUM MXIMUM⁴ 70 LO 0-0V % 8,500 9, C (- F) 5 C (95 F) 70 LO 0-0V 5% 8,500 9, C (- F) 0 C (0 F) 70 LO 0-0V % +,0 9 00, C (- F) 5 C (95 F) 70 LO 0-0V 5% +,0 9 00, C (- F) 0 C (0 F) 70 LO 0-0V % 8 7, , C (- F) 5 C (95 F) 70 LO 0-0V 5% 8 7,9 5 6, C (- F) 0 C (0 F) 70 LO 0-0V % + 5, , C (- F) 5 C (95 F) 70 LO 0-0V 5% + 5, , C (- F) 0 C (0 F) 70 HI 0-0V % 8 7, , C (- F) 0 C (86 F) 70 HI 0-0V 5% 8 9, , C (-0 F) 0 C (0 F) 70 EM0⁵ N N N N 0 C ( F) 5 C (95 F) ¹ DELIVERED LUMEN DT IS EXTRPOLTED FROM MESURED WITH NO EXTR OPTIONS. VRINCES WILL OCCUR WHEN OPTIONS RE CHOSEN ² WTTGE IS MESURED WITH 000K 0vC ND Tambient = 5C. WTTGES MY VRY WITH LTERNTE CONFIGURTIONS ³ EFFICCY CLCULTED USING 000K CCT DT. ⁴ TEMP RTING MY VRY WITH SPECIFIED DRIVERS OR NY NON STNDRD SELECTION ⁵ MINUTE 0W EMERGENCY DRIVER; LUMENS CLCULTED SED ON FIXTURE EFFICCY. (EX: 0W x 00Lm/W = 000Lm Delivered) PHOTOMETRICS FP-SEG-70-HI80-CDP-UNV-DIM5 FP-SEG-70-LO80-CDP-UNV-DIM Report No: Report No: Total Lumens: 9,0 Total Lumens: 7,9 Wattage: 50. Wattage: 5.5 Efficacy: 8. (Lumens Per Watt) 500 Efficacy: 0.5 (Lumens Per Watt) 500 Fixture Size: 7 x 000 Fixture Size: 7 x Deg. 70 Deg. 0 Deg. Deg. 80 Deg. 70 Deg. 0 Deg. Deg.

4 REV: /5/08 MOUNTING OPTIONS STNDRD RCKET.78" 6.00" CMH RCKET OPTION 6.00" M5 OPTION 6.00" DESCRIPTION: SEG-70 MOUNTING OPTIONS SHEET: DTE: /9/08

5 REV: /5/08 MOUNTING OPTIONS /" HU FCTORY INSTLLED E DCM OPTION STEMS Y OTHERS DETIL E.00" SCM OPTION STEM Y OTHERS /" HU FCTORY INSTLLED DETIL G G DESCRIPTION: SEG-70 MOUNTING OPTIONS SHEET: DTE: /9/08

Project Name: Part Number: Type: v q k. ^ o o. R v b ^ o

v q k ^ Project Name: Part Number: Type: WTZ AMAZON FEATURES Impact resistant, Ribbed Acrylic Frosted (RAFL std.), Ribbed Polycarbonate (RPCL) Deep Clear Lens (DPCL) or Deep Frosted Lens (DPFL) options