Series 206/208 Through-Hole DIP Switch

Transcription

1 Available with SPST, SPDT, DPST, 3PST circuitry choices Available with low profile, standard, or extended actuator heights. Consult the ordering information for options. RoHS compliant Optional top tape seal for board spray washing Description The terminals are molded into the thermoset base and provide an electrostatic discharge shield rating to 22KV when the OFF side terminals are connected to ground. The optimized contact design incorporating a dimple-toflat surface wiping interface provides long-term contact corrosion resistance making this the ideal choice for any HVAC, server, or security system. Ordering Information Series Poles Throws Switch s Actuator Height Bottom Epoxy Seal Top Tape Seal Actuation Preset 206-/208-2 E S T N No. of poles For SPST Single pole 2 Double pole 3 3 poles Notes:.Contact CTS for other common features not listed. 2. Alternate numbering format 20600/20800 instead of 206-/208- Example: ST For SPST Single throw 2 Double throw No. of switch positions position 2 2 positions 3 3 positions 4 4 positions 5 5 positions 6 6 positions 7 7 positions 8 8 positions 9 9 positions 0 0 positions 2 2 positions E LP S Standard (0.89mm/.035 ) Extended (3.43mm/.35 ) (SPST only) Low profile (Flush) (SPST & SPDT only) Bottom epoxy seal No epoxy seal Epoxy seal (Required for 206-S) BLANK N T Ship at OFF position Ship at ON position (SPST, DPST & 3PST only) Top tape seal No top tape seal Top tape seal (Not available for extended actuator or -position SPST DIP switch) Rev. C Page of 5

2 Electrical Specifications Series 206/208 Parameter Conditions & Remarks Min Max Unit Contact Resistance (206) Initial 50 At end of life 00 milliohms Contact Resistance (208) Initial 00 At end of life 500 milliohms Insulation Resistance Between insulated terminals 000 Megohms Dielectric Strength 500 VAC between adjacent switches minute Switch Capacitance Between adjacent closed switches 5.0 pf Nonswitching Rating Circuit Mechanical and Environmental Actuation Life (206) Actuation Life (208) Soldering Shock Vibration Seal Marking Packaging: Operating Temperature Range Storage Temperature Range SPST SPDT DPST 3PST 00 or ma or VDC 0,000 cycles switching 24VDC 2,000 cycles switching 24VDC Maximum wave temperature, 260 C for 5 seconds Per MIL-STD-202F, method 23B, condition A(50G s) with no contact inconsistencies greater than microsecond Per MIL-STD-202F, method 204D, condition B (.06 or 5G s between 0 HZ to 2K HZ) with no contact inconsistencies greater than microsecond Bottom epoxy seal optional Optional top tape seal for board spray washing Special side or top marking available-consult CTS Standard anti-static tube packaging -55 C to +85 C -55 C to +85 C Rev. C Page 2 of 5

3 Mechanical Specifications Figure - SPST Series 206/208 Figure 2 SPDT Figure 3 DPST Rev. C Page 3 of 5

4 Figure 4-3PST Figure 5 Low Profile Actuators (SPST & SPDT only) Figure 6 Extended Actuators (SPST only) Rev. C Page 4 of 5

5 Rev. C Page 5 of 5