RSD Range Door Subchassis Gas Tubing Storage Base Top Frame Cell/Case Manifold Bezel Membrane Updates

Transcription

1 RSD Range Door Gas Tubing Top Frame Manifold Subchassis Storage Base Cell/Case Bezel Membrane Updates

2 RSD - OVEN DOOR ASSEMBLY 75 OBSOLETE BRACKET, HEAT BARRIER GLASS, (NO LONGER USED) A/B/R FRAME, GLASS MOUNTING, (Almond, Black or Arctic White) B FRAME, GLASS MOUNTING GLASS/OVERLAY ASSEMBLY, (Stainless Only) GASKET, DOOR 80 OBSOLETE GLASS, HEAT BARRIER, (NO LONGER USED) WINDOW PACK, (10X16, Double) * 82790BP "J"-TRIM WINDOW PACK, (Black Porcelain) * THERMOCORD, WINDOW PACK A/B/R OUTER GLASS, (Almond, Black or Arctic), (Use assembly number 86360, for stainless) 83 NOT USED A/B/R HANDLE, DOOR, (Almond, Black or Arctic) TAPE, DOUBLE SIDED,.30 THK HINGE, DOOR * HINGE, DOOR (Stainless Front) 87 OBSOLETE INSTRUCTION PLATE, (NO LONGER USED) INSULATION BP LINER, INNER LINER, OUTER, (Black Porcelain) B HEAT SHIELD, DOOR, (Black) 92 OBSOLETE HEAT SHIELD, DOOR, (Black) SHIELD, LEFT SHIELD, RIGHT

3 Issued By: Technical Service Subject: 1440 Bridge Gate Drive Diamond Bar CA Grates Date Issued: Product Type: Gas Cooktops / Ranges Page 1 of 1 Distribution: Service/Parts Model No: Supercedes: Bulletin No: On October 10, 2002 the grates were changed on the cooktops and ranges listed below. The grates were changed to increase cleanability. The newer grates have a smooth black finish. The serial revision level changes are noted below. Effective immediately the old style grate, part number 82109BM, are no longer available. When replacing a grate, care must be taken to ensure that the grates all match. One grate cannot be replaced without replacing both or all three grates. Please refer to the serial number revision levels when ordering replacement grates. MODEL NUMBER OLD SERIAL REVISION NEW REVISION SGM364 F G SGM464EM F G SGM464GG F G SGM362EM (this model was obsolete prior to the grate change but like replacements are no longer available. RSD30 E F PGR30 E F RSG30 (this model was obsolete prior to the grate change but like replacements are no longer available. GRATE SETS 1 GRATE 2 GRATES 3 GRATES

4 Date: Re: Preference Range Door Changes RSE REVISION B AND OLDER REVISION C AND NEWER RSD30, PGR30 REVISION D AND OLDER REVISION E AND NEWER Description Old Part # New Part # Door Gasket Hinge Stainless Steel Hinge Black/Arctic Window Pack W/J-Channel N/A Window Pack N/A Side Shield, Left Side Shield, Right Heat Shield, B/R B Heat Shield S B Insulation Inner Liner Assy 27459BP 27728BP Bracket, Inner Liner Outer Liner BP Door Bumpers N/A Inner Door Assembly Inner Door W/1 Window Pack 27 Black/Arctic Stainless Black/Arctic Stainless 66623

5 RSD - SUB CHASSIS ASSEMBLY COOLING FAN SUBCHASSIS TERMINAL BLOCK, 2-POLE DUCT TRANSITION HEAT SHIELD FUSE BOX ASSEMBLY, (CSA) FUSE, 15 AMP, (CSA) * FUSE, 15 AMP, (CSA) CSA SINGLE SOCKET * FUSE, 30 AMP /2 FLEX, 90 DEGREE CONNECTOR, (Elbow) BACK COVER EXHAUST COVER DIVIDER EXHAUST DUCT CONNECTOR, 1/2 FLEX, STRAIGHT CONDUIT, (UL) LEAD WIRE KIT, (UL) LEAD WIRE KIT, (CSA)

6 RSD - STORAGE / BASE ASSEMBLIES ADAPTER, 3/8 FPT TO 3/8 TUBE GAS TUBE RACEWAY, GAS TUBE ADAPTER, 1/2MNPT TO 3/8 TUBE BRKT, INLET FITTING ATTCH SUPPORT, STORAGE PANEL (Includes key numbers; 7, 8 & 9) NUT, 8-32 KEEPS WASHER, NYLON SHOULDER SCREW 10 ORDER 26851A\B\R OR 13059(Stainless) A\B\R PANEL, STORAGE, (Almond, Black, Arctic) * PANEL, STORAGE, (Stainless) HINGE CATCH, MAGNETIC LINER, STORAGE PANEL BRKT, STORAGE COMP. MTG LEVELER, ADJUSTABLE, 5/16" * LEVELER, ADJUSTABLE, 1/2" ASSY, BASE, RANGE ( Uses 1/2" Leveler) BRACKET, ANTI-TIP ASSY, STIFFENER, BASE EXHAUST PLATE ASSEMBLY B ASSEMBLY, STORAGE COMPARTMENT

7 RSD - GAS TUBING / CONTROL ASSEMBLIES IGNITOR WIRES SPARK MODULE, 4 POINT, (Attaches with Velcro) SIDE SUPPORT ASSEMBLY, (Left) SPARK BOX PLATE JUMPER WIRES, LIGHTS & SWITCHES IGNITOR HARNESS BURNER TUBE/BASE, (Left Rear) BURNER TUBE/BASE, (Front) BURNER TUBE/BASE, (Right Rear) BURNER SUPPORT CHANNEL SIDE SUPPORT ASSEMBLY, (Right) TERMINAL BLOCK REAR PANEL ASSEMBLY P.C.B. SUPPORT, NYLON * RELAY PCB, 105 C* ASSEMBLY, AIR BAFFLE PUSH TIE PUSH TIE STANDOFF, 6/32 X.438LG, 1/4 HEX, (Two used with screw and nut) P.C.B. MOUNTING PLATE HARNESS, ERC TO RELAY P.C.B. *Click on Updates for updated part.

8 Date: Re: Relay Board Products Covered: ECS127, 130, 136 MCS127, 130 PCS130 ERD30SO6 ERD60S06, ERD36, ERDE36, MRES30S, RSD30 Revision Level Change: Model# Old Rev New Rev ECS127B/R/SBK/ SBR/SCH/SCP, MCS127B/R/S H J ECS127B/R/SBK/SCH/SBR/SCP/208V, MCS127B/R/S/208V, ERD60S06 F G ECS130B/R/SBK/SBR/SCH/SCP, MCS130B/R/S, PCS130BRS J K ECS130B/R/SBK/SBR/SCH/SCP/208V, MCS130B/R/S/208V, PCS130B/R/S/208V G H ECS136SBK/SBR/SCH/SCP E F ERD30S06 U V ERDE36, MRES30S B C ERD36 N P RSD30 L M Condition: This replacement was implemented to improve reliability and to reduce warranty cost due to service issues relative to flickering lights. Relay boards ARE backwards compatible and can be used as service replacements. Correction: Description Old Part # New Part # Relay Board This change IS backward compatible, new parts can be used on any unit.

9 RSD - OVEN CELL / CASE ASSEMBLY ** Not Shown 13425B, S, R 3" Sidepanel - RH 13426B, S, R 3" Sidepanel - LH CASE TOP DOOR LATCH MECHANISM LATCH PLATE 4 Not Replaceable ASSY, OVEN CELL 30" ASSY, CASE SIDE, LEFT SUPPORT RACK, BLK PORC OVEN RACK, 30"CONV. CELL PLATED GRILL, BROILER PAN PORCELAIN PAN BROIL ELEMENT, 3000W, 240V BAKE ELEMENT, 2200W, 240V FILTER, CONVECTION BP CONVECTION BAFFLE, 30" OVEN, (Black Porcelain) CONVECTION ELEMENT, 2200W, 240V FAN BLADE, CONVECTION MOTOR SMOKE ELIMINATOR LIGHT ASSY WITH 40W BULB, (130 Volt) * LENS COVER HEAT SHIELD, STORAGE, RSD RECEPTACLE, HINGE, DOOR ASSY, CASE SIDE, RIGHT TEMPERATURE SENSOR ASSY, CONV. MOTOR MOUNTING PLATE CONVECTION MOTOR CASE BACK TERMINAL BLOCK COVER COVER PLATE, LIGHT THERMAL SWITCH, HI-TEMP CUTOUT EXHAUST TUBE **82089 Bulb

10 RSD - MANIFOLD ASSEMBLY BUSHING, 5/8 DIA ASSY, MANIFOLD ENCLOSURE (Please Note: Effective 6/25/96; a design change now uses the RSG enclosure #27095), (pry-out plug #83387, is now needed to block the right hole, when replacing an original RSD enclosure "C"-AIR SHUTTER "C"-VALVE W/JETS, (Left Rear/Natural Gas) Use Prior To Serial # FD * "C"-VALVE W/JETS, (Left Rear/Liquid Propane) Use Prior To Serial # FD "C"-VALVE W/JETS (Left Rear/Natural Gas) Use Starting Serial # FD * "C"-VALVE W/JETS (Left Rear/Liquid Propane) Use Starting Serial # FD MICROSWITCH "B"-VALVE W/JETS, (Left Front/Natural Gas) Use Prior To Serial # FD * "B"-VALVE W/JETS, (Left Front/Liquid Propane) Use Prior To Serial # FD "B"-VALVE W/JETS, (Left Front/Natural Gas) Use Starting Serial # FD * "B"-VALVE W/JETS, (Left Front/Liquid Propane) Use Starting Serial # FD "B"-AIR SHUTTER GAS VALVE, 90, 3/8 NPT REGULATOR, 1/2 X 1/2 (Also Order Bushing Part # /2 x 3/8, When Replacing Regulator) 10 * MANIFOLD, GAS RANGE "C"-VALVE W/JETS, (Right Front/Natural Gas) Use Prior To Serial # FD * "C"-VALVE W/JETS, (Right Front/Liquid Propane) Use Prior To Serial # FD "C"-VALVE W/JETS, (Right Front/Natural Gas) Use Starting Serial # FD * "C"-VALVE W/JETS, (Right Front/Liquid Propane) Use Starting Serial # FD "B"-VALVE W/JETS, (Right Rear/Natural Gas) Use Prior To Serial # FD * "B"-VALVE W/JETS, (Right Rear/Liquid Propane) Use Prior To Serial # FD "B"-VALVE W/JETS, (Right Rear/Natural Gas) Use Starting Serial # FD * "B"-VALVE W/JETS, (Right Rear/Liquid Propane) Use Starting Serial # FD "B"-AIR SHUTTER "C"-AIR SHUTTER GROMMET, EPDM RUBBER BRKT, MTG., ENCLOSURE SEAL, SHUT-OFF VALVE ENCLOSURE TOP, MANIFOLD BRASS PLUG, MANIFOLD (Not Shown) - COMPLETE MANIFOLD ASSEMBLY - Please Note: (Replace with Regional Service Manager approval only) *62121 MANIFOLD ASSEMBLY, (Natural Gas) *62099 MANIFOLD ASSEMBLY, (Liquid Propane)

11 RSD - BEZEL-MEMBRANE-TRIM ASSEMBLIES Ref. # Part # Description B/R MEMBRANE (Black/Arctic - Use Blk for Almond) 2* B/R ASY, BEZEL (Black/Arctic - Use Blk for Almond) A/B/R KNOB, RANGE (Almond/Black/Arctic) A/B/R TRIM POST, LEFT B CONTROL BEZEL TRIM (Black Only) B INTAKE GRILL A/B/R EXHAUST GRILL NAMEPLATE, SELF CLEAN A/B/R TRIM POST, RIGHT INDICATOR LIGHT, BLUE NEON A/B/R SPILL PROTECTOR (Almond/Black/Arctic) ** OVEN CONTROL(E.R.C.) *PLEASE NOTE: Also order 4 indicator light assemblies, part # prior to serial numbers below Starting serial numbers for almond and black models is: FA Stainless is FA and arctic white is number: FA ** Order As Kit, (Click Note for Details)

12 RSD - TOP FRAME ASSEMBLY BM GRATE PACK EXTENDED, (Black Matte Porcelain) GRATE SUPPORT PAD IGNITOR ASSEMBLY AP/BP/RP/SG TOP FRAME, (Almond, Black, Arctic White, or Stainless) O-RING, "B"-BURNER HEAD * O-RING, "C"-BURNER HEAD "B"-BURNER HEAD ASSEMBLY, W/IGNITOR BRASS NUT; "B" & "C"- BURNER HEAD * "B"-BURNER RING BM "B"-BURNER CAP, (Medium) BM "C"-BURNER CAP, (Large) * "C"-BURNER RING "C"-BURNER HEAD ASSEMBLY, W/IGNITOR Note: Burner Rings part number (set of 4) should be used when replacing all 4 igniters or burner assemblies. Units with a serial number revision N or higher will have the individual part number (old) style of rings.