Gateway Type Serial Transmission System

Transcription

1 P99-EX-B Gateway Type Serial Transmission System P Maximum 8 point control (64 inputs/64 outputs) P Flexibility of manifold valve installation improved with 4 branch wiring

2 Flexible installation and removal of Uses connector Gateway Type Serial Transmission System A large selection of applicable manifold valves SV Tie-rod type manifold valves VQC Applicable cylinder sizes Tie-rod type manifold product series line-up SV VQC name SV000 SV000 SV000 SV4000 VQC000 VQC000 Cv factor Applicable cylinder size ø40 ø50 ø6 ø80 ø00 ø5 (Load factor: 50%, Cylinder speed: 50mm/s) Cv factor may vary depending on construction of manifold.

3 manifold valves and input blocks! type junctions. Wiring efficiency improved (wiring labor reduced) The use of connector type cables for all wiring between equipment improves work efficiency and prevents miswiring. Since power supply lines are included in all cables, separate power supplies for SI units (valves) and input devices are unnecessary. Low running cost Low power consumption of 0.6W (SV solenoid valve, 5mA, 4VDC) Service life of 50 million cycles or more (Based on SMC life test conditions.) Connector junctions No complicated wiring Manifold valves and input blocks can be easily installed or removed to accommodate specification changes. Manifold valve Input block IP65 rating All equipment comprising the EX500 series has an IP65 rating, which allows use in environments where there is direct contact with water, etc. (Based on IEC59.) Unused connectors are protected with water proof caps.

4 Gateway (GW) Unit Total I/O points: 64 inputs/64 outputs 4 branches, with 6 inputs and 6 outputs per branch, allow decentralized control. 6 inputs x 4 6 outputs x 4 Since the communications to each branch unit are separate from the master PLC transmission, there is no need to worry about transmission delay time. Gateway units can be selected for use with remote I/O, DeviceNet and PROFIBUS-DP. PLC 64 inputs 64 outputs 5 Port Solenoid Valve/ SV000, 000 Cassette base manifolds The lever type facilitates easy and reliable installation and removal. Lever Pull the lever forward with a screw driver, etc. DIN rail holding screw Loosen the DIN rail holding screws at both ends, and separate the manifold to the left and right. Pull the valve up at the front. Interchangeable cylinder port fitting assemblies SV000: C, C4, C6, N, N, N7 SV000: C4, C6, C8, N, N7, N9 High speed response: 0ms (SV000, double, 0.5MPa, 4VDC, with surge voltage suppressor) Relay output modules can be installed ( SV000) Equipment up to a maximum of 0VAC, A can be simultaneously controlled together with series SV. Applicable cylinder sizes SV000 SV000 Cv factor Applicable cylinder size ø40 ø50 ø6 ø80 (Load factor: 50%, Cylinder speed: 50mm/s) M8 and M connectors can be used on the same unit One input unit is able to accommodate a variety of input equipment. Input Unit

5 EX500 Gateway (GW) Unit How to Order EX500 G AB (-X) AB DN PR Network communication protocol Remote I/O (RIO) DeviceNet PROFIBUS-DP RIO compatible Specifications Model Applicable PLC/Communication protocol Communication speed Rated voltage Power supply voltage range Input/Output points Input/Output branches Branch cable Branch cable length Branch communication connector Power supply connector Ambient temperature/humidity Enclosure Compatible standards EX500-GAB-X Rockwell Automation PLC 57.6Kbit/sec 5.Kbit/sec 0.4Kbit/sec EX500-GDN DeviceNet Release.0 5Kbit/sec 50Kbit/sec 500Kbit/sec 4VDC EX500-GPR PROFIBUS-DP 9.6, 9., 9.75, 87.5, 500Kbit/sec.5,, 6, Mbit/sec Input & control unit power supply: 4VDC ±0% Solenoid valve power supply: 4VDC +0%/ 5% (voltage drop warning at approx. 0V) 00mA or less Maximum 64 inputs/maximum 64 outputs 4 branches (one branch 6 inputs/6 outputs) 8 wire heavy duty cable 5m or less (total extension 0m or less) M connector (8 pins, socket) M connector (5 pins, plug) +5 C to +45 C/5% to 85%RH (with no condensation) IP65 UL, CSA, CE Input Units How to Order Input Manifolds How to Order Input Blocks EEX500 IB E 8 (-X) EX500 IE (-X) Input block (M8) Input block (M) Connector type E T M M8 connector M connector M8, M mixed RIO compatible Stations 8 station stations 8 stations 4 Connector type/ Input specification M8 connector/pnp M8 connector/npn M connector/pnp M connector/npn RIO compatible Input unit specifications Current source type input block (PNP input block) Connection block or Current sink type input block (NPN input block) Communication connector M connector (8 pins, plug) Connection block qty. Maximum 8 blocks Block supply voltage 4VDC Block supply current 0.65A Max. 00mA or less (at rated voltage) Operates at ATyp. (power supply cut) Short circuit protection Reset by turning GW unit power off and back on again. When placing an order, the input manifold part number and input block part number are entered together. Cables Input block specifications Compatible sensor Sensor connector Input points Rated voltage Indication Insulation Sensor supply current Current source type (PNP output) or Current sink type (NPN output) M8 connector ( pins) or M connector (4 pins) points 4VDC Green LED None Maximum 0mA/Sensor How to Order Branch Cables with M Connector How to Order Power Supply Connector Cables EX500 AC 00 SSPS EX500 AP 00 S SSPS SAPA Cable length m 0.5m m m 5m Connector specification Socket side: Straight, Plug side: Straight Socket side: Angled, Plug side: Angled Cable length m 5m Connector specification S A Straight Angled 4

6 5 Port Solenoid Valve/ SV000, 000 EX500 How to Order Cassette Base Manifolds SS5V W6S AW D 05 U C4 Relay output module SV000 SV000 SI unit specification AW AW Remote I/O (RIO) DeviceNet PROFIBUS-DP Valve stations 0 stations 6 6 stations 6 solenoids or less P, R port entry position U D B Pilot specification R How to Order Solenoid Valves U side D side Both sides Internal pilot External pilot SV000 C ø. C4 ø4 C6 ø6 N ø/8" N ø5/" N7 ø/4" DIN rail length Standard length For stations 0 For 0 stations A, B port size (One-touch fitting) SV000 C4 ø4 C6 ø6 C8 ø8 N ø5/" N7 ø/4" N9 ø5/6" SV 00 5F U Relay Output Module Part Number SV A-A SV000 SV000 Type of actuation 4 5 Single solenoid Double solenoid Closed center Exhaust center Pressure center Pilot type R Internal pilot External pilot Manual override Light/Surge voltage suppressor U R D Non-locking push type Slotted locking type With light/surge voltage suppressor With surge voltage suppressor Valve specifications position single Operating pressure position double range (MPa) position Enclosure Rated coil voltage Allowable voltage fluctuation Power consumption (W) 0.5 to 0. to 0. to IP65 (based on IEC59) 4VDC ±0% of rated voltage 0.6 (With light: 0.65) SI unit specifications Connection block Connection block stations Block supply voltage Block supply current Communication connector Relay output module Solenoid valve (single, double) Double solenoid valve: Maximum 8 stations Single solenoid valve, Relay output module: Maximum 6 stations 4VDC 0.65A Max. 00mA or less (at rated voltage) M connector (8 pins, socket/plug) Manifold specifications Model Manifold type P(SUP), E(EXH) type Valve stations Port size Valve Cv factor P, E port A, B port P A/B A/B E SV000 SV000 Plug-in type Common SUP, EXH to 6 stations ø8, ø5/6" ø0, ø/8" ø., ø4, ø6 ø4, ø6, ø8 ø/8", ø5/", ø/4" ø5/", ø/4", ø5/6" 0.6 Valve Cv factors are shown for A, B port sizes of C6 for SV000, and C8 for SV000. Relay output module specifications Output points Output type Maximum load voltage Maximum load current Indicator light point output (connector with lead wire/m) 4 pin connector (M) plug Not connected Output connection Not connected Output connection Contact type ["a" (N.O.) contact] 0VAC A Green LED 0mA or less Relay output module pin wiring -6-4 Shimbashi, Minato-ku, Tokyo , JAPAN Tel: Fax: URL SMC CORPORATION All Rights Reserved st printing March, 000 D-SMC.L.A. P-50 (OCPC) nd printing September, 000 D-SMC.L.A. P-0 (SP) Specifications are subject to change without prior notice and any obligation on the part of the manufacturer. Printed in Singapore